• Proceedings of the Acoustical Society of Korea Conference
• /
• autumn
• /
• pp.561-564
• /
• 2004

방음벽의 상단모서리는 방음벽의 차음효과를 저하시키는 또 다른 허상음원으로 작용하며 이 현상은 저주파수 영역일수록 두드러지게 나타난다. 이 논문에서는 능동소음제어장치를 통해서 상단 모서리 표면의 음장을 최소화함으로써 표면임피던스의 변화를 통한 상단모서리 주변의 소리에너지의 역학과 원거리 음장에서의 효과를 고찰한다. 능동제어장치를 함유하는 상단모서리를 수학적으로 모델화하여 음장의 분포와 소리의 세기, 능동제어 효과에 영향을 미치는 조건들을 검토하였다. 수치해석적 연구를 통하여서 효과적으로 방음벽의 차음효과를 높이는 최적의 조건을 제시하였다.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.10a
• /
• pp.120-121
• /
• 2011

• The Journal of the Acoustical Society of Korea
• /
• v.30 no.1
• /
• pp.42-48
• /
• 2011

This preliminary study is about the application of the compound source to the active noise barrier system as control sources. A compound source is composed of two monopole sources but having opposite phase. However, both monopole sources in one compound source are not independently controlled. The source strength of monopole source close to the noise source is proportional to the other one. Therefore, the cost for the hardware system is cheaper than usual system but known to possibly having a similar performance in generating anti-noise acoustic field. In this study, using a simple active noise barrier system model having a non-reflective floor, the effectiveness of the system with compound sources is investigated through computer simulations and shows 30~40 % performance improvement of noise reduction.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.20 no.12
• /
• pp.1216-1222
• /
• 2010

Based on the MacDonald's analytic model for the diffracted sound field of a semi-infinite noise barrier, computer simulations were performed for various positions of error microphones for an active noise barrier system. The simulation process also included the effects of floor reflections on both sides of the barrier. The results were also compared with Niu's simulation results and showed a straight line arrangement of sensors and actuators, in the order of primary source, secondary source and error microphone is better than over the top arrangement of the error microphones.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.1046-1047
• /
• 2015

기존에 시행 중인 도로교통 소음을 저감시키기 위한 방안인 방음벽과 저소음 포장은 보편적으로 사용되어 오고 있으나, 몇 가지 단점을 가지고 있다. 방음벽은 높은 시공으로 인한 도시 경관 저하, 과도한 시공비 및 유지비, 조류가 방음벽에 부딪혀 유발되는 생태계 교란 현상 등 여러 문제점을 가지고 있다. 또한, 저소음 배수성 포장은 타이어와 도로 포장간의 마찰 소음을 원천적으로 저감시키는 효율적인 공법이나, 시공 후 일정기간이 지나면 공극이 막혀 성능이 저하되어 유지 보수가 적절하게 필요한 단점이 있다. 수음점의 거리별 소음예측을 통하여 일반적인 원소음과 능동형 소음 저감 기술(ANC) 적용 후의 효과를 알아보고, 소음원의 제어 및 영향거리에 따른 저감 목표를 예측하고자 한다.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.8 s.101
• /
• pp.891-896
• /
• 2005

On the basis of theoretical studies on the effect of the cylinders attached to semi-infinite screens, the tangential sound power-transport parallel to the surface of the attached cylinder is minimized by means of a secondary sound field, which is generated from a part of the attached cylinder. The numerical study shows the possibility of deflecting the incident sound by minimizing the sound field of the upper sections. The acoustical shadow region was more pronounced in both near- and far-field compared to the passive case with rigid surface, i.e. without active control. For a relatively wide frequency range it was possible to enhance shielding effects only with few secondary sources and error microphones. In this paper effects of control parameters on the actively controlled sound field near the top edge of noise barriers are studied. Results of numerical study and model measurements are shown and discussed.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.482-485
• /
• 2004

On the basis of theoretical studies on the effect of the cylinders attached to semi-infinite screens, the tangential sound power-transport parallel to the surface of the attached cylinder is minimized by means of a secondary sound field, which is generated from a part of the attached cylinder. The numerical study shows the possibility of deflecting the incident sound by minimizing the acoustic surface impedance of the upper sections. The acoustical shadow region was more pronounced in both near- and far-field compared to the passive case with rigid surface, i.e. without active control. For a relatively wide frequency range it was possible to enhance shielding effects only with few secondary sources and error microphones. In this paper effects of some control parameters on the actively controlled sound field near the top edge of noise barriers are studied. Results of numerical study and model measurements are shown and discussed.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.554-555
• /
• 2011

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2010.10a
• /
• pp.298-299
• /
• 2010

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.191-192
• /
• 2011