• Journal of the Korean Recycled Construction Resources Institute
• /
• v.3 no.1
• /
• pp.43-49
• /
• 2015

The objective of this paper is to investigate experimentally the effect of the substitution of recycled aggregates under 13mm on the properties of the concrete using coarse aggregate with size of 13~25mm. Recycled aggregate under 13mm were substituted to the concrete ranged from 10% to 100%. To compare the properties with the case of recycled aggregate, crushed stone with smaller than 13mm was also substituted to the concrete by 20% and 40%. Test results showed that increase of recycled aggregate under 13mm resulted in the increase of slump and compressive strength compared with plain mixture, which was made with only aggregate with 13~25mm size. This is due to the dense gradation of aggregate in association with addition of relatively small particle. It is thought that the use of recycled aggregate under 13mm along with 30% contributes to the quality improvement of the concrete made with only 13~25mm aggregate.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.7 no.1
• /
• pp.44-49
• /
• 2019

The purpose of this study is to analyze the fundamental characteristics of concrete with the change of reject ash(Reject ash=Rj) in the mixed aggregate where single grain aggregate of different grain size and aggregate of opposite grain size are mixed together, to analyze the possibility of a mixed aggregate system that premixes at an aggregate manufacturing plant and delivers it as one aggregate. As a result of the experimental study, it was found that the grain size regulation is satisfied if the mixed aggregate(CSb+SS) is substituted for about 5% of Rj. In the case of the fluidity slump, slump flow and air volume, it was found that they decrease as the substitution ratio of Rj increases, while the compressive strength increases as the substitution ratio of Rj increases. Therefore, it is analyzed that it would contribute greatly to an improvement of quality such as improvement of compressive strength if adequate fluidity and air quantity are secured by the water reducing agent and AE agent while premixing the Rj, which is disposed of by landfill, with about 5% of the mixed aggregate.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.10 no.3
• /
• pp.327-334
• /
• 2022

In this study, in order to evaluate the characteristics of mortar and concrete using wood chip cogeneration plant flooring as fine aggregate, mortar characteristics according to wood chip aggregate replacement rate and water-cement ratio as a substitute for crushed sand, and concrete characteristics according to wood chip aggregate replacement rate were compared and evaluated. The cement mortar flow according to the wood chip aggregate replacement rate showed a tendency to increase as the wood chip aggregate replacement rate increased, and the compressive strength and flexural strength increased as the wood chip aggregate replacement rate increased. The slump and air content of concrete increased as the aggregate replacement rate increased, and the compressive strength and tensile splitting strength of concrete tended to increase as the wood chip aggregate replacement rate increased. Accordingly, the possibility of using the flooring by the cogeneration plant as a fine aggregate for concrete was confirmed.

• Magazine of the Korea Concrete Institute
• /
• v.13 no.1
• /
• pp.66-72
• /
• 2001

지구 온난화, 천연 자원의 고갈, 처분 장소의 핍박 등 환경문제가 사회적인 문제로 대두되고 있다. 특히 건설분야에서 천연산 골재의 부족은 매우 심각한 상황에 있으며, 이를 해결하기 위해 재생골재의 재활용 등 많은 연구가 이루어져 1999년도에는 아스팔트 콘크리트용 재생골재(KS F 2572), 콘크리트용 재생골재(KS F 2573), 도로기층용 재생골재(KS F 2574)에 대한 규격을 제정함으로써 실용화의 단계에까지 이르고 있다 그러나 제철소의 제강 및 정련 공정상에서 발생하는 철강슬래그를 콘크리트용 골재로서 활용하기 위한 국내의 연구는 몇몇 연구자들에 의해서만 이루어지고 있어 초기 단계에 있다고 할 수 있다. 이에 본고에서는 콘크리트용 천연산 골재의 대체 재료로서 각종 철강슬래그의 적극적인 재활용을 도모하기 위해 최근 슬래그를 골재로서 사용하기 위해서 연구한 결과 및 실례를 수록한 문헌을 조사 검토하여 슬래그 골재의 특성에 대하여 소개하고자 한다.

• Economic and Environmental Geology
• /
• v.57 no.2
• /
• pp.129-141
• /
• 2024

This study derived production-production multipliers using a regional input-output table and estimated the induced effect of aggregates through the non-metallic minerals sector and the concrete products sector. In deriving the induced effect of aggregates, it is difficult to use the regional input-output table due to the sector classification problem. This study analyzed the non-metallic mineral sector, including aggregates, as aggregates sector, and the concrete products sector, which uses most of the aggregate production. By analyzing this, we attempted to alleviate difficulties caused by sector classification restrictions. In the process of estimating the induced effect, it was assumed that there was a decrease in aggregate production, and in the process of analyzing the concrete products sector, the effect of the decrease in concrete product production due to the decrease in aggregate production, that is, the decrease in production of one unit of aggregate was 0.8511 in the concrete product sector. The analysis was conducted on the premise of a decrease in unit production. Inducing effects within and between regions were calculated for the 17 metropolitan cities and provinces classified by the regional input-output table. The employment effect was also calculated, assuming a 10% production decrease to show differences according to the size of the aggregate and concrete product sectors in each region.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.2
• /
• pp.160-167
• /
• 2017

The purpose of this study is to identify the possibility of developing the 100% Recycled-resources Absorbent-Pervious Alkali-activated Blocks using both the alkalli-binder and the recycled aggregate. In addition, It established a test method such as Void ratio, compressive strength, coefficient permeability, absorption, and evaporation. As a result, an alkali-activated using recycled aggregate block was able to manufacture an 24 MPa class absorbent-pervious blocks with a liquid type sodium silicate and early high temperature curing. In this case, water-holding capacity, absorption and relative absorption were more effective than the natural aggregates. In conclusion, Absorbent-pervious alkali-activated Block Using recycled aggregate has a surface temperature reducing effect of approximately 10 % compared to ordinary concrete block.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.4 no.1
• /
• pp.1-9
• /
• 2016

While the amount of construction waste has not been changed much in discharge for last 10 years, the recycled resources refined from construction waste have been mainly applied to low-leveled one such as reclamation, back-fill, road base or subbase and so on. Thus this study addresses the applicability of recycled fine aggregate as a replaceable material in precast concrete. To evaluate the possibility, both of dry and wet processes were adopted as well as steam curing, widely used in the field for rapid producing. Most important experimental parameters were driven through preliminary experiments and were evaluated in terms of concrete properties. It is found from aggregate-replacement tests that all of consistency and strengths of concrete were decreased as the ratio of recycled fine aggregate increased, and the amount of decrease can be estimated using proposed equations. Though the recycled fine aggregate showed a decrease of concrete properties more or less, the applicability in large volume as a constituent of precast product was well noted from experimental results.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.7 no.1
• /
• pp.50-56
• /
• 2019

This study aims to make artificial stone by recycling blast furnace slag powder, red mud and recycled aggregate, which are known as industrial waste. Recycled aggregate is a typical construction waste, and various recycled products such as concrete block are being sold. In this study, we tried to make artificial stone mixed with waste such as recycled aggregate, and experimented with the use of artificial stone and further study. As the red mud replacement ratio increased, the absorption ratio, fluidity and air content of the matrix were measured to be decreased, and the strength and density were found to increase. The fluidity and absorption ratio decreased with increasing the replacement ratio of recycled aggregate, and the air quantity, rate of aggregate on the surface, density and intensity increased to a certain level. Therefore, this study intends to make artificial stone using recycled resources and conducted basic experiments for further study.

• Economic and Environmental Geology
• /
• v.54 no.5
• /
• pp.581-594
• /
• 2021

In 2020, about 132 million m³ of aggregate was produced in Korea. Of the total domestic aggregates produced in 2020, about 33.3 % was sand and about 66.7% was gravel. It estimated that of the 132 million m³ of aggregates in Korea in 2020, about 52% was produced by screening crushed aggregate, by 36% by forest aggregate, 3% by land aggregate, 5.6% by sea aggregate and 2.5% by washing each other, and 0.4% by river aggregate. This indicates that screening crushed aggregate and forest aggregate are the main producers of domestic aggregates. Leading producing metropolitan cities were Gyeonggi-do, Gyeongsangnam-do, Chungcheongbuk-do, Gangwon-do, Chungcheongnam-do, Incheon in order decreasing volume, which together accounted for about 72.4% of total product. In 2020, aggregates were produced in 153 cities, about 67% of the 231 cities of Korea, 38 local governments have developed aggregates of more than 1 million m³, and the combined production of the 38 cities accounted for about 65% of national total. This means that the aggregate extraction trend of local governments is becoming larger and more concentrated. In 2020, at 153 local governments, a total of 889 operations produced aggregates with 420 operations by permission, 469 operations by declaration. A review of production by size of operation indicated that about 17 million m³ (12.8% of the total aggregate) was produced by 14 operations reporting production of more than 1 million m³. In about 420 operations, the maximum period of permit is 32 years to at least 2 months. When the remaining period of permit is taken into account, only about 55% of active operations can be developed the aggregate after 2021. In order to maintain the permitted aggregate volume by 2020 level, it will be necessary to obtain an extension permit or find new operation sites for at least 200 or more operations.

• Economic and Environmental Geology
• /
• v.56 no.1
• /
• pp.87-101
• /
• 2023

The purpose of this study identifies the production of aggregate every year, and is to understand the supply and demend prospects. In 2021, the total of 135 million m³ of of aggregates was produced in Korea, a slightly increase from the total production of 2020. Of these, about 47 million m³ of sand and about 88 million m³ of gravel were produced. About 46% of total quantity of aggregates were produced with permission and the rest were aggregates produced after declaration. It estimated that of the 135 million m³ of aggregates in Korea in 2020, about 49.6% was produced by screening crushed aggregate, by 36.8% by forest aggregate, 2.6% by land aggregate, 6.8% by sea aggregate and 2.6% by washing each other, and 0.2% by river aggregate. This indicates that screening crushed aggregate and forest aggregate are the main product as in 2021. Leading producing metropolitan governments were Gyeonggi-do, Chungcheongnam-do, Incheon, Gyeongsangnam-do, Chungcheongbuk-do, Gangwon-do, Jeollanam-do, Gyeongsangbuk-do in order decreasing volume. In 2021, aggregates were produced in 148 local governments, and The 10 leading producing local governments were, in descending order of volume, Hwaseong, Ongjin, Paju, Pocheon, Gwangju, Youngin, Cheongju, Gimhae, Anseong, west EEZ. The combined production of the 10 leading local governments accounted for 30% of the national total, and. 47 local governments have produced aggregates of more than 1 million m³ each other. In 148 local governments that produced aggregate, a total of 805 active operations produced aggregate with 372 operations by river, land and forest aggregate, 433 operations by selective crushed and washing aggregate.