• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2006.07a
• /
• pp.749-749
• /
• 2006

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.5
• /
• pp.463-470
• /
• 2015

In this paper, a new dual-band bandpass filter(BPF) that has resonators and feed lines with Stepped-Impedance Resonator(SIR) structures is proposed. Feed lines with SIR structure provide maximum magnetic field points which occur at the same locations of the input and output feed lines, so the insertion loss of BPF was reduced. Applying the SIR structure to the BPF for the first passband improves rejection characteristics between the first passband and the second passband. It reduces the coupling between the BPF for the first passband and the BPF for the second passband, so it makes the dual-band BPF more compact. The proposed design method provides independent changes of both the center frequency and the bandwidth for each resonator, and also improves filtering characteristics. The validity of the proposed design method is confirmed by comparisons between the designed parameters and the measured results satisfying WLAN specifications.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.1-9
• /
• 2014

In this paper, a reconfigurable polarization patch antenna that uses a Y-shaped feed is proposed. The proposed antenna consists of a square patch, a Y-shaped feeding structure, a PIN diode, and a bias circuit for diode operation. The structural symmetry/asymmetry of the feeding structure is determined by the on/off operation of the PIN diode that inserted into the side of one of the lines of the Y-shaped feeding structure. For the proposed reconfigurable antenna, the two microstrip lines of the feeding structure have the same length when the PIN diode operates in the on state, and the antenna exhibits linear polarization(LP). On the other hand, when the PIN diode operates in the off state, the length of one side line of the feeding structure is relatively shorter than that of the other line. Therefore, the antenna exhibits circular polarization(CP). From the measurement results, it is found that the proposed antenna exhibits good impedance matching and axial ratio. In addition, polarization switching can be easily achieved in the same operating band.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.7B
• /
• pp.1326-1332
• /
• 2000

본 연구에서는 Ka 밴드 대역의 LMDS에 사용될 수 잇는 저잡음증폭기를 MMIC로 설계하고 제작하였다. 능동소자로는 p-HEMT를 사용하였으며, 주파수가 높으므로 저주파 MMIC에서 사용되는 수동 소자인 spiral 인덕터나 MIM 커패시터를 사용하지 못하고 마이크로스트립라인을 이용하여 증폭기를 설계하였다. 증폭기 설계 시 안정도를 해결하고 잡음 지수를 낮추기 위하여 RC 궤환회로와 소스 인덕터를 사용하였으며, 제작된 증폭기는 4단 증폭기로 26.5 GHz에서 이득 27.4dB, 잡음지수 3.46 dB를 얻었다.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.11
• /
• pp.49-54
• /
• 2001

In this work, we developed a Ka-band hybrid 4-stage power amplifier module using GaAs pHEMTs and waveguide to microstrip transitions. It has high gain and high output power characteristics. We used a 10 mil- thickness duroid substrate to fabricate this power amplifier and waveguide to microstrip transitions. The fabricated waveguide to microstrip transition showed about 1 dB insertion loss(back to back) at 32 40 GHz. The measured results of power amplifier module showed over 1W output power at 36.1 - 37.1 GHz. And it showed 31 dBm output power, 24 dB power gain and 15 % power-added efficiency(PAE) at 36.5 GHz.

• Journal of IKEEE
• /
• v.18 no.4
• /
• pp.625-629
• /
• 2014

This study derives the asymptotic phase noise formula of the oscillators perturbed by the colored noises. Based on the derived formula, this study presents a sub-1V series-tuned differential Colpitts VCO. The ADS simulation result on the phase noise shows that the presented VCO exhibits about 3dBc/Hz lower phase noise at the 1MHz offset frequency from the oscillation frequency of 4.8GHz than the existing series-tuned differential Colpitts VCO with the inductor current sources.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.8
• /
• pp.878-883
• /
• 2003

New feeding structures using linearly and exponentially tapered lines to planar microstrip resonators are proposed. These can overcome the design problems from coupling losses and impedance mismatching by increasing the coupling efficiency. The variation of its feeding angle is evaluated for the insertion loss and bandwidth and the feedline length is optimized at ${\lambda}_g$/2. The ring resonators and patches fed by the tapered line have been designed and implemented. The experimental results show that the insertion loss is enhanced by about 7 dB. Both rings and antennas are better matched, without disturbing the single-mode resonance or distorting their radiation pattern

• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2002.11a
• /
• pp.159-163
• /
• 2002

So far, many kinds of researches on the chip components and MCM-C RF module especially on the 3-dimensional ceramic module using embedded passives have been performed. LTCC system has many kinds of advantages, like low loss, low cost of process, stability of process etc..The electrical behaviors of components are affected by that of the material systems including dielectrics and conductors. In this study, many kinds of conductor pastes in the variation with metal content and grain size are fabricated and their effect on the characteristics of stripline resonator are examined upto 6 ㎓.

• Proceedings of the KIEE Conference
• /
• 2001.11a
• /
• pp.35-37
• /
• 2001

다층 인쇄 회로 기판에 Combline 구조를 가진 스트립 라인 또는 마이크로 스트립 라인 대역통과 필터를 구현하였다. 저 비용 구현과 이동성과 휴대성을 강조하기 위해 기존의 세라믹 대신 FR4 와 에폭시를 기반으로 하는 다층 회로 기판의 도체 층에 집적화하였다. Combline 각 끝단에 커패시터를 부하 함으로써 전기적 길이를 화장하였고 전체적인 크기를 감소시킴으로서 적당한 필터 특성을 얻을 수 있었다. 구현된 필터는 마이크로파 대역에서 사용 가능하며 특히 Bluetooth나 Wireless LAN 과 같은 ISM 대역을 사용하는 무선통신소자로서 사용 가능하다.

• Proceedings of the Acoustical Society of Korea Conference
• /
• spring
• /
• pp.393-396
• /
• 2000

기존의 탄성표면파 듀플렉서 필터는 1/4 파장 정합선로를 이용한 격리회로를 이용하기 때문에 패키지 상에 스트립라인을 구성하는 제작상의 어려움이 있다 본 연구에서는 격리회로가 송신용, 수신용 필터와 함께 온칩상에 위치할 수 있는 새로운 형태의 탄성표면파 필터를 설계하였다. 그 과정으로 송수신 대역을 각각 담당하는 사다리형 필터를 설계하였고, 집중소자 즉, 인덕터와 캐패시터로 구성되는 탄성표면파 듀플렉서 필터의 격리회로를 구성하였으며, 우수한 성능을 가질 수 있도록 각각의 집중소자들의 값을 최적화하였다.