• 한국신재생에너지학회:학술대회논문집
• /
• 2007.11a
• /
• pp.623-626
• /
• 2007

킬른형 열분해 반응기를 이용하여 혼합폐플라스틱의 열분해로부터 얻어진 고분자성분의 열적분해 특성에 관한 연구를 TGA와 GC-MS를 이용하여 수행하였다. 열적분해의 속도론적 연구는 $10{\sim}50^{\circ}C/min$ 사이의 여러 가열속도에서 비등온 질량감소 기술을 이용하여 수행하였으며 활성화 에너지 및 반응 차수와 같은 속도 상수들에 대한 정보를 얻기 위하여 문헌에 제시된 여러 가지의 속도론 해석방법을 이용하여 질량감소곡선 및 그 미분 값을 해석하였다. 또한 회분식 열분해 반응기를 이용하여 반응온도에 따른 액상 생성물의 수율변화를 고찰하였으며 GC-MS를 이용하여 액상 생성물의 반응온도 증가에 따른 특성연구를 수행하였다.

• Analytical Science and Technology
• /
• v.25 no.1
• /
• pp.50-59
• /
• 2012

In this study, the effect of humidity change on DNPH cartridge sampling efficiency for carbonyl compounds (CCs) has been investigated. For this analysis, gaseous standard of 6 different CCs (formaldehyde (FA), acetaldehyde (AA), propionaldehyde (PA), butyraldehyde (BA), isovaleraldehyde (IA), and valeraldehyde (VA)) was calibrated after derivatization with three types of DNPH cartridge products. Their calibration results derived at RH values between 0 and 80% were then compared against liquid phase standards. If the results of our analysis are compared by the RH values between 20 and 80%, the effect of RH can be distinguished between light and heavy CCs. For lighter CCs (like FA and AA), there was no significant change. However, for the ones heavier than PA, there was fairly noticeable increase in relative recovery ratio in RH value between 20 and 80%. Such patterns are seen consistently from all three DNPH products tested for comparison. The results of our analysis suggest that proper correction for RH change may be needed for heavier CCs by the cartridge method.

• Food Science and Preservation
• /
• v.10 no.4
• /
• pp.498-505
• /
• 2003

This was studied to evaluate the rheology properties of the Dumpling shell added chitosans(commercial and prepared from fungal), polyphosphate, guargum and tapioca. The physicochemical properties of fungal chitosans (FCs95 and FCs 40) were as follows respectively. The nitrogen was 6.71% and 6.9％, the solubility 99.05% and 99.13％, the viscosity 2.23cps and 2.21cps, the acetylation 12.0% and 12.7% and the molecular weight 3.12${\times}$10$\^$5/Dalton and 3.01${\times}$10$\^$5/Dalton. From the above facts, the components and physicochemical properties of two kinds of fungal chitosan had little difference. The addition of polyphosphate, guargum and tapioca showed effect on the texture parameters(hardness, cohesiveness, springiness and gumminess) of Dumpling shell dough and the optimum addition concentration wag 0.074%, 6.59% and 0.062%(w/w), respectively. In case of chiotsans addition, texture of the dough by added SCs, FCs95 and FCs40 showed effect.

• Journal of Korean Society for Atmospheric Environment
• /
• v.24 no.2
• /
• pp.133-142
• /
• 2008

Five intensive measurements of particulate PAHs were made at a roadside in Seoul from May 2005 to June 2006. The average concentration of particulate PAHs was $15.1{\pm}10.6ng\;m^{-3}$. The high concentrations of particulate fluoranthene and pyrene were observed in November 2005 due to the influence of the lower ambient temperature. Compared to the previous results at tunnel and ambient sites in Seoul, larger fraction of the high molecular PAH compounds which consist with five or six benzene rings, was observed at a roadside. This might indicate high influence of vehicle emission at a roadside. The distribution of diagnostic ratios for specific PAH compounds indicated that the influence of vehicular emission, especially diesel vehicular emission seems to be high at a roadside.

• Proceedings of the Korean Printing Society Conference
• /
• 2001.06a
• /
• pp.91-91
• /
• 2001

환경문제에 대해 오래 전부터 관심을 가져온 선진국은 잉크의 수성화에 주력하여 왔으며, 그 결과 이미 수용성 소재의 양산체재에 들어가 수성 원료 사업을 대형화하는 추세에 있다. 이에 한화석유화학 중앙연구소에선 스티렌/아크릴계 수용성 High Solid 수지를 개발하여, 수성 잉크용 분산제, Resin Fortified Emulsion (RFE), UV Resist 잉크, 수성코팅제, 바닥광택제 등에 적요하기 위한 응용기술을 개발하였다. 본 연구는 수성 잉크의 주요 구성 성분인 grinding vehicle. let-down vehicle로 사용되는 수용성 High Solid 수지 (SAA 수지) 및 이를 이용한 에멀젼 수지의 합성과 수성 잉크로의 응용에 대한 것이다. SAA(HCC Soluryl Resin) 수지는 구조적으로 Styrene, Alpha-methyl Styrene, crylic Acid의 삼원공중합체이며 약 70%의 소수성 물질과 30%의 친수성 물질이 Random 하게 중합되어 있으며 약 5000∼15000정도의 낮은 분자량을 가진 물질로, 고고형분에서도 낮은 점도를 유지하기 위하여 분자량과 좁은 분자량과 좁은 분자량을 가지는 수지를 연속벌크중합방법으로 합성하였다. 또한 이를 고분자 유화제로서 사용하여 수지보강 에멀젼수지 (RFE 수지, HCC Soluryl Emulsion) 를 제조하는데 사용하였으며, SAA수지 및 RFE수지를 수성잉크용 분산제, 잉크 바인더용으로 적용하였다.

• Proceedings of the KOR-BRONCHOESO Conference
• /
• 1993.05a
• /
• pp.88-88
• /
• 1993

Immunohistochemical staining for keratin proteins may be useful as a diagnostic parameter in head and neck neoplasm. Our study evaluates the keratin antibody staining properties of normal tissues and squamous cell carcinoma of the vocal folds from surgical procedures performed on 27 cases. In normal epithelia, low molecular weight cytokeratins were strongly positive in basal layer but apparently reduced in suprabasal layers and completely negative in superficial layer. In invasive squamous cell carcinomas, low molecular weight anti-ck Ab were positive in all carcinoma cells of poorly differentiated carcinomas. On the other hand, high molecular weight anti-ck Ab were positive in almost carcinoma cells of well differentiated carcinomas.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.13-13
• /
• 2009

본 연구는 MLCC 구성성분의 증발/비등에 의한 저분자물질의 제거가 bar 수축에 미치는 영향도를 평가하기 위해, 압착 bar에서 발생하는 고농도의 out gas를 정량하기 위한 최적 system을 구축하고자 하였다. gas 포집에 범용적으로 사용하는 Purge & Trap sampler 대신 Heating block를 사용하여 gas를 발생시키고 동시에 solvent에 용해시킴으로써 고농도의 시료가 희석될 수 있는 전처리 장치를 디자인하였다. 그 결과 고농도 gas 주입에 의한 장비오염과 peak saturation 문제가 해결되었고, gas phase의 시료를 liquid phase로 상전이 시켜 autosampler를 이용한 정확한 량의 시료 주입이 가능하였다. System의 Gage Linearity와 Bias는 각각 1.7%와 1.3%로 개선이 필요없는 수준의 정확도를 가졌다.

• Polymer(Korea)
• /
• v.31 no.4
• /
• pp.289-296
• /
• 2007

The material factors influencing the sound absorption of the polyurethane foam were investigated with FT-IR, small-angle X-ray scattering (SAXS), and dynamic mechanical thermal analyzer (DMTA). The measurements were performed using the samples which had a similar cell structure but different absorption coefficients. It was found that the ability of the sound absorption of the polyurethane foams was closely related to the damping behavior over the transition range. In order to confirm the use of the low monol polyol (LMP) in high-performance applications, the polyurethanes based on LMP and polypropylene oxide polyol (PPG) were prepared by the solution polymerization method. The microstructure and the physical properties of these polyurethanes were compared. The PPG-based polyurethane showed a higher level of the phase-separated structure because the considerable amount of monol presented in PPG made a contribution to the increased chain mobility. However the short chains formed due to the monol species deteriorated the damping property. As a result, the LMP-based polyurethane showed the superior damping behavior as compared with the PPG-based one.

• Microbiology and Biotechnology Letters
• /
• v.30 no.1
• /
• pp.39-45
• /
• 2002

It was found that the peptides originated from the hydrolysates of silk fibroin have in vitro immunostimulating effects in murine macrophage RAW264.7 cells. The stimulation effects on nitric oxide (NO) production resulted from treatments of acid or enzymatic hydrolysates were measured. The silk fibroin preparation isolated from cocoon was most efficiently digested by acid hydrolysis. Even though the sole treatment of acid hydrolysate stimulated the NO production in dose-dependent pattern, a part of its activity was found to be caused by the contaminated endotoxin, LPS. When each endotoxin-free hydrolysates obtained by filtering it through an ultrafiltration membrane of molecular weight (MW) cut-off 10,000 to eliminate LPS was used, the peptic hydrolysate with lowest degree of hydrolysis showed the highest activity. The fractions of peptic hydrolysate with MW ranges of 1,000∼10,000, 500∼1,000 and below 500 also showed a higher MW-higher activity correlation. From the analyses of amino acid composition of each hydrolysate, it was found that the contents of arginine, lysine, alanine and glycine residues affected the activity level of hydrolysate. The results of this study showed a possibility of utilizing fibroin as a source for immunostimulating (chemopreventive) functional peptides.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.44 no.4
• /
• pp.447-453
• /
• 2018

Acetyl hexapeptide 8 (AH8) is a synthetic peptide for anti-wrinkle cosmetics ingredient. It was developed as a mimetic of botox, patternd after N -terminal end of the protein synatosomal-associated protein 25 (SNAP25), a substrate of botulinum toxin. While AH8 has good efficacy and safety profiles, the permeation through the skin is poor. Therefore, we tried to enhance the transdermal delivery of AH8 by using of hyaluonic acid (HA), a linear polysaccharide of N-acetyl glucosamine and glucuronic acid. To investigate the effect of HA on AH8 penetration, we analyzed paraffin sections of $Micropig^{(R)}$ skin. Fluorescence labeled AH8 was applied to micropig skin with or without HA. The absorption of AH8 was limited to the stratum corneum (SC) without HA. On the other hand, AH8 penetrated to the dermis with HA. Especially, low molecular weight HA (5 kDa) was most efficient compared to 500 kDa HA and 2000 kDa HA. Experiments using fourier-transform infrared (FTIR) spectroscopy revealed that lower molecular weight HA had a tendency to increase the fluidity of the SC lipids more, which means enhancing the skin penetration. Therefore, HA could be expected to enhance the anti-wrinkle effect of AH8.