• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.6
• /
• pp.49-54
• /
• 2009

Sensor nodes in wireless sensor networks operate in distributed environments with limited resources and sensing capabilities. Especially, a sensor node has a small energy. After the sensor nodes are distributed in some area, it is not accessible to the area. AIso, a battery of sensor node cannot change. One of the hot issues in wireless sensor networks maximizes the network lifetime through minimizing the energy dissipation of sensor nodes. In LEACH, the cluster head is elected based on a kind of probability method without considering remaining energy of sensor node. In this paper, we propose a cluster formation scheme that the network elect the node, which has higher energy level than average energy level of overall sensor network, as cluster head node. We show the superiority of our scheme through computer simulation.

• The Journal of the Korea Contents Association
• /
• v.9 no.9
• /
• pp.31-40
• /
• 2009

What are important in wireless sensor networks are reliable data transmission, energy efficiency of each node, and the maximization of network life through the distribution of load among the nodes. The present study proposed DSPR, a dynamic unique path routing machanism that considered these requirements in wireless sensor networks. In DSPR, data is transmitted through a dynamic unique path, which has the least cost calculated with the number of hops from each node to the sink, and the average remaining energy. At that time, each node monitors its transmission process and if a node detects route damage it changes the route dynamically, referring to the cost table, and by doing so, it enhances the reliability of the network and distributes energy consumption evenly among the nodes. In addition, when the network topology is changed, only the part related to the change is restructured dynamically instead of restructuring the entire network, and the life of the network is extended by inhibiting unnecessary energy consumption in each node as much as possible. In the results of our experiment, the proposed DSPR increased network life by minimizing energy consumption of the nodes and improved the reliability and energy efficiency of the network.

• Journal of the Korean Applied Science and Technology
• /
• v.35 no.4
• /
• pp.1088-1095
• /
• 2018

In this study, reduced graphene oxide/polyaniline composite was fabricated tomaximize their advantages with electrochemical performances and use as a electrodematerial for supercapcaitor. Polyaniline as an electrode material was synthesized bychemical polymerization of aniline monomer and reduced graphene oxide wasintroduced to prepare composite with polyaniline without any pre-treatment. Thereduced graphene oxide, polyaniline and their composite electrodes were fabricatedon gold coated PET(polyethylene terephthalate) substrate through spray coatingmethod which can also apply to industrial scale. we have also prepared reducedgraphene oxide and polyaniline single material electrode to compare theirelectrochemical properties with reduced graphene oxide/polyaniline composite electrode. We have analyzed and compared electrochemical properties of eachelectrodes by using cyclic voltammetry(CV), galvanostaticcharge-discharge(GCD) and electrochemical impedancespectroscopy(EIS) at same condition. As a result, reduced graphene oxide /polyaniline composite electrode showed higher capacitance value more thanpolyaniline and reduced graphene oxide electrode, respectively. Internal resistanceof reduce graphene oxide/polyaniline composite electrode was 24% and 58% lessthan polaniline and reduced graphene oxide electrode respectively. These resultsconsidered that reduced graphene oxide/polyaniline composite electrode has potential ability and enable to apply flexible energy storage and wearable devices.

• Applied Chemistry for Engineering
• /
• v.21 no.3
• /
• pp.311-316
• /
• 2010

This study aimed to prepare antimony-doped tin oxide (ATO) dispersion with high stability. The methods to achieve this goal were sought by investigating the changes of ATO particle size, size distribution, dispersion property as wet ball milling treatment time increased. And the changes of wet ball milled ATO dispersion property were also investigated, as pH increased. The changes of ATO particle size and size distribution, according to wet ball milling treatment time were evaluated with laser diffraction particle size analyzer and scanning electron microscope (SEM). The changes of ATO dispersion property, as wet ball milling treatment time and pH increased, were evaluated with zeta potential analysis and Turbiscan. By 60 min wet ball milling treatment time, ATO particle size decreased and size distribution became narrower, as the treatment time increased. After 60 min milling, the ATO particle size decreased to less than 30% of the initial size and the size distribution was narrowed to $0.1{\sim}5{\mu}m$ from $1{\sim}35{\mu}m$. However, more than 60 min milling, ATO particles aggregated and the particle size increased. ATO dispersion stability also increased as the treatment time and pH increased because the reduced particle size increased particle surface energy and repulsion between particles and the increased pH enhanced particle surface ionization. Hence, after proper length of wet ball milling treatment, highly stable ATO dispersion can be prepared, as increasing pH of the dispersion.

• Journal of the Korean Institute of Gas
• /
• v.22 no.3
• /
• pp.32-37
• /
• 2018

Recently, the distributed power generation market using natural gas is expected to expand gradually according to the government's future energy conversion policy. Distributed power generation means small power generation source near the power demand site, which has the advantage of reducing the construction costs of the transmission and distribution infrastructure, operating cost and power loss. A typical example of distributed generation using natural gas is the trigeneration system. In this study, we conducted a basic study on the performance analysis of trigeneration desiccant system for dehumidifying / cooling / heating in the air conditioner room by using the cold and engine waste heat energy generated in the trigeneration system. It shows that the system efficiency increases and the energy consumption decreases as the temperature difference between the inlet and outlet of the trigeneration system increases compared with the general air conditioning system.

• Korean Journal of Optics and Photonics
• /
• v.15 no.2
• /
• pp.89-99
• /
• 2004

At the interface of two materials with frequency-dependent material-parameters of permittivity and permeability, there may exist two kinds of surface polaritons: surface electric-polaritons(SEPs) and surface magnetic-polaritons(SMPs). Possible combinations of the material-parameters to support propagation of the two surface polaritons are suggested at the interface between metals and metamaterials such as a left-handed material. Dispersion relations are also derived in order to characterize frequency dependence of propagation of the SEP and SMP. It is found that only one propagation mode of SEP or SMP is allowed at a given set of four material parameters, and that counter-propagation of the phase and group velocities of the propagation mode can be observed even in the case when there are no double negative(or, negative-index) materials. Physical origin of the counter-propagation of the group velocity is proposed by evaluating the ratio of two electromagnetic-energy densities of a surface polariton propagating along within the two interface media, and it is confirmed by the dispersion relations.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.71-71
• /
• 2011

ZnO 반도체가 넓은 에너지띠와 큰 엑시톤 결합에너지를 가지기 때문에 가진 투명 전극, 태양전지, 발광소자 및 메모리와 같은 다양한 전자 및 광전자 소자의 응용에 대한 많은 연구가 활발히 진행되고 있다. 본 논문에서는 절연성 고분자인 폴리스티렌 박막에 분산되어 있는 ZnO 나노 입자를 기억 매체로 사용하는 write-once-read-many times (WORM) 메모리 소자를 제작하고 전기적 성질과 안정성에 대하여 관찰하였다. 화학적 방법으로 형성한 ZnO 나노입자와 폴리스티렌을 N,N-dimethylformamide 용매에 녹인 후 초음파 교반기를 사용하여 나노 복합 소재를 형성하였다. 하부 전극으로 indium-tin-oxide가 증착되어 있는 유리 기판 위에 나노 복합 소재를 스핀코팅 방법으로 도포한 후 열을 가해 잔류 용매를 제거하였다. ZnO 나노입자가 분산되어 있는 폴리스티렌 나노 복합 소재로 구성된 박막위에 상부 전극으로 Al을 열증착하여 메모리 소자를 제작하였다. 전류-전압 측정 결과에서 저전압에서는 전도도가 낮은 OFF 상태를 유지하다 약 1.5 V에서 전도도가 갑자기 증가하여 높은 전도도의 ON 상태로 전이되는 쌍안정성이 관찰되었다. 전류의 ON/OFF 비율은 약 103이며 ON 상태에서 OFF 상태로 전환되지 않는 전형적인 WORM 메모리 소자의 전류-전압 특성을 나타났다. 두 전극 사이에 폴리스티렌 박막으로만 제작된 소자를 제작하여 전류-전압 측정을 하였으나 메모리 특성이 나타나지 않았다. 그러므로 WORM 메모리 특성은 폴리스티렌 박막안의 ZnO 나노입자에 기인함을 알 수 있었다. 제작된 소자에 대해 기억 시간 측정 결과는 ON과 OFF 상태의 전류가 장시간에도 변화가 거의 없는 소자의 안정성을 보여주었다. 이 실험 결과는 ZnO 나노입자가 분산된 폴리스티렌 나노 복합 구조체를 사용하여 안정성을 가진 WORM 메모리 소자를 제작할 수 있음을 보여주고 있다.

• Journal of KIISE:Databases
• /
• v.36 no.1
• /
• pp.50-62
• /
• 2009

In wireless and mobile environments, data broadcasting is recognized as an effective way for data dissemination due to its benefits to bandwidth efficiency, energy-efficiency, and scalability. In this paper, we address the problem of delayed query processing raised by tree-based index structures in wireless broadcast environments, which increases the access time of the mobile clients. We propose a novel distributed index structure and a clustering strategy for streaming XML data which enable energy and latency-efficient broadcast of XML data. We first define the DIX node structure to implement a fully distributed index structure which contains tag name, attributes, and text content of an element as well as its corresponding indices. By exploiting the index information in the DIX node stream, a mobile client can access the wireless stream in a shorter latency. We also suggest a method of clustering DIX nodes in the stream, which can further enhance the performance of query processing over the stream in the mobile clients. Through extensive performance experiments, we demonstrate that our approach is effective for wireless broadcasting of XML data and outperforms the previous methods.

• The KIPS Transactions:PartC
• /
• v.15C no.1
• /
• pp.19-30
• /
• 2008

Sensor nodes are used as a storage space in the data centric storage method for sensor networks. Sensor nodes save the data to the node which is computed by hash table and users also access to the node to get the data by using hash table. One of the problems which the data centric storage method has is that queries from many users who are interested in the popular data could be concentrated to one node. In this case, responses for queries could be delayed and the energy of heavy loaded node could be dissipated fast. This would lead to reduction of network life time. In this paper, ALT, Data Centric Storage based on Adaptive Local Trajectory, is proposed as scalable data centric storage method for sensor network. ALT constructs trajectory around the storage node. The scope of trajectory is increased or decreased based on the query frequency. ALT distributes the query processing loads to several nodes so that delay of response is reduced and energy dissipation is also distributed.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.6
• /
• pp.163-171
• /
• 2021

In this paper, the energy transaction system was optimized by applying a resource allocation algorithm and deep reinforcement learning in the distributed power system. The power demand and supply environment were predicted by deep reinforcement learning. We propose a system that pursues common interests in power trading and increases the efficiency of long-term power transactions in the paradigm shift from conventional centralized to distributed power systems in the power trading system. For a realistic energy simulation model and environment, we construct the energy market by learning weather and monthly patterns adding Gaussian noise. In simulation results, we confirm that the proposed power trading systems are cooperative with each other, seek common interests, and increase profits in the prolonged energy transaction.