• Proceedings of the Korea Water Resources Association Conference
• /
• 2007.05a
• /
• pp.1189-1193
• /
• 2007

국내 정수장내 설치되어 있는 혼화기는 대부분 기계식 급속혼화 방식을 채택하여 운영하고 있으며 대부분의 혼화지가 크게 설계되어 설계 변경을 하지 않고서는 혼화 효율을 높이는 한계가 있다. 혼화지내 격벽을 설치하여 혼화 구간을 축소시킴으로써 혼화구간이 큰 구조에 비해 6.27%의 효율이 더 좋은 것으로 나타났으며 격벽이 설치된 혼화구간내에 임펠러는 격벽으로 둘러싸인 유출부쪽(상단부)에서 85.45%로 가장 좋은 효과가 나타났다. 또한 약품위치가 임펠러 하단에 가까우면 혼화효과가 크며 멀 경우에 격벽설치에 따른 혼화효과가 더욱 큰 것으로 나타났다.

• The Korean Journal of Rheology
• /
• v.6 no.1
• /
• pp.49-59
• /
• 1994

높은 전기장 하에서 다분산, 비구형 실리카/실리콘 오일 현탁액의 전기유변 (electrorheological, ER)현상을 살펴 보았다. 전기유변유체는 전기장 방향으로 사슬구조를 형 성하는 특성을 보이며 이것이 유변물성의 향상에 기여하는 것으로 알려졌다. 동적(dynamic) 상태 실험에서 전기장 하의 실리카 현탁액은 매우낮은 임계변형율(${\gamma}$c =0.1%)이상에서 비선 형 점탄성을 보였다. 저장탄성계수(G＇)는 변형율 변화에 손실탄성계수(G＂)는 매질의 점도 에 더 민감한 의존성을 보였다. 또한 겉보기 항복응력은 입자의 부피분율과 전기장에$\Phi$1.9E1.4 의 의존성을 보였는데 부피분율에 대한 의존성이 큰 이유는 0.1 이상의 부피분율에서 복합 사슬 구조 내의 입자들 간의 상호 정전효과가 지배적으로 나타나기 때문이라고 생각된다. 정상상태 실험에서는 부피분율이 크거나 높은 전기장 하에서 전단속도가 0.1sec-1 정도 이하 로 감소함에 따라 전단응력이 급겨히 증가하는 현상을 보였다. 그러므로 본질적인 동적 항 복응력을 얻기 위해서는 매우 낮은 전단속도 영역의 특이한 응력거동을 고려해야한다. 큰 전단속도 하에서는 hydrodynamic interaction의 영향으로 전단속도의 증가에 따라 전단응력 이 증가하였다. 이같은 전단응력의 거동을 계단전단실험으로 확인하였다.

• Journal of the Korean Chemical Society
• /
• v.40 no.6
• /
• pp.415-419
• /
• 1996

Hydrogen bonding, dielectric effects and steric effects are all factors which determine the carbonyl stretching frequency, νC=O of ketones in solution. The νC=O frequency of ketones is affected by change in concentration of ketones in various solvents. The νC=O frequency shifts to lower frequency in nonpolar solvents and shifts to higher frequency in polar solvents with the increasing volume% of ketones. In acetonitrle, the νC=O frequency shifts to higher frequency as the volume% of ketones is increased except dimethyl ketone. The νC=O frequency shifts to lower frequency as the solvent system becomes increasingly polar or with the increasing extent of intermolecular hydrogen bonding, as in the case of increasing volume% chloroform in $CHCl_3$/$CCl_4$ solvent system.

• Journal of the Korean Chemical Society
• /
• v.16 no.6
• /
• pp.341-348
• /
• 1972

The significance of the curvature dependency correction of surface tension is studied in calculating the pore volume distribution of porous adsorbent from nitrogen adsorption isotherm. That is, Kelvin radii are calculated with curvature dependent surface tension values calculated by Chang et al, and then with these Kelvin radii, pore volume distributions of three porous adsorbents, silica alumina (steam deactivated), silica gel (Davidson 59), and silica gel (Mallinc-krodt Standard Luminescent), are calculated. The results are compared with those obtained by the previous method in which surface tension is taken as constant and also with the others. obtained by the modelless method proposed by Brunauer et al. The maximum point of the distribution curve shift to the larger pore radius, when the curvature dependency is considered. Furthermore, the relative pressure at which capillary condensation commences is by far the lower than that accepted previously. This effect becomes significant as the pore radius approaches to the micropore range.

• Korean Journal of Materials Research
• /
• v.7 no.9
• /
• pp.728-732
• /
• 1997

비정질 금속 $Co_{66}$F $e_{4}$Ni $B_{14}$S $i_{15}$ 의 표면층 제거에 대한 자기임피턴스 효과는 시료의 길이방향에 평행한 일축자기장에 대하여 측정하였다. MIR(Magnetoimpedance Ratios)은 비정질 금속의 두께가 얇아짐에 따라 감소하고, 전류에 비례하여 증가하는 경향을 나타내었다. 인가전류 주파수에 대한 MIR과 자기장의 감도는 모든 시료에서 주파수에 비례하여 증가하며 수 MHz 부근에서 최대값을 가지고 점차 감소하는 경향을 나타내었다. 시료의 표면층제거에 기인한 이방성자기장의 변화는 MI $R_{Max}$을 나타내는 외부 자기장을 감소시키지만, MIR은 표면층 제거에 따른 부피효과에 기인하여 감소하였다....

• Journal of the Korean Society of Radiology
• /
• v.15 no.6
• /
• pp.821-831
• /
• 2021

In order to calibrate energy and efficiency using the PENELOPE Code, a PENELOPE simulation was performed using a volume source. Here, we want to verify peak efficiency and usefulness by performing simultaneous measurement and correction. calculate the coincident sum correction for all volumes, first subdivide the volumes of the cylinder and the four Marinelli beakers into three heights again. Therefore, the simultaneous measurement correction coefficient in three areas and the simultaneous measurement correction coefficient for the entire volume source are calculated as output. At low energies, the j value for each source volume (50-300 ml) is small and increases significantly in the high energy range. Simulation results showed good agreement within 2.5% for all source volumes except for 50 ml and 300 ml, which were up to 4%. This means that the correction for the simultaneous measurement effect during measurement is effective. In addition. Based on this, it can be confirmed that there is an advantage to improve the detection efficiency when measuring various sources and environmental samples.

• Progress in Medical Physics
• /
• v.24 no.4
• /
• pp.243-252
• /
• 2013

The aim of this study was to clarify the impacts of acquisition parameters on artifacts in four-dimensional computed tomography (4D CT) images, such as the partial volume effect (PVE), partial projection effect (PPE), and mis-matching of initial motion phases between adjacent beds (MMimph) in cine mode scanning. A thoracic phantom and two cylindrical phantoms (2 cm diameter and heights of 0.5 cm for No.1 and 10 cm for No.2) were scanned using 4D CT. For the thoracic phantom, acquisition was started automatically in the first scan with 5 sec and 8 sec of gantry rotation, thereby allowing a different phase at the initial projection of each bed. In the second scan, the initial projection at each bed was manually synchronized with the inhalation phase to minimize the MMimph. The third scan was intentionally un-synchronized with the inhalation phase. In the cylindrical phantom scan, one bed (2 cm) and three beds (6 cm) were used for 2 and 6 sec motion periods. Measured target volume to true volume ratios (MsTrueV) were computed. The relationships among MMimph, MsTrueV, and velocity were investigated. In the thoracic phantom, shorter gantry rotation provided more precise volume and was highly correlated with velocity when MMimph was minimal. MMimph reduced the correlation. For moving cylinder No. 1, MsTrueV was correlated with velocity, but the larger MMimph for 2 sec of motion removed the correlation. The volume of No. 2 was similar to the static volume due to the small PVE, PPE, and MMimph. Smaller target velocity and faster gantry rotation resulted in a more accurate volume description. The MMimph was the main parameter weakening the correlation between MsTrueV and velocity. Without reducing the MMimph, controlling target velocity and gantry rotation will not guarantee accurate image presentation given current 4D CT technology.

• 한국과학교육학회:학술대회논문집
• /
• 2009.02a
• /
• pp.64.2-64.2
• /
• 2009

• The Korean Journal of Rheology
• /
• v.3 no.2
• /
• pp.117-123
• /
• 1991

현탁액에 대한 기본적인 유변학적 특성을 조사하기 위해 입자의 부피분율에 따른 점도의 변화를 측정하였고 현탁액의 Die Swell 현상에 대해 실험적으로 규명하였다. 뉴톤성 특성을 조사하기 위해 입자의 부피 분율에 따른 점도의 변화를 측정하였고 현탁액의 Die Swell 현상에 대해 실험적으로 규명하였다. 뉴톤성 특성을 갖는 Silicone 오일을 현탁 매질 로 사용하였고 미세한 유리 구슬이 filler로써 사용되었다. 현탁액의 점도는 Couette 점도계 와 모세관 점도계를 사용하였다. 관의 입구와 출구에 대한 보정을 위해서 Bagley의 방법을 이용하였으며 중력으로 인한 Swell의 감소효과를 제거하기 위해서 분사 유체와 유사한 밀 도를 지니며 분사 유체와 섞이지 않는 유체를 담은 부력용기가 사용되었다. Die Swell 현상 은 사진을 찍고 이를 정밀한 확대경을 통해 관찰함으로써 수치적으로 값을 얻었다.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.50 no.2
• /
• pp.155-167
• /
• 2023

The aim of this study was to investigate the effects of slow maxillary expansion (SME) on the dentoalveolar, skeletal, upper airway, and maxillary sinus using cone-beam computed tomography (CBCT). Twenty-three orthodontic patients (mean age 8.93 ± 1.61 years) who were treated with maxillary expansion using banded hyrax in the Department of Pediatric Dentistry at Jeonbuk National University Dental Hospital were included. According to the expansion speed applied, they were divided into two groups: SME (12 subjects, mean age 8.92 ± 1.45 years) and rapid maxillary expansion (RME, 11 subjects, mean age 8.94 ± 1.84 years). CBCT were obtained before (T0) and after (T1) the treatment and were analyzed with InVivo5 software (Anatomage, San Jose, CA, USA). Descriptive statistics showed no significant differences between the two groups in age, sex, or skeletal maturity. There were significant increases in maxillary width at the dentoalveolar and skeletal levels for both groups. Upper airway volume revealed a significant increase of 38.59% in the SME group and 28.72% in the RME group. However, there was no significant difference between SME group and RME group in all measurements. This study suggested the efficacy of SME in growing patients. SME was effective in increasing not only dentoalveolar and skeletal measurements but also airway volume. Therefore, pediatric dentists should select an appropriate expansion method considering the physiological aspects of periodontal tissues and discomfort in growing children.