• Journal of the Korean Society of Marine Environment & Safety
• /
• v.14 no.2
• /
• pp.163-168
• /
• 2008

Ship detection from satellite remote sensing is a crucial application for global monitoring for the purpose of protecting the marine environment and ensuring marine security. It permits to monitor sea traffic including fisheries, and to associate ships with oil discharge. An automatic ship detection approach for RADARSAT Fine Synthetic Aperture Radar (SAR) image is described and assessed using in situ ship validation information collected during field experiments conducted on August 6, 2004. Ship detection algorithms developed here consist of five stages: calibration, land masking, prescreening, point positioning, and discrimination. The fine image was acquired of Ulsan Port, located in southeast Korea, and during the acquisition, wind speeds between 0 m/s and 0.4 m/s were reported. The detection approach is applied to anchoring ships in the anchorage area of the port and its results are compared with validation data based on Vessel Traffic Service (VTS) radar. Our analysis for anchoring ships, above 68 m in length (LOA), indicates a 100% ship detection rate for the RADARSAT single beam mode. It is shown that the ship detection performance of SAR for smaller ships like barge could be higher than the land-based radar. The proposed method is also applied to estimate the ship's dimensions of length and breadth from SAR radar cross section(RCS), but those values were comparatively higher than the actual sizes because of layover and shadow effects of SAR.

• Economic and Environmental Geology
• /
• v.53 no.6
• /
• pp.703-713
• /
• 2020

In many geological fields, including hydrogeology, it is of great importance to determine the heterogeneity of the subsurface media. This study briefly introduces the concept and theory of the method that can estimate the hydraulic properties of the media constituting the aquifer, which was recently introduced by Park (2020). After the introduction, the method was applied to the synthetic aquifer to demonstrate the practicality, from which various implications were drawn. The introduced technique uses a global optimization technique called the covariance matrix adaptation evolution strategy (CMA-ES). Conceptually, it is a methodology to characterize the aquifer heterogeneity by assimilating the groundwater level time-series data due to the imposed hydraulic stress. As a result of applying the developed technique to estimate the hydraulic conductivity of a hypothetical aquifer, it was confirmed that a total of 40000 unknown values were estimated in an affordable computational time. In addition, the results of the estimates showed a close numerical and structural similarity to the reference hydraulic conductivity field, confirming that the quality of the estimation by the proposed method is high. In this study, the developed method was applied to a limited case, but it is expected that it can be applied to a wider variety of cases through additional development of the method. The development technique has the potential to be applied not only to the field of hydrogeology, but also to various fields of geology and geophysics. Further development of the method is currently underway.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.24 no.2
• /
• pp.102-116
• /
• 2021

For the safe operation of autonomous vehicles, the representative technology of the 4^th industrial revolution era, a combination of various technologies such as sensor technology, software technology and car technology is required. An autonomous vehicle is a vehicle that recognizes current location and situation by using the various sensors, and makes its own decisions without depending on the driver. Perfect recognition technology is required for fully autonomous driving. Since the precise road maps provide various road information including lanes, stop lines, traffic lights and crosswalks, it is possible to minimize the cognitive errors that occur in autonomous vehicles by using the precise road maps with location information of the road facilities. In this study, the definition, necessity and technical trends of the precise road map have been analyzed, and the HD(High Definition) map prototype based on the web GIS has been built in the autonomous driving-specialized areas of Daegu Metropolitan City(Suseong Medical District, about 24km), the Happy City of Sejong Special Self-Governing City(about 33km), and the FMTC(Future Mobility Technical Center) PG(Proving Ground) of Seoul National University Siheung Campus using the MMS(Mobile Mapping System) surveying results given by the National Geographic Information Institute. In future research, the built-in precise road map service will be installed in the autonomous vehicles and control systems to verify the real-time locations and its location correction algorithm.

• Korean Journal of Remote Sensing
• /
• v.33 no.5_3
• /
• pp.855-866
• /
• 2017

Several research cases using remote sensing methods to analyze changes of storage and dynamics of groundwater aquifer were reviewed in this paper. The status of groundwater storage, in an area with regional scale, could be qualitatively inferred from geological feature, surface water altimetry and topography, distribution of vegetation, and difference between precipitation and evapotranspiration. These qualitative indicators could be measured by geological lineament analysis, airborne magnetic survey, DEM analysis, LAI and NDVI calculation, and surface energy balance modeling. It is certain that GRACE and InSAR have received remarkable attentions as direct utilization from satellite data for quantification of groundwater storage and dynamics. GRACE, composed of twin satellites having acceleration sensors, could detect global or regional microgravity changes and transform them into mass changes of water on surface and inside of the Earth. Numerous studies in terms of groundwater storage using GRACE sensor data were performed with several merits such that (1) there is no requirement of sensor data, (2) auxiliary data for quantification of groundwater can be entirely obtained from another satellite sensors, and (3) algorithms for processing measured data have continuously progressed from designated data management center. The limitations of GRACE for groundwater storage measurement could be defined as follows: (1) In an area with small scale, mass change quantification of groundwater might be inaccurate due to detection limit of the acceleration sensor, and (2) the results would be overestimated in case of combination between sensor and field survey data. InSAR can quantify the dynamic characteristics of aquifer by measuring vertical micro displacement, using linear proportional relation between groundwater head and vertical surface movement. However, InSAR data might now constrain their application to arid or semi-arid area whose land cover appear to be simple, and are hard to apply to the area with the anticipation of loss of coherence with surface. Development of GRACE and InSAR sensor data preprocessing algorithms optimized to topography, geology, and natural conditions of Korea should be prioritized to regionally quantify the mass change and dynamics of the groundwater resources of Korea.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.3 no.4
• /
• pp.199-205
• /
• 2001

This study was conducted to figure out temperature profiles of a partially developed paddy rice canopy, which are necessary to run plant disease forecasting models. Air temperature over and within the developing rice canopy was monitored from one month after transplanting (June 29) to just before heading (August 24) in 1999 and 2001. During the study period, the temporal march of the within-canopy profile was analyzed and an empirical formula was developed for simulating the profile. A partially developed rice canopy temperature seemed to be controlled mainly by the ambient temperature above the canopy and the water temperature beneath the canopy, and to some extent by the solar altitude, resulting in alternating isothermal and inversion structures. On sunny days, air temperature at the height of maximum leafages was increased at the same rate as the ambient temperature above the canopy after sunrise. Below the height, the temperature increase was delayed until the solar noon. Air temperature near the water surface varied much less than those of the outer- and the upper-canopy, which kept increasing by the time of daily maximum temperature observed at the nearby synoptic station. After sunset, cooling rate is much less at the lower canopy, resulting in an isothermal profile at around the midnight. A fairly consistent drop in temperature at rice paddies compared with the nearby synoptic weather stations across geographic areas and time of day was found. According to this result, a cooling by 0.6 to 1.2$^{\circ}C$ is expected over paddy rice fields compared with the officially reported temperature during the summer months. An empirical equation for simulating the temperature profile was formulated from the field observations. Given the temperature estimates at 150 cm above the canopy and the maximum deviation at the lowest layer, air temperature at any height within the canopy can be predicted by this equation. As an application, temperature surfaces at several heights within rice fields were produced over the southwestern plains in Korea at a 1 km by 1km grid spacing, where rice paddies were identified by a satellite image analysis. The outer canopy temperature was prepared by a lapse rate corrected spatial interpolation of the synoptic temperature observations combined with the hourly cooling rate over the rice paddies.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.6B
• /
• pp.589-598
• /
• 2010

When the hydraulic structures, such as bridge and weir, are consecutively installed to a short section of a river with complicated cross section, analyzing the flow characteristics and the riverbed change modality of the river is very important. In the 250 m section of the Taehwa river near the Samho-bridge, which passes through Ulsan city, three bridges has been installed, and the tributary water is flowing into both up and downstream of the section. Due to these factors, when the flood occurs, the cross section of the river changes vastly by the water level change and scour. Even so, due to the fact that the Samho-bridge divides the section into two parts, the national river and the regional river, each part is being analyzed separately by the onedimensional model. In this study, the flow characteristics due to the bridge concentration and the tributary water inflow were jointly analyzed for both up and downstream by using the one-dimensional HEC-RAS model and the two-dimensional SMS model, such as RMA2. The riverbed change modality of the section was also investigated by using the SED2D model. The results showed that the water level difference between the HEC-RAS and RMA2 was 0.87 m when applied to the three consecutive bridges. The riverbed change simulation using SED2D showed that the maximum scour was 0.231 m and it occurred at the Samho-bridge, which located in the middle and has short pier distance. In conclusion, when planning the river maintenance for the regions with concentrated bridges or the sections with severe changes in cross-section and flow, estimating the flood elevation by two-dimensional model and establishing countermeasures for the scouring of the bridge are required. In addition, an integrated analysis on both the national river and the regional river is necessary.

• Korean Journal of Remote Sensing
• /
• v.39 no.5_4
• /
• pp.1097-1109
• /
• 2023

Urban is an area where small-scale changes to individual buildings occur frequently. An existing urban building database requires periodic updating to increase its usability. However, there are limitations in data collection for building changes over a wide urban. In this study, we check the possibility of detecting building changes and updating a building database by using satellite images that can capture a wide urban region by a single image. For this purpose, building areas in a satellite image are first extracted by projecting 3D coordinates of building corners available in a building database onto the image. Building areas are then divided into roof and facade areas. By comparing textures of the roof areas projected, building changes such as height change or building removal can be detected. New height values are estimated by adjusting building heights until projected roofs align to actual roofs observed in the image. If the projected image appeared in the image while no building is observed, it corresponds to a demolished building. By checking buildings in the original image whose roofs and facades areas are not projected, new buildings are identified. Based on these results, the building database is updated by the three categories of height update, building deletion, or new building creation. This method was tested with a KOMPSAT-3A image over Incheon Metropolitan City and Incheon building database available in public. Building change detection and building database update was carried out. Updated building corners were then projected to another KOMPSAT-3 image. It was confirmed that building areas projected by updated building information agreed with actual buildings in the image very well. Through this study, the possibility of semi-automatic building change detection and building database update based on single satellite image was confirmed. In the future, follow-up research is needed on technology to enhance computational automation of the proposed method.

• Korean Journal of Remote Sensing
• /
• v.27 no.5
• /
• pp.613-623
• /
• 2011

This study assessed the feasibility to apply Two-band and Three-band reflectance models for chlorophyll-a estimation in turbid productive waters whose scale is smaller and narrower than ocean using a high spatial resolution image. Those band ratio models were successfully applied to analyzing chlorophyll-a concentrations of ocean or coastal water using Moderate Imaging Spectroradiometer(MODIS), Sea-viewing Wide Field-fo-view Sensor(SeaWiFS), Medium Resolution Imaging Spectrometer(MERIS), etc. Two-band and Three-band models based on band ratio such as Red and NIR band were generally used for the Chl-a in turbid waters. Two-band modes using Red and NIR bands of RapidEye image showed no significant results with $R^2$ 0.38. To enhance a band ratio between absorption and reflection peak, We used red-edge band(710 nm) of RapidEye image for Twoband and Three-band models. Red-RE Two-band and Red-RE-NIR Three-band reflectance model (with cubic equation) for the RapidEye image provided significance performances with $R^2$ 0.66 and 0.73, respectively. Their performance showed the 'Approximate Prediction' with RPD, 1.39 and 1.29 and RMSE, 24.8, 22.4, respectively. Another three-band model with quadratic equation showed similar performances to Red-RE two-band model. The findings in this study demonstrated that Two-band and Three-band reflectance models using a red-edge band can approximately estimate chlorophyll-a concentrations in a turbid river water using high-resolution satellite image. In the distribution map of estimated Chl-a concentrations, three-band model with cubic equation showed lower values than twoband model. In the further works, quantification and correction of spectral interferences caused by suspended sediments and colored dissolved organic matters will improve the accuracy of chlorophyll-a estimation in turbid waters.

• Journal of Environmental Policy
• /
• v.13 no.1
• /
• pp.69-93
• /
• 2014

The aim of this research was to develop a climate change vulnerability index at the district level (Si, Gun, Gu) with respect to the health care sector in Korea. The climate change vulnerability index was esimated based on the four major causes of climate-related illnesses : vector, flood, heat waves, and air pollution/allergies. The vulnerability assessment framework consists of six layers, all of which are based on the IPCC vulnerability concepts (exposure, sensitivity, and adaptive capacity) and the pathway of direct and indirect impacts of climate change modulators on health. We collected proxy variables based on the conceptual framework of climate change vulnerability. Data were standardized using the min-max normalization method. We applied the analytic hierarchy process (AHP) weight and aggregated the variables using the non-compensatory multi-criteria approach. To verify the index, sensitivity analysis was conducted by using another aggregation method (geometric transformation method, which was applied to the index of multiple deprivation in the UK) and weight, calculated by the Budget Allocation method. The results showed that it would be possible to identify the vulnerable areas by applying the developed climate change vulnerability assessment index. The climate change vulnerability index could then be used as a valuable tool in setting climate change adaptation policies in the health care sector.

• Journal of dental hygiene science
• /
• v.10 no.3
• /
• pp.147-153
• /
• 2010

The purpose of this study was to investigate the correlation between food intake pattern body component bone mineral density(BMD) and dental caries experience of college women and we wanted to determine the correlation of these factors with dental caries experience. Research was conducted to offer basic data to develope a nutritional program for the future prevention from oral disease. The subjects in this study were 132 college women who participated in the food intake survey and who's body component and BMD was measured. The statistical analysis was done by using the SPSS 15.0 program. The results of this study were as follows; 1. The food intake pattern was not directly correlated with DMFT index. 2. The body component was not directly correlated with DMFT index. 3. The SOS, BQI was directly correlated with DMFT index(p<0.05). 4. T-score of BMD had the greatest influence on DMFT index(p<0.05). Above results indicated that bone mineral density are related with the incidence of dental caries experience and further research is necessary to develop a nutritional and health promotional program in order to prevent oral illness.