• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.681-684
• /
• 2015

Power amplifier is an essential component for transmitting signals to a remote receiver in wireless communication systems. Power amplifier is a non-linear device in general, and the nonlinear distortion becomes severer as the output power increases. The nonlinearity results in spectral regrowth, which leads to adjacent channel interference, and decreases the transmit signal quality. To linearize power amplifiers, many techniques have been developed so far. Among the techniques, digital pre-distortion is known as the most cost and performance effective technique. However, the linearization performance falls down abruptly when the power amplifier operates in its saturation region. This is because of the severe nonlinearity. To relieve this problem, this paper proposes a new adaptive predistortion technique. The proposed technique controls the adaptive algorithm based on the power amplifier input level. Specifically, for small signals, the adaptive predistortion algorithm works normally. On the contrary, for large signals, the adaptive algorithm stops until small signals occur again. By doing this, wrong coefficient update by severe nonlinearity can be avoided. Computer simulation results show that the proposed method can improve the linearization performance compared with the conventional digital predistortion algorithms.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.12
• /
• pp.1684-1690
• /
• 2018

A new digital pre-distortion (DPD) technique for closely spaced dual-band signals is proposed. In the system under consideration, dual-band signals are amplified by a single broadband power amplifier (PA) at a transmitter. The PA output is distorted by cross-modulation between the two bands as well as their own inter-modulation distortion. Especially, if the two bands are placed in close proximity to each other, their spectral regrowths due to in-band intermodulation overlap with each other, which degrades DPD performance. To solve this problem, we propose a new DPD technique where the dual-band PA characteristics are estimated first, and then the DPD parameters are obtained from the estimated PA characteristics. By finding the DPD parameters through two steps, pre-distortion can perform well for the closely-spaced dual band signals. The proposed technique is verified through computer simulation. Simulation result shows that the proposed method performs better than the conventional method for closely-spaced dual band signals.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.673-676
• /
• 2015

Digital Pre-Distortion (DPD) is a linearization technique for nonlinear power amplifiers (PAs) by implementing inverse function of the PA at baseband digital stage. To obtain proper DPD parameters, a feedback path is required to convert the PA output to a baseband signal, and a memory is also needed to store the feedback signals. DPD parameters are usually found by an adaptive algorithm from the feedback samples. However, for the adaptive algorithm to converge to a reliable solution, long feedback samples are required, which increases convergence time and hardware complexity. In this paper, we propose a DPD technique that requires relatively short feedback samples. From the observation that the convergence time of the adaptive algorithm highly depends on the initial condition, this paper iteratively utilizes the feedback samples while keeping and using the converged DPD parameters at the former iteration as the initial condition at the current iteration. Computer simulation results show that the proposed method performs better than the conventional technique while the former requires much shorter feedback samples than the latter.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.3
• /
• pp.499-508
• /
• 2017

A new digital pre-distortion technique to linearize power amplifier (PA) is proposed for concurrent dual-band transmitters. In the conventional dual-band DPD techniques, two independent dual-feedback paths are required to compensate nonlinear cross-products between different bands as well as the nonlinear self-products of each band's own signal. However, it increases hardware complexity and expense. In this paper, we propose a new DPD method requiring only a single feedback path. In this new structure, the proposed technique first estimates the dual-band PA characteristics using the single feedback path. The DPD parameters are then extracted from the estimated PA characteristics. The DPD performance of the proposed method is validated through computer simulation. According to the results, the proposed technique can achieve comparable performance to the conventional two feedback DPD with significantly reduced hardware complexity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.12
• /
• pp.1289-1295
• /
• 2012

An adaptive digital predistortion (PD) technique is proposed for linearization of power amplifiers (PAs) in multiple-input multiple-output (MIMO) transmitters. We consider a PD structure equipped with only one combined feedback path while conventional systems have multiple feedback paths. Hence, the proposed structure is much simpler than that of multiple feedback paths. Based on the structure, a new PD algorithm is derived. The simulation results show that linearization performance of the proposed method is almost the same as the conventional multiple feedback technique while the former is much simpler to implement than the latter.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.4
• /
• pp.430-439
• /
• 2011

In this paper, we design a digital predistortion(DPD) for linearity enhancement of RF power amplifier operating in 900 MHz band. We verify improvement of linearity by comparing the proposed DPD using tanh as a nonlinear indexing function and the DPD using linear indexing function based on signal amplitude. The digital predistortion is realized by look-up table(LUT) method, and the Saleh model is employed for power amplifier modeling, then a commercial power amplifier module is used for measurement. The LUT has 256 tables, and the NLMS(Normalized Least Mean Square) algorithm was utilized for an adaptive algorithm for estimation. As a result, we improve the ACLR(Adjacent Channel Leakage Ratio) by around 15 dB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.4
• /
• pp.484-490
• /
• 2012

In this paper, we design a digitally pre-distorted RF power amplifier operating in 900 MHz band. The linearity of RF power amplifier is improved by employing the digital pre-distortion(DPD) based on affine projection(AP) algorithm, where the look-up table(LUT) method is used with non-linear indexing. The proposed DPD with AP algorithm is compared with that with normalized least mean square(NLMS) algorithm, applied to the RF power amplifier. A commercial power amplifier module is used for verification of the proposed algorithm which shows improvement of adjacent channel leakage ratio(ACLR) by about 21 dB.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2016.11a
• /
• pp.60-62
• /
• 2016

이동통신 시스템의 OFDM(Othogonal frequency division multiplexing) 신호는 큰 PAPR(Peak to Average Power Ratio)을 가지기 때문에 비선형 특성을 가지는 전력 증폭기의 효율 감소를 가져온다. 이러한 전력 증폭기의 비선형 특성을 개선하여 효율을 증가시키기 위해서 전력 증폭기의 역 특성을 가지는 디지털 전치 왜곡기가 이용된다. 본 논문에서는 제곱근 근사를 이용한 Look-up Table(LUT) 기반의 디지털 전치왜곡(Digital Pre-Distortion :DPD) 기법을 제안한다. 제안하는 방식은 복소 이득(Complex Gain) LUT 구조에서 입력신호의 크기를 구할 때, 기존의 테이블을 이용하여 제곱근 연산을 하는 방식보다 좋은 성능을 내면서 근사를 위한 테이블의 메모리를 필요로 하지 않는다. 또한 간단한 쉬프트 연산 등을 이용하므로 DSP 또는 MCU 기반의 DPD를 구현할 때 간단하게 구현 될 수 있다는 장점을 갖는다. 컴퓨터 모의실험을 통해 제안하는 제곱근 근사방식을 이용한 DPD와 기존의 방식을 사용한 DPD를 비교함으로써 제안하는 방식이 기존 방식보다 좋은 성능을 내면서도 보다 효율적으로 구현될 수 있음을 검증하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.2
• /
• pp.307-314
• /
• 2011

A new predistortion technique for dynamic spectrum allocation systems such as cognitive radio (CR) is proposed. The system model considered in this paper occupies a small band at a time, but the center frequency can be changed in the wide range of frequency. In this scenario. the front-end filter may not eliminate the harmonics of the power amplifier (PA) output. The proposed PD reduces the spectral regrowth of the fundamental signal at the carrier frequency (${\omega}_0$) and removes the harmonics ($2{\omega}_0$, $3{\omega}_0$, ...) at the same time. The proposed PD structure is composed of multiple predistorters (PDs) centered at integer multiples of ${\omega}_0$. The PD at ${\omega}_0$ is for removing spectral regrowth of the fundamental signal, and the others are for harmonic reduction. In the proposed PD structure, parameters of PDs are found jointly. Simulation results show that the spectral regrowth can be reduced by 20dB, and the 2nd and 3rd harmonics can be reduced down to -70dB from the power of the fundamental signal.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1847-1853
• /
• 2014

The PAPR of the input signal is increased due to OFDMA signal in a mobile communication system. High efficiency of a power amplifier, which accounts for power consumption, is a very important key technology. Digital Pre-Distortion techniques were used to improve the linearity of the power amplifier. The Asymmetric Doherty scheme was used to improve the efficiency of the power amplifier. In this paper, we propose a new structure of Asymmetric Doherty. Drive power amplifier part is separated as main path and peak path, and phase shifter is employed to improve power combine characteristics of the Doherty Amplifier. Also, envelope tracking technology for drive gate bais in drive peak amplifier is used to improve efficiency.