• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.3 no.3
• /
• pp.117-127
• /
• 1983

An experimental research was performed employing the two stage anaerobic digestion of the mixture of the nightsoil and septic tank sludge to determine the effects of various hydraulic retention time of the digestion on chemical characteristics and treatment effeciency, thus determining the proper retention time. Results of the research are as follows, 1. Volatile-acid decreased as HRT increased. 2. Alklinity and ammonia-N tended to increase as HRT increased as did pH values, however, were observed to be constant at higher HRT values than 15 days. 3. The removal efficiencies of TBOD, TCOD and VS increased as HRT increased. 4. The removal efficiency of volatile solid decreased as VS loading increased. 5. It was observed that the rates of gas production were: 0.33 with HRT of 5 days, 0.58 with HRT of 15 days and $0.57m^3/kg$ VS fed/day with HRT of 25 days respectively. It is believed that the highest rate of gas production was at HRT of 15 days. 6. The sludge settling experiment showed that the minimum settling time required to ensure the desired underflow concentraton was estimated to be 8.6 days.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.2
• /
• pp.171-179
• /
• 2013

The thermodynamic characteristics of a combined cycle applied with a topping cycle such as a trilateral cycle at relatively high temperatures and a bottoming cycle such as an organic Rankine cycle at relatively low temperatures have been theoretically investigated. This is an electric generation system used to recover the waste heat of the exhaust gas from a diesel engine used for the propulsion of a large ship. As a result, when the boundary temperature between the topping and the bottoming cycles increased, the system efficiencies of energy and exergy were simultaneously maximized because the total exergy destruction rate (${\sum}\dot{E}_d$) and exergy loss ($\dot{E}_{out2}$) decreased, respectively. In the case of a marine diesel engine, the waste heat recovery electric generation system can be utilized for additional propulsion power, and the propulsion efficiency was found to be improved by an average of 9.17 % according to the engine load variation, as compared to the case with only the base engine. In this case, the specific fuel consumption and specific $CO_2$ emission of the diesel engine were reduced by an average of 8.4% and 8.37%, respectively.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.2 no.2
• /
• pp.138-150
• /
• 1997

The late Quaternary stratigraphy of the tidal deposits in the Hampyung Bay, southwestern coast of Korea comprises 1) Unit III (nonmarine fluvial coarse-grained sediments), 2) Unit II (late Pleistocene tidal deposits), and 3) Unit I (late Holocene fine-grained tidal deposits) in ascending order. The basements of the Hampyung Bay is composed of granitic rocks and basic dyke rocks. These three units are of unconformally bounded sedimentary sequences. The sequence boundary between Unit I and Unit II, in particular, seems to be significant suggesting erosional surface and exposed to the air under the cold climate during the LGM. The uppermost stratigraphic sequence (Unit I) is a common tidal deposit formed under the transgression to highstand sea-level during the middle to late Holocene.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.22 no.1
• /
• pp.82-89
• /
• 2016

In this study, we proposed a pier of pontoon-type, "Very Large Floating Structure" (VLFS), with the length of 500m, breadth of 200 m and height of 2 m in Yeosu domestic port. Since this structure ought to endure wave loads for long periods at sea, it is essential to analyze the wave response characteristics. Direct-method is used to analyze the fluid-structure problem and the coupled motion of equation is used to obtain response results. The structural part is calculated by using finite element method (FEM) and the fluid part is analyzed by using boundary element method (BEM). Dynamic responses caused by the elastic deformation and rigid motion of structure are analyzed by numerical calculation. To investigate response characteristics of the pier in regular waves, several factors such as the wavelength, water depth, wave direction and flexural rigidity of structure are considered. As a result, wave response of pier changed at the point of $L/{\lambda}$ 1.5 and represented the torsional phenomenon according to the various incident waves. And the responses showed increasing tendency as the water depths increase at the incident point in case of $L/{\lambda}=8.0$ and peak point of vertical displacement amplitude moved from side to side as the flexural rigidity of structure changes.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.3
• /
• pp.36-46
• /
• 2011

At present, the number of local governments using the Traffic Information Center are increasing and drivers are utilizing its traffic information from VMS installed on roads in cities. However, the cases of the user's utility of VMS about urban roads with special characteristics different from expressways and urban highways haven't been evaluated so far. Because VMS is a medium installed from a budget to provide traffic information, it is necessary to evaluate and manage the efficiency of users. This study judged that the efficiency of the drivers using VMS of urban roads most influences the duty on alternative route information provision so that it established its evaluation criteria. In addition, it needs to raise its value by many drivers' observation of VMS. Therefore, in case of the same conditions, the installation location of VMS should be a road section with much traffic volume so its the evaluation criteria was established. At present, the study results can be utilized to raise the user's utility of VMS installed in the urban roads.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.7
• /
• pp.61-69
• /
• 2010

In this paper, an 1.2V 8b 800MSPS A/D Converter(ADC) with an odd number of folding block to overcome the asymmetrical boundary-condition error is described. The architecture of the proposed ADC is based on a cascaded folding architecture using resistive interpolation technique for low power consumption and high input frequency. The ADC employs a novel odd folding block to improve the distortion of signal linearity and to reduce the offset errors. In the digital block, furthermore, we use a ROM encoder to convert a none-$2^n$-period code into the binary code. The chip has been fabricated with an $0.13{\mu}m$ 1P6M CMOS technology. The effective chip area is $870{\mu}m\times980{\mu}m$. SNDR is 44.84dB (ENOB 7.15bit) and SFDR is 52.17dBc, when the input frequency is 10MHz at sampling frequency of 800MHz.

• Journal of Service Research and Studies
• /
• v.7 no.3
• /
• pp.21-36
• /
• 2017

Recently in information business, managing and auditing are getting more difficult because of enlargement, intellectualization and convergence. In addition, ordering organizations have been having a difficult time choosing a service because not only there is a huge overlap between information audit system and PMO but also the work boundaries of those two are not clear enough. As the demand that a business managing and auditing frame work need to be more developed in terms of independence, quality, economic feasibility and responsibility has been increased, the Korea Association Of Information Systems Audit has been attempting to improve business management and audit system by proposing Unified Project Management Framework whose process is approximately constructed. This study introduces Unified Project Management Framework which is all-encompassing from the ordering at the very beginning of business to the operating in the post-processing step and then verifies its work scope through a comparative analysis with existing management systems. Also, this thesis examines the necessity of unification of audit system and PMO by analysing existing similar systems. At the end, this study, analyses the suitability of Unified Project Management Framework by evaluating it with IT goal frame of COBIT5 which is constructed based on BSC performance management index. The result of the analysis is expected to help people in charge understanding the features of Unified Project Management Framework before they apply it to practical business.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.37 no.1
• /
• pp.23-36
• /
• 2011

The purpose of this study is to make theoretical examinations into the makeup trend shown in digital communication environment and thereby determine potential associations of makeup trend with digital communication environment and characterize said trend, so that it can provide reference materials required for follow-up studies. This study comes to the following findings: First, it is found that there are sociocultural characteristics of digital communication environment, such as interactivity, technology-orientedness, sentiment-orientedness and mixture of time and space. Secondly, it is found that trends developed in makeup fall categorically into interactivity, virtuality, amusement and mobility. Thirdly, it is found that each type of digital communication adopts a mixture and juxtaposition of contemporary styles or categories with traditional ones through eclectic combination based on open-minded and horizontal ideas. Fourthly, it is found that a trend from digital communication environment doesn't coincide perfectly with any makeup trend, but the former trend works interactively and organically with the latter trend on the basis of homogeneity and similarity within a general framework that represents external esthetics of human being. With the creation of digital communication environment, our contemporary society forms as the complex phenomena of digital society in a combination and destruction of different categories beyond any certain international boundary, so that a hybrid tendency appears in contemporary makeup trend as well. Based on these findings, this study has its implications in the sense that it gives a new viewpoint based on design, formative characteristics and expression styles of makeup, and also provides useful reference materials for related industrial sectors.

• Geophysics and Geophysical Exploration
• /
• v.20 no.3
• /
• pp.137-145
• /
• 2017

High-grade limestone applied to various chemical industries is abundant within upper Pungchon formation in Taebaeksan basin, South Korea. Geophysical exploration is one of the most efficient methods to investigate subsurface geological structure in an extensive area. Since the geophysical exploration for the high-grade limestone has rarely been conducted in Korea, its appropriate strategy has not been set up yet. In this study, we focused on to suggest the reasonable strategy and accumulate geophysical databases which are essential for interpreting geophysical images by characterizing laboratory physical properties of in-situ rocks. Hence, rocks were obtained from drilled cores consisting of lower Hwajeol formation, Pungchon formation, and dykes in Jeongseon area, Gangwon province. Geophysical laboratory experiments and petrography of the rocks were conducted. Since susceptibility values of the rocks in Pungchon Formation were obviously lower than those of upper Hwajeol and dykes, it is considered that the lithological boundaries could be distinguished by magnetic survey. In addition, electrical properties of the rocks in middle Pungchon formation were relatively different compared with those of upper/lower Pungchon formations. Thus, induced polarization is shown to be able to detect the high-grade limestone in upper Pungchon formation.

• Geophysics and Geophysical Exploration
• /
• v.20 no.3
• /
• pp.176-184
• /
• 2017

To interpret the seismic image precisely, random noises should be suppressed and the continuity of the image should be enhanced by using the appropriate smoothing techniques. Structure-Oriented Filter-Edge Preserving (SOF-EP) technique is one of the methods, that have been actively researched and used until now, to efficiently smooth seismic data while preserving the continuity of signal. This technique is based on the principle that diffusion occurs from large amplitude to small one. In a continuous structure such as a horizontal layer, diffusion or smoothing is operated along the layer, thereby increasing the continuity of layers and eliminating random noise. In addition, diffusion or smoothing across boundaries at discontinuous structures such as faults can be avoided by employing the continuity decision factor. Accordingly, the precision of the smoothing technique can be improved. However, in the case of the structure-oriented semblance technique, which has been used to calculate the continuity factor, it takes lots of time depending on the size of the filter and data. In this study, we first implemented the SOF-EP method and confirmed its effectiveness by applying it step by step to the field data. Next, we proposed and applied the corner response method which can efficiently calculate the continuity decision factor instead of structure-oriented semblance. As a result, we could confirm that the computation time can be reduced by about 6,000 times or more by applying the corner response method.