• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.12B
• /
• pp.1979-1987
• /
• 2000

다중 경로 감쇄 채널 환경에서 순방향 DS-CDMA 송수신기의 성능은 사용자에 할당된 확산 수열의 특성에 따라 영향을 받는다. DS-CDMA의 수신기 비트 오류 확률 (BER) 성능은 수신단에서의 신호 대 간섭전력비 (SIR)의 함수로서, 사용자 확산 수열로 왈시 부호와 같은 직교 수열을 사용한 직교 확산 방식과 임의의 랜덤 수열로 사용한 랜덤 확산 방식에서의 수신 신호 간섭 전력은 상이한 특성을 가진다. 이 논문에서는 채널 부호를 사용하지 않은 경우와 길쌈 부호를 사용한 경우에 대해 두 시스템에서의 수신 심벌 SIR을 유도한 뒤 몬테 카를로 분석을 통해 이론적인 BER 성능을 구하고, 전산 모의 실험을 통해 이러한 분석의 타당성을 확인한다. 위상 지연이 동일한 다른 사용자 신호들로 인한 간섭 전력의 상승으로 인해 랜덤 확산 방식은 직교 확산 방식에 비해 성능이 크게 떨어진다. 경로수가 증가함에 따라 이러한 성능 차이는 감소하나 경로수가 많은 경우에도 2배 이상의 사용자 용량 차이가 발생한다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.3A
• /
• pp.257-265
• /
• 2004

General closed-form expression is derived and analyzed for the exact bit error rate (BER) performance of the arbitrary rectangular Gray coded QAM signal in conjunction with maximal-ratio combining (MRC) diversity on frequency non-selective slow m-distributed Nakagami fading channel in the presence of co-channel interference. Numerical results demonstrate error performance improvement with the use of MRC diversity reception. The new expressions presented here are suitable for evaluating various cases of practical interest on wireless communication channels.

• Proceedings of the Korean Information Science Society Conference
• /
• 2003.04d
• /
• pp.316-318
• /
• 2003

본 논문에서는 무선랜 프로토콜 IEEE802.11g에서 사용되는 변조방식인 OFDM (Orthogonal frequency division multiplexing) 방식을 TMX320C6416을 사용하여 구현하였다. 통신 시스템의 발달에 따라 고속으로 데이터를 전송하는 방식이 요구되었고, 유선망 없이 장소에 구애 받지 야고 데이터를 송수신할 수 있는 무선랜 시스템의 필요성이 증가하고 있다. 이러한 필요성에 따라 2002년 6월 현재 발표된 IEEE 802.11g 규격 Draft 2.8은 2.4GHz 주파수 대역에서 기존 IEEE 802.11b규격과 호환성은 유지하며 전송속도를 최소 20Mbps 이상을 목표로 한다. IEEE802.119에 정의된 규정에 따라 OFDM방식의 기저대역 알고리즘을 TMX320C6416 을 사용하여 각 블록별로 C언어로 구현하였고, TMX320C6416에 대한 리니어 어셈블리 언어로 구현하는 최적화 작업을 통해 연산속도를 향상시키는 것을 목적으로 하며, 구현한 알고리즘의 비트 오류 확률을 매트랩 시뮬레이션 결과와 비교해 보도록 한다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8C
• /
• pp.645-654
• /
• 2012

In this paper, we consider a two-way relay (TWR) system, where two user nodes exchange their information within two transmission phases, by the help of a relay node adopting physical layer network coding. In the system, two users transmit their binary phase shift keying symbols simultaneously in the first phase, and the relay node decodes the XORed version of two user data and broadcasts it back to two users in the second phase. The performance of the system is analyzed in terms of the average end-to-end symbol error probability in Nakagami-m fading channels, for which a tight upper bound is derived in a closed form to provide an accurate and handy estimate on the performance. The results show that our upper bounds are almost indistinguishable from simulation results for various channel and system configurations. In addition, the optimal relay location and power allocation for various conditions can be obtained quickly with our analysis.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.42 no.5
• /
• pp.951-958
• /
• 2017

In an attack context, the adversary wants to retrieve the message from the intercepted noisy bit stream without any prior knowledge of the channel codes used. The process of finding out the code parameters such as code length, dimension, and generator, for this purpose, is called the blind recognition of channel codes or the reconstruction of channel codes. In this paper, we suggest an improved algorithm of the blind recovery of rate k/n convolutional encoders in a noisy environment. The suggested algorithm improves the existing algorithm by Marazin, et. al. by evaluating the threshold value through the estimation of the channel error probability of the BSC. By applying the soft decision method by Shaojing, et. al., we considerably enhance the success rate of the channel reconstruction.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.99-107
• /
• 2013

Controller area network (CAN) was designed for multiplexing communication between electronic control units (ECUs) in vehicles and thus for decreasing the overall wire harness. The increasing number of ECUs causes the CAN bus overloaded and consequently the error probability of data transmission increases. Since the time duration for the data transmission is proportional to CAN frame length, it is desirable to reduce the frame length. In this paper, a CAN message compression method is proposed using Data Length Code (DLC) and compression area selection algorithm to reduce the CAN frame length and the error probability during the transmission of CAN messages. By the proposed method, it is not needed to predict the maximum value of the difference in successive CAN messages as opposed to other compression methods. Also, by the use of DLC, we can determine whether the received CAN message has been compressed or not without using two ID's as in conventional methods. By simulations using actual CAN data, it is shown that the CAN transmission data is reduced up to 52 % by the proposed method, compared with conventional methods. By using an embedded test board, it is shown that 64bit EMS CAN data compression can be performed within 0.16ms and consequently the proposed algorithm can be used in automobile applications without any problem.

• Journal of Advanced Navigation Technology
• /
• v.11 no.1
• /
• pp.9-16
• /
• 2007

In this paper, the Bit Error Ratio (BER) performances of the D8PSK modulation schemes for VDL Mode-2 are analyzed according to the matched and unmatched cases of the channel filters. The carrier frequency and phase offset effects are analyzed with unmatched case. Generally in digital transmission techniques, the Root Raised Cosine filters which are used as channel filters are applied to both sides at transmitter and receiver in order to achieve no ISI, but in VDL Mode-2, the Raised Cosine Filter is used only in transmission section and the receiver section uses general low pass filter, therefore we could not achieve ISI reduction effects but can have better spectrum quality. From the simulation results, the error probability is increased slightly (1~2dB) with use of un-matched channel filter, we got the conclusions that carrier phase offset do not effect to bit error ratio, but the frequency offset effect is so serious. Finally, narrow band D8PSK modulation signals are generated by the use of Digital Up-Converter and then its features are compared with analog modulator.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.12
• /
• pp.2813-2819
• /
• 2015

In this paper, we investigate the physical layer network coding (PNC) technique in a two-way relay channel (TWRC) where two source nodes send and receive data with each other via a relay node. In particular, we consider the communication scenario where packet length from the two sources is different from each other. We analyze the bit error rate (BER) of the received packet at the relay node according to degree of overlapping between two packets. The BER of the short packet remains unchanged regardless of the degree of overlapping since the entire packet is overlapped with the longer packet, while the BER of the longer packet becomes improved as the degree of overlapping decreases. Thus, we need a novel transmission scheme to enhance BER performance of the PNC technique in TWRC environments since the overall BER performance of the PNC technique at the relay node depends on the worse BER between two ovelapping packets' BERs.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.7
• /
• pp.13-23
• /
• 2009

In this paper, the network performance of a turbo coded optical code division multiple access (CDMA) system with cross-layer, which is between physical and network layers, concept is analyzed and simulated. We consider physical and MAC layers in a cross-layer concept. An intensity-modulated/direct-detection (IM/DD) optical system employing pulse position modulation (PPM) is considered. In order to increase the system performance, turbo codes composed of parallel concatenated convolutional codes (PCCCs) is utilized. The network performance is evaluated in terms of bit error probability (BEP). From the simulation results, it is demonstrated that turbo coding offers considerable coding gain with reasonable encoding and decoding complexity. Also, it is confirmed that the performance of such an optical CDMA network can be substantially improved by increasing e interleaver length and e number of iterations in e decoding process. The results of this paper can be applied to implement the indoor optical wireless LANs.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.4
• /
• pp.350-359
• /
• 2013

In this paper, Inter user interference elimination algorithm based on Block Diagonal Geometric Mean Decomposition(BD-GMD) for eliminating inter user interference apply to Zero-Forcing in the Successive Signal to Leakage plus Noise Ratio(SSLNR) in Coordinated Multi-Point Coordinated Beamforming system(CoMP CB). As a result, the leakage power is eliminated. The inter user interference elimination algorithm, however, cannot guarantee the enough desired signal power therefore we perform the channel ordering to overcome this disadvantage and increase the desired signal power. The simulation results show that the proposed scheme provides the improved Bit Error Rate(BER) performance compared with existing SSLNR-Zero-Forcing-Tomlinson Harashima precoding(SSLNR-ZF-THP).