• Food Science and Industry
• /
• v.53 no.3
• /
• pp.284-294
• /
• 2020

High voltage pulsed electric field technology has been attracting attention in the the food industry as an eco-friendly nonthermal process technology using electrical energy. The lack of understanding of the equipment and the burden of equipment cost have not significantly increased the commercial application, but the potential as a technology to replace the heat process has been continuously increased. Sterilization of foods using the PEF process has been applied to liquid foods with low viscosity such as fruit and vegetable juices, but recently, high viscosity smoothies, high concentrate protein drink, mixed juice, and alcoholic beverages. Studies on sterilization of solid foods such as powders, raw meats are also being conducted. Also, the application of extraction and recovery of useful ingredients, activation of active compounds, pretreatment of drying, improvement of meat quality, changes of properties of starch has been studies.

• Food Science of Animal Resources
• /
• v.32 no.2
• /
• pp.212-219
• /
• 2012

The objective of this study was to investigate the effect of high pressure (HP) processing on shelf life, as well as the addition of phosvitin on lipid and protein oxidation stability of minced chicken leg meat. Minced chicken leg meat was mixed with yolk phosvitin at 500 or 1000 mg/kg meat levels, and divided into raw and cooked groups. Then, the samples were subjected to HP at 0.1, 300, and 600 MPa. The total aerobic bacteria, lipid and protein oxidation, along with instrumental meat color ($L^*$, $a^*$, and $b^*$value) of the samples were measured during storage for 7 d at $4^{\circ}C$. In raw meat, the number of total aerobic bacteria was decreased by HP at 300 MPa (4 Log reductions) and 600 MPa (5 Log reductions) after 7 d of storage (p<0.05). HP at 600 MPa increased lipid oxidation of samples at all storage days and protein oxidation of samples during storage at 3 and 7 d. HP induced the changes of meat color by increase of $L^*$ value and decrease of $a^*$ value (p<0.05). The total aerobic bacteria was not detected in the cooked samples, regardless of HP pressure, and the lipid or protein oxidation of the cooked sample treated by 600 MPa was higher than that of the control (0.1 MPa) on day 7 or control on day 3, respectively (p<0.05). The results suggested that HP can improve the shelf life of minced chicken leg meat. However, phosvitin might be a limited antioxidative agent for the improvement of oxidation stability induced by HP.

• Korean Journal of Food Science and Technology
• /
• v.31 no.2
• /
• pp.368-374
• /
• 1999

This study was designed to investigate effects of pulsed electric field (PEF) treatment on physiological changes of microbial cells, using domestically fabricated pilot scale PEF device. The effect of non-thermal PEF treatment on physiological characteristics of microorganisms was determined by salt resistance, the amount of UV absorbents, cell staining, recovery rate of defected cells, and changes in structure of cell membrane. Salt resistance of Escherichia coli, Bacillus subtilis and Rhodotorula minuta was examined after PEF treatment at 40 kV/cm, 84 pulse, $10{\mu}s$ pulse duration. Approximately $1\;log_{10}$ cell number of viable microorganisms was decreased by addition of salt. PEF treatment significantly increased the amount of UV absorbents at 260 and 280 nm because of leakage from damaged cell membrane by PEF treatment. Although three kinds of microorganisms treated by PEF were difficult to be observed due to their cell membrane damage, untreated cells were clearly observed by a microscope. PEF-treated R. minuta was not stained by methylene blue due to cell membrane defect. When E. coli, B. subtilis and R. minuta were cultured after PEF treatment, they showed 5, 4, and 8 hr longer lag phase, respectively, compared to control, but growth rates were not affected.

• Journal of Chest Surgery
• /
• v.29 no.8
• /
• pp.867-874
• /
• 1996

This study was designed to assess the left ventricular peak systolic pressure/end-systolic volume (PSP/ESV) ratio in predicting symptomatic improvement with valve replacement in patients with aortic regurgitation and enlarged left von'lrlcular volume. We studied 21 patients (15 men and 6 women aged 15 to 60 years) with moderate or severe aortic regur- gitation, no other cardiovascular abnormalities and left ventricular end-systolic volume over 60 m11m2. In this group we assessed the preoperative variables which routinely were measured at cardiac catheterlzation to predict symptomatic improvement with valve replacement. Six months after operation, symptoms were alleviated in 13 patients(62%), and unchanged in 8()8%). By multivariate analysis, the PSP/ESV rati was a strong predictor for functional class 6 months after surgery(p=0.005) and also for change- in functional class prior to an operation to 6 months postoperatively(p=0.0)2). By 6 months after receiving valve replacement, all patients with a ratio over 1. 71 mmHglml/m'were in functional class I or II , in contrast, of those with a ratio < 1.71 mmHg/ml/m2, 40% were in functional class III. The PSP/ESV ratio may help to predict which patients with aortic regurgitation and enlarged left ven- tricular end-systolic volume will have symptomatic improvement with valve replacement.

• The Journal of the Convergence on Culture Technology
• /
• v.6 no.2
• /
• pp.553-560
• /
• 2020

In the existing research paper, we developed Mechanical Pressurizing Equipment(MPE) that can apply a certain amount of pressure and found out about improving the bonding strength of repair materials constructed in the repair section, and if pressurized, the bonding strength could be increased. In this study, the pressure of Mechanical Pressurizing Equipment(MPE) was changed to 0, 10, 30, 50, and 80 kPa, and the test was conducted to select effective pressure by measuring the flexural, compressive, and bonding strength of the specimens and deformation of the pressure plate at the age of 3 and 28th days. As a result of the test, 30 kPa was the most efficient pressure for the MPE. After producing the specimen with three types of repair materials with different main components, the bonding strength was measured according to dry and wet conditions, construction site (ceiling, wall and floor), and whether or not pressurized, on the 3rd, 7th, 14th, and 28th, indicating that the repair materials mixed with cellulose fiber was most effective for the MPE.

• Journal of the Korean Society of Radiology
• /
• v.4 no.2
• /
• pp.21-25
• /
• 2010

Recently, various semiconductor compounds as radiation detection material have been researched for a diagnostic x-ray detector application. In this paper, we have fabricated the CdS detecton sensor that has good photosensitivity and high x-ray absorption efficiency among other semiconductor compounds, and evaluated the application feasibility by investigating the detection properties about energy range of diagnostic x-ray generator. We have fabricated the line voltage selector(LCV) for a signal acquisition and quantities of CdS sensor, and designed the voltage detection circuit and rectifying circuit. Also, we have used a relative relation algorithm according to x-ray exposure condition, and fabricated the interface board with DAC controller. Performance evaluation was investigated by data processing using ANOVA program from voltage profile characteristics according to resistive change obtained by a tube voltage, tube current, and exposure time that is a exposure condition of x-ray generator. From experimental results, an error rates were reduced according to increasing of a tube voltage and tube current, and a good properties of 6%(at 90 kVp) and 0.4%(at 320 mA) ere showed. and coefficient of determination was 0.98 with relative relation of 1:1. The error rate according to x-ray exposure time showed exponential reduction because of delayed response velocity of CdS material, and the error rate has 2.3% at 320 msec. Finally, the error rate according to x-ray dose is below 10%, and a high relative relation was showed with coefficient of determination of 0.9898.

• Journal of the Korea Convergence Society
• /
• v.9 no.4
• /
• pp.261-269
• /
• 2018

The purpose of this study was to determined the converge effects of Kaatsu treatment on body compositions, physical fitness and dynamic and static balance during unmilled rice dumbbell exercise in older women. They are divided into three groups(Kaatsu treatment+exercise, n=12, non-Kaatsu treatment+exercise, n=11, Control, n=12). In this study, there were a no significant differences on body weight and lean body mass and body mass index between the group, but there was a significant differences on percent of body fat between the group(P<.001). There was a significant differences on left grip strength between the group, and significant differences on flexibility and agility after the unmilled rice dumbbell exercise training. There were a significant differences on the dynamic and static balance between the group after the unmilled rice dumbbell exercise training(respectively P<.001, P<.05).

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.3
• /
• pp.1611-1619
• /
• 2015

This study examined the toughness improvement of a track shoe used as the undercarriage of excavator and bulldozer parts. The excavator is operated under poor conditions, such as the build-up field and quarry. Therefore, the track shoe requires high strength and impact toughness to endure immense shock while at work. The track shoe was made of heat treated boron steel. The sufficient possibility of hardenability with the theoretical Jominy curve for boron steel was confirmed while quenching. The Taguchi orthogonal array experiment method was used to optimize the process variables, such as area reduction ratio and heat treatment conditions (tempering temperature and holding time), to achieve toughness improvement. The toughness of the track shoe increased with increasing area reduction, and a tempering temperature of $210^{\circ}C$ and a tempering time of 80 min are beneficial for improving the toughness of the track shoe.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.7
• /
• pp.599-607
• /
• 2015

In this study, we theoretically investigate the thermal performances of heat pipes that have different nano-fluid properties. Two different types of nano-particles have been used: $Al_2O_3$ and CuO. The thermal performances of the heat pipes are observed for varying nano-particle aggregations and volume fractions. Both the viscosity and the conductivity increase as the volume fraction and the aggregation increase, respectively. Increasing the volume fraction helps increase the capillary limit in the well-dispersed condition. Whereas, the capillary limit is decreased under the aggregate condition, when the volume fraction increases. The dependence of the heat pipe thermal resistance on the volume fraction, aggregation, and conductivity of the nano-particles is analyzed. The maximum thermal transfer of the heat pipe is highly dependent on the volume fraction because of the high permeability of the heat pipe. For the proposed heat pipe, the optimum volume fraction of the nano-particle can be seen through 3D graphics.

• Geotechnical Engineering
• /
• v.11 no.1
• /
• pp.113-126
• /
• 1995

Both resonant column (RC) and torsional shear(TS) tests were performed at small to intermediate strain levels to investigate deformational characteristics of cohesive soils. The effects of variables such as strain amplitude, loading frequency, and number of loading cycles were studied. Plasticity index was found to be an important variables in evaluating these effects. Soils tested include undisturbed silts and clays and compacted subgrade soils. At small strains below the elastic threshold, shear modulus is independent of number of loading cycles and strain amplitude. Small strain material damping exists wi th ranges be tween 1.1% and 1.7% for 75 tests. The elastic threshold strain increases as confining pressure and plasticity index increases. Above the cyclic threshold strain, the modulus of cohesive soil decreases with increasing number of cycles while damping ratio is almost independent of number of load cycles. Moduli and damping ratios of cohesive soils obtanined by RC test are higher than those from 75 test because of the frequency effect. Shear modulus of cohesive soil increases linearly as a function of the logarithm of loading frequency.