• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.8
• /
• pp.1-11
• /
• 2012

The multi-code spread spectrum communication system, which spreads data bit stream by multiplexing orthogonal codes, can transmit data in high rate. However it needs the high-cost good linear amplifier because of the multi-level output signal. In order to overcome this drawback several systems making the amplitude of output signal constant with Walsh codes have been proposed. Recently constant amplitude pre-coded multi-code spread spectrum systems using extended m-sequence have been proposed. In this paper we consider an extended m-sequence based constant amplitude multi-code spread spectrum system with code set partitioning. By grouping the orthogonal codes into 4 subsets, not only is the computational complexity of the transceiver reduced but BER performance also improves. It has been shown that parity checking on four detected codes at the receiver can correct code detection error and result in BER performance enhancement. In this paper we propose a improved parity check receiver. We carried out computer simulation to verify feasibility of the proposed algorithm.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.4
• /
• pp.39-50
• /
• 2011

In this paper, we presents a CDR circuit for $2^{nd}$-generation AiPi+, one of the Intra-panel Interface. The speed of the proposed clock and data recovery is increased to 1.25 Gbps compared with that of AiPi+. The DLL-based CDR architecture is used to generate the multi-phase clocks. We propose the simple scheme for frequency detector (FD) to mitigate the harmonic-locking and reduce the complexity. In addition, the duty cycle corrector that limits the maximum pulse width is used to avoid the problem of missing clock edges due to the mismatch between rising and falling time of VCDL's delay cells. The proposed CDR is implemented in 0.18 um technology with the supply voltage of 1.8 V. The active die area is $660\;{\mu}m\;{\times}\;250\;{\mu}m$, and supply voltage is 1.8 V. Peak-to-Peak jitter is less than 15 ps and the power consumption of the CDR except input buffer, equalizer, and de-serializer is 5.94 mW.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.201-211
• /
• 2013

In this paper, we propose a hand tracking and gesture recognition system. Our system employs a depth capture device to obtain 3D geometric information of user's bare hand. In particular, we build a flexible tracking volume and restrict the hand tracking area, so that we can avoid diverse problems caused by conventional object detection/tracking systems. The proposed system computes running average of the hand position, and tracking volume is actively adjusted according to the statistical information that is computed on the basis of uncertainty of the user's hand motion in the 3D space. Once the position of user's hand is obtained, then the system attempts to detect stretched fingers to recognize finger gesture of the user's hand. In order to test the proposed framework, we built a NUI system using the proposed technique, and verified that our system presents very stable performance even in the case that multiple objects exist simultaneously in the crowded environment, as well as in the situation that the scene is occluded temporarily. We also verified that our system ensures running speed of 24-30 frames per second throughout the experiments.

• Journal of the Korean Society of Radiology
• /
• v.11 no.1
• /
• pp.37-42
• /
• 2017

We measured the absorbed dose and the area dose using an ionization chamber type of area dose product (DAP) meter and measured the calibration factor in the X-ray examination. In the indirect dose measurement method, the detector was installed in the radiation part of the X-ray equipment, and the measured value was calculated as the dose at the exposure part. The instrument used to calculate the calibration factor was an X-ray equipment (DK-550R / F, DongKang Medical Co., Ltd., Seoul, Korea). The calibration method for the calibration factor was to connect the DAP meter (PD-8100, Toreck Co. Ltd., Japan) to the calibration dosimeter tube voltage of 70 kV, tube current of 500 mA, 0.158 sec. The reference dosimeter used a semiconductor (DOSIMAX plus A, Scanditronix, $Wellh{\ddot{o}}fer$, Germany). After installing the DAP meter on the front of the multi-collimator of the ionization chamber, the calibration factor of the dosimeter was obtained using the reference dosimeter for accurate dose measurement. Experimental exposure values and values from the calibration dosimeter were calculated by multiplying each calibration factor. The calibration factor was calculated as 1.045. In order to calculate the calibration coefficient according to the tube voltage in the ionization type DAP dosimeter, the absorbed dose and the area dose were calculated and the calibration factor was calculated. The corrective area dose was calculated by calculating the calibration factor of the DAP meter.

• Journal of Life Science
• /
• v.28 no.5
• /
• pp.555-562
• /
• 2018

Swine influenza virus (SIV) causes one of the most common diseases of the pig population, and its subtypes are determined by hemagglutinin (HA) and neuraminidase (NA). Recently, the SIV subtype diagnosis has been developed. The method using antigen-antibody reaction rather than PCR was mainly used because of the large change in the ribonucleotide sequences of SIV. Here, we have developed 10 diagnostic primer sets through multi-nucleotide sequences alignment of spreaded SIV since 2008 in Korea and then optimized the reaction of the one-step RT-PCR for rapid determination of SIV subtype. In addition, specific primers were designed to early determine the pandemic SIV by detecting unique M sequences proven in highly infectious and virulent subtypes of the influenza H1N1 (pH1N1). Here, some of the SIVs spread in Korea from 2008 to 2014 have been tested to determine the subtypes and pandemic potential of SIV. All diagnostic primer sets were found to be able to accurately determine the SIV subtype and to detect the pandemic SIV. In conclusion, it was confirmed that the optimized one-step RT-PCR analysis using these primer sets is useful for rapid diagnosis of SIV subtypes. These results can be used for development of SIV subtype diagnostic kit to early detect before virulent SIV spreads do.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2006.05a
• /
• pp.1023-1026
• /
• 2006

There are some cases in trouble with monitoring emergency patient by existing electrode sensor in measuring instrument in home and hospital etc. And there are problem to measure because of coming down electrode in emergency car or vessel of shaking and fat, humidity of patient. In this study, it has designed band-type for patient to put on the breast easily and go around anywhere freely putting band electrode on his body. Gold has used as electrode material in this electrocardiogram because of its excellent electronic resistance peculiarity and no trouble with skin. And it is able to monitor multi-body-signal by additional design of periphery temperature. There are good results of body signal transmission in the breast or the rib, and get a little body signal in abdomen. We get a result it is better case of gold than usual electrode on signal detection, and know usual electrode was disposable, but we have more correct result from gold electrode sensor, being semi-permanent ana. great contact ability even if movement.

• Journal of radiological science and technology
• /
• v.27 no.2
• /
• pp.21-27
• /
• 2004

This study was conducted to estimate absorbed radiation doses associated with CT examinations. We compared CT dose index between single detector CT and multi detector CT. To establish radiation dose criteria in CT examination in Korea, we measured radiation dose for CT examinations in Seoul and kyungki-do. The results obtained were as follows ; 1. Averaged CTDIW value per 100 mAs was $13.5{\pm}3.2\;mGy$, and ranged from 8.1 mGy to 19.1 mGy in head phantom, was $7.1{\pm}2.0\;mGy$, and ranged from 3.7 mGy to 10.9 mGy in body phantom. 2. CTDIW was 3.2 mGy(1.26 times) larger in multi detector CT than single detector CT in head phantom, and 2.1 mGy(1.34 times) larger in body phantom. 3. The dose was the highest in 4 channel multi detector CT, and followed 8 channel multi detector CT, 16 channel multi detector CT and single detector CT in head phantom. And the dose was the highest in 4 channel and 8 channel multi detector CT, and followed 16 channel multi detector CT and single detector CT in body phantom.

• Journal of the Korea Convergence Society
• /
• v.10 no.1
• /
• pp.103-113
• /
• 2019

License plate recognition camera is dedicated device designed for acquiring images of the target vehicle for recognizing letters and numbers in a license plate. Mostly, it is used as a part of the system combined with server and image analysis module rather than as a single use. However, building a system for vehicle license plate recognition is costly because it is required to construct a facility with a server providing the management and analysis of the captured images and an image analysis module providing the extraction of numbers and characters and recognition of the vehicle's plate. In this study, we would like to develop an embedded type convergent camera (Edge Base) which can expand the function of the camera to not only the license plate recognition but also the security CCTV function together and to perform two functions within the camera. This embedded type convergence camera equipped with a high resolution 4K IP camera for clear image acquisition and fast data transmission extracted license plate area by applying YOLO, a deep learning software for multi object recognition based on open source neural network algorithm and detected number and characters of the plate and verified the detection accuracy and recognition accuracy and confirmed that this camera can perform CCTV security function and vehicle number plate recognition function successfully.

• Clinical and Experimental Pediatrics
• /
• v.52 no.11
• /
• pp.1241-1248
• /
• 2009

Purpose:The etiology of Kawasaki disease (KD) is still unknown. Recently, an association between human coronavirus NL63 (HCoV-NL63) and KD was implicated. Hence, we attempted to determine the association between KD and acute respiratory viral infections. Methods:Nasopharyngeal aspirate samples were obtained from 54 patients diagnosed with KD at the Seoul National University (SNU) Children's Hospital and SNU-Bundang Hospital between October 2003 and September 2006. Viral diagnoses of 11 respiratory viruses were made using multiplex reverse transcriptase-polymerase chain reaction (RT-PCR): respiratory syncytial virus (RSV), adenovirus, rhinovirus (RV), parainfluenza viruses (PIVs) 1 and 3, influenza viruses (IFVs) A and B, human metapneumovirus (HMPV), human bocavirus (HBoV), HCoV OC43/229E, and HCoV-NL63. Clinical data were reviewed retrospectively. Results:The median age was 32 months (6 months-10.4 years). Respiratory symptoms were observed in 37 patients (69%). The following respiratory viruses were identified in 12 patients (22%): RV (n=4), PIV-3 (n=2), HBoV (n=2), and adenovirus, RSV, PIV-1, IFV-A, and HCoV-NL63 (n=1). Co-infection with PIV-3 and RV was observed in one patient. Respiratory symptoms were observed in 7 (58.3%) and 30 (71.4%) patients of the virus-positive and virus-negative groups (P>0.05). Response rate to intravenous immunoglobulin administration was 67% (n=8) and 86% (n=36) in the virus- positive and virus-negative groups (P>0.05). Conclusion:Respiratory symptoms were commonly observed in KD patients but the association between respiratory viruses and KD were not found. Large multicenter-based investigations are required to confirm the association between acute respiratory viral infections and KD.

• Clinical and Experimental Pediatrics
• /
• v.52 no.3
• /
• pp.330-338
• /
• 2009

Purpose : The causes of acute lower respiratory tract infection (ALRTI) are mostly attributable to viral infection, including respiratory syncytial virus (RSV), parainfluenza virus (PIV), influenza virus A/B (IFV A/B), or adenovirus (ADV). Several Korean studies reported human metapneumovirus (hMPV) as a common pathogen of ALRTI. However, studies on seasonal distribution and clinical differences relative to other viruses are insufficient, prompting us to perform this study. Methods : From November 2006 to October 2007, we tested nasopharyngeal aspiration specimens in children hospitalized with ALRTI with the multiplex reverse transcriptase-polymerase chain reaction to identify 6 kinds of common pathogen (hMPV, RSV, PIV, IFV A/B, and ADV). We analyzed positive rates and clinical features by respiratory chart review. Results : We detected 38 (8.4%) hMPV-positive cases out of 193 (41.8%) virus-positive specimens among 462 patients. HMPV infection prevailed from March to June with incidence peaking in April. HMPV-positive patients were aged 15 years (76.3%), and the ratio of boys to girls was 1.2:1. The median age was 27 months. HMPV primarily caused pneumonia (76.3 %) (P=0.018). Average hospitalization of HMPV-associated ALRTI patients was 5.8 days. In addition, they showed parahilar peribronchial infiltration (100%) on chest X-ray, normal white blood cell count (73.7%), and negative C-reactive protein (86.8 %) (P>0.05). All hMPV-positive patients recovered without complication. Conclusion : HMPV is a common pathogen of ALRTI in Korean children, especially in 1-5 year olds, from March to May. Immunocompetent children diagnosed with hMPV-associated ALRTI may have a good prognosis.