• Journal of Korean Tunnelling and Underground Space Association
• /
• v.19 no.5
• /
• pp.779-797
• /
• 2017

Recently, underground road construction is attracting attention because the ground transportation facilities in the urban area have reached the saturation level and traffic volume has increased and the air pollution has risen. Construction of underground roads is not only reduce trafficjam in downtown but also design the city eco-friendly, so existing roads as well as new roads go underground. It is essential to construct divergence tunnels that serve as IC (interchage) and JC (Junction) when constructing underpasses. Therefore, the analysis of the effect of the existing tunnel by the divergence tunnel should be considered. In this study, numerical analysis is performed to analyze the effect of existing tunnel on the excavation of the divergence tunnel. The divergence tunnels were set in 5 cases at $45^{\circ}$ intervals in the clockwise direction starting from the lower part of the existing tunnel. In each case, numerical analyses were carried out by using the DCM (Displacement Controlled Model) for applying the volume loss of 0.5%, 1.0% and 1.5%. As a result, when the volume loss increased, the effect on displacement, fracture range, and effect on stability increased as well. In addition, it was confirmed that the divergence tunnel located directly underneath is the weakest for the stability, and the case where the divergence tunnel is located diagonally rather than the vertical and horizontal direction is found to be vulnerable to displacement and lining destruction.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.5
• /
• pp.1-11
• /
• 2017

Expressway network which plays an important role on land transportation system, have been developing quantitatively and qualitatively with $7{\times}9$ structure. To cope with complex geometric condition, guidance lane marking has been installed to induce safer lane-changing maneuver. However, there is no standard on guidance lane marking and its effectiveness is also verified with limited scope. The major purpose of this research is to clarify its effectiveness in terms of driving safety aspect using virtual driving simulator and to suggest standard on the proper length. To carry this out, preference data from subjects was collected and lane-changing pattern within virtual driving environment was investigated. In addition, in order to quantify the level of comfort, Electroencephalogram data was collected and validated using statistical test. Finally, it is expected that this research can be used to establish standard on guidance lane marking.

• International Journal of Highway Engineering
• /
• v.14 no.3
• /
• pp.173-182
• /
• 2012

Entry and exits of the rest area are sections where designed speed can be rapidly change and also a weak traffic safety section. In addition, two tasks can be performed simultaneously at entry of the rest area, particularly searching for deceleration and parking spaces/parking sides etc. Thus, design criteria is required in order to procure the stability of accessed vehicle. In case of Korea, geometric structure design criteria of entry facilities, such as toll-gate, interchange, junction etc was established. However there are no presence in a detailed standards for geometric structure of the rest area which affiliated road facilities. In this study, Derive problems in regards to the entry of geometric structure of resting areas by utilizing a sight survey and an investigation research of traffic accidents. The survey was targeting 135 general service areas. After Classifying the design section of resting areas' entry as well as derive design elements on each section, a speed measurement by targeting entry of rest areas and car behavior surveys were performed, then each element's minimum standard was derived through the analyses. According to the speeds at the starting/end point of entrance connector road, the minimum length of the entrance connector road is decided as 40m using Slowing-down length formula and based on the driving pattern, the range of the junction setting angle of the entrance connector road is defined as $12^{\circ}{\sim}17^{\circ}$. Suggest improvement plans for existing rest areas that can be applied realistically. This should be corresponded to the standards of entry and exit of developed rest areas.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.20 no.2
• /
• pp.1-14
• /
• 2021

The exclusive bus lanes in the Yeongdong Expressway were implemented in the Singal to Yeoju section in 2017, but the capacity of both exclusive bus lanes and general-purpose lanes of the Yeongdong Expressway decreased and the travel time increased, reducing it to the Singal to Deokpyeong section. Therefore, it is necessary to increase the efficiency of exclusive bus lanes to revitalize public transportation and improve environmental problems. This study calculated the willingness to pay and the social benefits of permission for Green cars to drive on exclusive bus lanes in Yeongdong Expressway. A survey was conducted on two groups of Green car users and Expressway users, and the willingness to pay was estimated using the CVM method. As a result, the average WTP of Green car users were estimated to be 218.7(won/km·person), and that of Expressway users were estimated to be approximately 235.5(won/km·person). The direct benefits were estimated to be approximately 7.9 billion won for Green car users, and 8.5 billion won for Expressway users in 2019. Finally, the value of time saving was estimated to be approximately 8.0 billion won.