• Journal of Korea Water Resources Association
• /
• v.36 no.6
• /
• pp.971-984
• /
• 2003

This paper presents the hydraulic analysis of the air entrainment by the weir types. For the weir types, the stepped weir, the labyrinth weir and the gate underflow weir were selected, and the oxygen transfer efficiency was estimated by the site investigation and the hydraulic model tests. The most effective type for the oxygen transfer was stepped weir The more steps the stepped weir had, the higher efficiency it revealed. Oxygen transfer was proportional to the flow velocity, the Froude number, and the flow discharge in order. Hydraulic model tests showed that a nappe flow occurred at small flow rates. The concurrent condition of a nappe flow and a skimming flow occurred as flow rate increases, nappe flow at the upper part and skimming flow at the lower part. In the region of nappe flow, air inception occurred from the step edges due to flow separation, and air entrainment was made through a free-falling nappe, an air pocket, a nappe impact and a subsequent hydraulic jump. In the region of skimming flow, air entrainment occurred by the variation of water surface over the steps, but it was relatively small compared with nappe flow.

• Proceedings of the KSME Conference
• /
• 2004.11a
• /
• pp.1715-1720
• /
• 2004

This paper presents the characteristics of internal clearances for the interstage of blades and shaft gland seals on the steam turbine which are installed in tandem compound. Internal clearances was changed when the rotor turned in the cylindrical sleeve bearing due to the generation of oil film wedge. This presented concern is very useful to prevent the rubbing damage of seal edge between the fixed and moving parts in steam turbine due to the misalignment at the rotating and stationary parts. This method is applied for the unbalanced clearances distribution to the left and right sides in the turbine casing. A considerable amount of unbalanced clearances distribution trend is determined according to the rotating speed of rotor, size and type of proceeding bearing, oil viscosity, surface roughness of bearing and shaft, oil temperature, oil pressure and bearing load.