• Membrane Journal
• /
• v.25 no.1
• /
• pp.67-74
• /
• 2015

In this study the nanofiber was prepared by electrospinning method with polyvinylidene fluoride (PVdF) and a completely dispersed solution of graphene oxide (GO) in the mixed solvent of dimethylformamide (DMF) and acetone. The $0.4{\mu}m$ pore size microfiltration flat membrane was made by increasing layers of the PVdF/GO composite nanofiber. Also, transmembrane pressure (TMP) was measured in order to evaluate fouling of the PVdF/GO composite membrane which was introduced GO reducing biological fouling with the intrinsic antibacterial characteristics. The permeate experiments were carried out simultaneously for the PVdF/GO and commercialized CPVC (chlorinated polyvinyl chloride) flat membranes with $0.01m^2$ effective area in the activated sludge solution of MLSS 4,500 mg/L. TMP of PVdF/GO membrane decreased up to 79% lower than that of CPVC for $10L/m^2{\cdot}h$ permeate flux without air supply. Also, for the case of run/stop operational mode, TMP of PVdF/GO membrane decreased up to 69% lower than that of CPVC for $10L/m^2{\cdot}h$.

• Journal of the Korea Concrete Institute
• /
• v.28 no.2
• /
• pp.197-204
• /
• 2016

Concrete walls of neutron generating facilities such as fusion reactors and fission reactors become radioactive by neutron irradiation. Both low-activation and neutron shielding are a critical concern at the dismantling stage after the shutdown of facilities with a requirement of radioactive waste management. To tackle this, two types of additives were investigated in fabricating mortar specimens: synthetic high polymers and boron carbide. It is well known that a hydrogen atom is effective in neutron shielding by an elastic scattering because its mass is almost the same as that of the neutron. And boron is an effective neutron absorber with a big neutron absorption cross section. In this study, the effect of the type, shape, and size of polymers were investigated as well as that of boron carbide. Total 16 mix designs were prepared to reveal the effect of polymers on mechanical properties and neutron shielding performance. The neutron does equivalent of polymers-based mortar for fast neutrons decreased by 36 %, and the count rate of boron carbide-based mortar with regard to thermal neutrons decreased by 90 % compared to conventional mortar. These results showed that a combination of polymers and boron carbide compounds has potential to reduce the thickness of neutron shields as well as radioactive waste from reactors.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2004.08a
• /
• pp.138-156
• /
• 2004

GPR(Ground Penetrating Radar) was used for imaging the interior of the historical masonry such as stone pagoda in order to provide the basic information of safely inspection. The scope of the imaging was restricted to the foundation part of stone pagoda that transferred the load of the pagoda to the ground. Kirchhoff migration and traveltime tomography was used for imaging the outer stone and the inside of stone pagoda, respectively. From the migrated images, we could measure the thickness and the shape of the boundaries of the outer stone in the foundation part. From the reconstructed tomograms for the physical model, we could get the GPR propagation velocity distribution and exactly find the position of the air in the model and calculate the average velocity with respect to the different filling materials. The properties and the shape of the interior materials of stone pagoda can be basic informations for the safety inspection.

• Investigative Magnetic Resonance Imaging
• /
• v.4 no.2
• /
• pp.113-119
• /
• 2000

Purpose : To know the possibility of clinical application of MRI using oxygen inhalation as a perfusion MRI Materials and methods : Two healthy volunteers and three patients of one moyamoya disease, one acute infarction and one meningioma were studied using a 1.5 Tesla MRI unit. Oxygen (15 liters/min) mixed with room air was given using face mask from 8 second to 35 second during the study. Images were acquired 25 times (scan time per study were 1.6 seconds) using susceptibility contrast EPI (echo planar image) sequence. Difference maps were acquired by early (study 12-18), and late (study 19-25) O2 inhalation image groups minus pre-O2 inhalation image group (study 3-9) with a Z-score of 0.7-1.0 using VB31C program of Magneton Vision. The resulting perfusion images were created by superimposition of difference maps on corresponding T1 weighted anatomic images. On moyamoya patient, similar perfusion images were acquired after Gd-DTPA injection, and compared with O2 inhalation perfusion images. Results ; The author can get the perfusion images of the brain by oxygen inhalation with susceptibility contrast EPI sequence at the volunteers, and the patient of moyomoya disease, acute infarction and meningioma. On moyamoya patient, perfusion images with O2 inhalation are similar with perfusion images by Gd-DTPA injection. Conclusion 1 This study has demonstrated that the susceptibility contrast EPI by oxygen inhalation can be used as the clinically useful perfusion MRI technique

• Journal of the Korean Society of Radiology
• /
• v.17 no.6
• /
• pp.957-964
• /
• 2023

This study focused on hand sanitizer as a medium that can replace ultrasonic gel, which is vulnerable to contamination by bacteria that reside on the hand. Hand sanitizer produces a strong sterilization effect from germs resident on the hands through different sterilization principles depending on the ingredients. Select products of gel type, cream type, and foam type, except for liquid type with low viscosity, and ultrasonically apply one 62% ethanol gel type and one cream type, one benzalkonium chloride 0.066% cream type and one foam type, respectively. Using ATS-539 as a medium, image evaluation was performed on the axial and lateral resolution and penetration depth, and the presence or absence of an air layer between the probe and the phantom. As a result, in the evaluation of the axial and lateral resolution and the depth of penetration, all four experimental groups met the evaluation criteria. However, in the case of the foam type, although it was suitable for the evaluation criteria of resolution and penetration depth, dark shadows appeared on both sides except for the center of observation during image evaluation. Through this experiment, it was possible to confirm the possibility that the remaining three types of hand sanitizers except the foam type could replace the ultrasonic gel.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.6
• /
• pp.434-441
• /
• 2014

This study is purposed to measure airborne asbestos concentrations at demolition sites and surrounding areas of asbestos containing buildings in Seoul and examine whether the measurement results correspond with allowable exhaust standard for asbestos of the Asbestos Safety Control Act. The airborne asbestos concentrations for 37 sites were below the detection limit ($7fiber/mm^2$) in 101 (35%) out of 288 samples. The whole average airborne asbestos concentration in 37 sites was $0.003{\pm}0.002f/cc$(max 0.0013 f/cc) and almost the whole airborne asbestos concentrations were satisfied with allowable exhaust standard for asbestos, 0.01 f/cc, of the Asbestos Safety Control Act. So possibility of asbestos exposure is not yet a major concern at current levels for sites demolished of asbestos containing buildings in Seoul. Looking at each sampling point, the average airborne asbestos concentrations in boundary line of site, entrance of sanitation, around the workplace (in), around the workplace (out), negative pressure units, storage area for waste, outlet for waste and residential area of residents were respectively $0.002{\pm}0.002f/cc$, $0.004{\pm}0.002f/cc$, $0.004{\pm}0.002f/cc$, $0.004{\pm}0.002f/cc$, $0.004{\pm}0.002f/cc$, $0.005{\pm}0.004f/cc$, $0.005{\pm}0.003f/cc$ and $0.003{\pm}0.002f/cc$. As a result, all sampling points of study were satisfied with allowable exhaust standard for asbestos, 0.01 f/cc, of the Asbestos Safety Control Act.

• Geotechnical Engineering
• /
• v.11 no.3
• /
• pp.43-54
• /
• 1995

The aim of the work described in this paper is to develope a constitutive model for the prediction of an unsaturated soil and to confirm the application'of the model, which is composed of the elastic and plastic part in consideration of the matric suction and the net mean stress. From test results, volume changes and deviator stresses are analyzed at each state and their relationships are formulated. The application of the model to silty sands is confirmed by the comparison between test and predicted results. During drying -wetting and loading -unloading processes for isotropic states, the agreement between predicted and test results are satisfactory. Predicted deviator stresses are well agreed with test results in shearing process. Overall acceptable predictions are reproduced in high confining pressure. Usefulness of the model is confirmed for the unsaturated soil except volumetric strain, which is not well agreed with the test results due to deficiency of dilatancy of the model in low confining pressure. It is, therefore. recommended to study the behavior of dilatancy for an unsaturated soil.

• Journal of the Korean Chemical Society
• /
• v.54 no.1
• /
• pp.137-141
• /
• 2010

Generally, polymer materials are not air-permeable and hydrophilic. In addition, they do not possess anti-fungal property. Hydrophilicity, air-permeability, and anti-fungal properties of new composites consisting of polymer, ceramic nanoparticles, and silver ion were investigated by contact angle measurements, air permeation time, and cell culture. The hydrophilic, air-permeable, and anti-fungal composites can be used in health care industry.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2009.11a
• /
• pp.46.1-46.1
• /
• 2009

산업이 점차 발달함에 따라 발생하는 환경오염으로 인해 인간의 삶에 있어 불가분의 관계에 있는 물에 대한 관심이 지속적으로 높아지고 있는 추세이다. 각종 질병의 요인이 되는 박테리아는 주로 물을 운송 매개체로 하기 때문에 이로 인한 물의 오염으로 인도의 경우 모든 질병 발생의 80%를 차지하는 것으로 세계보건기구(WHO)에 의해 보고되었다. 현재까지물 또는 공기의 항균 및 살균 정화를 위해 화학적, 생물학적 방식 등 다양한 기술이 개발되었으나 박테리아와같은 세균제거에는 무리가 있는 실정이다. 따라서 본 연구에서는 여러 물질 중에서도 특히 항균작용(Antibacterial activity)이 탁월한 은(Ag)을 나노입자화하여 in-situ 코팅을 통한 다공성 알루미늄 하이드록사이드 나노복합재의 제조함으로써 생물학, 생체의용공학, 약학 등에 응용될 수 있는 새로운 형태의 항균재료제조방법을 제안하였다. 우선, 다공성 알루미늄 하이드록사이드기판은 알루미늄 기판에 알칼리 표면개질을 실시함으로서 표면에 마이크로포어가 형성된 알루미늄 하이드록사이드 기판을 제조하였다. 이렇게 제조된 다공성 기판에 Polyol 공정으로 은나노입자를 합성 및 분산시킴으로서 in-situ로 은나노입자가 분산된 알루미늄 하이드록사이드 나노복합재 기판을 만들수 있었다. 본 연구를 통하여 제조된 은나노입자가 분산된 알루미늄 하이드록사이드 나노복합재 기판은 주사전자현미경(SEM) 및 투과전자현미경(TEM)을 통하여 미세구조와 상분석을 실시하였으며 X선 광전자분석(XPS)를 이용하여 기판 표면의 화학적 상태를 분석하였다.

• Journal of Fashion Business
• /
• v.11 no.4
• /
• pp.101-110
• /
• 2007

Since cotton fabrics with ripple finish treatment form wavy furrows on the surface or bumpy patterns, air circulation during wearing is good and the fabric is cool to the touch. The finishing principle is based on the mercerization, which utilizes the fact that cotton fibers contract in a concentrated NaOH solution. In this study, as fabric specimens, cotton fabrics with yarn counts of 40's, 60's and 80's were used. Concentrations of the NaOH solutions were 15%, 25%, and 35%. After dyeing fabrics using Rubia akane nakai, color and other properties were measured. As the concentration of the NaOH solution increased, the fabric became thicker and denser, and the number of occurrence of the prominence and depression per unit length became larger. The color of the region contracted by ripple finish became darker after dyeing, while the color of the untreated region became lighter, which enhanced the cubic effect of the ripple finish. As the count of the cotton yarn increased, the dyeability became better. As the concentration of the NaOH solution increased, the air permeability became lower.