• Journal of IKEEE
• /
• v.23 no.3
• /
• pp.1112-1115
• /
• 2019

This paper proposes a novel low-profile omni-directional microstrip antenna to mount on the deployable wing of the observation munition. The proposed antenna is designed on seven hexagonal resonators in a quasi-circular array to achieve a monopolar radiation pattern with a thin substrate. By employing the mesh ground structures, the resonant frequencies and impedance bandwidths of the proposed antenna is investigated. To verify the feasibility of the mesh ground structure, the thin ground wire width is investigated theoretically for improving the 3-dB fractional bandwidth, realized antenna gain and quality-factor. The proposed antenna demonstrates a good monopolar radiation in good agreement with the simulation results. The implemented prototype shows the measured bandwidth of 326 MHz with respect to 5.65% centered at 5.77 GHz and realized gain of 5.49 dBi at 5.84 GHz.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.18 no.6
• /
• pp.23-29
• /
• 1981

By using a slot-line in combination with microstrip lines, a coplanar wide-band balun is designed and fabricated. The slot-line of balun junction is compensated to be operated in C-band(4~8GHz), and therefore the results are agreement with theoritical prediction. Experimental data are given for a 3-section Chebyshev transformer-matched balun with a balanced-to-unbalanced line impedance ratio of 2 : 1. A bandwidth from 3.5GHz to 7.0GHz is obtained with V.S.W.R. of below 1.2 : 1. Maximum insertion loss is measured as 0.9dB, and the phase difference varies linearlly within 180$^{\circ}$$\pm$5$^{\circ}$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.3
• /
• pp.379-387
• /
• 2000

In this paper, to transmit and receive the differently polarized wideband signals simultaneously with a single antenna system, the wideband, dual-frequency and dual-polarized(WDFDP) microstrip array antenna is proposed and designed. This antenna operates simultaneously at 14.25 GHz and 12.50 GHz. To extend to two dimensional array, microstrip feed line and coaxial probe through via-hole are used. The experimental results show that the proposed WDFDP microstrip antenna can be used in the compact portable terminals with a single antenna system and the characteristic of the resonators in this antenna produces a greatly enhanced bandwidth.

• Proceedings of the KAIS Fall Conference
• /
• 2012.05b
• /
• pp.471-473
• /
• 2012

본 논문은 DMS (defected microstrip structure) 선로를 이용한 전력분배기 설계에 대하여 기술하고 있다. DMS 선로는 마이크로스트립 선로의 패턴에 변형을 가하여 설계되는데, 이 때 부가적으로 발생하는 인덕턴스와 커패시턴스 효과에 의하여 선로의 특성 임피던스가 변하고, 또한 종래 주기구조에서의 특징들을 보인다. 이를 이용하면 초고주파 전송선로 구조의 무선회로들을 소형화할 수 있는데, 그 한 예로 본 논문에서는 윌킨슨 전력분배기를 소형화하는 설계에 대하여 기술한다. DMS 구조를 삽입하여 소형화된 전력분배기를 설계한 결과, 소형화된 분배기는 표준형 회로에 비하여 약 82%의 크기를 가지면서도 우수한 성능을 갖는다.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.2
• /
• pp.70-77
• /
• 2003

In this paper, analysis and measurement on coaxial connecter designed for packaging of microwave and micro strip transition structure are carried out. Even though researches on optimization of various kinds of transition structures have been conducted actively; however, the range of the application was very limited since they have been focused mainly on improvement of specific transmission line. Therefore, in this paper, we tried to analyze three kinds of substrates of which dielectric constants are 2,5,10 and are commercially used nowadays. Besides, we have confirmed reliability of FEM analysis, extracted equivalent circuit of transition area, found out factors determining extracted physical values, and made proof of electromagnetic variations for optimum characteristics. In addition, transition structure showing optimized characteristics on the basis of dielectric and microstrip structure was proposed. We reckon that the result of this research will apply with effect to transition design in microwave packaging development.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.115-118
• /
• 2001

마이크로 스트립을 이용하여 셀룰러(824-894 MHz) 이통통신용 송수신 안테나를 설계 및 제작하였다. 이때 넓은 대역폭을 얻기 위하여 개구면 결합형(aperture-coupled) 안테나를 설계하였으며 사용된 기판은 2층의 FR-4 ($\varepsilon$$_{r}$ =4.7) 기판과 공기층을 합한 3단으로 이루어져 있다. 안테나 특성파악을 위한 스트립의 전류분포와 슬롯의 자류분포 해석은 전송선로 모델법을 적용하였고 제작된 안테나는 VSWR 1.5:1 이하의 높은 복사 특성을 얻으므로써 좁은 공간에서 편리하게 설치하여 쓸 수 있는 우수한 안테나임을 확인하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.10
• /
• pp.1409-1415
• /
• 2021

The Gysel divider has the advantage of easily setting the resistor in the circuit. If the line impedance in the Gysel divider is set differently, the input signal can be distributed to the two output ports at various distribution ratios. This paper proposes the Gysel divider that can change the power distribution to 1:3 or 3:1 by changing the line impedance. The impedance change of the line can be implemented by placing a floating copper plate on the bottom of the microstrip-line. When the floating copper plate and the ground plane are connected, the line operates as the microstrip-line, and when the floating copper plate and the ground plane are disconnected, the line operates as the coplanar-line. The proposed Gysel divider was fabricated at the center frequency of 1.5GHz. The fabricated 3:1 Gysel divider has a stable value S₁₁ of below -17dB, S₂₁/S₃₁ of 4.8±0.2dB, S₂₁(to high output port) of -1.39±0.12dB and S₃₁(to low output port) of -6.15±0.08dB over 1.3~1.7GHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.2
• /
• pp.165-172
• /
• 2019

Using two or more coaxial lines, if one port is connected in series and the other port is connected in parallel, it can be implemented the wideband transmission line transformer(TLT). Because the wideband TLT utilizes the outer conductor of the coaxial line, it is difficult to predict the characteristics. In this paper, based on the analysis for the transfer characteristic(S21) according to the loss of the each line in ${\lambda}/4$-microstrip line TLT, the operating characteristic of the fabricated wideband 4:1 TLT using two $25{\Omega}$-coaxial lines is investigated. The fabricated wideband TLT shows the notch characteristic in which the transfer signal sharply decreases at ${\lambda}/4$ frequency of the coaxial line and has a value within -0.2dB of the transfer characteristic(S21) in $0.06{\sim}0.2{\lambda}$ frequency range of the coaxial line. This transfer characteristics(S21) can change the operating frequency range slightly and set the optimum transfer characteristic(S21) at the desired frequency by changing the length of the microstrip line.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.4
• /
• pp.418-426
• /
• 2008

In this paper, investigations on the impedance characteristics of a DGS(Defected Ground Structure) slot in the groud plane of microstripline are presented in spectral domain and applied to the characteristic improvement of stepped impedance microstrip low pass filter(LPF). In this method, expressions for the impedance of a DGS slot are derived from self-reaction of the angular spectrum of plane waves and the discontinuity in the modal voltage. The numerical results are compared with those of the rigorous full-wave method and are shown to produce reasonably accurate data. And the stepped impedance microstrip low pass filter is designed and fabricated with the uniform and nonuniform DGS slots for improving the frequency responses. The experiments show that the proposed filter with slots in the ground plane has a wider stopband and sharper cutoff response.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.9
• /
• pp.1005-1014
• /
• 2007

In this paper, The four types SRA(Sequential Rotated Array) antennas has been analyzed. Those are consisted of a 4-elements SRA, a 8-elements SRA, the $2{\times}2$ planer array SRA and the triple (4+8+4)-elements SRA. These LHCP SRA antennas are used a probe feeding multi-layer truncated microstrip antenna whose center frequency is 11.85 CHz. The cooperated feeding circuits are designed for feeding to each elements with equal amplitude and regular phase. Comparing with the each simulation results and experiment results of this 4-type SRA antennas, the triple (4+8+4)-elements SRA showed the most electrical characteristics in the degree of integration, high gain and low cross polarization.