• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.11a
• /
• pp.1476-1481
• /
• 2007

Numerical investigation on radiation characteristics of discrete frequency noise from asymmetry aero-intakes was carried out. The near-field predictions were obtained by solving the linearized Euler equations with computational aeroacoustic techniques consisting of high order finite difference scheme, non-reflecting boundary conditions, oversetgrid techniques. For the prediction of far-field directivity pattern, the Kirchhoff integral method was applied. By comparing the directivities of noise radiating from the scarf and the scoop aero-intakes with that from an axisymmetric aero-intake, it is shown that noise reduction at downward peak radiation angle can be achieved. The scattering of the radiating acoustic wave by background mean flow shifts the peak lobe radiation angle toward ground and increases the amplitude of the acoustic pressure compared with the cases without mean flow effect.

• Journal of computational fluids engineering
• /
• v.11 no.3 s.34
• /
• pp.64-70
• /
• 2006

A Computational study was carried out in order to investigate the moving wall effect of a circular cylinder at a Reynolds number of $2.0{\times}10^4$. The viscous-incompressible Navier-Stokes equations and Spalart-Almaras turbulent model of the commercial CFD code were adopted for this numerical analysis. The moving wall was set parallel with the freestream, and moving speed was equal to the freestream velocity. The gap ratio is defined as the distance ratio between the circular cylinder diameter and the height from the moving wall. The results show that there is vortex shedding over the critical gap ratio and aerodynamic loads including amplitude and the Strouhal number change according to the gap ratio.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.18 no.4
• /
• pp.1-8
• /
• 2010

In the aerospace field, the study on a morphing-wing is in progress to improve flight performance and perform multi flight mission. There are many concepts of morphing-wing such as camber-change, wing-twist, variable-span, and so on. In this study, the aerodynamic characteristics and flight control of an air vehicle with a variable-span morphing wing (VSMW) have been investigated. VSMW with symmetric span control(SSC) can increase cruising range of aircraft by reducing drag in various flight condition. VSMW with anti-symmetric span control(ASSC) can be used in the roll control of an aircraft. The flight control about pure rolling dynamic system and full dynamic system have been performed about the cruise missile.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.9
• /
• pp.825-834
• /
• 2008

Nose chine shape optimization study has been performed to maximize the directional stability at high angle of attack supersonic flow. Various chine shapes are generated using super ellipse equation. By numerically investigating the directional stability characteristics of those shapes, the baseline configuration for the shape optimization has been selected using the three-dimensional Navier-Stokes equations. The configuration is represented by the NURBS curves which can adjust the surface geometry by the control points. The response surfaces are constructed to obtain optimum shape which has high directional stability characteristics and lift-to-drag ratio. From this study, an efficient configuration design and optimization process which utilizes the parameter-based configuration generation techniques and approximation method has been established, then 29% improvement of the directional stability by strong vortexes from chine nose is accomplished.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.41 no.5
• /
• pp.342-349
• /
• 2013

A damage imposed on an unmanned aerial vehicle changes the flight dynamic characteristics, and makes difficult for a conventional controller based on undamaged dynamics to stabilize the vehicle with damage. This paper presents a neural network based adaptive control method that guarantees stable control performance for an unmanned aerial vehicle even with damage on the main wing. Additionally, Pseudo Control Hedging (PCH) is combined to prevent control performance degradation by actuator characteristics. Asymmetric dynamic equations for an aircraft are chosen to describe motions of a vehicle with damage. Aerodynamic data from wind tunnel test for an undamaged model and a damaged model are used for numerical validation of the proposed control method. The numerical simulation has shown that the proposed control method has robust control performance in the presence of wing damage.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.186-186
• /
• 2010

개별 블레이드 피치 제어(individual blade pitch control)는 각각의 로터 블레이드의 피치각을 독립적으로 조정함으로써 블레이드에 작용하는 공력을 변화시키는 원리로 풍력 터빈 구조물에 발생하는 동적 피로하중을 저감시키기 위한 제어기법이다. 그러나 개별 피치 제어에 의해 발생하는 각 블레이드의 독립적인 피치 운동은 풍력 터빈 회전자에 비대칭성을 야기하고 구조물의 동적 불안정 현상을 발생시킬 수 있기 때문에 이에 대한 정확한 동적 해석이 선행되어야 한다. 하지만 블레이드의 피치 운동이 반영된 풍력 터빈은 시변계로 간주되어 기존의 시불변계 해석기법을 직접 적용할 수 없기 때문에 동적 해석에 어려움이 있다. 이 논문에서는 각각의 블레이드 피치운동을 주기함수로 근사화 함으로써 풍력 터빈을 주기 시변계로 모형화한다. 그리고 효율적으로 주기 시변계의 근사해를 구하기 위한 변조 좌표 변환(modulated coordinate transformation)기법을 적용하여 블레이드의 피치운동이 반영된 풍력 터빈의 동적 안정성 해석을 수행하였다. 그리고 현재 풍력 터빈의 동적 해석에 활용되는 대표적인 해석 기법인 다중 블레이드 좌표변환(multi-blade coordinate transformation)기법을 이용한 해석보다 정확한 결과를 얻을 수 있음을 보였다.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.5
• /
• pp.28-33
• /
• 2005

Nonlinear aeroelastic characteristics of a two dimensional typical section model with bilinear plunge spring are investigated. Doublet-point method(DPM) is used for the calculation of supersonic unsteady aerodynamic forces which are approximated by using the minimum-state approximation. For nonlinear flutter analysis structural nonlinearity is represented by an asymmetric bilinear spring and is linearized by using the describing function method. The linear and nonlinear flutter analyses indicate that the flutter characteristics are significantly dependent on the frequency ratio. From the nonlinear flutter analysis, various types of limit cycle oscillations are observed in a wide range of air speeds below or above the linear flutter boundary. The nonlinear flutter characteristics and the nonlinear aeroelastic responses are investigated.

• Journal of Aerospace System Engineering
• /
• v.10 no.3
• /
• pp.39-43
• /
• 2016

In this paper, a wind-tunnel test is accomplished to investigate the roll characteristics of a variable-span wing flying inside a channel. The factors that affect the roll characteristics of the wing were identified by analyzing the measured data; accordingly, when the wing is flying without both the ground and sidewall effects, the asymmetric wing extension causes the roll moment. Both the ground and the sidewall can increase the roll moment, but when the wing is affected by both the ground and the sidewall, the roll moment does not increase as much as the case where the wing is only affected by the ground. Also, the aerodynamic characteristics of the flying wing inside a channel are the nonlinear function of the wing height and the gap between the wingtip and the sidewall, both of which should be considered in a study of the stability and the flight control of the wing-in-ground effect of the vehicle flying inside a channel.

• KEPCO Journal on Electric Power and Energy
• /
• v.3 no.2
• /
• pp.79-88
• /
• 2017

In this paper, the wind tunnel test for the measurement of aerodynamic characteristics of transmission conductors with asymmetric sections is described. A single conductor model and bundled conductor models with ice accreted shapes are tested both in steady and turbulent flow, and the aerodynamic coefficients are acquired. Transmission conductor galloping is a kind of wind-induced vibration which is characterized by primarily vertical oscillation with a very low frequency and a high amplitude. It is well known that transmission conductor galloping is generally caused by moderately strong, steady winds when a transmission conductor has an asymmetric cross-section shaped by accreted ice. Galloping should be considered from the design stage of overhead lines because it can cause severe wear and fatigue damage to attachments as well as transmission conductors. It is reported that there have been normally 20 events of galloping per year in Korea, which may be followed by serious consequences in the electric power system. Therefore, this research is performed to measure aerodynamic characteristics of ice accreted transmission conductors to understand and control transmission conductor galloping so that it would help to prevent unexpected failures and reduce the maintenance costs caused by galloping.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.5
• /
• pp.34-40
• /
• 2005

Most analyses and researches on Micro Aerial Vehicle(MAV) have focused upon propulsion, automatic control, aerodynamic configuration in low Reynolds number region, and miniaturization of telemetric parts. In the present study, a structural concept for MAV is designed by using the composite material suitable for light flight structures. In order to study the load path and stress state of the MAV, the load and structural analyses are simultaneously performed by the aeroelasticity module of MSC/NASTRAN. The stability derivatives of the MAV are obtained for three symmetric, two antisymmetric, and four unsymmetric maneuvering conditions. Although the aerodynamic theory in MSC/NASTRAN could not be proper for MAV analysis, it provides an traditional and effective tool for trim and load analyses and may be corrected with the results by more accurate theory or test. The results show that the inertial load due to payloads has a more effect on stress rather than the aerodynamic load.