• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.31 no.3
• /
• pp.180-198
• /
• 2019

In recent years, countries like Europe and Japan have been involved in many researches on the Low-Crested Structure (LCS) which is the method to protect beach erosion and it is regarded as an alternative to the submerged breakwaters, and compiled its results and released the design manual. In the past, studies on LCS have focused on two-dimensional wave transmission and calculating required weight of armor units, and these were mainly examined and discussed based on experiments. In this study, three-dimensional numerical analysis is performed on permeable LCS. The open-source CFD code olaFlow based on the Navier-Stokes momentum equations is applied to the numerical analysis, which is a strongly nonlinear analysis method that enables breaking and turbulence analysis. As a result, the distribution characteristics of the LCS such as water level, water flow, and turbulent kinetic energy were examined and discussed, then they were carefully compared and examined in the case of submerged breakwaters. The study results indicate that there is a difference between the flow patterns of longshore current near the shoreline, the spatial distribution of longshore and on-offshore directions of mean turbulent kinetic energy in case of submerged breakwaters and LCS. It is predicted that the difference in these results leads to the difference in sand movement.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.10a
• /
• pp.339-342
• /
• 2003

Sea level variations and sea surface circulations inthe Korean seas were observed by Topex/Poseidon altimeter data from 1993 through 1997. In sea level variations, the West and South Sea showed relatively high variations with comparison to the East Sea. Then, the northern and southern area in the West Sea showed the range of 20-30cm and 18-24cm, and the northern west of Jeju island and the southern west of Tsushima island in the South Sea showed the range of 15-20cm and 10-15cm, respectively. High variations in the West Sea was results to the inflow in sea surface of Yellow Sea Warm Current (YSWC) and bottom topography. Sea level variations in the South Sea was due to two branch currents (Jeju Warm Current and East Korea Warm Current) originated from Kuroshio Current (KC). In sea surface circulations, there existed remarkably three eddies circulations in the East Sea that are mainly connected with North Korea Cold Current (NKCC), East Korea Warm Current (EKWC) and Tushima Warm Current (TWC). Their eddies are caused basically to the influence of currents in sea surface circulations; Cyclone (0.03 cm/sec) in the Wonsan bay on shore with NKCC, and anticyclone (0.06 cm/sec) in the southwestern area of Ulleung island with EKWC, and cyclone (0.01 cm/set) in the northeastern area of Tushima island with TWC, respectively.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.4 no.5
• /
• pp.26-36
• /
• 1996

The fully developed turbulent momentum and heat transfer induced by the square-ribbed roughness elements on both the inner and outer wall surfaces in concentric annuli are studied analytically based on a modified turbulence model. The analytical results of the fuid flow are verified by experiment. The experiment is done with a pitot tube and a X-type hot wire anemometer to measure the time mean velocity profiles, zero shear stress positions, maximum velocity positions and friction factors, and etc. shown in Fig.1. The resulting momentum and heat transfer are discussed in terms of various parameters, such as the radius ratio, the relative roughness, the roughness density, Reynolds number, Nusselt bumber and Prand시 number. The study demonstrates that certain artificial roughness elements may be used to enhance heat transfer rates with advantage from the overall efficiency point of view by investigating turbulent flows and heat transfer in Fig.1.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.19 no.7
• /
• pp.1749-1757
• /
• 1995

The structure of turbulence of fully developed flow through three concentric annuli with both rough inner and outer walls was investigated experimentally for Reynolds number range Re=15000-93000. Turbulence intensities were measured in three (u, v, w) directions, and turbulence shear stresses in annuli of radius ratios .alpha.= 0.26, 0.4 and 0.56, respectively. The result showed that the structure of turbulence for these asymmetric flows was not the same as that for the annulus with smooth walls. The velocity fluctuations of all three components (u, v, and w-directions) showed little discernible variation with Reynolds numbers, but became apparent with the influence of radius ratio (.alpha.) The experimental results for an annulus with the roughened outer wall and a smooth annulus were shown in the figures as a reference. The eddy diffusivities and friction factors were also presented and discussed.

• Journal of Advanced Marine Engineering and Technology
• /
• v.19 no.4
• /
• pp.27-33
• /
• 1995

The turbulent flow and heat transfer in the tunnel laminar flow type clean room is investigated by a numerical simulation. The model clean room is assumed to be a rectngular $5m\times3m$, in which a worktable of 0.75m hight, and 1.5m or 3m long at the floor. Major parameters are the inlet flow velocity, inlet hole size and worktable surface distance. The mean Nusselt number is increased by increasing Reynolds number and can be expressed by the correlation equation.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2007.05a
• /
• pp.403-407
• /
• 2007

본 연구에서는 개수로 흐름에서의 오염물질 거동 특성에 대해 분석하였다. 이를 위해 개수로 흐름을 등류상태로 가정하여 3차원의 수직모형을 구성하고 운동량 방정식과 스칼라 수송방정식에서의 난류 폐합을 위해 레이놀즈응력 모형 및 GGDH 모형을 사용하였다. 개발된 모형을 이용하여 복단면 수로에서 오염물질이 점으로 주입된 경우에 대해 난류 흐름 및 오염물질의 농도 분포를 수치모의 하고 기존의 실험 데이터와 비교하였다. 그 결과 개발된 모형이 개수로 흐름에서의 평균유속 및 난류구조, 오염물질의 농도 분포 등을 잘 모의하는 것으로 나타났다. 특히, 이차흐름의 영향으로 인해 최대 농도 값의 위치가 거리에 따라 이동하는 것으로 나타났으며, 농도 분포 역시 정규분포에서 거리에 따라 점차 왜곡되는 것으로 확인되었다.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.19 no.9
• /
• pp.2297-2307
• /
• 1995

An experimental study on the structure of a separated shear layer downstream of the backward-facing step has been performed by examining mean flow and turbulent quantities in terms of free stream turbulence. When free stream turbulence exists, the entrainment rate of the separated shear layer and the flow rate in the recirculation region are enhanced, resulting in shorter reattachment length. The production and diffusion terms in the turbulent kinetic energy balance are shown to increase more than the dissipation term does. Rapid decrease of the pressure-strain term in the shear stress balance implies the enhancement of the three-dimensional motion by free stream turbulence.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.3 no.3
• /
• pp.161-167
• /
• 1991

This paper presents the results of some measurement of the fluctuating velocity field in the turbulent boundary layer disturbed by a triangular prism and discusses the discovery of the disturbed boundary layer. A prism of height 8mm was used for experiments. The streamwise location of the prism was fixed at 1200mm downstream from the leading edge and the space between the prism center and the wall was set at three different values, 6, 15 and 33.5mm. The results show that the near-wall region of the disturbed boundary layer recovers original state much more quickly than the outer region. In the case h=6mm the recovery is faster than the other cases. Moreover, it was found that peak of fluctuating velocities moves outwards somewhat rapidly with increasing ${\times}$ mainly due to the turbulent diffusion of the fluctuating velocity.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.3
• /
• pp.954-962
• /
• 1991

본 연구에서는 횡 방향으로 속도구배를 타내는 a=.part.W/.part.z에 대한 방정식을 3차원 운동량 방정식으로 부터 유도한 준 3차원 수학적 모델을 성정하여 해석하였다. 또한 수치 해석을 위하여 Chen에 의하여 고안된 유한 해석법과 2-방정식 저 레이놀즈 K-.epsilon. 난류모델, 그리고 Maeng에 의해 제시된 경계 공정 좌표계를 사용하였다. 그리 고 프로그램의 검증을 위하여 G.Ber geles가 수행한 실험치와 비교하여 그 타당성을 입증하였다.

• Journal of the KSME
• /
• v.29 no.5
• /
• pp.520-524
• /
• 1989

chaos란 "질서 있는 무질서"를 의미한다. chaos의 큰 특징은 초기조건에의 민감성이다. 역으로 말 하면, 주어진 운동은 초기조건에 민감하므로 chaotic한 운동을 한다고 말할 수 있겠다. 제2장에서 는 유동문제의 대표격인 Lorenz chaos를 살펴보고, 3장에서는 동역학 문제인 Duffing-Holmes방 정식, 4장에서는 map의 대명사인 logistic map을, 5장에서는 기타 무수히 많은 분야 중 기계공 학에 가장 가까운 것들을 골라 연구된 내용을 소개하고 그 특징들을 살펴본다. 6장과 7장에서는 chaos의 정량화를 위한 Lyapunov지수와 fractal dimension의 개념과 그 계산 방법을 다룬다. 8 장에서는 현재까지도 그 의문이 풀리지 않은, chaos학문의 큰 관심사인, 난류의 시작문제를 취 급하고, 마지막으로 9장에서는 문제점, 과제 및 앞으로의 전망을 살펴보기로 한다. 살펴보기로 한다.