• Journal of the Korean Society of Industry Convergence
• /
• v.4 no.2
• /
• pp.193-198
• /
• 2001

2성분계 혼합물(1,2-dichloropropane + 2-methoxyethanol)에 대해 과잉몰 부피(excess molar volumes) $V^E$ 및 과잉 몰엔탈피(excess molar enthalpies) $H^E$를 298.15K에서 측정하였다. 혼합물의 밀도측정은 digital vibrating tube densimeter를 이용하였고, 과잉 몰엔탈피는 isothermal flow microcalorimeter를 이용하였다. 측정한 과잉 몰부피는 전 조성 영역에서 양의 편차를 나타내었으며, 과잉 몰엔탈피는 S 자형용 보였다. 또한 얻어진 data는 Nelder- Mead의 simplex method를 이용하여 Redlich-Kister 다항식에 접합 (fitting)하였다.

• Korean Chemical Engineering Research
• /
• v.44 no.5
• /
• pp.444-452
• /
• 2006

This paper reports experimental excess molar volumes $V^E_m$ using a digital vibrating-tube densimeter and excess molar enthalpies $H^E_m$ by means of an isothermal microcalorimeter with a flow mixing cell for the binary mixtures{1,2-dichloropropane + 2-(2-methoxyethoxy)ethanol} and {1,2-dichloropropane + 2-(2-ethoxyethoxy)ethanol} at 298.15 K under atmospheric pressure. All the $V^E_m$ and $H^E_m$ of the two binary mixtures showed S-shaped forms, being negative for poor and positive for rich 1,2-dichloropropane mole fractions. These show that the excess properties were shown to be negative deviation from ideality due to the strong self-association effect among 2-(2-alkoxyethoxy)ethanol molecules at an early stage of mixing, a relatively high energy then is needed to break hydrogen bonds of 2-(2-alkoxyethoxy)ethanol with an increase ofhalogenated hydrocarbon molecular at high mole fraction of 1,2-dichloropropane. The values of excess molar properties($V^E_m$ and $H^E_m$) were fitted by the Redlich-Kister equation using Nelder-Mead's simplex pattern search method. The Wilson, NRTL, and UNIQUAC models were used to correlate the $H^E_m$ values.

• Journal of the Korean Applied Science and Technology
• /
• v.37 no.3
• /
• pp.516-525
• /
• 2020

The densities of aqueous solutions of the amphiphile 2-(2-hexyloxyethoxy)ethanol (C₆E₂) were measured at 279.15 K and 282.15 K by vibrating-tube densitometry. Then using the density data of the binary C₆E₂ (1)/water(2) system, the excess volumes and partial molar volumes were determined at various compositions. Excess volume V^E exhibits negative deviation for the whole region of composition, which implies relatively stronger attraction between molecules. At the C₆E₂ mole fraction of around 0.45, V^E was at its minimum. Partial molar volume ${\bar{V}}_1$ increases monotonously with the mole fraction x₁(=x) and ${\bar{V}}_2$ decreases with x. Any particular point in ${\bar{V}}_1$ and ${\bar{V}}_2$, which may point to molecular association, was unobserved.

• Korean Chemical Engineering Research
• /
• v.57 no.2
• /
• pp.198-204
• /
• 2019

For the removal of carbon dioxide from the chemical process, a chemical absorption method is typically used industrially. Development of new processes for the removal of carbon dioxide by the chemical absorption method has been developing new absorbents by using various absorbents. Thermodynamic data of the sorbent mixture in the new process design using hybrid absorbent is essential to reduce the equipment cost and operating costs of the process. In this study, densities of water+diisopropanolamine (DIPA), DIPA+MDEA(Methyldiethanolamine) binary systems and Water+DIPA+MDEA ternary system were measured over the full range of composition at temperatures from 303.15 K to 333.15 K by using an Anton Paar digital vibrating tube densimeter (DMA4500). The experimental excess volumes have been obtained from the experimental density results and have been fitted using the Redlich-Kister-Muggianu expression. The parameters obtained from the binary excess volume data were used for the correlation of ternary system with one additional ternary parameter for each isotherm. All investigated binary and ternary systems are completely miscible, because the values of excess volume are negative under the examined conditions.

• Korean Journal of Construction Engineering and Management
• /
• v.13 no.6
• /
• pp.24-32
• /
• 2012

Reinforced Concrete is the most dominant structure type for buildings in South Korea. Reinforced Concrete is one of materials having the most cost and quantity at construction projects. It is important to manage concrete quantity so that the total project cost is not affected due to underestimate or overestimate of its quantity. Generally the concrete quantity is taken-off based on the volume of the space inside forms without subtracting volumes of rebar embedded, which cannot be considered to make quite accurate results. Resource waste and extra cost due to over or under estimate of quantity occur since they cannot estimate accurate quantity at practices. Therefore, the objective of this paper is to analyze the effect of the volume for rebars embedded in reinforced concrete members. By comparing the quantity based on the existing method with the one from BIM data, it was found that about 1~2% of quantity discrepancy was observed while the typical concrete waste rate is 1 % at the current practice.

• Korean Chemical Engineering Research
• /
• v.43 no.5
• /
• pp.637-640
• /
• 2005

The density of polar-nonpolar liquid mixtures composed of methyl tert-butyl ether(MTBE) and 2,2,4-trimethylpentane, and methyl ethyl ketone (MEK) and 2,2,4-trimethylpentane, and the density of polar-polar liquid mixture of MTBE and MEK were measured by densitometer at 278.15 K, 288.15 K and 298.15 K, respectively. The excess molar volume of the binary systems calculated from the measured density was shown good agreement with the calculated one by the cubic Peng-Robinson- Stryjek-Vera (PRSV) equation of state together with Huron-Vidal mixing rule and it confirmed that the cubic PRSV equation of state could be used in the molar volume calculation of polar mixture.

• Korean Chemical Engineering Research
• /
• v.56 no.2
• /
• pp.204-211
• /
• 2018

In this study, densities of water + N-Methyldiethanolamine (MDEA), Water + 2-Amino-2-Methyl-1-Propanol (AMP), MDEA + AMP binary systems and Water+MDEA+AMP ternary system were measured over the full range of composition at temperatures from 303.15 K to 333.15 K by using an Anton Paar digital vibrating tube densimeter (DMA4500). The experimental excess volumes have been obtained from the experimental density results and have been fitted using the Redlich-Kister-Muggianu expression. The parameters obtained from the binary excess volume data were used for the correlation of ternary system with one additional ternary parameter for each isotherm. All investigated binary and ternary systems are completely miscible, because the values of excess volume are negative under the examined conditions.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.6
• /
• pp.41-49
• /
• 2006

This paper deals with development and dissipation of excess pore pressure induced by the cyclic load. Cyclic triaxial tests on reconstituted samples of weathered residual soils, which were widely used as construction materials in Korea, were performed. Test results showed that excess pore pressures developed under undrained condition increased with the increase of cyclic loads and confining pressures. And a new concept based on modified excess pore pressure ratio (MEPPR) was proposed for simply estimating excess pore pressures in terms of the number of cyclic load, irrespective of cyclic loads and confining pressures. Also, it was proposed that excess pore pressure ratio (EPPR) could be effectively utilized to estimate volumetric strains during dissipation which decreased as confining pressures increased. Consequently, concept and method to effectively estimate settlements under non-liquefied condition, induced by dynamic loads such as earthquake loads were evaluated based on laboratory test results for reconstituted weathered residual soils.

• KSBB Journal
• /
• v.7 no.1
• /
• pp.67-71
• /
• 1992

We studied a continuous production of ethanol by Saccharomyces cerevisiae in a hollow fiber membrane bioreactor which consisted of 50 polypropylene fibers and 3 teflon fibers. The produced $CO_2$ was removed through the teflon fibers and excess biomass was removed through the shell side. We obtained the cell and ethanol concentrations of 266g/L and 205g/L based on the shell-side volume. A nitrogen deficient medium resulted in too low an ethanol productivity to be applied to a practical process.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2008.11a
• /
• pp.63-63
• /
• 2008

Volmer-Weber 형의 성장을 하는 구리박막은 두께 증가에 따라 초기 압축, 인장, 2차 압축응력의 독특한 3단게 응력거동을 보인다. 인장응력의 경우 일반적으로 박막 두께 증가에 따른 과잉 부피를 줄이기 위해 결정립 성장 및 결정립 병합이 인장응력을 일으킨다고 보고되고 있다. 박막 증착시 결정립 크기는 증착속도, 증착된 원소의 이동도, 섬의 핵생성 속도 등 여러 가지 인자의 상호작용에 의해 결정되므로, 본 연구에서는 각각 다른 표면조도를 갖는 기판을 사용하여 결정립 성장 및 결정립 병합을 다르게 함으로써 고유인장응력 기구를 밝히고자 한다.