• Proceeding of EDISON Challenge
• /
• 2013.04a
• /
• pp.415-420
• /
• 2013

천음속 영역에서 비행하는 에어포일 주위의 유동은 아음속 영역과는 달리 충격파(Shockwave)를 동반하고 이에 따라 복잡한 유동 현상이 발생한다. 본 연구는 천음속 영역에서 설계된 에어포일 주위의 유동에서 충격파 발생에 따른 유동변화의 특징들을 관찰하였다. 특히, 충격파에 의해서 발생하는 진동(Buffeting)과 경계층 유동 박리(Shock-induced boundary layer separation)현상에 대한 관찰과 일반적인 에어포일과 초임계 에어포일(Supercritical airfoil)간의 유동 특성의 차이점을 분석하였다. 본 연구를 위해서 EDISON CFD코드가 사용되었다.

• Proceedings of the Korean Society of Disaster Information Conference
• /
• 2015.11a
• /
• pp.162-165
• /
• 2015

본 연구는 ${\bigcirc}{\bigcirc}$ 공구 공유수면 매립공사 수행 중에 매립토량의 부족이 발생함에 따라 이를 대상으로 원인을 분석하고자 수행하였다. 매립지의 토량부족 원인을 파악하기 위해 설계 및 계측자료를 수집하여 시공 현황을 파악하고 지반조사를 통해 해안지역과 매립지반의 시료를 채취하여 성상분석과 원지반에 대한 공학적 특성을 비교 검토하였다. 특히. 현장 시추조사에 의한 경계면 분석과 토질 종류를 점성토, 사질토, 부유토로 구분하고 침하량 공식에 따라 발생량을 산출하였다. 구역의 구분은 설계 시와 동일한 조건에서 침하량을 계산하였고 설계 시 지반고가 침식과 퇴적으로 인해 일부 변경되어 설계시 지반고와 착공시 지반고를 구분하여 기재하고 각각의 침하량을 비교하였다.

• The Korean Journal of Applied Statistics
• /
• v.11 no.2
• /
• pp.363-376
• /
• 1998

The linear smoothing spline estimator is modified to remove boundary bias effects. The resulting estimator can be calculated efficiently using an O(n) algorithm that is developed for the computation of fitted values and associated smoothing parameter selection criteria. The asymptotic properties of the estimator are studied for the case of a uniform design. In this case the mean squared error properties of boundary corrected linear smoothing splines are seen to be asymptotically competitive with those for standard second order kernel smoothers.

• Proceedings of the Korea Multimedia Society Conference
• /
• 2002.05c
• /
• pp.272-276
• /
• 2002

본 논문은 영역을 병합할 때 두 영역의 색상 차를 영역 병합의 제한 조건으로 사용하는 칼라 영상 분할 기법을 제안하였다. 이는 먼저 영역의 경계선 정보를 잘 보존하기 위해서 RGB 공간상에서 수리형태학 필터와 변형된 워터쉐드 알고리즘을 이용하여 칼라 영상을 과분할 한다. 그리고 영역 간의 색상 차를 제한 조건으로 사용하는 영역 병합 과정을 반복 수행하여 칼라 영상의 분할 결과를 얻는다. 이는 인간 시각 시스템이 색상, 채도, 명도의 형태로 색을 구분하는 것을 기반으로 한다. 명도가 낮지 않는 경우에 색차 보다 색상 차가 중요한 요소로 작용하기 때문에 이를 영역 병합의 제한 조건으로 사용한다. 실험결과에서 제안된 칼라 영상 분할 기법은 다양한 칼라 영상에 대하여 적은 개수의 영역으로 동일한 색상을 가지는 영역의 경계선을 유지하는 효율적인 분할을 보임을 확인하였다.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.15 no.11
• /
• pp.895-901
• /
• 2003

Direct numerical simulation database of an axial turbulent boundary layer is used to compute frequency and wave number spectra of the wall shear-stress fluctuations in a low-Reynolds number axial turbulent boundary layer. One-dimensional and two-dimensional power spectra of flow variables are calculated and compared. At low wave numbers and frequencies, the power of streamwise shear stress is larger than that of spanwise shear stress, while the powers of both stresses are almost the same at high wave numbers and frequencies. The frequency/streamwise wave number spectra of the wall flow variables show that large-scale fluctuations to the ms value is largest for the streamwise shear stress, while that of small-scale fluctuations to the rms value is largest for pressure. In the two-point auto-correlations, negative correlation occurs in streamwise separations for pressure and spanwise shear stress, and in spanwise correlation for both shear stresses.

• Journal of KIISE:Software and Applications
• /
• v.27 no.5
• /
• pp.529-542
• /
• 2000

Recent years, the use of multimedia information is rapidly increasing, and the video media is the most rising one than any others, and this field Integrates all the media into a single data stream. Though the availability of digital video is raised largely, it is very difficult for users to make the effective video access, due to its length and unstructured video format. Thus, the minimal interaction of users and the explicit definition of video structure is a key requirement in the lately developing image and video management systems. This paper defines the terms and hierarchical video structure, and presents the system, which construct the clustering-based video hierarchy, which facilitate users by browsing the summary and do a random access to the video content. Instead of using a single feature and domain-specific thresholds, we use multiple features that have complementary relationship for each other and clustering-based methods that use normalization so as to interact with users minimally. The stage of shot boundary detection extracts multiple features, performs the adaptive filtering process for each features to enhance the performance by eliminating the false factors, and does k-means clustering with two classes. The shot list of a result after the proposed procedure is represented as the video hierarchy by the intelligent unsupervised clustering technique. We experimented the static and the dynamic movie videos that represent characteristics of various video types. In the result of shot boundary detection, we had almost more than 95% good performance, and had also rood result in the video hierarchy.

• Geophysics and Geophysical Exploration
• /
• v.15 no.2
• /
• pp.92-101
• /
• 2012

Three-dimensional finite-difference simulation in a small-scale half-sphere basin with planar free-surface is performed for an arbitrary shear-dislocation point source. A new scheme to deal with free-surface boundary condition is presented. Then basin parameters are examined to understand main characteristics on ground-motion response in the basin. To analyze the frequency content of ground motion in the basin, spectral amplitudes are compared with each other for four sites inside and outside the basin. Also particle motions for those sites are examined to find which kind of wave plays a dominant role in ground-motion response. The results show that seismic energy is concentrated on a marginal area of the basin far from the source. This focusing effect is mainly due to constructive interference of the direct Swave with basin-edge induced surface waves. Also, ground-motion amplification over the deepest part of the basin is relatively lower than that above shallow basin edge. In the small-scale basin with relatively simple bedrock interface, therefore, the ground-motion amplification may be more related to the source azimuth or direction of the incident waves into the basin rather than depth of it.

• Journal of the Korean Wood Science and Technology
• /
• v.36 no.6
• /
• pp.59-68
• /
• 2008

This study was carried out to investigate the effects of the Inside end-taping (Inside-ET) and Outside end-taping (Outside-ET) treatments on prevention of drying defects during radiofrequency/vacuum (RF/V) drying domestic yellow poplar log cross section with size of 20~75 mm in thickness and 120~470 mm in diameter. The treatments of Inside-ET and Outside-ET were quite effective for producing sound log cross sections with thinner than 33 mm and smaller than 270 mm in diameter. Even the 60 mm- and 75 mm-thick log cross sections, if the diameter was smaller than 30 cm, it might expect preventing formation of border checks by appropriate end-taping treatments. The positions of the observed border checks differed in diameter ranging at a relative radius about 0.50~0.63 diameter, and it was estimated that it was necessary to select the border position of end-taping treatment properly according to the diameter of log cross sections. It was observed that the radius of 0.3 diameter was the critical location for pretreatment for preventing formation of border checks in the log cross section with middle diameter. There were severe border checks and V-shaped cracks in the log cross section with large diameter. This was because of the severe variation of moisture content along radial direction of natural characteristic of domestic yellow poplar.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.8
• /
• pp.75-84
• /
• 2013

Soil freezing is a phenomenon arising due to temperature difference between atmosphere and ground, and physical properties of soils vary upon the phase change of soil void from liquid to solid (ice). A heat-transfer mechanism for this case can be explained by the conduction in soil layers and the convection on ground surface. Accordingly, the evaluation of proper thermal properties of soils and the convective condition of ground surface is an important task for understanding freezing phenomenon. To describe convection on ground surface, simplified coefficient methods can be applied to deal with various conditions, such as atmospheric temperature, surface vegetation conditions, and soil constituents. In this study, two methods such as n-factor and convection coefficient for the convective ground surface boundary were applied within a commercial numerical program (TEMP/W) for modeling soil freezing phenomenon. Furthermore, the numerical results were compared to laboratory testing results. In the series of the comparison results, the convection coefficient is more appropriate than n-factor method to model the convective boundary condition.

• Journal of KIISE:Computer Systems and Theory
• /
• v.29 no.11
• /
• pp.589-600
• /
• 2002

Deformable models offer an attractive approach for extracting three-dimensional boundary structures from volumetric images. However, conventional deformable models have three major limitations - sensitive to initial condition, difficult to represent complex boundaries with severe object concavities and protrusions, and self-intersective between model elements. This paper proposes a deformable model that is effective to extract geometrically complex boundary surfaces by improving away the limitations of conventional deformable models. First, the proposed deformable model resamples its elements hierarchically based on volume image pyramid. The hierarchical resampling overcomes sensitivity to initialization by extracting the boundaries of objects in a multiscale scheme and enhances geometric flexibility to be well adapted to complex image features by refining and regularizing the size of model elements based on voxel size. Second, the physics-based formulation of our model integrates conventional internal and external forces, as well as a non-self-intersecting force. The non-self-intersecting force effectively prevents collision or crossing over between non-neighboring model elements by pushing each other apart if they are closer than a limited distance. We show that the proposed model successively extracts the complex boundaries including severe concavities and protrusions, neither depending on initial position nor causing self-intersection, through the experiments on several computer-generated volume images and brain MR volume images.