• Korean Journal of Cognitive Science
• /
• v.10 no.3
• /
• pp.17-28
• /
• 1999

Systematic distortions in perceived 3-D shape were obtained for elliptical and parabolic stereoscopic surfaces viewed at different distances under full and reduced cue conditions. In both conditions of Experiments 1 and 3, elliptical hemi-cylinders a appeared near veridical at the 45 cm viewing distances and flattened up to 74% of veridical at 135 cm. In Experiment 2, under full cue conditions, parabolic hemi-cylinders a appeared stretched to 118% of veridical at 45 cm, near veridical at 90 cm, and flattened to 85% of veridical at 135 cm. Under reduced cue conditions parabolas appeared flatter overall: veridical curvature was obtained at 45 cm viewing distance with flatness increasing to 68% of veridical at 135 cm. Results support a scaling explanation of perceived 3-D shape from disparity and rule out the alternative hypothesis that disparity curvature, an optical invariant, provides information for the direct perception of 3-D s shape.

• Science of Emotion and Sensibility
• /
• v.21 no.4
• /
• pp.91-102
• /
• 2018

Although accurate time perception is necessary to properly respond to the environment, it was discovered that non-temporal features also affect time perception. Previous studies have identified various factors that affect time perception, but there was no attempt to directly investigate the possible effects of the distance between participants and the stimuli on time perception. The current study examined the effects of viewing distance on time perception, by considering the retinal, physical, and perceived size of the stimuli. The viewing distance had no effect when either the physical size or the perceived size of the stimulus was the same. Viewing distance was found only to have an effect when the retinal size of the stimulus was the same. This effect might be a size effect rather than a distance effect because as the viewing distance increases the size should also increase to maintain the retinal size. These results imply that temporal perceptual constancy is preserved irrespective of the viewing distance, when distance information is not limited.

• Science of Emotion and Sensibility
• /
• v.25 no.1
• /
• pp.79-90
• /
• 2022

IThe perception of sub-second duration through the visual sensory system is affected by non-temporal characteristics (factors other than the duration of the stimulus). However, studies have shown that if distance information is abundant and size constancy maintained, the duration of the target is constantly perceived. The current study examined the relationship between size and time perception constancy in a three-dimensional environment with limited distance information. A device was constructed to limit the participants' bilateral and monocular cues. This prevented participants from maintaining size constancy, resulting in size illusions that could not accurately perceive physical size. In Experiment 1, the size of the physical stimulus of reference and test stimuli were the same at all viewing distances. The results suggest that, despite the same physical size, stimuli with close observations were perceived to be greater and lasted longer. In Experiment 2, the retinal size of the reference stimuli and test stimuli was controlled equally at all viewing distances. As a result, although the physical size of the stimuli increased as the observation increased, the perceived size of all the stimuli was the same. Therefore, the duration of the target was constantly perceived at all viewing distances. The results of this study demonstrate that even when distance information is limited, time perception is affected by the perceived size of the object. It also suggests that when rich distance information exists, the duration of the object can be constantly perceived even if the observation distance varies.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2007.11a
• /
• pp.41-41
• /
• 2007

타겟-모재간 거리를 변수로 하여 마그네트론 스퍼터링법에 의해 CrN 박막을 합성하고 미세구조 및 물성을 평가하였다. 타겟-모재간 거리 85mm 및 180mm에서 CrN 박막을 합성하였으며, 합성된 코팅막의 내식 특성을 평가하기 위해 양극분극시험을 수행하였다. 타겟-모재간 거리 변화에 따른 미세구조 변화를 관찰하기 위해 주사전자현미경을 이용하여 박막의 파단면 조직을 관찰하였으며, XRD 분석을 통해 상천이 거동을 관찰하고 이를 물성 결과와 비교 분석하였다.

• Science of Emotion and Sensibility
• /
• v.24 no.4
• /
• pp.17-28
• /
• 2021

The purpose of the research was to examine the effect of field of view on egocentric distance perception in the real and virtual environment. The replica that mimicked the real environment condition was used to create the virtual environment condition. We manipulated field of view levels equally in both viewing conditions using glasses that limit the field of view in real-world conditions and limiting the field of view in virtual-world conditions in a manner equivalent to real-world conditions via HMD. Eighteen participants observed the target with a limited field of view in a real and virtual environment without head movement. Then, we measured perceived distance using the timed imagined walking method, which measures the time taken by each participant to mentally walk to the target. The target was shown three times at three different distances from the participants: 3, 4, and 5 m. For the analysis, we converted time estimates into distance estimates. Consequently, the estimated distance in the virtual environment condition was less than the estimated distance in the real environment condition. And as the field of view shrank, the estimated distance also decreased. The estimated distance did not vary with field of view levels in real-world conditions. In the virtual environment, the estimated distance decreased as the field of view decreased, whereas in the real environment, the estimated distance increased. The implications of the results and some future research directions are discussed below.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2016.11a
• /
• pp.162-162
• /
• 2016

비전도체를 피도금체로 하여 전기 도금을 하는 경우 우선 피도금체 상에 시드 층을 형성 시키고 이후 여러 번의 전기도금을 거치게 된다. 이때 접점의 위치와 전류 인가 방법은 도금 특성에 영향을 미치게 된다. 이를 고찰하기 위하여 접점간 거리에 따른 도금 두께 분포 계산을 하였다. 본 연구에서는 도금 분포 계산을 위해 Elsyca社의 PlatingMaster를 사용하였다. 방향별 도금 두께 분포의 변화를 극명하게 관찰하기 위하여 종횡비 10:1로 음극과 양극 모델링을 하였고 접점의 개수는 1 ~ 3개, 접점의 위치는 10 mm 간격으로 이동하는 것을 변수로 하였다. 피도금체의 시드 층은 니켈 층으로 두께 $0.4{\mu}m$로 설정하고 유산동 도금 용액을 이용하여 용액 데이터베이스 측정하고 반영하였다. 계산을 위한 전류 밀도는 $50mA/cm^2$, 도금시간은 10분으로 모든 모델에서 동일하게 적용하였다. 도금이 성장한 면의 두께를 폭과 길이 방향으로 비교 관찰한 결과 전극간의 거리는 시드 층이 얇을수록 두께 분포에 큰 영향을 미쳤다. 하지만 하지 도금 층의 두께가 충분히 두꺼운 경우 전극간의 거리는 큰 영향을 미치지 않는다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11B
• /
• pp.1320-1327
• /
• 2009

In stereoscopy using stereo camera system, the representative factors inducing stereoscopic depth distortions have been reported such as the inter camera distance, the convergence angle and the depth resolution. The image distance is just known to us as a factor related in optical system. In a point of view of depth distortion, it will be a factor inducing a stereoscopic depth distortion. In this paper, we focused on the proof of our opinion that the image distance is one of the weighted factors inducing depth distortion under orthostereoscopic condition.

• School Mathematics
• /
• v.18 no.4
• /
• pp.881-901
• /
• 2016

This study is about investigating students' recognition and expression on relationship of 'time, distance, speed' via teaching experiment. In this process, students showed not only a change in perception of the relationship of 'time, distance, speed' but also recognizing the average speed as a viewpoint of the slope of the line connecting the end points of the interval in the distance function as well as another way of perceiving average speed of a height of a rectangle. In this process, the study shows the scene of expanding the relation of 'distance = time ${\times}$ speed' to 'distance = time ${\times}$ average speed', and also the student who makes the continuous reasoning shows the possibility of constructing a new function that can explain the change of the primitive function by allocating the average rate of change to the interval. Although this study was conducted with a limited number of students, this study suggests some implications through the observation of relationship of 'time, distance, speed' the students'. We hope that these results will be the starting point for various studies for constructing the integral learning model in the future.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.256-257
• /
• 2003

반도체 와이어 본딩(wire-bonding) 조립공정에 사용되는 검사용 현미경 광학계를 설계하였다. 이러한 와이어는 리드프레임에 대해 $\pm$ 1 mm의 단차를 가진다. 이 때 리드프레임은 6배로 관찰하며, 와이어 부분은 2배로 관찰하고자 한다. 그러나 와이어의 단차로 인해 물체거리가 변하게 되며, 일반 광학계로는 배율도 변하게 된다. 물체거리가 변해도 동일한 배율을 가지는 광학계를 설계하기 위해 유한 물점용 3군 줌 광학계를 목적에 맞게 변형시켰다. (중략)

• Korean Journal of Optics and Photonics
• /
• v.7 no.1
• /
• pp.9-16
• /
• 1996

We perform computer simulations of a lenticular autostereoscopic display system and obtain two one-dimensional intensity distributions seen by the left and right eyes of the observer, respectively. Our result shows that the lens period should be smaller than the LCD pixel period as the observer moves closer to the system. We obtain the values of the system parameters for which the intensity distributions are uniform across the lenticular lens array. We also obtain the system crosstalks which represent the right pixel image seen by the left eye and the left pixel image seen by the right eye. Our simulation also shows that the crosstalk increases as the observer moves away from the lenticular system.