• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• 제8권4호
• /
• pp.39-45
• /
• 2009

In this paper, designed and fabricated the microstrip antenna using parasitic plane. This active antenna for the use of AM/FM, DMB(Digital Multimedia Broadcasting), GPS(Global Positioning System) band in vehicle. Fabricated active antenna was compared to existing planar antenna represents more than 15% size reduction and equivalence performance compared to commercial helical antenna. And satisfy performance in DMB, GPS band. This active antenna composed of single input port and two output ports and entire size of antenna is $133{\times}31{\times}1.2mm$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제14권4호
• /
• pp.413-420
• /
• 2003

In this paper, the correction method of antenna beam direction errors is introduced which caused by frequency scan effect in active Phased may antenna for satellite communications. The antenna makes the beam directional error from frequency scan effect when it has dual beam may structure with asymmetrical series connection, their frequencies are different and for from each other, their 3dB beamwidth is narrow, and scan range is wide. By proposed equations, estimated beam direction error angles can be calculated and active phase shifter control values also can be calculated to compensate them. In this paper, the active phased array antenna system was fabricated to measure beam direction errors both before and after correction, which has dual beam from 32${\times}$4 main level array and 4${\times}$2 second level array, frequency deviation 500 MHz max.(6.7 %) at 7.25 GHz∼7.75 GHz ranges, 0$^{\circ}$∼${\pm}$35$^{\circ}$nm ranges, and 35.6 dBi gain with 2.2$^{\circ}$3 dB beam width. Its beam direction error by frequency san effect which was 2.5$^{\circ}$max., was reduced to 0.2$^{\circ}$max. after correction. This was 7 dB improvement of signal loss. The active phased array antenna can accurately track the target satellite for communications by this proposed correction method.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제19권11호
• /
• pp.1193-1203
• /
• 2008

An active antenna(AA) can have wider bandwidth and more gain with small antenna size than those of passive antennas. However, AA inherently generates thermal noise and spurious signals from an active device. Moreover, the spurious performance of AA is very important in a highly sensitive receiving system since it is located at the front end of the receiving system. In this study, we developed an AA with $100{\sim}500\;MHz$, having the output P1dB higher than 3 dBm and little spurious signals in real environments. To achieve such performance, we designed an AA with 3-stage amplifier using CD(common drain) FET and 2 BJTs. Its electrical performances were simulated using ADS. The measurement results for typical gain, NF, OIP3, VSWR and P1dB in the required frequency band were 9.7 dBi, 10 dB, 14 dBm, 1.7:1 and 3 dBm respectively. They are in good agreement with simulation results. The unwanted spectrum level of the proposed AA is $10{\sim}30\;dB$ lower than that of the antenna with CS(common source) FET configuration at a west suburban area of Seoul, which shows that the proposed AA can be applicable to a highly sensitive receiving system for detecting unknown weak signals mixed with broadcasting and civilian communication signals.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• 제14권5호
• /
• pp.203-208
• /
• 2014

In this paper, the antenna of a small active RFID for 433MHz is proposed, and the proposed antenna is a kind of built-in antenna, which uses IFA structure. The performance was improved by the change of the spacing between the feed point and short strip, inserting the meander line structure in a radiator, and varying the gap between the radiator and the ground plane in the proposed antenna. To confirm the characteristics of the antenna parameters, HFSS from ANSYS Inc. was used for the analysis. The frequency band of 433MHz Active RFID is from 433.67 to 434.17 MHz. There is a value of return loss less than -9.54 dB in 433MHz band of the active RFID, and the maximum antenna gain is -4.28dBi. The Jig size of the proposed antenna is $72{\times}44{\times}1mm$, and the size of the antenna area is $35.5{\times}19.5mm$. The result proved the possibility of the practical use on miniaturized 433MHz antenna using IFA structure that came from comparing and analyzing the measured and simulated data of the antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제13권4호
• /
• pp.359-365
• /
• 2002

In this work, a new type of the active array antenna for IMT-2000 base stations by using dual-polarization diversity is proposed and developed. As an element of array antenna, a single micorstrip patch antenna of ${\pm}$ 45$^{\circ}$slanted is designed by obtaining the bandwidth of 1,885 ㎒ to 22,000 ㎒. The polarization isolation between two linearly polarized waves is less than 16 ㏈. The gain of element antenna is more than 7 ㏈i. finally, 2${\times}$8 dual-polarization active array antenna is developed with ElRP of 1,200 W and polarization isolation of 20 ㏈ by placing a low power amplifier at each antenna element.

• Smart Media Journal
• /
• 제9권4호
• /
• pp.60-65
• /
• 2020

The monopulse tracking algorithm can estimate the location of a partner station based on an RF (Radio Frequency) signal. The location of the partner station is estimated based on the monopulse ratio curve (MR-C), which is calculated based on the sum and difference signal patterns of an antenna. Therefore, the range in which the estimated location can be calculated with high accuracy increases in proportion to the linear region of MR-C. In this paper, we proposed a method to extend the linear region of the MR-C curve using the beamforming technique for the tracking antenna system using the active phased array antenna. Simulation results based on the same antenna system, it was confirmed that the linear region of MR-C was enlarged by about twice as much as the general case where the proposed method was not applied.

• The Journal of the Korea institute of electronic communication sciences
• /
• 제17권1호
• /
• pp.23-30
• /
• 2022

The active phased array antenna system performs beam steering, multi-beam formation and adaptive beam forming by controlling the amplitude and phase of signals fed to each radiating element. In order to obtain the desired radiation characteristics using an active phased array antenna system, the accurate amplitude and phase of the signal must be fed to each radiating element; however, due to various causes, the signal errors occurs in each radiating element. In this paper, a signal error estimation method of each radiating element is proposed. The proposed method simplifies the process of signal error estimation, and can quickly and accurately calculate the signal error.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• 제14권2호
• /
• pp.55-67
• /
• 2003

본 고에서는 차세대 무선통신용 초소형 단말기 구현에서 RF 시스템의 성능 개선에 크게 기여하게 될 RF 집적형 안테나 기술 현황과 향후 발전 방향이 제시된다. 고성능을 유지하면서 초소형 RF 전치단을 실현하기 위한 능동소자와 안테나가 결합하여 복합 기능을 하는 능동 집적 안테나(AIA, Active Integrated Antenna) 기술 현황, RF 시스템 단일 패키지(RF-SOP, System On Package) 형태에 집적 가능한 안테나 및 미래의 꿈인 RF 시스템 단일 칩 (RF-SOC, System On Chip)을 향한 단일 칩 안테나 (AOC, antenna on chip) 기술 동향 등이 기술된다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제23권1호
• /
• pp.29-37
• /
• 2012

In this paper, a stabilizd system operation through a composition of a protective circuit and an improvement of active reflection coefficient(ARC) is studied. Unlike the passive-phased array antenna, the APPA is a combined form of radiating element and transmitter-reciever module. Therefore, a definition of new ARC that differentiates itself from typical passive-phased array antenna must apply. The ARC is a reflection coefficient considering a superposition of a coupling from nearby radiating elements and self reflection. It is an important parameter that predicts and analyzes charateristics of a APPR system. A high level ARC is a direct source inducing a performance degradation of a system. In this paper, as a method for a stabilized operation of APAR, one method for improving a performance and another for degradation prevention are analyzed. An effectiveness of two methods was validated using experiment results of real-fabricated active-phased array antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제18권6호
• /
• pp.620-628
• /
• 2007

An H-sector horn antenna has a constant beam coverage characteristic and it can be useful for application to a wide band phased array antenna system. In this paper, we designed a broadband E-plane H-sector horn phased-array antenna, which has a 3:1 bandwidth and ${\pm}60^{\circ}$ beam steering capability. An H-sector hem antenna was designed to have $30{\sim}50^{\circ}$ half-power beam width in the principal H-plane. The active reflection coefficient including mutual coupling was calculated using a waveguide simulator, and the active reflection characteristic was improved by mutual coupling over wide frequency range. Using these results, an $8{\times}1$ H-sector phased array antenna was fabricated. The measurement results for the half-power beam width in the principal H-plane and the active reflection coefficient showed a good agreement with the simulation results. The peak-value pattern in the steered radiation beams also agreed well with the active element pattern. The measured active reflection coefficients within the beam steering range are mostly less than 0.3 over the 3:1 frequency range.