• Journal of Energy Engineering
• /
• v.10 no.2
• /
• pp.153-160
• /
• 2001

본 연구에서는 고온 분위기 온도 및 대기압 하에서 액적의 급속가열과 연소가 가능한 고온 연소로 장치와 고속도 비디오 카메라를 이용하여 다조성 단일 액적 연소에 대해 고찰하였다. 그 결과 저비점 성분을 혼합한 경유의 액적은 기본적으로 입경의 2승 법칙에 의해서 감소되었으며, 그 과정에서 입경이 일시적으로 급속히 감소하는 현상이 보여짐과 더불어 연소기간도 단축되었다. 즉, 저비점 성분을 혼합한 경유의 액적은 미세폭발 현상에 의해 기존 디젤 연료에 비해 더 빨리 증발되고 연소가 되었다. 또한, 순수 파라핀계 및 함산소계 연료의 화염은 전체 연소기간동안 기존 경유의 화염에 비해 푸른색을 띠고 있어, 매연이 없는 연소를 입증해 주었다.

• Journal of Energy Engineering
• /
• v.18 no.2
• /
• pp.101-107
• /
• 2009

The combustion characteristics of a single droplet of diesel and bio-diesel have been investigated experimentally with varying droplet size, ambient temperature and compound ratio in a high temperature chamber. The fuels used were diesel with bio-diesel contents varied from 0% to 100%. Each experiment has been performed from 970K to 1070K by 50K intervals. Imaging with a high-speed digital camera was adopted to measure the ignition delay and flame life-time, as well as to observe micro-explosion behavior. The increase of droplet size and decrease of furnace temperature cause an increase of the ignition delay time. As the bio-diesel content decreases, the ignition delay increases and the micro-explosion behavior is strengthened. It is also confirmed that the full combustion time decreases as the micro-explosion occurred.

• Journal of the korean Society of Automotive Engineers
• /
• v.11 no.2
• /
• pp.34-40
• /
• 1989

본 연구에서는 유화연료 액적의 연소시에 나타나는 일반적인 연소특성과 이에 미치는 압력의 영향에 대하여 실험적인 방법으로 연구를 수행하였다. 고압용기내에서 유화연료의 단일 액적을 연소시키면서 그 연소과정을 고속으로 촬영하여 분석하는 한편, 연소과정중의 액적 내부의 온도변화를 측정하였다. 고압 용기내의 압력은 대기압으로부터 10atm까지, 연료에 대한 물의 혼합비는 체적비로 0-20%까지 변화시키면서, 유화연료 액적의 연소특성에 미치는 물의 함량과 압력변화의 영향을 분석하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.30 no.5
• /
• pp.552-561
• /
• 2006

The single droplet combustion characteristics of diesel fuel and low quality oil with additive oxygenate and paraffin under high ambient temperature and atmospheric pressure were investigated in the study. The results of the study may are concluded as follows: In the combustion of diesel fuel and low quality oil droplet with additive of oxygenate and paraffin. the dimensionless droplet size of $(D/Do)^2$ was linearly decreased with time. A fuel droplet with low boiling temperature additives and in high boiling temperature base fuel evaporates and burns faster than usual base fuel. Especially. these trends were remarkably obtained by decreasing boiling point and increasing blending contents of additives in case of oxygenated agents rather than n-paraffin agents. This rapid burning may result from so-called 'micro-explosion' and its burning intensity varies with the types of additives. The results above may suggest that rapid evaporation of oxygenate additive in the middle stage of combustion can contribute much to combustion improvement of blended fuels.

• Particle and aerosol research
• /
• v.8 no.2
• /
• pp.55-68
• /
• 2012

Particulate matters (PM) which are collected into a diesel particulate filter (DPF) system have to be periodically removed by thermal oxidation. In this report, we fabricated an electrohydrodynamic-assisted pressure-swirl nozzle to spray diesel droplets finer. Atomization performance of the nozzle was evaluated using both experimental and numerical methods. Two types of nozzle designs, the charge induction type and the charge injection type, were tested. While the former generated diesel droplets of $400\;{\mu}m$ at an applied electric potential over 10 kV, the latter presented the droplets smaller than $23\;{\mu}m$ at an applied electric potential of 8 kV. The numerical simulation results showed that the reduced size of droplets caused higher evaporation of droplets and therefore the increased temperature, which would eventually increase the regeneration performance of the DPF system.