• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.11
• /
• pp.20-24
• /
• 1990

A fast convergent solution to the scattering problem of a transverse electric (TE) plan wave by a periodic strip grating with a dielectric slab is considered. The present method follows from an expansion of the equivalent surface magnetic current placed over the shorted slot according to the equivalence principle in a series of Chebyshev polynomials satisfying the appropriate edge condition. To examine the accuracy and convergence of the present method, the numerical results are calculated for the reflection and transmission coefficients and compared with other results available in the literature.

• Journal of the Korean Geophysical Society
• /
• v.9 no.4
• /
• pp.417-426
• /
• 2006

Geophysical survey has been conducted on the continental margin off the South Shetland Islands aboard R/V Onnuri of KORDI in 1992/1993. About 800-line km of 96-channel reflection data have been acquired. On the seismic section, BSR with strong reflectivity and negative polarity has been found at 700 ms below the sea bottom. BSR is considered as the base of gas hydrates and AVO analysis was performed to study physical properties along BSR. True amplitude recovery and surface consistence amplitude were applied to seismic data and angle gathers were obtained. AVO gradient and AVO intercept are calculated on every CDP gather. Section of AVO intercept show strong reflectivity and negative polarity on BSRs and stronger continuity of BSR than stacked section. Cross plot of P-G indicates that the lower layer below BSR is filled with free gas.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.2
• /
• pp.187-195
• /
• 1999

A series feedback DRO operating at 3.2 GHz applicable to the spectrum analyzer as the second local oscillator, is designed and fabricated. We can obtain a low noise by utilizing the small signal S-parameter of the transistor and adjusting the reflection coefficient from the coupling coefficient between dielectric resonator and microstrip line. The results show that output power is 10.50 dBm, a stable low phase noise is -116 dBc/Hz at a 10 kHz offset frequency and a harmonic characteristic is 19.33 dBc.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.30 no.4
• /
• pp.180-190
• /
• 2018

The preliminary study was carried out to utilize the rolling porous pendulum plate as a hybrid system combining blocking and extracting of wave energy. The Galerkin method suggested by Porter and Evans (1995) was used to solve the diffraction and radiation problems to obtain reflection and transmission coefficient, roll displacement, extracted power. The Galerkin method provides better convergence than the matched eigenfunction expansion method (MEEM), which improves the accuracy of the analytical solution even if the CPU time is shorter. The porous plate can not be said to be more effective than the impermeable plate in terms of wave energy extraction and wave blocking, but it has the advantage of reducing the wave load and exchanging seawater.

• The Journal of Engineering Geology
• /
• v.23 no.4
• /
• pp.457-465
• /
• 2013

We integrated and correlated datasets from surface and subsurface geophysics, drilling cores, and engineering geology to identify geological interfaces and characterize the joints and fracture zones within the rock mass. The regional geometry of a geologically weak zone was investigated via a fence projection of electrical resistivity data and a borehole image-processing system. Subsurface discontinuities and intensive fracture zones within the rock mass are delineated by cross-hole seismic tomography and analyses of dip directions in rose diagrams. The dynamic elastic modulus is studied in terms of the P-wave velocity and Poisson's ratio. Subsurface discontinuities, which are conventionally identified using the N value and from core samples, can now be identified from anomalous reflection coefficients (i.e., acoustic impedance contrast) calculated using a pair of well logs, comprising seismic velocity from suspension-PS logging and density from logging. Intensive fracture zones identified in the synthetic seismogram are matched to core loss zones in the drilling core data and to a high concentration of joints in the borehole imaging system. The upper boundaries of fracture zones are correlated to strongly negative amplitude in the synthetic trace, which is constructed by convolution of the optimal Ricker wavelet with a reflection coefficient. The standard deviations of dynamic elastic moduli are higher for fracture zones than for acompact rock mass, due to the wide range of velocities resulting from the large numbers of joints and fractures within the zone.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.1
• /
• pp.19-25
• /
• 2015

In this paper, a design method for a CPW-fed slot antenna for harmonic suppression is studied. The structure of the proposed slot antenna is a rectangular slot antenna appended with stepped impedance resonators (SIRs) at both ends of the slot symmetrically. Optimal design parameters are obtained by analyzing the effects of the length and width of the SIRs on the input reflection coefficient. The optimized harmonic-suppressed slot antenna operating at 2.45 GHz WLAN band is fabricated on an FR4 substrate with a dimension of 42 mm by 30 mm. The slot length of the proposed harmonic-suppressed slot antenna is reduced to 33.3% compared to that of a conventional rectangular slot antenna owing to the appended SIRs. Experiment results show that the antenna has a desired impedance characteristic with a frequency band of 2.39-2.49 GHz for a VSWR < 2, and a measured gain of 2.5 dBi at 2.45 GHz.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.6 no.4
• /
• pp.439-451
• /
• 1994

A numerical model for harbour oscillation is presented by use of Galerkin finite element method. The governing equation is used by the modified mild slope equation derived from Chen (1986) in which bottom friction is incorporated. Since the existing absorbing boundary condition. however. is shown to be incorrect correct boundary condition and forcing term due to an incident plane wave are rederived. Computation results for a rectangular harbour are shown in comparison with both laboratory data and existing numerical results. After the values of friction factor (f) and reflection coefficient (K$_{r}$) are discussed, the set (K$_{r}$=0, 94, f=0) is found to be best fitted to the laboratory data of the rectangular harbour.

• Geophysics and Geophysical Exploration
• /
• v.5 no.3
• /
• pp.169-177
• /
• 2002

We develop the weighted-averaging finite-element method which uses four kinds of element sets. By constructing global stiffness and mass matrices for four kinds of element sets and then averaging them with weighting coefficients, we obtain a new global stiffness and mass matrix. With the optimal weighting coefficients minimizing grid dispersion and grid anisotropy, we can reduce the number of grid points required per wavelength to 4 for a $1\%$ upper limit of error. We confirm the accuracy of our weighted-averaging finite-element method through accuracy analyses for a homogeneous and a horizontal-layer model. By synthetic data example, we reconfirm that our method is more efficient for simulating a geological model than previous finite-element methods.

• Geophysics and Geophysical Exploration
• /
• v.11 no.2
• /
• pp.148-152
• /
• 2008

Multichannel seismic profiles reveal a strong bottom simulating reflector (BSR) occurring below the seafloor in the plain of the Ulleung Basin, East Sea (Japan Sea). The essential characteristics of the BSR include its cross-cutting relationship to strata, strong amplitude, and reverse polarity with respect to the seafloor reflection, representing the base of the gas hydrate stability zone (BHSZ). The BSR reflection coefficient ranging from -0.23 to -0.26 is 1.5${\sim}$1.7 times that of the seafloor reflection and interval velocities decrease to less than 700 m/s below the BSR. These features indicate the existence of free gas beneath the GHSZ. Heat flow, estimated from the BSR depth as $95{\sim}98mW/m^2$, is in good agreement with measured values. Therefore, the BSR can be efficiently used to estimate regional distribution of heat flow in the Ulleung Basin.

• Journal of Advanced Navigation Technology
• /
• v.11 no.1
• /
• pp.43-49
• /
• 2007

In this paper, the performance of OFDM/64QAM systems under Rummler model based cable channel is evaluated through computer simulation, and then the degree of performance improvement is estimated when adopting adaptive LMS equalizer. From the performance evaluation results, in the Rummler two-ray channel model, it is known that the performance improvement degree by adopting equalizer is greatly increased in case of attenuation coefficient of reflected ray (b) being less than 0.15, but when attenuation coeffcient (b) is larger than 0.15, the performance improvement degree by adopting equalizer shows little changes in almost all range of Eb/No.