• Korean Journal of Remote Sensing
• /
• v.26 no.2
• /
• pp.123-131
• /
• 2010

In this paper we applied Ground-Based Synthetic Aperture Radar(GB-SAR) interferometry to detect artificial displacement of a reflector and performed an atmospheric humidity correction to improve the accuracy. A series of GB-SAR images were obtained using a center frequency of 5.3 GHz with a range resolution of 25 cm and a azimuth resolution of $0.324^{\circ}$, all in full-polarization (HH, VV, VH, HV) modes. A triangular trihedral corner reflector was located 160 m away from the system, and the artificial displacements of 0-40 mm was implemented during the GB-SAR image acquisition. The result showed that the RMS error between the actual and measured displacements, averaged in all polarization data, was 1.22 mm, while the maximum error in case of the 40 mm displacement was 2.72 mm at HH-polarization. After the atmospheric correction with respect to the humidity, the RMS error was reduced to 0.52 mm. We conclude that a GB-SAR system can be used to monitor the possible displacement of artificial/natural scatterers and the stability assessment with sub-millimeter accuracy.

• Journal of the Mineralogical Society of Korea
• /
• v.25 no.1
• /
• pp.41-50
• /
• 2012

페루 남동부 지역에 위치한 꾸스코 동-금을 포함한 다중금속 광상 지역의 지질은 고생대 페름기-중생대 삼첩기 변성퇴적암인 미투(Mitu)층군과 이를 관입한 동시기 관입암으로 구성되어 있다. 조사지역은 페름기-삼첩기 관입암과 관련된 U-W-Sn-Mo, Au-Cu-Pb-Zn, REE 광화작용과 관련된 금속광화 대로 알려져 있다. 특히 해당 관입암은 대자율 측정 결과 S-type, 티탄철석계열과 관련이 있는 것으로 보인다. 꾸스코 지역은 깔까 북쪽과 시꾸아니 부근에 주요 광화대가 발달하고 있다. 조사대상 광상은 아줄 동, 올미오 동, 빅토리아 금, 빠딴자 동, 나우챠피-초차까나 동, 체카 금광상이다. 아줄 광상의 모암은 안산암질암이며 광석광물로는 반동석 및 황동석이 산출하며, 동은 7.81~15.3%의 범위를 가지고 평균 10.7%이다. 올미오 광상의 모암은 흑색편암이며 엽리를 따라 산화동이 충진되어 있고, 동은 0.61~2.60%의 범위를 가지고 평균 1.74%이다. 빅토리아 광상의 모암은 변성퇴적암이며, 석영맥 충진형 광상으로 금함량은 < 0.1 g/t, 은함량은 < 0.1~< 0.3 g/t이다. 빠딴자 광상에서는 이암 또는 실트암의 층리를 따라 충진하고 있는 산화동이 산출하며, 동은 3.74~9.21%의 범위를 보이며 평균 6.21%이다. 나우챠피-초차까나 광상은 적색사암의 층리를 교대충진하고 있는 산화동 광체이며, 동은 1.62~10.5%의 범위를 가지며 평균 6.39%이다. 체카 광상은 모암인 규암이 각력화작용을 받은 부분에서 금이 산출되고 있는 것으로 보고되어있으나 분석결과 금이 탐지되지는 않았다.

• Geophysics and Geophysical Exploration
• /
• v.8 no.1
• /
• pp.112-117
• /
• 2005

Geophysical logging is routinely undertaken as part of most coal mine exploration programs. Currently, the main application for the logs is to determine coal seam depth and to qualitatively estimate coal quality, lithology, and rock strength. However, further information can be obtained, if quantitative log interpretation is made. To assist in the uptake of quantitative interpretation, we discuss log responses in terms of the mineralogy of the clastic sedimentary rocks frequently found in the Australian black coal mining areas of the Sydney and Bowen Basins. We find that the log responses can be tied to the mineralogy with reasonable confidence. Ambiguities in the interpretation will be better resolved if a full suite of logs is run. A method for checking for internal consistency, by comparing calculated and observed velocities, is also described. A key driver for quantitative interpretation is geotechnical characterisation. We propose a classification system for clastic rocks that takes into consideration physical rock properties that can be inferred from geophysical logs.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.9
• /
• pp.17-24
• /
• 2020

This study examined the spectral information and reflectance of cracks of an embankment with drone-based hyperspectral imagery for crack detection. A Nano-Hyperspec mounted on a drone was used as a sensor, and hyperspectral videos of different intensities of illumination of the cracks on the embankment located in the downstream of Andong-Dam were obtained. An analysis of the data value of the illumination and peak data-value, the coefficients of determination were calculated to be 0.9864 of the uncracked areas and 0.9851 of the cracked area. The reflectance of each area showed a similar value and pattern, regardless of the intensity of illumination. This result may have occurred because the reference values of the white reference as the calculation criteria of reflectance varied according to the intensity of illumination. The reflectance at the cracked area was 5.65% lower in visible light and 4.58% lower in near-infrared light than that at the uncracked area. The detection of cracks may offer more precise results in further studies when the gimbal direction and camera angles of the drone are calibrated. Because hyperspectral imagery enables the detection of crack depths and types of clay minerals, which are difficult to identify in general RGB imagery, it can serve as a preemptive measure for evaluating the embankment stability.

• Analytical Science and Technology
• /
• v.16 no.5
• /
• pp.1041-1051
• /
• 2003

Neutron induced prompt gamma activation analysis (PGAA) offers a nondestructive, sensitive and relatively rapid method for the determination of trace and major elements and is proven to be convenient for online analysis of minerals, metals, coal, cement, petrochemical, coating, paper as well as many other materials and products. The technique has found many uses in medicine, industry, research, security and the detection of contraband items. This report reviews the present status and future trends of the PGAA techniques. Requirements for the system are neutron source, high resolution HPGe detectors with a high-voltage power supply, an amplifier, analog-to-digital converter, and a multichannel analyzer for the detection and measurement of prompt ${\gamma}$-ray emit form the neutron capture elements. Introducing a ${\gamma}$-${\gamma}$ coincidence system also improves the quality of the ${\gamma}$-ray spectrum by suppressing the background created from the Compton scattering of high energy prompt ${\gamma}$-rays. A PGAA system using a $^{252}Cf$ neutron source is currently under construction for the on-line measurement of several elements in aqueous samples at KAERI. The system can be applied for the detection of chemical weapons and explosives as well as various narcotics.

• Geophysics and Geophysical Exploration
• /
• v.4 no.4
• /
• pp.124-132
• /
• 2001

Electrical resistivity survey has been conducted for delineating geological fault structure in Kaekok-ri near Kyungju. In general, electrical resistivity survey has an advantage of searching buried faults and its traces compared with other geophysical survey methods. Distribution of electrical conductivity in the ground is influenced by the ratio of pores, groundwater and clay minerals. These properties are evidenced indirectly to explain for weathering condition, faults and fracture Bones. Thus the electrical resistivity survey can be an effective method to find buried faults. We have carried out two dimensional (2-D) interpretation by means of smoothness-constrained least-squares and finite element method. Field data used in this paper was acquired at Kaekok-ri, Wuedong-eup, Kyungju-si, where is Ulsan Fault and is close to the region in which debatable quaternary fault traces were found recently. The dipole-dipole array resistivity survey which could show the 2-D subsurface electrical resistivity structure, was carried out in the area with three lines. The results showed good property of fault, fracture zone and fault traces which we estimated were congruous with the results. Through this study, 2-D electrical resistivity survey interpretation for fault is useful to apply.

• Economic and Environmental Geology
• /
• v.26 no.2
• /
• pp.167-174
• /
• 1993

Limited geochemical components have been detected in fluid inclusions from ore deposits in south Korea by non-destructive and destructive analytical methods. Review of fluid inclusion studies display that the homogenization temperatures and salinities are in direct proportion. W and Cu ore deposits tend to show higher homogenization temperatures and salinities than Au ore deposits. Abundant halite-bearing fluid inclusions from the Eonyang Granite producing precious amethyst crystals may indicate that the initial fluid originated from magma is highly saline as shown by the quartz from the granite. Raman Laser microprobe detected $CO_2$, $N_2$ and $CH_4$ in a gold deposit, while these components are hardly detected from other deposits, even though destrucive analysis has dectected $CO_2$, $N_2$, $CH_4$, $H_2S$, and $SO_2$ from most of ore deposits. Individual fluid inclusion shows quite different components. These results suggest that large numbers of fluid inclusions should be analysed by Raman Laser microprobe to gain reliable data. Halite-bearing inclusion is hardly found in fluid inclusions from epithermal gold deposits in south Korea. Geochemistry, homogeinzation temperature and salinity of fluid inclusions may be useful to apply for exploration to find a concealed orebody.

• Geophysics and Geophysical Exploration
• /
• v.10 no.4
• /
• pp.322-331
• /
• 2007

In this study, electrical resistivity tomography (ERT) were conducted to find the mineralized zone at the Geumpung mine in Dojeon-ri, Susan-myeon, Jecheon-si, Chungcheongbuk-do. The deviation of the inclined borehole was measured to obtain the exact positions of the electrodes for correcting apparent resistivity values from ERT. Geophysical loggings such as resistivity and natural gamma were conducted to obtain the properties of the material near the borehole. Measurements of the physical properties of the cores, such as porosity, water content, density, susceptibility, resistivity were performed to analyze the correlation between physical properties and resistivity. Grade analysis for core sample was also conducted to identify relationship between grade and resistivity. Rock property analysis shows that the resistivity is more dominated by susceptibility and grade than by porosity and water content in the mineralized zone. The results of ERT are well consistent with geophysical logging data and geologic column. So ERT is powerful method to identify conductive mineralized zone.

• Korean Journal of Remote Sensing
• /
• v.21 no.4
• /
• pp.341-369
• /
• 2005

Hyperspectral images have emerged as a new and promising remote sensing data that can overcome the limitations of existing optical image data. This study was designed to provide a comprehensive review on definition, data processing methods, and applications of hyperspectral data. Various types of airborne, spaceborne, and field hyperspectral image sensors were surveyed from the available literatures and internet search. To understand the current status of hyperspectral remote sensing technology and research development, we collected several hundreds research papers from international journals (IEEE Transactions on Geoscience and Remote Sensing, International Journal of Remote Sensing, Remote Sensing of Environment and AVIRIS Workshop Proceedings), and categorized them by sensor types, data processing techniques, and applications. Although several hyperspectral sensors have been developing, AVIRIS has been a primary data source that the most hyperspectral remote sensing researches were relied on. Since hyperspectral data have very large data volume with many spectral bands, several data processing techniques that are particularly oriented to hyperspectral data have been developed. Although atmospheric correction, spectral mixture analysis, and spectral feature extraction are among those processing techniques, they are still in experimental stage and need further refinement until the fully operational adaptation. Geology and mineral exploration were major application in early stage of hyperspectral sensing because of the distinct spectral features of rock and minerals that could be easily observed with hyperspectral data. The applications of hyperspectral sensing have been expanding to vegetation, water resources, and military areas where the multispectral sensing was not very effective to extract necessary information.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2005.09a
• /
• pp.21-36
• /
• 2005

Although the main geology of Korea consists of granite and gneiss, it Is not uncommon to encounter anisotropy Phenomena in crosshole radar tomography even when the basement is crystalline rock. To solve the anisotropy Problem, we have developed and continuously upgraded an anisotropic inversion algorithm assuming a heterogeneous elliptic anisotropy to reconstruct three kinds of tomograms: tomograms of maximum and minimum velocities, and of the direction of the symmetry axis. In this paper, we discuss the developed algorithm and introduce some case histories on the application of anisotropic radar tomography in Korea. The first two case histories were conducted for the construction of infrastructure, and their main objective was to locate cavities in limestone. The last two were performed In a granite and gneiss area. The anisotropy in the granite area was caused by fine fissures aligned in the same direction, while that in the gneiss and limestone area by the alignment of the constituent minerals. Through these case histories we showed that the anisotropic characteristic itself gives us additional important information for understanding the internal status of basement rock. In particular, the anisotropy ratio defined by the normalized difference between maximum and minimum velocities as well as the direction of maximum velocity are helpful to interpret the borehole radar tomogram.