• Journal of Bio-Environment Control
• /
• v.18 no.3
• /
• pp.225-231
• /
• 2009

'Nokkwang' green pepper plants were grown in soil system (silty loam with pH 6.5) under the greenhouse, to determine the effects of subsurface drip irrigation (SDI) and subsurface drip irrigation plus aeration (SDIA) into root zone comparing with conventional surface drip irrigation (DI) in terms of water use efficiency, soil properties, and growth and fruit yield. Two drip lines per crop row were layed on the soil surface in DI system, buried at a depth of 20cm below the soil surface in SDI system, and also buried at a depth of20cm below the soil surface and aerated for 3minutes a hour during the daytime ($08:00{\sim}19:00$) by a air compressor in SDIA system. A automatic irrigation with starting point of -20kPa and ending point of -10kPa based on soil moisture contents was applied by controllers and electronic vacum soil moisture sensors. Reduction in soil moisture contents was delayed in SDI and SDIA, compared to DI. Irrigation amount applied in pepper cultivation was around 30% less in SDI than in DI. Electric conductivity and nitrate nitrogen content in the surface soil grown green pepper were significantly lowered in SSDI and SDIA, compared to DI. Better development of root system was observed in SDIA and SDI than in DI. Results showed that pepper fruit yield increased by 30% in SDIA and 22% in SDI in comparision with DI.

• Journal of Bio-Environment Control
• /
• v.9 no.3
• /
• pp.151-155
• /
• 2000

In order to investigate the optimum irrigation point by soil water tension in oriental melon grown in plastic greenhouse during low temperature season, irrigation points from 10 days before fruiting to 10 days before harvesting were examined with 10, 20, 30 and 50 kPa, respectively. Total amount of water applied was 92.5mm at 10kPa but not irrigated at 50kPa due to the unreach of irrigation point. Fruit weight increased with increased soil water content; it was 456g at 10kPa but 324g at 50kPa. While marketable yield of fruit was lowest at 10 kPa due to increased fermented fruit. Sugar content in fruit was highest at 30 or 50 kPa but lowest at 10kPa. As a result, for higher sugar content and marketable yield, the recommended irrigation point is 30kPa of soil water tension.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2018.10a
• /
• pp.118-118
• /
• 2018

• Horticultural Science & Technology
• /
• v.32 no.4
• /
• pp.448-453
• /
• 2014

Influences of shading and irrigation in summer hot pepper cultivation on the plant growth and mesophyll tissue were investigated. Hot pepper plants were exposed to three shade levels (0, $30{\pm}5$ and $80{\pm}5%$) and irrigated or non-irrigated in greenhouse condition. Plant height and leaf area were highest in 30% shading and stem diameter and fresh and dry weights were highest in no shading. Plant growth was better in rain shelters with irrigation than in those without irrigation. The numbers of hot pepper fruits in the beginning of harvest were 49 in rain shelters without irrigation and shading, 22 in those with irrigation and without shading, 5 in those without irrigation with 30% shading, and 1 in those with irrigation and 30% shading. However, 80% shading showed lowest flower number and flower abscission, resulting in no fruit set, regardless of irritation. This is because carbohydrate translocation from leaves to reproductive organs may be not enough for developing fruits due to the lack of sunlight. The yield of hot pepper tended to be higher in rain shelter with irrigation than in those without irrigation. In optical microscopy observation, the thickness and development of mesophyll tissues decreased as increasing the degree of shading but no effect of irrigation on mesophyll tissues was observed. When stomata were observed with scanning electron microscope (SEM), the shape of stomata was normal but tissues surrounding stomata were slightly wrinkled in plants grown under 30% shading. The large number of abnormal stomata and wrinkled leaves was observed among plants grown in rain shelters with 80% shading. In plants grown in rain shelters without irrigation, tissues surrounding stomata were wrinkled and 10-20% decrease in the number of stomata was observed. Therefore, in hot pepper cultivation in summer with high temperature, shading was not effective for fruit yield and mesophyll tissue development; if shading is unavoidable, high degree of shading is not advisable. Further studies are needed for appropriate cultivar selection and environment-control techniques in hot pepper cultivation in summer with high temperature.

• Research in Plant Disease
• /
• v.14 no.2
• /
• pp.85-89
• /
• 2008

Clubroot of Chinese cabbage, caused by Plasmodiophora brassicae, is one of the most serious plant diseases in the world. The objectives of this study were to investigate the effect of the irrigation times on the development of club root after planting and to evaluate the effect of clubroot disease on yield of chinese cabbage in pot and field. The clubroot disease gradually increased with increasing irrigation frequency after planting. The growth characters and yield of chinese cabbage by irrigation times varied according to soil moisture and clubroot disease severity. Based on marketable yield and control value, an ideal irrigation point was at the soil matric potential of 0.06 MPa. These results suggest that the suppression on clubroot disease development could be achieved by initially reduced irrigation times after planting. Future studies on irrigation times using fungicide treatment and resistant cultivar under natural field conditions are required to improve the control effect of clubroot.

• Journal of Bio-Environment Control
• /
• v.29 no.4
• /
• pp.399-405
• /
• 2020

Recently, it is difficult to produce uniform scions and rootstocks with high quality in a greenhouse due to weather extremes. The closed transplant production system is useful for producing scions and rootstocks with desirable morphological characteristics by environment control regardless of weather outside. In this study, we investigated transpiration rates and growth of cucumber and tomato scions and rootstocks grown under different light intensity conditions for precise irrigation control in a closed transplant production system. Hanging system to measure continuously the weight of plug tray consisting of seedlings and substrate with load-cell was installed in each growing bed. Using this system, we confirmed initial wilting point of cucumber and tomato seedlings, and conducted subirrigation when moisture content of substrate was not below 50%. The irrigation time of cucumber scions and rootstocks were 7 and 6 days after sowing, respectively. In tomato scions and rootstocks grown under PPF (photosynthetic photon flux) 300 μmol·m^-2·s^-1, the irrigation time were 5, 8, 11, and 13 days after sowing. Increasing light intensity increased transpiration rates and differences of transpiration rates by light intensity was higher in tomato seedlings. The growth of cucumber and tomato seedlings was promoted by increasing light intensity, especially, hypocotyl elongation and stem thickening was affected by light intensity. Cumulative transpiration rate of plug tray in cucumber and tomato seedlings was increased by increasing light intensity, and daily transpiration rate per seedling was regressed by 1st-order linear equation with high correlation coefficient. Estimation of transpiration rates by weighing continuously plug tray of vegetable seedlings can be useful to control more accurately irrigation schedule in a closed transplant production system.

• Journal of Bio-Environment Control
• /
• v.18 no.4
• /
• pp.309-315
• /
• 2009

Maintenance of adequate soil water content during the period of crop growth is necessary to support optimum plant growth and yields. A better understanding of soil water movement for precision irrigation would allow efficient supply of water to crops, thereby resulting in minimization of water drainage and contamination of ground water. This research reports on the characterization of spatial and temporal variations in water contents through three different textured soils, such as loam, sandy loam, and loamy sand, when water is applied on the soil surface using an one-line drip irrigation system and the soils are dried after the irrigation stops, respectively. Water contents through each soil profile were continuously monitored using three Sentek probes, each consisting of three capacitance sensors at 10, 20, and 30cm depths. Spatial variability in water content for each soil type was strongly influenced by soil textural class. There were big differences in wetting pattern and the rate of downward movement between loam and sandy loam soils, showing that the loam soil had a wider wetting pattern and a slower rate of downward movement than did the sandy loam soil. The wetting pattern in loamy sand soil was not apparent due to a low variability in water content (< 10%) by a lower-water holding capacity as compared to those measured in the loam and sandy loam soils, implying that the rate of water drainage below a depth of 30cm was high. When soils were dried, there were highly exponential relationships between water content and time elapsed after irrigation stops ($r^2$${\geq}$0.98). It was estimated that equilibrium moisture contents for loam, sandy loam, and loamy sand soils would be 17.6%, 6.2%, and 4.2%, respectively.

• Horticultural Science & Technology
• /
• v.19 no.4
• /
• pp.579-584
• /
• 2001

This experiment was conducted to investigate the effect of soil moisture content on cut flower quality of Gypsophila paniculata L. 'Bristol Fairy' in spring and autumn cultivations. The soil moisture potential (SMP) set point for irrigation was either -3.2 or -10.0kPa in the vegetative growth stage, and -10.0, -31.6, or -79.4kPa after the budding stage. When soil moisture reached at each set SMP point, 10 mm water was drip-irrigated. Tendency of flowering was earlier as SMP set point was lower in both vegetative growth and after budding stages. No other flower characteristics were found among other treatments. In both spring and autumn cultivations, as SMP set point was lower, the low primary branch length and upper internode length were decreased, the stem firmness was increased, and curvature of cut flower stem was decreased. Especially, in autumn, the higher the SMP set point, the higher the low primary branch than the apex, thus the paniculate inflorescence was deeply destroyed. Yield in spring cultivation was not significantly different among treatments, while that in autumn cultivation increased as the lower the SMP value. It is thought that optimal imgation points during vegetative growth and after budding stages to produce high quality cut flowers are -10.0 and -79.4kPa, respectively.

• Journal of Bio-Environment Control
• /
• v.33 no.2
• /
• pp.114-119
• /
• 2024

Rockwool substrate has superior physicochemical characteristics and is often used in crop cultivation. However, rockwool substrate has the disadvantages of high purchase cost and difficulty in disposal. Reuse of substrate can compensate for these disadvantages. Substrate must be disinfected and rehydrated during reuse, and various physicochemical changes during this process must also be considered. This study was to compare the physical properties of two types of rockwool substrates (reused and unused) and to evaluate the reuse potential of rockwool substrate by analyzing the chemical properties of the reused rockwool substrate during the rehydration process. The experiment on substrate physicochemical properties comparison was conducted from March to August 2023 using used rockwool substrates in tomato cultivation and unused rockwool substrates. Drainage time, drainage volume, and substrate weight were measured using load cells installed at the top and bottom of the irrigation monitoring system. The reused rockwool substrate weight and density were higher than those of the unused rockwool substrate, while the average drainage time after irrigation was 1.5 times longer for the reused rockwool than for the unused rockwool. The salinity concentration in different parts of the reused rockwool substrate was found to be lower in the reused rockwool substrate compared to the unused rockwool substrate. The electrical conductivity of the drainage was at its peak at the beginning of the drainage and decreased exponentially as the drainage volume increased. Change in electrical conductivity of the drainage over the irrigation time showed an exponential decay pattern. Through the experiments, the potential reusability of the rock wool substrate was assessed by conducting a comparative analysis of its physicochemical properties.

• Korean Journal of Soil Science and Fertilizer
• /
• v.32 no.2
• /
• pp.171-181
• /
• 1999

A field experiments was carried out to investigate the physicochemical properties of soil and cucumber growth in vinyl house when irrigation point was made at 0.2, 1/3, 0.5 and 1.0 bar. The obtained results was summarized as follow: The taxonomic class of the soil used was loam and each content of the required water was 4.4, 7.3, 9.6 and 13.4 mm per each irrigation time at 0.2, 1/3, 0.5 and 1.0 bar treatments in spring culture, respectively. At 0.2 bar and 1.0 bar treatments, interval of irrigation was 2.3 and 14.8 day, the times of irrigation was 37 and 6, and total irrigation volume was 163.5 and 80.3 mm, respectively. After cucumber culture, pH, EC concentration and exchangeable K content of soil at 0.2 bar treatment was distributed near to the level of improvement target while EC, available $P_2O_5$ and exchangeable base content in other treatments were higher compared to improvement target. At 1.0 bar treatment, ratios of the solid and liquid phase were 44.9 and 27.1%, respectively, and bulk density was $1.26g\;cm^{-3}$ which was the highest among the treatments. At 0.2 bar treatment, the ratio of the solid and liquid phase was 41.7 and 22.8%, respectively, and bulk density was $1.09g\;cm^{-3}$ which was the lowest. The root length and radius at 0.2 bar treatment were best, while those at 1/3 bar were worst. At 0.2 bar treatment, the total yield was 7,269 kg and the weight of good products was 5,677 kg which was the highest among treatments. At 0.33 bar treatment, the yield was the lowest with the high ratio of deformity.