• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.3
• /
• pp.301-307
• /
• 2012

The characteristics of pressure loss in an asymmetric bifurcating tube were investigated numerically for steady inspiratory conditions. The loss coefficient K calculated for various asymmetry and flow-distribution ratios found in human lung airways showed a power-law dependence on the Reynolds number (Re) and length-to-diameter ratio (L/d), with different exponents for Re $\geq$ 100 and Re < 100. The fundamental characteristics of the asymmetric bifurcation are similar to the case of symmetric bifurcation. In addition, the effect of skewed inlet velocity profiles on the pressure loss was weak, and decreased with an increasing number of bifurcations.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.33 no.3
• /
• pp.482-490
• /
• 2006

Deep caries in primary molars without early intervention frequently induce a pulpal disease and consequent abscess lesion in surrounding tissue. Especially in many furcation radiolucent lesions of primary molars, accessory canals in furcation areas of primary molars play an important role in theses pathological progress. Although the studies of these communication canals in furcation area of human permanent molar well documented, there has been little research showing their existence in primary molar. For the purpose of understanding the morphological characteristics of accessory canals at furcation areas of primary molars and examining its frequency and patency, 52 specimen teeth were observed under the scanning electro-microscope and tested with dye penetration under vacuum pressure, and obtained the results as follows : 1. In SEM study, the frequency of accessory foramina viewed from the external and internal furcation area was 60% and 35% respectively. Likewise the diameter of the accessory canals was within the range of $11{\sim}107{\mu}m$ and $12{\sim}62{\mu}m$ respectively. 2. The frequency of patent accessory canals evidenced by the dye penetrated under the vacuum suction at furca areas in primary molars was 50% among the 20 specimen teeth tested.

• 한국전산유체공학회:학술대회논문집
• /
• 2008.03b
• /
• pp.385-388
• /
• 2008

The objective of this paper is simulating blood flow through the branched and stenotic tube numerically. SC-Tetra, which is one of the commercial code using FVM method, was utilized for this analysis. The flow is assumed as an incompressible laminar flow with the additional condition of non-Newtonian fluid. As the constitutive equation for the fluid viscosity, the following models were solved with governing equations ; Cross Model, Modified Cross Model, Carreau Model and Carreau-Yasuda Model. Final goal was achieved to get analytic data about shear stress, at specific points, changing the geometry with various factors like the bifurcation angle, diameter of the branches, the ratio of stenosis, and etc. The material property of blood was referred from the related papers. Furthermore, to verify results they were compared with those of the published papers. There were some discrepancies based on the different solver and the different data post-processing method. However, many parameters like the location of low shear stress, which arised from bifurcation or stenosis, and the tendency of various factors were found to be very similar.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.26 no.4
• /
• pp.357-362
• /
• 1981

This study was conducted to examine the best population density and agronomic characteristics affected by different row-widths and planting-spaces within row in safflower. As both row-width and spacing were narrowed, plant height and height to first branch were increased, and the number of branch per plant showed decrease. Plant height showed negative correlation with row-width, height to first branch showed negative correlation with row-width x spacing, and number of branch per plant had positive correlation with row width, and row-width x spacing but negative correlation with plant height. Yield was affected by spacing and row-width x spacing. In spacing, 5cm plot performed the best yield, and 30 x 5cm population density was the best cultural method to increase safflower yield. Yield had negative correlation with spacing and row-width x spacing, but positive correlation with height to first branch.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.1
• /
• pp.31-37
• /
• 2006

The present study has been experimentally investigated the effect of geometric and operating parameters on the two-phase flow distribution of refrigerants in a horizontal T-junction. The operating parameters were the kind of refrigerants (R-22, R- l34a, and R-410A), saturated temperature, and the inlet mass flux and quality. The geometric parameters were the tube diameter and the tube diameter ratio. The measured data of refrigerants were compared with the values predicted using the models developed by several researchers for air/water or steani/water two-phase flow. Among the operating parameters, the inlet Quality was the most sensitive to the mass flow rate ratio. Between the geometric parameters, the tube diameter ratio was more sensitive than tube diameter.

• Proceedings of the KSME Conference
• /
• 2002.08a
• /
• pp.165-168
• /
• 2002

This paper describes the dynamics of the weak shock wave propagating inside some kinds of branched pipe bends. Computations are carried out by solving the two-dimensional, compressible, unsteady Euler Equations. The second-order TVD(Total Variation Diminishing) scheme is employed to discretize the governing equations. For computations, two types of branched pipe($90^{\circ}$ branch,$45^{\circ}$ branch) with a diameter of D are used. The incident normal shock wave is assumed at D upstream of the pipe bend entrance, and its Mach number is changed between 1.1 and 2.4. The flow fields are numerically visualized by using the pressure contours and computed schlieren images. The comparison with the experimental data performed for the purpose of validation of computational work. Reflection and diffraction of the propagating shock wave are clarified. The present computations predicted the experimented flow field with a good accuracy.

• Journal of the Korean Society of Visualization
• /
• v.4 no.2
• /
• pp.32-36
• /
• 2006

Recently there are many researches about single flow and two-phase flow phenomena in the mini and microchannel. But from this result the principle in the microchannel was not explained clearly. In this paper two-phase flow pattern was visualized in the micro-multi-branched-channel using a high speed camera. Microchannel was fabricated with PDMS and glass slide. The velocity profile was obtained by a Micro PIV. Then flow boiling at the near inlet area was occurred and vapor was moved in the micro-multi-branched-channel.

• Proceeding of EDISON Challenge
• /
• 2013.04a
• /
• pp.403-408
• /
• 2013

본 논문은 EDISON_CFD를 이용하여 관상동맥 분지관에서 점도에 따른 유체의 유동현상에 관하여 연구를 하였다. 뉴턴유체인 물의 점성계수 일때와 비뉴턴유체인 혈액의 Carreau model에서의 영전단율 점성계수(${\eta}_0$)와 무한전단율 점성계수(${\eta}_{\infty}$)일 때의 유동현상을 살펴보았다. 그 결과 점도가 증가할수록 재순환 영역에서 유체의 속도가 감소하였고 CF 및 CP값이 감소하는 구간의 수가 증가하여 벽면의 저전단응력으로 인해 생기는 재순환영역의 수가 증가하는 것으로 나타났다.

• Journal of Veterinary Clinics
• /
• v.27 no.5
• /
• pp.573-578
• /
• 2010

A 4-year-old intact male Shih Tzu dog (weighing 5 kg), was presented with signs of severe dyspnea, exercise intolerance and cyanosis. Diagnostic studies suggested a reverse patent ductus arteriosus (rPDA) with pneumonia. Despite emergency treatments with oxygen, diuretics, antibiotics and medical therapy for hyperkalemia, the dog died of ventricular fibrillation from hyperkalemia and dehydration. Necropsy revealed the rPDA with a marked descending aortic dilation and abnormally arisen left common carotid artery.

• Clean Technology
• /
• v.18 no.4
• /
• pp.410-418
• /
• 2012

The performance of the ammonia injection gun (AIG) used for maximizing the utilization of reducing agent in the selective catalytic reduction (SCR) system is decided by several parameters such as the pattern of flow distribution, geometry of the air distribution manifold (ADM) and the array and geometry of nozzles. In the study, the uniformity of jet flows from the nozzles in AIG was analyzed statistically by using the computational fluid dynamics (CFD) method to evaluate the role of design parameters on the performance of the SCR system. The uniformity of jet flows from the nozzles is being deteriorated with increasing the supplying flow rate to the AIG. Distribution rates to each branch pipe become lower with decreasing distance to the header, and flow rates from nozzle are also reduced with decreasing distance to the header. The uniformity of jet flows from nozzles becomes stable significantly when the ratio of summative area of nozzles to each sectional area of the branch pipe is below 0.5.