• 전기의세계
• /
• v.31 no.3
• /
• pp.168-171
• /
• 1982

본고에서는 전력송배전계통에 사용되고 있는 변압기와 피뢰기용소재로서, 무부하운전시 또는 부하동작시에 발생되는 불가피한 소비전력을 절감시키기 위한 새로운 전기재료의 기술개발 내용을 소개하고자 한다.

• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1753-1755
• /
• 2001

최근 전력설비의 절연을 위해 고분자 재질의 절연물이 광범위하게 사용되고 있다. 이러한 고분자 재료는 현재까지 주로 사용되어 온 세라믹 재질과는 달리 환경에 의한 열화를 동반하게 된다. 최근에 현장에 적용되기 시작한 고분자 재질의 절연물에 대한 장기 열화특성을 평가하기 위한 연구들이 다수 진행되고 있는 것도 이러한 이유 때문이다. 피뢰기의 경우에도 기존의 세라믹 애관을 고분자 재질의 애관으로 대체하기 시작하여 일부 제품들이 현장에서 우수한 특성을 보이는 것으로 보고되고 있으나 장기신뢰성에 대해서는 명확하지 않은 상태이다. 본 논문에서는 국내에서 제작되어 현장사용중인 폴리머 피뢰기를 발취하여 사용기간중 성능상의 변화를 분석하고 가속열화시험을 통해 성능의 변화를 관찰하고자 하였다.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.10
• /
• pp.59-65
• /
• 2007

Recently, ubiquitous sensor network(USN) techniques have been applied to electric power facility management. This paper dealt with the designed and fabricated ubiquitous sensors which monitor transformers and lightning arresters installed in overhead distribution systems. The sensors consist of a 8-[bit] microprocessor unit, a wireless communication nodule specified in IEEE 802.15.4, and associated electronics. A Rogowski coil was fabricated to measure load of transformer and surge current without saturation having good linearity up to 1000[A]. A zero-phase current transformer with a high relative permeability of $10^5$ at 180[Hz] was used to detect small leakage current of $50[{\mu}A]{\sim}1[mA]$ flowing lightning arrester, and the frequency bandwidth of the module is ranges from 12[Hz] to 1.24[kHz] at -3[dB].

• Electric Engineers Magazine
• /
• v.242 no.10
• /
• pp.11-14
• /
• 2002

철탑, 건물 또는 피뢰침에 낙뢰가 들어오게 되면 그 접지극 부근의 대지전위가 상승하고 다른 접지극에서 기기로 뇌 써지가 역류하기도 하고 피뢰기와 보호소자를 역섬락시켜 배전선측, 통신선측으로 뇌 써지가 흐른다. 한편 철탑이 건물의 옥상에 있는 경우는 피뢰침이 건물의 철골, 철근과 연결되어 있으므로 뇌써지는 건물에도 흐르고 그것도 접속되어 있는 기기의 지지물을 통하여 다른 접지계통에 유입된다.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.4
• /
• pp.94-99
• /
• 2003

A strong need to improve the quality of electric power is increased because of increasing use of the sensitive and small-sized electronic devices. The transient overvoltages on low-voltage AC power distribution systems are induced by direct or indirect lightning return strokes, and they can cause damage and/or malfunction of the utility systems for home automation, office automation and factory automation as well as medical equipment. The behaviors of lightning overvoltages transferred through the transformer to the low voltage AC power distribution systems were experimentally investigated using a Marx generator. The surge voltages in low-voltage ac power systems are rarely limited by the application of the surge arrester to the primary side of distribution transformer and a custom service ground.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.11a
• /
• pp.212-216
• /
• 2000

ZnO varistors for distribution surge arrester (18kV, 5kA) were developed and tested microstructure and electrical characteristics. Microstructure of ZnO varistor was consisted of ZnO grain, spinel phase and Bi-rich phase. Average grain size of ZnO varistor was $\mu\textrm{m}$ Reference voltage and lightning impulse residual voltage of ZnO varistor exhibited a good haracteristics above 5.5kV and below 11.56kV, respectively. Consequently, discharge capacity which is the most important characteristics of ZnO varistor for surge arrester exhibited excellent properties above 70kA at twice high-current impulse test. Moreover, variation rate of reference voltage and lightning impulse residual voltage showed below 5% and 2% after high-current impulse test, respectively. Leakage current and watt loss of ZnO varistor will not increase during accelerated aging test at stress condition, such as 3.213kV/$115^{\circ}C$/1000h.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.515-517
• /
• 2004

현재 배전선로는 4가지 접지종별을 준용하여 피뢰기, 가공지선, 변압기, 기기류, 중성선 둥을 접지시공하고 있다. 또한 규정된 접지저항값에 따라 접지전극을 시공하고 2년에 1회 주기적으로 접지저항값을 측정하고 관리하고 있다. 현재 접지저항값의 측정에는 휴대가 간편하고 측정이 용이한 HOOK-ON 접지저항계가 주로 이용되고 있다. 그러나 HOOK-ON 접지저항계는 $\pm$5[\%]$정도의 측정오차 뿐만 아니라 측정선 전류가 1[A]를 초과하는 경우 변류용 철심이 포화되어 측정이 어렵다는 단점을 가지고 있다. 따라서 본 논문에서는 HOOK-ON 측정기법의 단점을 보완하여 다중접지 배전계통에서 부하 불평형 및 고조파 둥에 의해 발생하는 접지선 누설전류를 전류원으로 이용하는 접지전극의 접지저항을 측정하는 새로운 측정기법을 제안하였다. 또한 이를 실제 배전계통에 적용하여 전위강하법을 이용하여 측정한 접지저항값과 비교하였다.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.5
• /
• pp.132-139
• /
• 2004

Unsymmetrical faults are classified into single line-to-ground faults, line-to-line faults, or double line-to-ground faults in receiving and distribution power systems. Many of overhead distribution-line faults are single line-to-ground faults, and lightning surge arresters are stressed by system frequency overvoltages due to unsymmetrical faults. In this work, the unsymmetrical faults in receiving and distribution systems were experimentally simulated, and the characteristics of total leakage current flowing through lightning surge arresters due to various unsymmetrical faults were investigated. As a result, a little variations of the leakage current flowing through Zinc oxide (ZnO) surge arresters in the range of $\pm$10[%] voltage regulations were observed. It could be concluded that the unsymmetrical faults have no effect on the long-term life performance of ZnO surge arresters in effective grounding systems. On the other hand, the magnitude of the leakage current flowing through ZnO surge arrester elements under single line-to-ground faults was more than 140 times as compared with that under normal operating voltages in ineffective grounding systems. But abnormal voltages caused by line-to-line faults and double line-to-ground faults have a little effect on total leakage current of ZnO surge arrester elements.

• Proceedings of the KIEE Conference
• /
• 1992.07a
• /
• pp.176-179
• /
• 1992

This paper presents results of typical sutdy on lightning overvoltages of underground distribution systems and discusses effective insulation coordination schemes. Typical lightning current and system parameters are used to analyze lightning overvoltage distribution on underground distribution systems by EMTP (Electro-Magnetic Transients Program).

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1676-1678
• /
• 1996

This paper introduced and study : new material electrode structures(cap type sealing structure, knuckle type electrode, stress relief housing electrode), and insulating housing which supporting shed and containg MOV(ZnO) and sub parts, of polymer arrester.