• Environmental and Resource Economics Review
• /
• v.21 no.2
• /
• pp.321-340
• /
• 2012

Korean government recently announced that new passenger cars sold within South Korea in 2009 ran an average of 12.27 kilometers per liter of fuel, which is an 7% point increase of the fuel efficiency. The government interpreted these improvements in the fuel economy as energy savings of 60,000 toe and as a reduction of 160,000 ton $CO_2$ emissions. However, improvements in energy efficiency make energy services cheaper, which is known as rebound effect. If this rebound effect exists, and the size of the effect is not negligible, ignoring this could result in overestimating the energy savings achieved by the fuel efficiency increase. Using detailed data on household and vehicle characteristics, our results suggest that there exist a short-run rebound effect of 0.299(29.9%) for the Korean automobile industry. This is notably smaller than the estimates of West (2004), which finds an estimate of 87% using cross-section data for the US. Furthermore our results highlight the importance of rebound effect on energy savings and the $CO_2$ emissions reduction. Our estimates suggest that the report from Korean government overestimates the energy savings and related $CO_2$ emissions by 29.9% point.

• Magazine of the Korea Concrete Institute
• /
• v.10 no.4
• /
• pp.125-133
• /
• 1998

In this study, an experiment in the field was performed to analyze the influence of steel fiber and silica fume on the rebound ratios of shotcrete. The experimental parameters which are the reinforcing methods(steel fiber, wire mesh), steel fiber contents(0.0%, 0.5%. 0.75%, 1.0%), silica fume contents(0.0%, 10.0%), and the three placing parts(side wall, shoulder, crown) were chosun. According to the results for the side wall in this test, the larger the fiber contents are in case of steel fiber reinforced shotcrete, the less the rebound ratios are within the range of 20~35%, compared to the wire mesh reinforced shotcrte. And also, the reduced rebound ratios were vary larger in using steel fiber reinforced shotcrete with silica fume content of 10%, and these results are true of the shoulder and the crown, respectively. In addition, the four-stage phenomenon for the rebound of the SFRS were estimated in the view of the co-action between steel fiber and coarse aggregate based upon the existing two-stage analysis method.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.9
• /
• pp.604-609
• /
• 2020

There are various methods of finishing concrete surfaces, and when considering workability, the spray method is effective, but rebound occurs. The allocation of rebound occurrence control should be adjusted according to the materials used. Thus, a basic study was conducted on multiple techniques for reducing the rebound incidence that are suitable for surface finishing materials containing a photocatalyst. A prior study derived the reduction effect and optimal mix ratio for photocatalytic performance. Based on that study, the rebound reduction was verified according to the specifications of the content and the mechanical durability characteristics of the mixed materials. Rebound, compressive strength, flexural rigidity, and table flow tests were done. The flow was fixed at 170±10 mm considering the workability of the mortar spray equipment. For the experimental variables, the rebound number was adjusted to the silica sand variables relative to the cement weight, and silica sands No. 5 and No. 7 were used. The results show the highest compression strength in the final S-1 variable, and the amount of rebound was minimized. These results were sufficiently filled with the bindings of the silica pores, which increased the binding force between the aggregates, resulting in a lower amount of rebound.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.6D
• /
• pp.615-622
• /
• 2012

The aim of shotcrete is to increase the bearing capacity and to protect the excavated surface from erosion by preventing falling of rock mass. Shotcreting method is divided into two types as dry process and wet process. Since 1997, wet process method has been used more frequently than dry process method in field works. The failure to bond, so called rebound, occurs in many case during shotcrete works. The excess amount of rebound has a significant effect on the total construction cost. For example, material and craft-man cost increases, the shooting time delays due to deceleration of work execution stage, work efficiency of craft-man decreases and additional cost to remove the muck generates. In this study, therefore, the experimental analysis of rebound amount and strength was conducted by analyzing the actual construction data for wet process type of shotcreting method upon accelerator contents. Also, the effective and rational method was suggested, which can be actually implemented in the Korea construction sites.

• Korean Journal of Applied Biomechanics
• /
• v.17 no.4
• /
• pp.107-113
• /
• 2007

The purpose of this study were to investigate the effects of knee brace on the knee muscular neuro-biomechanical variables during the rebound in female highschool basketball players. Twelve high school female ($17.9{\pm}0.8years$) basketball players rebound jumped for maximal vertical height to sufficiently stress the anterior cruciate ligament with and without knee brace. Kinematic data were collected to estimate the knee flexion, abduction angles and jump height. The EMG data from the biceps femoris and rectus femoris was used to estimate the ratio of quadriceps muscle activity. Female athletes with knee brace showed more reduced the knee abduction angle and the ratio of quadriceps muscle activity at foot contact phase than without knee brace. In conclusion, Female athletes with brace reduced knee anterior cruciate ligament loads.

• The Journal of Korean Medicine
• /
• v.34 no.3
• /
• pp.160-168
• /
• 2013

Psoriasis is a chronic, recurrent skin disease without any cure so far. The symptoms of the guttate psoriasis of Soyangins going through tonsillitis and of the psoriasis under the steroid rebound phenomenon are identical to one of yang poison exanthema of a Soyangin. The study administered Yangdokbagho-tang, which is used to cure yang poison exanthema of Soyangins, and, as a result, showed significant treatment results from these two types of four clinical cases. Sasang medicine is considered an effective treatment method to cure psoriasis, an obstinate skin disease.

• International Area Studies Review
• /
• v.22 no.1
• /
• pp.41-60
• /
• 2018

It is widely known that the increased productivity lead to a decrease in energy consumption. The policy for reducing energy consumption is also focusing on the improvement of firm's productivity. However, the issue of productivity dilemma phenomenon is recently raised in various fields. It is phenomenon that the increased productivity rather lead to a increased in energy consumption through a rise in output. This paper analyzed the presence of productivity dilemma in korean firm using Tang et al(2015)'s theoretical model. To closely analyze, I performed the analysis using 715 firms during 2011-2015 and estimated the model using system GMM to minimize the endogeneity. The results show that total effect of productivity had a significantly negative coefficient. It is implies that the increased productivity doesn't increase energy consumption. In other word, this paper could not identified productivity dilemma and so did in overseas investment firm and national firm cases.

• Geotechnical Engineering
• /
• v.13 no.2
• /
• pp.155-168
• /
• 1997

Lattice girder is a new steel support developed in Europe for the replacement of an existing H-shaped steel set, which is installed after tunnel excavation. Lattice girder has the following several advantages : 1. Lattice girder minimizes the amount of shotcrete shadow which happens to occur behind a steel support. 2. A triangular shape of lattice girder makes shotcrete placed efficiently. 3. Lattice girder provides a good bond strength for shotcrete, which makes the composite structure of lattice girder and shotcrete behave monolithic, and therefore, the rock load can be supported effectively by the lattice girder system, This paper presents the results from a model wall test, a strength test for shotcrete shot on the model wall and a strength test for the bond between lattice girder and shotcrete. These tests proved that lattice-girder system is superior to H-shaped steel-set system concerning the shotcrete rebound rate, the developed shotcrete strength and the adhesion characteristics.