• Journal of the Korean Geotechnical Society
• /
• v.23 no.12
• /
• pp.95-107
• /
• 2007

This study describes compressive characteristics of marine clay at southwestern coast in Korea by large block and piston samples. Through the analysis of disturbance effect and various consolidation test, consolidation result shows that volumetric strain from large block samples is lower than piston samples and compression index of large block samples is larger than piston samples value. We suggest new empirical equation of compression index by the effect of compression index following sampling method. If consolidation settlement is presumed using empirical equation of compression index, the resort will be more reasonable in predicting settlement than that obtained by the decision of compressibility characteristics from piston samples.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.11
• /
• pp.133-141
• /
• 2008

In this study, a new method for estimating the undrained shear strength $s_u$ of saturated clays using piezocone penetration test (CPTu) result is proposed. This is to develop more effective CPTu-based $s_u$ estimation method at lower cost with less uncertainty. For this purpose, a marine clay deposit is selected and tested through extensive experimental testing program including both in-situ and fundamental laboratory tests. The proposed method is based on a correlation between the undrained shear strength $s_u$ and the cone resistance $q_t$, without introduction of the total overburden stress into the $s_u-q_t$ correlation. As a result, no additional testing procedure for collecting undisturbed soils samples is required, which can reduce overall testing cost. To verify the proposed method, 4 test sites, which consist of a variety of soil conditions, are selected and used for comparison between measured and predicted undrained shear strength. From comparison, it is seen that predicted values of $s_u$ using the proposed method match well those from measured results.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.6
• /
• pp.37-51
• /
• 2007

In this study, pile load tests have been carried out to develop new P-y curves and then, to investigate the effects of pile rigidities on laterally loaded offshore drilled shafts in Incheon marine clay. This paper consists mainly of two parts: the first part, performance of a series of lateral load tests on small- and full-scale piles under one- and two-way loadings and the second part, comparison between the measured and predicted results by using O'Neill's and Matlock's clay models. Based on the results obtained, it is shown that relatively good agreements in bending moments and lateral displacements were obtained between the measured results using calculated P-y curves and predicted ones by O'Neill's and Matlock's clay models. The cases were considered with varying rigidity factors based on pile diameter, length and subgrade soil reaction. Through comparisons, it is found that soil P-y curve influences highly the behavior of flexible pile rather than that of rigid pile.

• Journal of Industrial Technology
• /
• v.28 no.B
• /
• pp.81-89
• /
• 2008

This paper is results of investigating the dominant factors influencing to coefficient of consolidation in horizontal direction of Korean marine clays and their correlations through literature review. From the results of analyzing data obtained from field tests such as piezocone penetration and dilatometer tests as well as laboratory tests, coefficient of consolidation in the horizontal direction was found to increase with increase of stiffness index of soil while it decreases with the increase of dissipation time of pore pressure developed during field tests. In general, the coefficient of consolidation in the horizontal direction tends to increase with increase of undrained shear strength and preconsolidation pressure although correlation between them are relatively low. Friction ratio has a high correlation with coefficient of consolidation in the horizontal direction in case of friction ratio being greater than 1.0. For methods of estimating coefficient of consolidation in the horizontal direction with different testing device, values obtained from methods of P2-logt and DMT-A with dilatometer were quite similar to values from piezocone penetration test. Consistency of soil is quite proportional to coefficient of consolidation in the horizontal direction. Clear correlation between coefficients of consolidation in the horizontal and the vertical directions could not be found. coefficient of consolidation in the horizontal direction estimated from the results of field test tends to be 1.13~3.11 times greater than that obtained from laboratory tests.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.5
• /
• pp.133-144
• /
• 2003

Horizontal consolidation characteristics of Busan marine clay were investigated by computing coefficient of horizontal consolidation from Piezocone data and comparing their results with those of standard consolidation test. It is well known that current prediction models of $c_h$ for high plastic soils have large uncertainties, and show a great difference between the predicted and the measured values. However, the spherical models and expanding cavity theory of Torstensson(1977), and Burns & Mayne(1998) based on modified Cam-Clay model with critical limit state concepts have relative reliability in estimating $c_h$ and good applicability in highly plasticity soils. In this paper, a normalization technique was used to evaluate $c_h$ using the Burns and Mayne's method based on the dissipation test, and their normalized consolidation curves give 0.015 of time factor($T_{50}$) when 50% degree of consolidation is completed. Comparison study using Piezocone data obtained at other similar ground site shows 1.5 times less systematicality than that of standard consolidation test, which indicates considerable approximation with the measured values because standard consolidation test gives the difference of three to few times compared with the measured values. In addition, design chart for estimating $c_h$ based on the chart from Robertson et al.(1992) and using the other method of the direct prediction from the of dissipation test was newly proposed. It is judged that new proposed chart is very applicable to Korean marine soils, especially in very high plastic soils.

• Journal of the Korean Geosynthetics Society
• /
• v.17 no.3
• /
• pp.9-18
• /
• 2018

The soil parameters important for the design of the soft ground are the compression index ($C_c$), the consolidation settlement and consolidation speed at the field. Compression index is obtained by laboratory consolidation test. In the laboratory consolidation test, sample disturbance always occurs. In order to correct the disturbance phenomena, the method of calculating the compression index proposed by Schmertmann (1955) is generally used. However, recent developments in sampling technology and Korean soil conditions are different from those proposed by Schmertmann. So it needs to be verified. In this study, each consolidation curve's cross void ratio is evaluated by doing consolidation test varying disturbance on high-plastic clay (CH), low-plastic clay (CL) and low-plastic silt (ML). The test results were $0.521e_0$ for low-plastic silt, $0.404e_0$ for low-plastic clay, and $0.458e_0$ for the high-plastic clay. This results were different from those of Schmertmann's suggested value of $0.42e_0$. Therefor we proposed a correction formula using the plastic index according to soil type. However, since the results of this study are limited test results, further studies on various korean soil are needed to suggest the compression index correction method according to the degree of plasticity index of soil.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.6
• /
• pp.83-90
• /
• 2012

Generally, the effect of the cement deep mixing method on the improvement of clay ground is far greater than the effect of physical improvement. Although it leads to great improvement strength in the initial stage, there are not many constructional precedents in Korea and it is hard to manage quality according to the cement-clay mixing method. In order to figure out the strength characteristics according to the mixing ratio of cement, sand, and clay and the improvement characteristics of weak ground according to the forms of the specimens to be improved, marine clay was used in this study to conduct the uniaxial compression test and soil bin model test. The test piece specimens for the uniaxial compression test were mixed with sand in a fixed ratio with the criterion of the water cement ratio. The cement was mixed with clay in the ratios of 10%, 20%, 30%, and 40% to the clay weight. The moisture content of the soil ground was made in the ratios of 40%, 60%, and 80%. The test piece specimens went through curing by moistening for 7, 14, and 28 days and underwent the uniaxial compression test according to the curing period. For the bearing test, the soil bin models were made and the ground improved in the Mat type was formed. After that, the bearing strength was compared in this study according to the improvement ratio and analyzed the intervening effect between the walls of the improved specimens.

• Geotechnical Engineering
• /
• v.9 no.3
• /
• pp.49-60
• /
• 1993

The compatibility of chemicals in the leachates with the three natural and artificially -made liner materials is analyzed by performing the laboratory hydraulic conductivity test. The selected liner materials are natural marine clay, fly ash and weathered granitic soil stomped from Kimpo Wastefills, Seochon power plant and Mansu Dong, Inchon, respectivaly. Bentonites of 20 and 10 percent by weight are used as additive materials for fly ash and weathered granitic soil and the chemical solutions used in the test are acetic acid, methanol, heptane, and aniline which are frequently found in the leachate of waste fills. The concentrations of the chemical solutions are 100% and 75%. The results of the tests show that hydraulic conductivities of the oxter materials are increased by one or two orders of magnitude with permeating pure chemical solutions. The rate of hydraulic conductivity increase is lowest for Seochon fly ash admixed liner and highest for natural marine clay liner. The influence of hydraulic chemical solutions on the liner materials is least for acetic acid and largest for aniline. The increases of conductivity are not shown with the permeation of the solution of concentration 75%. At least by this test results, it can be recognized that the tested liner material can be quite stable with the solutions of significantly high concentration except pure solutions.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.6
• /
• pp.73-81
• /
• 2002

Various CPT-based prediction models far profiling stress history of marine clay at the southern part of the Korean peninsula were investigated by using both statistical analysis and case history study. Preconsolidation pressures($\sigma'$p) and overconsolidation ratio(OCR) estimated by empirical correlations and cone penetration tests were compared with those of laboratory odometer test results. Stress history of marine clay determined by odometer test results was in general overconsolidated at below 10m depth from the mudline, whereas marine clay at below l0m depth from the mudline which has an around 0.3 overconsolidation ratio showed variable stresses and unstable states. Preconsolidation pressures were computed by both empirical methods of the Chen and Mayne(1996) and theoretical method of Konrad and Law(1987). It is estimated that Chen and Mayne(1996)'s prediction method based on pore water pressure is more reliable than any other prediction methods, and their method proved to be the most reliable for overconsolidation ratio estimation. However, it is recommended that Mayne & Holtz(1988) and Mayne & Bachus(1988) methods are more suitable than any other methods for predicting the overconsolidation ratio at an underconsolidated (OCR<1) clay. For these reasons, rather than making use of existing prediction models, development of site specific empirical correlations which considers local characteristics and site conditions may be required due to different local stress history and variable soil properties.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.58 no.1
• /
• pp.61-71
• /
• 2016

This study performed the physical and mechanical experiment on the samples of costal marine clays individually collected in western and southern regions to identify the characteristics of western and southern costal marine clay. Based on the experiment result, the characteristics of costal marine clay is identified undrained shear strength. Based on the experiment result on the physical and mechanical characteristics of costal marine clays, the regression is presented that can analyze the mechanical characteristics of undrained shear strength in costal marine clay of Korea, region of Korea and western-southern region. The correlation of uniaxial compressive strength and undrained shear strength was suitable for use of western-southern region correlation equation. The test result of Jeonnam Yeosu area compares with prediction results of previous researchers formula and western-southern region formula. Prediction results appear highest reliability on the 0.827 of coefficient of determination in the prediction results of the western-southern region formula.