• Journal of Energy Engineering
• /
• v.4 no.2
• /
• pp.288-296
• /
• 1995

촉매변환기용 모노리스에서의 속도변화에 따른 압력강하를 알아보기 위하여 풍동을 제작하여 실험하였다. 200 cpsi, 300 cpsi와 400 cpsi의 모노리스 담체에 대한 압력강하를 측정하였고, 듀얼베드 형태에서의 압력강하를 알아보기 위하여 200 cpsi, 300 cpsi와 400 cpsi들 중 두 개씩 조합하여 두 모노리스 담체의 사이 간격을 변화시켜가면서 압력강하를 측정하였다. 또한 많이 사용되고 있는 촉매가 담지된 400cpsi의 모노리스를 이용하여 촉매 담지에 대한 유동의 영향을 살표보았다. 모노리스 상·하류간의 압력강하는 공극율에 상관없이 공기와 유로벽과의 접촉면적에 따라 증가한다. 실험 결과로부터 제안된 상관관계를 상용하여 모노리스 형상에 따른 압력강하를 근사적으로 예측 할 수 있다. 듀얼베드 형태에서의 압력강하는 상류부와 하류부의 개별적인 모노리스의 압력강하와 두 모노리스 사이에서의 압력강하의 합으로 볼 수 있는데, 두 모노리스 사이에서의 압력강하는 무시할 만 하였다. 따라서 듀얼베드 형태의 전체적인 압력강하는 상류부와 하류부의 개별적인 모노리스에서 생기는 압력강하만의 합으로 구할 수 있다. 촉매가 담지되지 않은 모노리스의 측정결과로부터 제안된 상관관계를 촉매가 담지된 모노리스의 압력강하를 예측하는데 사용하기 위해서는 모노리스 길이를 원래길이의 1.25배로 수정하여 사용하여야 한다.

• Journal of radiological science and technology
• /
• v.26 no.2
• /
• pp.49-56
• /
• 2003

The purposes of this study are to improve the ultrasound resolution of various nylon and metallic mono-filament wires, therefore, it was tested that it analyze on nylon mono-filament wire of 0.1 mm in A Co.'s ultrasonic phantom and synthesis of C15 g tissue mimicking materials(TMM), analyze resolution of nylon and metallic mono-filament wires in water and TMM. The results obtained were summarized as follows: 1. Metallic mono-filament wire of 0.1 mm and nylon mono-filament wire of 0.12 mm, 180 denier showed that it cleared dot echo pattern. 2. Metallic and nylon mono-filament wire of 0.2 mm showed that it cleared comet tail echo by reverberation artifact. 3. Nylon and metallic mono-filament wire of 0.1 mm showed that it can used for dead zone and axial resolution test. 4. Nylon mono-filament wire compared with metallic mono-filament wire showed that it satisfy elasticity and construction. 5. Degree of hardness of na not changed mono-filament's echo textures.

• Journal of Korean Ophthalmic Optics Society
• /
• v.20 no.2
• /
• pp.117-124
• /
• 2015

Purpose: The purpose of this study was to compare the accommodative function of young adult in their 20s wearing monovision, modified monovision, and aspheric multifocal contact lenses at near task. Methods: Thirty young adults ($23.53{\pm}2.37years$) were fitted with monovision, modified monovision (the application of single vision contact lenses and center-near low addition aspheric multifocal contact lenses), and aspheric center-near multifocal contact lenses. After wearing these modalities during a week for adaption, and after watching visual display at computer for inducing accommodative pressure for 1 hour. The following assessments of accommodative function were made: contrast visual acuity (VA) at distance and near; accommodative response; near accommodative facility; and negative relative accommodation (NRA)/positive relative accommodation (PRA). All measurements were carried out binocularly. Results: In binocular distance VA with contrast of 10%, monovision was the worst among the four modalities (p=0.005). In accommodative response at 1 m (1.00 D), monovision was the lowest (p<0.05) and accommodative response at 40 cm (2.50 D) with monovision was lower than that of modified monovision and multifocal contact lens (p<0.05). We also found that there were no significant differences in accommodative facility and NRA/PRA among the four modalities. Conclusions: In young adult (20s), monovision with low add reduced the accommodative response at near task, however, modified monovision and multifocal lens with center-near type did not affect accommodative relaxation.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.8 s.338
• /
• pp.47-54
• /
• 2005

The design method for a dual frequency antenna using CPW feed lines is presented. The antenna structures can be simplified by CPW feed lines and easily designed on integrated circuits. The presented antenna has two resonant frequency ranges and each respective resonant frequency is determined by its own length of monopole antenna. We used an impedance matching method by using a monopole coupling related to the ground of CPW feed lines As a result, the resonant frequencies were 5.25[GHz] and 23.5[GHz] and their bandwidths $35.2\%,\;and\;41.3\%$, respectively, and also, the separation of the two frequencies $370\;%$. We presented an analytical designing method to implement a dual frequency monopole antenna and showed simple antenna structures having two frequency ranges for RFIC Integrations.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.3-9
• /
• 2015

In this paper, we propose the operation procedures of the 1-channel monopulse receiver which achieves the new configuration. Also, we analyzed the monopulse ratio and the target angle accuracy of the fabricated receiver by using the monopulse signal generator developed for verifying the proposal equipment. As a result, it is apparent that the monopulse ratio of the proposal receiver is equal to that of the 3-channel monopulse receiver. Also, the fabricated receiver exhibits the target angle accuracy with fewer than 0.1 RMS. The proposal receiver achieves the simple receiver configuration and the simple tracking procedures, as contrasted with the 3-channel monopulse receiver. Also, the proposal receiver has advantages in terms of size, weight, cost and power. Because the proposal monopulse receiver requires 1-channel receiver and needs not the signal processor in comparison with 3-channel monopulse receiver which requires 3-channel receiver and need the signal processor.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.4
• /
• pp.797-804
• /
• 2014

The experimental design method based-on the measured data in the several LF monopole antenna was used in MF monopole antenna design. The design technique is also utilized in MF DGPS antenna design. It is not possible to predict the antenna performance of the MF short-monopole antenna because of simple experimental antenna design. Furthermore, it is difficult to design and analyze the various wired short-monopole antenna. The antenna models for performance analysis of the DGPS antenna with the various wired short-monopole structure are proposed in this paper. Based on the proposed antenna models, also, the antenna performance and design data of the wired short-monopole antennas are presented. To evaluate the validity of the analyzed antenna models, the wired short-monopole antenna for 100 kHz are modeled and analyzed. The antenna performance of the wired short-monopole antenna are compared with those of the previously presented LF antenna performance. Based on the evaluation for proposed antenna analyzing models, the DGPS wired short-monopole antennas are modeled and analyzed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.10
• /
• pp.6839-6845
• /
• 2015

The optimization design method for the broadband operation of the sleeve monopole was proposed to unify the multiple antennas essential to the multi-functional broadband wireless communication systems into one antenna. The structure of the sleeve part was optimized to enhance the impedance matching characteristics based on the theoretical analysis that sleeve part can works as the open stub. The thick monopole was used for the broadband operation. The radius of the sleeve and the permittivity of the dielectric inside the sleeve was optimized to enhance the impedance matching characteristics for the broadband operation. The optimized sleeve monopole having thick monopole shows broadband characteristics over 3:1 bandwidth, from 0.8 to 2.43 GHz, which is suitable for the commercial wireless communication system. The proposed broadband sleeve monopole can reduce multiple antennas essential to the multi-functional broadband systems to one antenna.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.4
• /
• pp.705-712
• /
• 2018

The radiation characteristics of a phased array antenna is changed according to the beam steering angle. The monopulse tracking system calculates the prediction angle using the radiation characteristics of antenna. Therefore, the monopulse ratio curve is changed according to the beam steering angle for the monopulse tracking system using a phase array antenna, and the tracking accuracy goes down. In the case of a single-channel monopulse system, the monopulse rate curve is controlled by the configuration variables of the system. In this paper, a simplified formula was presented for adaptive control of monopulse system configuration variables on beam steering angle. The presented formula can induce a uniform monopulse ratio curve for the beam steering angle as well as the phased array antenna design parameters.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.6 no.4
• /
• pp.267-271
• /
• 2013

A new structure of double-resonant cylindrical monopole is proposed for multiple band applications. Multiple band property for the proposed antenna is achieved by adjusting the coupling structure of the antenna base for a double resonance. Measured results of the proposed antenna are compared with those of wire and thick cylinder monopoles.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.584-587
• /
• 2007

PCS를 비롯하여 WLAN, DMB, W-CDMA, UWB 등의 무선통신 서비스가 증가함에 따라 안테나 동작 대역폭의 광대역화가 더욱 요구된다. 1/4 파장 선형 모노폴 안테나는 구조가 간단하고 전방향성을 갖는 복사특성으로 인하여 가장 널리 사용되는 안테나 중의 하나이다. 모노폴 안테나의 광대역화를 위해서 일반적으로 원통의 직경을 증가시키는 방법을 사용하지만, 평면 모노폴에 적용된 스텝 기법을 적용하여 광대역 특성을 얻을 수 있다. 그러나 스텝 모노폴 자체는 광대역 특성을 나타내지 않으며, 접지면에서도 일정 형태의 스텝 돌출부위가 필요하게 된다. 본 논문에서는 그라운드면의 볼록 계단 구조가 모노폴 안테나의 대역 특성에 미치는 영향을 분석하여 최적의 안테나 급전구조를 도출하고자 한다. 결과의 검증을 위해서 소프트웨어 시물레이션 및 측정결과를 제시한다.