• Applied Chemistry for Engineering
• /
• v.22 no.4
• /
• pp.395-399
• /
• 2011

Material of the gasket for lithium ion battery requires the chemical resistance, the electrical insulting property, the compression set, the anti-contamination level and the low temperature resistance. We compounded ethylene propylene diene monomer (EPDM), which showed widely different solubility parameter index, with adjusting the amount of metal oxide as an activator. We did long-term test and compression set against an electrolyte with consideration for operating conditions in lithium-ion battery. In these tests, we checked the physical, chemical characteristics and the effect to lithium ion battery with different kinds of activators. In case of rubber with ZnO as an activator, through 1000 h depositing test in propylene carbonate which is one of representative solvents, we could get the satisfying characteristics and result. However, $Zn^{2+}$ had eluted in the ion elution test. So, ZnO should be limited in EPDM compound for the gasket material in lithium-ion battery.

• Korean Journal of Plant Resources
• /
• v.34 no.1
• /
• pp.103-113
• /
• 2021

This study was investigated to find out the distribution of flora and remarkable plants and factors and management measures for influx of wild disturbed plants in the Damyang area of Mudeungsan National Park. The field survey was carried out 8 times from May 2019 to October 2020. First of all, in the Damyang area of Mudeungsan National Park, a total of 603 taxa in 107 families, 349 genera, 531 species, 57 varieties, 5 subspecies and 10 forms. This result was found to be about 12.33% of the total 4,881 taxa of vascular plants in Korea. In addition, Rare plants were classified as 15 taxa. Floristic special and Korean endemic plants were identified as 85 taxa and 13 taxa, respectively. Lastly, the naturalized plants that appeared in the Damyang area of Mudeungsan National Park were observed in 45 taxa with 45 species of 16 families and 36 genera. Moreover the naturalization rate was 7.46% and the urbanization index was calculated to be 14.01%. The wild disturbed plants were found in a total of 4 taxa. Especially, a sheep sorrel(Rumex acetosella) was focused on managing for physica and biological control at Sinseondae Eoksaepyungjeon.

• The Journal of Engineering Geology
• /
• v.31 no.2
• /
• pp.187-197
• /
• 2021

Clay mineral content of weathered zone is a key parameter for landslide studies. Electrical resistivity tomography is usually performed to delineate the geometry of complex landslides and to identify the sliding surface. In clay-bearing weathered zone, parallel resistivity Archie equation is employed to investigate the effect of conductivity added (resistivity reduced) by clay minerals of kaolinite and montmorillonite, which is dependent on their specific surface area and cation exchange capacities (CEC). A decrease of overall resistivity and apparent formation factor is observed with increasing pore-water resistivity, significantly in montmorillonite. Formation factor is found decreased with increasing porosity and decreasing cementation factor. Parallel Archie equation was applied to the electrical resistivity data from the test area (Sinjindo-ri, Taean-gun, Chungcheongnam-do, Korea) which experienced land creeping in the year of 2014. A panel test with varying clay-mineral contents provides the best fit section when the theoretical section constructed with the assumed contents approaches the field section, from which the clay-mineral content of the weathered zone is estimated to be approximately 10%. Resistivity interpretation schemes including the clay mineral contents for land creeping studies explored in this paper can be challenged more when porosity, saturation, and pore-water resistivity are provided and they are included in the numerical resistivity modeling.

• Korean Journal of Plant Resources
• /
• v.35 no.5
• /
• pp.686-695
• /
• 2022

The grain yield and flour quality of winter wheat (Triticum aestivum L. 'Jokyung') were investigated in the paddy fields in which the double-cropping of wheat linked to rice (Oryza sativa L.) and its alternative crops [black soybean (Glycine max (L.) Merr.), sesame (Sesamum indicum L.), and perilla (Perilla frutescens (L.) Britton)] was applied. In the soils in which black soybean, sesame, and perilla as pre-crops were cultivated, the soil pH was higher and the electrical conductivity was lower than in the rice pre-cropped soil. In addition, the available phosphate (Av. P₂O₅), and contents of Ca²⁺ and Mg²⁺ were higher than in the rice pre-cropped soil. Winter wheat growth characteristics such as culm length, spike length, number of spikes and grains were generally favorable in the black soybean pre-cropped soil. However, the grain yield of winter wheat increased in the black soybean, sesame, and perilla pre-cropped soils by 100 kg/10a or more than in the rice pre-cropped soil. Furthermore, protein content and SDS-sedimentation value of the flour were higher, while amylose content was slightly lower, in the black soybean, sesame, and perilla pre-cropped soils than in rice pre-cropped soil. These results suggest that cultivation of rice alternative crops such as sesame, black soybean, and perilla as pre-crops in paddy soil could improve the physical and chemical properties of the soil and contribute to producing high-quality wheat flour more advantageous for the baking process.

• The Journal of Engineering Geology
• /
• v.31 no.4
• /
• pp.507-522
• /
• 2021

Specific survey objectives often cannot be met using only one geophysical method, as each method's results are influenced by the specific physical properties of subsurface materials. In particular, areas susceptible to geological hazards require investigation using more than one method in order to reduce risks to life and property. Instead of analyzing the results from each method separately, this work develops a four-quadrant criterion for classifying areas of levees as safe or weak. The assessment is based on statistically determined thresholds of seismic velocity (P-wave velocity from seismic refraction and S-wave velocity from multichannel analysis of surface waves) and electrical resistivity. Thresholds are determined by subtracting the standard deviation from the mean during performance testing of this correlation technique applied to model data of four horizontal and inclined fracture zones. Compared with results from the crossplot of resistivity and P-wave velocity, crossplot analysis using resistivity and S-wave velocity data provides more reliable information on the soil type, ground stiffness, and lithological characteristics of the levee system. A loose and sandy zone (represented by low S-wave velocity and high resistivity) falling within the second quadrant is interpreted to be a weak zone. This interpretation is well supported by the N values from standard penetrating test for the central core.

• Journal of Korean Library and Information Science Society
• /
• v.54 no.1
• /
• pp.191-220
• /
• 2023

This research attempts to identify how members of an online community collaboratively engaged with particular social information behaviors and accomplished a defined collective action. While responding to the Sewol Ferry tragedy, MissyUSA members quickly communicated and mobilized a collective action, a full-page ad campaign in The New York Times. As a follow up study, this secondary analysis quantitatively analyzes the primary data from a previous study to explore potential relationships or underlying factors among the various identified information behaviors. In this study, nineteen of the previously identified information behaviors were analyzed using exploratory factor analysis, yielding a total of eight factors. The two major factors of shared representation/collective identification and mobilizing resources verified the findings of the previous study and are in line with the findings typical of political science. The three factors of collaborative decision-making, reaction to tension, and brainstorming were factors that maximized communication and mobilization online, without any face-to-face communication or physical organization. Three emergent factors of outburst of dissent, boycott, and planning explained how members used negative emotions of anger, referential information for boycott, and incubated next collective actions. Through exploratory factor analysis, this study verifies and expands on the findings of the previous study by identifying several emergent factors that relate to the collaborative information behaviors of an online community engaged in a collective action.

• Journal of the Korean Magnetics Society
• /
• v.4 no.1
• /
• pp.12-19
• /
• 1994

The crystallization behavior of the amorphous $Fe_{73.5}Cu_{1}Nb_{3}Si_{16.5}B_{6}$ alloy with isothermal annealing at $552^{\circ}C$ was studied by $M\"{o}ssbauer$ spectroscopy. The amorphous phase was revealed to coexist together with $Do_{3}-FeSi$ nanocrystalline and Cu-duster in annealed alloys by $M\"{o}ssbauer$ spectrum analysis. At the early stage of crystallization, Si content of FeSi is high due to the creation of Cu-cluster, and decreases with annealing until 60 minutes, which results in the increase in the mean hyperfine field of FeSi, and thereafter keeps constant. After 60 minutes, the decrease in the mean hyperfine field of the residual armrphous, in spite of a slight change in the volume fraction of the FeSi and the residual armrphous, is caused by the increase in the content of Nb and B in residual amorphous phase. Both directions of the hyperfine field, those of the FeSi and the residual amorphous, become randomly oriented in about 60 minutes. For FeSi and Cu-duster, the Avrami exponents are 0.51 and O.65, the activation energies are 2.35 eV and 2.44 eV, and the incubation times are 2.4 minutes and 0.8 minutes respectively. Earlier formation of Cu-duster than that of FeSi is coincidence with the fact that Cu atom promotes the nucleation of the FeSi.

• Clean Technology
• /
• v.16 no.3
• /
• pp.172-181
• /
• 2010

Hydrofluoroethers (HFEs) with fluoride molecules in their structure which are evaluated as the third generation replacement alternatives to chlorofluorocarbons (CFCs) are known to be excellent for removal of nanoparticles and fluoride-type soils due to their low surface tension and high wetting index. In addition, HFEs have good physical properties with no flash point and excellent drying characteristics. But, HFEs also have shortcomings in that they are not effective for removal of organic soils due to their poor solubility in soil. In this study, $C_5$ HFE-based cleaning agents were formulated through addition of solvents such as isopropyl alcohol (IPA), ethyleneglycol monoether (EG), propyleneglycol monoethylether (PM) to HFE-7100 [$CF_3CF_2CF_2CF_2OCH_3$] or HFE-mec-f [$CF_3CHF=CF_2OCH_2CF_3$] with its maximum amount, respectively, in order to have no flash point for the safety in the working environment. These solvents are known to be excellent for dissolving organics in soil. Their physical properties and cleaning abilities for fluxes, water-insoluble cutting oils, and fluoride-type oils were evaluated and compared with those of other cleaning agents with single components. The experimental results show that the HFE-based formulated cleaning agents have various good physical properties which are almost similar to those of a single type of HFE cleaner. They show excellent cleaning ability for fluxes, water-insoluble cutting oils, and fluoride-type oils. These results indicate that the HFE-based formulated cleaning agents can be applicable to various industrial cleaning fields because of their good physical properties and cleaning abilities for various soils.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.4
• /
• pp.5-13
• /
• 2007

Many construction projects adopt grouting technology to prevent the leakage of groundwater or to improve the shear strength of the ground. Recognition as a feasible field procedure dates back to 1925. Since then, developments and field use have increased rapidly. According to improvement of grout materials, theoretical study on grout penetration characteristics is demanded. Fluid of grout always tends to flow from higher hydraulic potential to lower one and the motion of grout is also a function of formation permeability. Viscosity of pout is changed by chemical action while grout moves through pores. Due to the increment of viscosity, permeability is decreased. Permeability is also reduced by grout particle deposits to the soil aggregates. In this paper, characteristics of new cement grout material that has been developed recently are studied: injectable volume of new grout material is tested in two different grain sizes of sands; and the method to calculate injectable volume of grout Is suggested with consideration of change in viscosity and clogging phenomena. The calculated values are compared with injection test results. Viscosity of new grout material is found to increase as an exponential function of time. And lumped parameter $\delta$ of new grout material to be used for assessing deposition characteristics is estimated by comparing deposit theory with injection test results considering different soil types and different injection pressures. Injection test results show that grout penetration rate is decreased by the increase of grout viscosity and clogging phenomena.

• The Journal of Engineering Geology
• /
• v.32 no.1
• /
• pp.157-171
• /
• 2022

Electrical resistivity tomography (ERT) is a traditional and representative geophysical method for determining the resistivity distributions of surrounding soil and rock volumes. Depth resolution profiles and sensitivity distribution sections of the resistivities with respect to various electrode configurations are calculated and investigated using numerical model data. Shallow vertical resolution decreases in the order of Wenner, Schlumberger, and dipole-dipole arrays. A high investigable depth in homogeneous medium is calculated to be 0.11-0.19 times the active electrode spacing, but is counterbalanced by a low vertical resolution. For the application of ERT depth resolution profiles and sensitivity distributions, we provide subsurface structure models for two types of land-creping failure (planar and curved), subvertical fracture, and weathered layer over felsic and mafic igneous rocks. The dipole-dipole configuration appears to be most effective for mapping land-creeping failure planes (especially for curved planes), whereas the Wenner array gives the best resolution of soil horizons and shallow structures in the weathered zone.