• Journal of Dental Rehabilitation and Applied Science
• /
• v.40 no.3
• /
• pp.142-148
• /
• 2024

Purpose: The purpose of this study was to investigate the accuracy of digital mounting with occlusal scans in the interocclusal record for a full-mouth fixed prosthetic treatment condition. Materials and Methods: The entire maxillary teeth were prepared in a dentiform model and attached to an articulator in maximum intercuspation. Temporary crowns were fabricated and occlusion was adjusted. After scanning the arch with tooth preparation, digital mounting was performed using an occlusion scan of the anterior or posterior teeth areas. The accuracy of the positioned jaw relation was evaluated three-dimensionally through positional deviation and angular error of the occlusal plane. Afterwards, the same procedure was repeated on the partially edentulous model to evaluate the accuracy of digital interocclusal record. Kruskal-Wallis test and Mann-Whitney U test were used for statistical analysis, and the significance level was set at 0.05. Results: There was no significant difference in the positional error at the center of the arch in the digitally established jaw relation depending on the scan area used and remaining tooth conditions (P = 0.53). The angular error of the occlusal plane was larger when the anterior teeth were used as the overlapping area, and a smaller error value was observed when both posterior teeth were used as the overlapping area (P < 0.001). Conclusion: The use of bilateral posterior occlusal scans is recommended when digitally mounting the jaw relation established with temporary teeth during full-mouth fixed prosthetic treatment.

• The korean journal of orthodontics
• /
• v.29 no.2 s.73
• /
• pp.267-276
• /
• 1999

Distributions trends were examined in 9159 malocclusion patients who had been examined and diagnosed at Department of Orthodontics, College of Dentistry Yonsei University over a 6 year-period from 1992 to 1997. The results were as follows ; 1. The total number of orthodontic patients in 1997 increased in comparing with that of 1992(86%) and after 1995, the number of annual patients showed an increase. 2. Age distribution had shown over-19 year-old group being the largest(39.9%) but percentages of pre-adolescent patients had been decreasing while that of adult patient had gradually increased. 3. Distributions in the types of malocclusion, the Angle's Classification had shown : 33.3% for Class I, 28.6% for Class II and the largest 38.1% for Class III. 4. Among Class I patients, crowding showed the largest(32.6%) and protrusion group had gradually increased to 33.9% in 1996. Otherwise openbite and crossbite groups tend to decrease, annually. 5. Geographic distribution showed a majority of patients from Seoul(above 70%). Among the patients from Seoul, group within the distance 3-6Km from Yonsei dental hospital was the largest(32.3%) and group within 9Km showed 69% of total patients.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.32 no.2
• /
• pp.229-235
• /
• 2005

A problem that affects children's dentitions is the harmful habit which is difficult to treat. Harmful habits for children are such as abnormal swallowing patterns, low/forward tongue rest posture problem, habitual open-lips resting posture, habitual mouth-breathing, excessive digital sucking habit and tongue thrusting. Tongue thrusting habits cause a bit of cranio-facial skeletal changes and a great deal of dental malocclusion such as anterior open bite. Anterior open bite causes masticatory, speech, and esthetic problems in the growing children and difficulties in diagnosis, treatment, and the prediction of its prognosis. The treatments of such abnormal behaviors involve orofacial myofunctional therapy and using of habit breaking appliance. The prognosis is not determined by the presence of severity of oral habit but the skeletal tendency of the patient. Usage of tongue crib resulted in not only the discontinuance of the habit but also improvement in overbite and overbite. This study showed that relatively successful results could be generated by using removable tongue crib and myofunctional therapy in the case of openbite related to tongue thrusting habit.

• Journal of Oral Medicine and Pain
• /
• v.31 no.4
• /
• pp.365-373
• /
• 2006

This study suggested correction of excessive mouth opening or maximum occlusal contact to analyse occlusal contact time, occlusal contact number and force through evaluation of occlusal pattern in policemen with temporomandibular disorders. The community of policemen influence on temporomandibular disorder's development and progress due to other condition of mouth opening and maximal occlusal contact. Repeated training or changes of usual life style may cause imbalance of stomatognathic system including the masticatory muscle, then develop or aggravate pain of temporomandibular joints and associated structures. This study uses T-scan II system(Tekscan Co., USA) for evaluation on occlusal pattern may influence temporomandibular disorders, and then the subjects take a sensor at 20 mm opening for maximal occlusal contact force. The policemen with temporomandibualr disorders get more long time on maximum contact timing, more short on end contact timing, and more force on end contact force than general society's. So they get closure of mouth with more short time and more force, then transfer remaining load to temporomandibular joint. There are no statistically significances between affected side and occlusal pattern of occlusal contact time and force. There are Left -right dental arch imbalances seems on Rt. dental arch if affected side is right and Lt. dental arch if affected side is left. In above results, It's worth due consideration that policemen with temporomandibular disorders get more smooth mandibualr movement and less force on maximal occlusal contact position.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.37 no.3
• /
• pp.157-170
• /
• 2021

Loss of posterior bite support might cause unstable occlusal relationship and when the mandible slides forward in the centric or habitual occlusion, excessive load is applied to the anterior region followed by causing the occlusal plane to collapse or leading to a decrease in occlusal vertical dimension. In addition, disorder of temporomandibular joint function may occur. The inter-dental arch discrepancy causes a mismatch in the vertical and horizontal overlap of the anterior and posterior regions. The deep bite in the anterior region and the scissor bite in the posterior region cause unstable occlusal contact and insufficient occlusal contact area. This report was to rehabilitate a patient with above-mentioned complex problems. Physiologic adaptation to increased vertical dimension and new occlusal plane were evaluated using provisional prostheses, and definitive prostheses was fabricated using cross-mounting technique. Stable occlusion, harmonious teeth overlap and adequate occlusal plane were established, so functionally and aesthetically satisfactory results are obtained.

• The Journal of Korean Academy of Prosthodontics
• /
• v.60 no.4
• /
• pp.420-430
• /
• 2022

Open bite is accompanied by decrease in tooth contact and overbite, and causes collapse of occlusal plane, mastication difficulties, speech disorders, changes in appearance, and lower occlusal force than normal. Open bite caused by temporomandibular joint disorder in adults with complete occlusion must be corrected after removal or stabilization of the causative factors. Orthodontic treatment, occlusal adjustment, prosthetic treatment, and surgical treatment can be the option of occlusal correction. This report describes about estimating the cause of occlusion change in two patients who developed an open bite due to mandibular displacement in adults with complete occlusion and different treatment approaches accordingly. In one patient, satisfactory result was obtained in functional and esthetic aspects through occlusal adjustment after stabilization of the temporomandibular joint.

• The Journal of Korean Academy of Prosthodontics
• /
• v.61 no.2
• /
• pp.160-178
• /
• 2023

Diagnosis and analysis of occlusal relationships are important factors in prosthetic treatment. A thorough occlusion analysis and evaluation should be performed before treatment to restore a stable interocclusal relationship. Analysis and evaluation are essential during the treatment process and at regular follow-ups. Recently, with the development of dental equipment and digital processing methods, new quantitative analysis methods that can record the patient's occlusal relationship have been introduced. Among them, the T-Scan Novus (Tekscan Inc., S. Boston, MA, USA) displays the strength of the initial contact point and the occlusal contact point of the teeth using a pressure sensor. With this, occlusal contact time of the teeth, anteroposterior and left-right balance of occlusal force can be compared. The Dental prescale II (GC Co., Tokyo, Japan) scans the occlusal contact point using a pressure-sensing film and analyzes the density of the contact point. It can measure the distribution and strength of the occlusal force of the teeth in the most natural occlusion state. Based on this, appropriate prosthetic treatment (four-unit fixed partial denture, removable partial denture, complete denture, and complete oral restoration cases) was performed according to the area and extent of the patient's tooth loss. The patient's occlusion at the first visit, treatment stage, right after treatment, and regular follow-up were compared and evaluated using a quantitative method for appropriate occlusion analysis using T-Scan Novus and Dental prescale II. This report enhances the understanding of occlusion analysis during prosthetic restoration. The results satisfied both the clinician and patients in terms of function and aesthetics.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.32 no.1
• /
• pp.1-7
• /
• 2016

Mastication is the process to help digestion by chewing or grinding food. Masticatory system consists of maxilla, mandible, temporomandibular joints, ligaments, dentitions, and musculatures. Assessing the bite force can be one of the methods to estimate the masticatory system. Bite force is influenced by facial morphology, age, sex, periodontal status, temporomandibular joint disorder and dental condition, and so forth. In general, higher maximum bite force is seen in those who have a square-shaped face and in male rather than female. In addition, bite force tends to be increased by age 20, maintained constantly until age 40 - 50, and then decreased. Periodontal disease is known as a causative factor for decreased bite force while temporomandibular disorder (TMD) remains controversial as to whether it affects the force. The status of teeth is considered as an important factor to determine the maximum bite force.

• The Journal of Korean Academy of Prosthodontics
• /
• v.33 no.2
• /
• pp.269-280
• /
• 1995

저작은 교합과 악운동 뿐만 아리라 근신경계, 고위 중추까지 복합적으로 관여하는 기능적 행위이다. 교합 양상은 다양하게 저작 형태에 영향을 끼치며 저작 효율에도 관여한다. 저작 형태는 다양한 모양을 가지나 두가지 전형적인 군 즉, 전방에서 관찰시 그 양상이 수직적이며 chopping운동을 닮은 군과 저작 형태가 주로 측방으로 이루어지며 grinding을 하는 군으로 나눌 수 있다. 본 연구의 목적은 저작 형태의 치아가 교합접촉 및 저작 효율에 미치는 영향을 고찰해 보고자 하는 것이다. 하악운동궤적기록기를 이용하여 정상교합을 가진 치과대학생중 전형적인 2가지 저작형태를 보이는 각 10명씩을 피검자로 선택하였다. 3가지 하악위 즉, 중심위, 작업측 비작업측에서의 교합접촉을 고무형 교합인기재로 기록하여 천공부의 직경이 1mm이하면 1점, 1-2mm또는 직선상이면 2점, 2mm이상이면 3점으로 평가하여 각 점수의 합으로 좌우 소구치 및 대구치의 접촉 지수를 측정하였다. 저작 효율을 평가하기 위해 땅콩 3g(${\pm}0.01g$)을 20회 저작하게 한 후 3회 입을 헹구어 뱉게 하였다. 체눈 크기가 각 0.425, 0.60, 0.85, 2.0, 4.0인 체에 거른 후 $65^{\circ}C$로 오븐에서 세시간 말려 무게를 측정하고 중심 크기$(M_{50})$과 저작효율치(R)를 계산 비교하여 다음과 같은 결론을 얻었다. 1. Chopping형은 grinding형에 비해 중심위에서 더 넓은 교합접촉을 보였다(P<0.01). 2. Grinding형은 chopping형에 비해 측방위에서 더 넓은 교합접촉을 보였다(P<0.01). 3. Chopping형은 중심크기($(M_{50})$)과 저작효율치(R)로 비교하였을 때 더 좋은 저작 효율을 보였다(P<0.01).

• The Journal of Korean Academy of Prosthodontics
• /
• v.58 no.2
• /
• pp.121-129
• /
• 2020

From the point of view of oral rehabilitation, the treatment of extensive tooth wear requires a prosthetic approach. Physiological tooth wear is considered as a normal process and generally does not require treatment, but excessive tooth wear causes problems like inadequate occlusion and esthetics. Changes of occlusal vertical dimension should be made through accurate diagnosis and analysis. Also, the patient's adaptation to the changed occlusal vertical dimension should be assessed over time. This case was a 60-year-old male patient who complained of a decrease in chewing function and esthetics due to severe tooth wear. Full-mouth rehabilitation was performed with a tooth supported fixed prosthesis. An occlusal stabilization splint and provisional restoration were used to evaluate the adaptation to increased occlusal vertical dimension and induce a stable centric relation position. After that, monolithic zirconia prosthesis was delivered. We report this as a satisfactory functional recovery and esthetics.