• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2000.04a
• /
• pp.147-152
• /
• 2000

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2001.11a
• /
• pp.251-256
• /
• 2001

• Journal of the Microelectronics and Packaging Society
• /
• v.23 no.3
• /
• pp.31-35
• /
• 2016

This paper demonstrates the successful application of yttria-stabilized zirconia thin films deposited by atomic layer deposition to the anode-side interlayer for cerium oxide electrolyte based solid oxide fuel cell. At the operating temperature over $500^{\circ}C$, the electrical conductivity of cerium oxide electrolyte is known to dramatically increase and, therefore, the open circuit voltage of the cell decreases leading to the decrease of the performance. Ultra-thin (60 nm) atomic layer deposited yttria-stabilized zirconia thin film in this study conformally coated the anode-side surface of the cerium oxide electrolyte and efficiently blocked the electrical conduction through the electrolyte. Accordingly, the open circuit voltage increased by up to 20%, and the maximum power density increased by 52% at $500^{\circ}C$

• Korean Chemical Engineering Research
• /
• v.48 no.2
• /
• pp.185-192
• /
• 2010

The chemical-looping combustion(CLC) has advantages of no energy loss for separation of $CO_2$ without $NO_x$ formation. This CLC system consists of oxidation and reduction reactors where metal oxides particles are circulating through these two reactors. In the present study, the reaction kinetic equations of iron oxide oxygen carriers supported on bentonite have been determined by the shrinking core model. Based on the reactivity data, design values of solid circulation rate and solids inventory were determined for the rector. Two types of interconnected fluidized bed systems were designed for CLC application, one system consists of a riser and a bubbling fluidized bed, and the other one has a riser and two bubbling fluidized beds. Solid circulation rates were varied to about $30kg/m^2s$ by aeration into a loop-seal. Solid circulation rate increases with increasing aeration velocity and it increases further with an auxiliary gas flow into the loop-seal. As solid circulation rate is increased, solid hold up in the riser increases. A typical gas leakage from the riser to the fluidized bed is found to be less than 1%.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.25-25
• /
• 2003

안정화 지르코니아(Stabilized Zirconia)는 산화물 연료전지 (SOFC: Solid Oxide Fuel Cell), 전기화학식 가스센서 등에 널리 사용되고 있는 대표적인 고체전해질이다. SOFC의 효율향상 및 센서의 저온 동작을 위해서는 높은 이온전도도를 갖는 고체전해질이 요구된다. 안정화 지르코니아의 이온 전도도를 향상시키기 위해 MgO, CaO, $Y_2$O$_3$, Yb$_2$O$_3$, Sc$_2$O$_3$ 등의 안정화제가 첨가된 바 있으며, 이들 첨가제의 변화에 의한 전기전도도 향상 연구는 현재 성숙된 단계이다. 지르코니아 고체전해질의 안정화제가 정해진 상태에서 재료의 전기전도도를 향상시키는 다른 방법은 입계에서의 이온전도도를 높이는 것이다. 안정화 지르코니아는 입계가 입내에 비해 저항이 약 100-10000배 정도크기 때문에, 입계가 얇은 두께에도 불구하고 전해질의 저항에서 큰 역할을 한다고 알려져 있다. 일반적으로 입계의 Si-포함상 편석, 입계액상, 공간전하층등이 입계의 저항에 대한 원인으로 받아 들여 지고 있다.

• Korean Chemical Engineering Research
• /
• v.57 no.6
• /
• pp.853-860
• /
• 2019

In order to meet more severe environmental regulations, oxy-fuel circulating fluidized bed(CFB) boilers or ultra supercritical CFB boilers, which are a kind of process in that solid particles moves similar to fluid, have been developed in the world. In CFB power generation processes, the method to reduce or remove sulfur dioxide is in-situ desulfurization reaction via limestone directly injected into CFB boilers. However, the desulfurization efficiencies have continuously changed because limestones injected into CFB boilers are affected by various operation conditions (Bed temperature, pressure, solid circulating rate, solid holdup, residence time, and so on). In this study, a prediction method with physical and chemical properties of limestone and operation conditions of CFB boiler for in-situ desulfurization reaction in CFB boilers has developed by integrating desulfurization kinetic equations and hydrodynamics equations for CFB previously published. In particular, the prediction equation for in-situ desulfurization was modified by using experimental results from desulfurization reactions of various domestic limestones.

• Clean Technology
• /
• v.19 no.4
• /
• pp.437-445
• /
• 2013

To develop SEWGS (sorption enhanced water gas shift) system using dry $CO_2$ absorbent for pre-combustion $CO_2$ capture, hydrodynamic characteristics of $CO_2$ absorbents were measured and investigated. The minimum fluidization velocity of $CO_2$ absorbent was measured and the effects of the operating conditions were investigated to operate the system at bubbling fluidized bed condition. The minimum fluidization velocity decreased as pressure and temperature increased. Moreover, the minimum fluidization velocity decreased as column diameter increased. The effects of operating conditions on the solid circulation rate were measured and investigated to select appropriate operating conditions for continuous $CO_2$ capture and regeneration. The measured solid circulation rates were ranged between 10 and 65 kg/h and increased as the solid injection velocity, gas velocity in the regeneration reactor, and solid height increased.

• Korean Journal of Crystallography
• /
• v.17 no.2
• /
• pp.60-65
• /
• 2006

표면 및 계면층의 결정구조, 결함구조, 불순물 편석, 표면의 전자 구조, 원자 진동 등과 같은 산화물의 표면물성은 촉매, 센서, 소결, 마찰, 부식 등과 같은 분야에서 그 특성을 좌우한다. 고체 표면의 결정구조 해석 수단으로 저에너지 이온산란 분광법이 유용한 도구로 알려져 있는데, 이 방법의 뛰어난 표면민감성은 표면에서의 효과적인 이온 중성화 과정에 기인한다. $He^+$, $Ne^+$, $Ar^+$ 등과 같은 이온은 Auger 중성화 과정에 의하여 쉽게 중성원자화 되고, 중성화 확율의 타겟에 대한 의존성이 낮기 때문에 이온빔으로서 종종 사용된다. 산란각도를 180$^{\circ}$로 고정하여 산란이온 검출기를 설치한 직충돌 이온산란 분광법의 경우는 산란된 이온의 궤적이 입사궤도와 거의 동일하기 때문에 산란궤적의 계산이 간단해지고, 수 층 깊이의 원자구조의 해석이 가능해진다. 본 고에서는 고체 표면의 원자구조를 실공간에서 해석할 수 있는 직충돌 이온산란 분광법에 대하여 측정의 기본원리, 측정장치, 간단한 분석 예 등에 관하여 기술하고자 하며, 다음 편에서는 복잡한 표면구조를 가지는 반도체 표면에서 직충돌 이온산란분광법의 이용하여 해석한 예를 중심으로 기술하고자 한다.

• Applied Chemistry for Engineering
• /
• v.8 no.5
• /
• pp.784-789
• /
• 1997

Aluminium solid electrolytic capacitor in which electroconducting polypyrrole(PPy) is used as an electrolyte is studied. Pyrrole(Py) is electrochemically synthesized using the etched and anodized aluminium foil electrode($Al_2O_3$) as an anode on which the thin layer of chemicalpolymerized PPy as a pre-coating layer is formed previously by chemical oxidative polymerization(CP). Investigating the effects of the polymerization conditions on the electrical characteristics of resulting capacitors, the capacitors which were obtained from the galvanostatic electrolysis of pyrrole containing sodium p-toluenesulfonate(TsONa) under the currents of $2.0{\sim}4.0mA/unit(6.5{\times}10mm)$, showed the most superior properties.

• Journal of Radiation Protection and Research
• /
• v.22 no.4
• /
• pp.243-250
• /
• 1997

A relative-calibration-method of solid-state-track-detector for measurement of radon in air has been developed, and the concentration of radon in each room of a 15th-floor-apartment was measured by using the relative calibrated SSTD. There is a tendency to decrease the concentration of radon when the floor is higher, but the main factor to reduce the concentration of radon in room appeared to be ventilation rate. Average concentration of radon of the 15th-floor-apartment was $1.50{\pm}0.51pCi/l$, and the highest and the lowest concentration of radon were $2.68{\pm}0.32pCi/l$, $0.69{\pm}0.16pCi/l$ respectively.