• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1791-1797
• /
• 2014

A water level measurement radar estimates beat frequencies to extract the corresponding water level information for water resource management. Therefore, it is required to maintain the high degree of reliability and accuracy in beat frequency estimates. However, Beat spectra of water surface return echoes can have very widely varying shapes according to system frequency linearity, measurement environments and weather conditions. Therefore, serious problems may arise in maintaining the reliability and accuracy of the conventional level estimation method. Therefore, in this paper, high resolution spectrum estimates are analyzed for improvement of the conventional method. These methods show that the more accurate level measurement can be possible on the condition that SNR is higher than a certain required threshold. However, if SNR is too low, the conventional method shows that estimates are more reliable than the suggested method though absolute errors are too large.

• Journal of the Korea Convergence Society
• /
• v.10 no.3
• /
• pp.73-79
• /
• 2019

This study simulated external ear canal modeling with different external ear canal lengths, vertical flexion angles, and inner/outer diameter ratios using digital imaging and communications in medicine(DICOM) of the head temporal region and measured the acoustic sensitivity. The experiment was performed by increasing the audible frequency for humans by 200 Hz and expressing the frequency constantly transmitted at 1 Pa as the eardrum acoustic volume and presented the measurements by linear and quadratic curve regression analysis. The results showed that the longer the external ear canal length and the higher the ratio of the outer/inner diameter, the faster the acoustic response at lower frequencies. The acoustic sensitivity correlation of the meta-model using regression analysis showed a 77% influence by the external ear canal length and 5% by the external/internal diameter ratio, while the vertical flexion angle did not show a significant relationship. This showed that auditory acoustic sensitivity of humans is a factor that reacts faster at a low frequency when the external ear canal length is longer and when the difference between the outer and inner diameter is higher.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.2
• /
• pp.152-159
• /
• 2019

In general, a Doppler radar can measure only the velocity of a moving target. To measure the distance of a moving target, it is necessary to use a frequency-modulated continuous wave or pulse radar. However, the latter are very complex in terms of both hardware as well as signal processing. Moreover, the requirement of wide bandwidth necessitates the use of millimeter-wave frequency bands of 24 GHz and 77 GHz. Recently, a new kind of Doppler radar using multitone frequency has been studied to sense the distance of moving targets in addition to their speed. In this study, we show that distance sensing of moving targets is possible by adjusting only the frequency of a 2.4 GHz Doppler radar with low cost phase lock loop. In particular, we show that distance can be sensed using only alternating current information without direct current offset information. The proposed technology satisfies the Korean local standard for low power radio equipment for moving target identification in the 2.4 GHz frequency band, and enables multiple long-range sensing and radio-frequency identification applications.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.8
• /
• pp.988-995
• /
• 2019

In this paper, we propose the Tile Based Frequency Hopping - Chirp Spread Spectrum(TBFH-CSS) technique, which has excellent Low Probability of Intercept(LPI)/Anti-Jamming(AJ) performance. Conventional Frequency Hopping - Chirp Spread Spectrum(FH-CSS) technique uses only single chirp signal, that makes the follower jammer easy to find and jam. However, proposed TBFH-CSS uses various kind of chirp signals which are generated according to the structure of basis tile, it is composed the basis time unit and the basis bandwidth unit. The TBFH-CSS signal has variety signal period and signal bandwidth. Therefore, the follower jammer hard to find and difficult to jam the TBFH-CSS signal. We analysis the LPI/AJ performance of the TBFH-CSS technique when the follow jamming attack exist and compared with the performance of the conventional FH-CSS technique. From the analysis, we can see the proposed TBFH-CSS technique has better LPI/AJ performance than conventional technique.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2017.04a
• /
• pp.165-165
• /
• 2017

모돈은 사육 특성상 제한된 파일롯 공간 안에 장시간 머물기 때문에 과중한 몸무게에 의한 지제 이상, 섭식 등의 불량, 수면상태의 불량 등을 지속적으로 관찰해야 하는 대상이다. 측면에 다수의 초음파 센서를 설치하여 기립의 상태 및 운동 시 몸체 궤적의 특성을 분석하여 종합적으로 모돈의 행동 특성을 정량화 하고자 하였다. 이 과정에서 계측 신호의 값을 대수적으로 비교하는 방식에 한계가 있음을 발견하였고, 이를 해결하고자 10 Hz/Ch 내외의 시계열 상대거리 궤적 신호를 주파수 도메인으로 변경하여 분석을 수행하였다. 일정 주파수에 집중되어 있는 주파수 값의 크기 변화(파워 스펙트럼 밀도)를 기준으로 모돈의 움직임의 정상 상태 유무 판별이 가능하였다. 단, 이러한 분석은 계측 데이터를 일괄 처리 방식으로 분석하는 방법으로 도출이 되었으므로, 계측과 정량 분석을 동시에 수행하기 위한 개선이 필요하였다. 계측 시스템에서 사용한 마이크로 프로세서는 Nucleo-446(STMelectronics, CA, USA)로 180 Mhz의 클럭 속도로 작동하나, 총 100 Hz 내외의 16비트 계측 신호에 대해 추가적으로 FFT 등의 주파수 변환 신호 처리를 수행하기에는 연산 능력이 부족하였다. 한편, 주파수 분석의 주기를 1분 단위로 할 경우 처리해야할 정보의 크기는 $100{\times}60{\times}5{\times}2Byte$ 이므로 1분 내에 해당 연산을 종료할 수 있는 추가의 연산 장치가 필요하였다. 계측과 주파수 도메인 변환 연산을 동시에 수행하기 위하여 1 Ghz의 연산능력을 가진 ARM A9 계열의 초소형 멀티코어 AP인 NanoPi Neo Air(Friendlyarm, Guangzhou, China)을 선정하였다. 4개의 코어를 각각 계측, Median 필터링, Smoothing 연산, FFT 분석에 사용하여 1분 단위, 2분 단위, 5분 단위의 주파수 분석을 동시에 수행하였다. 병렬 연산 라이브러리는 오픈 소스인 MPICH(www.mpich.org)를 이용하였다. 상대적으로 여유있는 자원을 보유하고 코어를 실시간으로 결정하여 다수의 모돈 개체 동시 모니터링을 위한 네트워크 연결 역할을 동시에 수행하도록 하였다. 1주일 내외의 요인 실험 수행 결과, 약 70 Mbyte의 데이터가 축적이 되었으며, 1분 단위, 2분 단위, 5분 단위의 주파수 도메인 변환 후 결과를 동시에 취득할 수 있었다. 일부 주파수 도메인 상의 파워 밀도 값이 모돈의 행동 특성에 분석에 유효한 정보를 제공함을 발견하였다. 모돈사 내 현장 보급이 가능한 초소형 AP와 멀티 코어 기반 병렬 처리 기법을 이용한 현장 진단 시스템 개발 연구를 지속적으로 수행할 것이다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.11
• /
• pp.1074-1080
• /
• 2013

The low phase noise and wideband frequency synthesizer has been designed by using YTO. Offset PLL structure is used for reducing a division ratio of feedback loop. The phase noise modeling is applied to optimize loop filter of PLL and YTO module. And DDS is used as reference signal of frequency synthesizer for fine resolution. The fabricated wideband frequency synthesizer has the output frequency of 3.2 GHz to 6.8 GHz, phase noise of -107 dBc/Hz at 10 kHz offset from the carrier and frequency resolution of 1 Hz. The measured phase noise is well agreed with the simulated one.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.11
• /
• pp.34-40
• /
• 2011

This paper presents a low-dropout (LDO) linear regulator using ultra-low output impedance buffer for frequency compensation. The proposed buffer achieves ultra low output impedance with dual shunt feedback loops, which makes it possible to improve load and line regulations as well as frequency compensation for low voltage applications. A reference control scheme for programmable output voltage of the LDO linear regulator is presented. The designed LDO linear regulator works under the input voltage of 2.5~4.5V and provides up to 300mA load current for an output voltage range of 0.6~3.3V.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.11
• /
• pp.1034-1042
• /
• 2004

In this paper, as one of countermeasure techniques for a frequency selective fading, an adaptive analog slope equalizer(ASE) applicable to 64-QAM digital radio relay system is presented in terms of principle, implementation, and its performance. Also interference of cross-talk between I- and Q-channel caused by a fiequency selective lading has been analyzed by doing channel model in the baseband, which make it possible to derive the solution for implementing ASE in If-band. The effects of signal for the faded channel are investigated in the time and the frequency domains, respectively, with/without ASE. As system performance, it is shown that the signature is improved up to 6.2 dB at the edge of signal bandwidth for a given BER 10$\^$-3/.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.124-128
• /
• 2009

This raper proposes a dual-bandstop filter, which is based on a metamaterial transmission line using the composite right/left-handed (CRLH) and dual composite right/left-handed (D-CRLH) structures. The metamaterial structure is used for miniaturization and dual-bandstop operation at the TDMB frequency range (195 MHz) and DVB-T/H frequency range (670 MHz). The size of the proposed filter is $30{\times}15\;mm$, and the -10 dB bandstop fractional bandwidth is approximately 73 % and 50 % at each frequency, respectively.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.19 no.6
• /
• pp.46-51
• /
• 2005

Grounding insures a reference potential point for electric devices and also provides a low resistance path for fault currents in the earth. The ground impedance as a function of frequency is necessary for determining its performance since fault currents could contain a wide range of frequencies. A cower rod electrode is the most commonly used grounding electrode in electric distribution systems. In this paper, the ground impedance of cower rods has been measured in frequency ranging from 60[Hz] up to 100[kHz] and an equivalent circuit model, transfer function model of the ground impedance are identified from the measured values.