• Journal of the Korean Chemical Society
• /
• v.31 no.6
• /
• pp.491-497
• /
• 1987

$ThO_2-Tm_2O_3$ (TDT) solid solutions containing 1,3,5,8,10, and 15 mol% $Tm_2O_3$ were synthesized from spectroscopically pure $ThO_2$ and $Tm_2O_3$ polycrystalline powders. The TDT solid solutions were indentified to the fluorite structure by the X-ray powder technique. The values of the lattice parameter were decreased with increasing amount of $Tm_2O_3$ incorporated. But, there was no linearity for the samples containing 8, 10, and 15 mol% $Tm_2O_3$. It was concluded that these samples became incomplete solid solutions. From the intensity analyses of X-ray diffraction patterns, the residual factor was found below 0.13 even for the 15 mol% TDT system. lt was confirmed from the DTA and TGA analyses that any phase transitions did not occur under the experimental condition executed. Comparing the pycnometric density with the lattice parameter obtained from XRD, it was suggested that the predominant defect model be an oxygen vacancy.

• Korean Journal of Materials Research
• /
• v.9 no.3
• /
• pp.234-239
• /
• 1999

A Abstract Yttria-stabilized zirconia(YSZ) thin films were synthesized by plasma enhanced chemical vapor deposition process. $Zr[TMHD]_4$ $Y[TMHD]_3$ precursors and oxygen were used with the deposition temperature of $425^{\circ}C$ and rf power ranging 0-100 watt. Effects of the deposition parameters were studied by X-ray diffraction and thickness anal­ysis. YSZ thin films have cubic crystal structure with (200) orientation. From the results of EDX analysis, the converte ed content of TEX>$Y_2O_3$ was determined to be 0-36%, and the film thickness was increased with bubbling temperature which is considered to be due to increasing TEX>$Y_2O_3$ flux. The depth profiles of Zr, Y and 0 appeared relatively $\infty$nstant through film thickness. Columnar grains of $1000~2000\AA$ grew vertical to the substrate surface for the case of Ar carri­er gas. In case of He carrier gas, the grain size was observed to be about $1000~2000\AA$. X-ray diffraction data showed the increase of lattice constant with TEX>$Y_2O_3$ content. It was that the presence of the cracks formed during film deposition, partially released the stress generated by the increase of lattice constant.

• Korean Chemical Engineering Research
• /
• v.57 no.3
• /
• pp.331-337
• /
• 2019

Titania has become the most applicable material for photocatalytic application. Nevertheless, titania has the weak point in its wide band gap energy that is mainly activated by UV irradiation. There have been vast research challenges in order to make the wide band gap energy of titania narrow that could be activated in the presence of visible light. Various modifications of titania surface were popular because titania needs to change its surface to respond in visible light. Among the methodological approaches, N-doping to titania can be the alternative candidate because it is facile process and eco-friendly. The activated electron from valence band in N-doped $TiO_2$ migrates to conduction band in the presence of visible light irradiation, which shows photocatalytic activity as well. In this study, focused on the evaluation of nitrogen state after N-doping through brief review. Arguments are still existed in nitrogen states and their different effects on photocatalytic activity. In particular, two nitrogen states are generally reported; substitutional and interstitial states. The research articles regarding N-doped $TiO_2$ are continuously appearing because the potential application of water split in visible light is still fascinate. The future of N-doped $TiO_2$ is also presented by referrals based on various literature.

• Korean Journal of Materials Research
• /
• v.4 no.8
• /
• pp.934-944
• /
• 1994

Effects of residual chloride on thermal decomposition behaviour of a-stannic acid and physical properties of $SnO_{2}$ powder were observed. The powder was fabricated by hydroxide method; $\alpha$-stannic acid was precipitated by mixing acqueous solutions of $SnCl_{4}$ and $NH_{4}$OH . The precipitate was washed with $NH_{4}NO_{3}$ solution while washing was controlled to be of three grades to modify its residual chloride content. The precipitate was dried at $1100^{\circ}C$ ~ 24h and calcined in air at $500^{\circ}C$ ~ $1100^{\circ}C$ for one hour. Thermal decomposition behaviour of $\alpha$-stannic acid was examined by a DT-TGA and a FTIR. Chemical composition and physical properties of $SnO_{2}$ powder were observed by an AES, a BET and a TEM, respectively. With a reduction in chloride content, the relative crystallite size of $SnO_{2}$ powder slightly increased by a low-temperature-calcining. However, at a high calcining temperature(T), the reverse relation occured. It was suggested that chloride ion replaces part of lattice oxygen site of a-stannic acid. Also, chloride ion on the site was suggested to retard de-hydration as well as crystalization at a low T while to promote crystal growth of $SnO_{2}$ by forming oxygen vacancy at a high T.

• Journal of the Korean Chemical Society
• /
• v.38 no.12
• /
• pp.873-879
• /
• 1994

A series of samples of solid solutions in the $Sr_xEu_{1-x}FeO_{3-y}(0.00{\leq}x{\leq}1.00)$ system has been prepared at $1200^{\circ}C$ under an atmospheric air pressure. The structures of solid solutions are studied by X-ray diffraction, thermal, Mohr salt, and Mossbauer spectroscopic analyses. Their physical properties are also discussed with the electrical conductivities. X-ray diffraction data for the compositions of x = 0.00, 0.25, and 1.00 are assigned to the orthorhombic and the compositions of x = 0.50 and 0.75 to the cubic systems. The lattice volume reduced to cubic cell increases with the x value. The mole ratio of $Fe^{4+}$ iometric chemical formulas of the system are formulated from the x, $\tau$, and y values. The mixed valency state of Fe ions, the oxygen coordination, and covalent bond character are discussed with the Mossbauer spectroscopic data. The activation enegy of the electrical conductivities depends on the $\tau$ value in the temperature range of -$100^{\circ}C$ to $600\circC$ under the air pressure. The Mossbauer spectrum and electrical conductivity of the solid solutions are discussed with nonstoichiometric chemical compositions.

• Applied Chemistry for Engineering
• /
• v.2 no.2
• /
• pp.127-137
• /
• 1991

The dissociation and partial oxidation of $CH_3OH$ on polycrystalline $MoO_3$ powder catalyst were studied using thermal desorption spectrometry(TDS) under high vacuum condition. $CH_3OH$ was dissociatively adsorbed on $MoO_3$ in the forms of surface methoxy($-OCH_3$) and atomic hydrogen(-H). $CH_3OH$ desorbed at 425 K via the re-association of methoxy and adsorbed hydrogen atom, and HCHO desorbed at 545 K through the bond breakage of C-H in methoxy. Water TDS spectra showed two desorption peaks, that is, ${\alpha}$-peak at 428 K and ${\beta}$-peak at 586 K. It was suggested that ${\alpha}$-peak was due to the hydroxyl formed on $MoO_3$ surface during the dissociation of $CH_3OH$, and that ${\beta}$-peak was from the association of lattice oxygen and surface hydrogen atom formed by the bond breakage of C-H in methoxy. Pre-adsorbed oxygen on the surface of $MoO_3$ catalyst increased the amount of adsorption of $CH_3OH$ by promoting the dissociation of $CH_3OH$ on the surface, whereas pre-adsorbed water decreased the amount of adsorption of $CH_3OH$ by blocking of adsorption sites for $CH_3OH$.

• Applied Chemistry for Engineering
• /
• v.19 no.5
• /
• pp.477-483
• /
• 2008

$La_{0.7}Sr_{0.3}Co_{0.2}Fe_{0.8}O_{3-{\delta}$ oxide was synthesized by a citrate method and a typical dense membrane of perovskite oxide has been prepared using as-prepared powder by pressing and sintering at $1300^{\circ}C$. Precursor of $La_{0.7}Sr_{0.3}Co_{0.2}Fe_{0.8}O_{3-{\delta}$ prepared by citrate method was investigated by TGA and XRD. Metal-citrate complex in precursor was decomposed into perovskite oxide in the temperature range of $260{\sim}410^{\circ}C$ but XRD results showed $SrCO_3$ existed as impurity at less than $900^{\circ}C$. Electrical conductivity of membrane increased with increasing temperature but then decreased over $700^{\circ}C$ in air atmosphere ($Po_2=0.2atm$) and $600^{\circ}C$ in He atmosphere ($Po_2=0.01atm$) respectively due to oxygen loss from the crystal lattice. The oxygen permeation flux increased with increasing temperature and maximum oxygen permeation flux of $La_{0.7}Sr_{0.3}Co_{0.2}Fe_{0.8}O_{3-{\delta}$ membrane with 1.6 mm thickness was about $0.31cm^3/cm^2{\cdot}min$ at $950^{\circ}C$. The activation energy for oxygen permeation was 88.4 kJ/mol in the temperature range of $750{\sim}950^{\circ}C$. Perovskite structure of membrane was not changed after permeation test of 40 h and the membrane was stable without secondary phase change with 0.3 mol Sr addition.

• Journal of the Korean Chemical Society
• /
• v.29 no.2
• /
• pp.111-120
• /
• 1985

The oxidation reaction of CO on the catalysts 4 mol%, 8 mol%, and 12 mol% Cd-doped ${\alpha}-Fe_2O_3$ is individually investigated. Regardless of Cd doping level, over-all reaction order for the oxidation of CO is 1.5; the first order with respect to CO and the one-half order with respect to $O_2$. Over the temperature range of 350∼$460^{\circ}C$, the activation energy for CO oxidation is 10.10∼11.30Kcal/mol. From the agreement between the kinetic data and conductivity measurements, the reaction mechanism is suggested. Especially from the effect of Cd doping, the fact that catalytic activity of ${\alpha}-Fe_2O_3$ is due to the excitation of electrons which are traped on oxygen vacancy is found, and the adsorption sites for reactant molecules are found.

• Korean Journal of Materials Research
• /
• v.3 no.4
• /
• pp.319-326
• /
• 1993

The effects of $SnO_2$ crystallite size on the powder characteristics, the resistance in air and the sensitivity to 0.5 vol % $H_2$, CO-air mixture were observed. The size of SnO, powder was controlled by calcining temperature variation ($500^{\circ}C$ ~$1100^{\circ}C$) of $\alpha$-stannic acid fabricated from $SnCl_4 \cdot xH_2O$. Its crystallite size. evaluated from TEM image, was in the range of 8-54nm. With the reduction of crystallite size, the adsoption peak of $H_2O$ on FTIR curve became more clear while the lattice parameters were invariable. As the crystallite size decreased, with elements of thick film, the temperatures showing a minimum resistance in air and a maximum sensitivity to H, gas reduced. The temperature variations were assigned to the changes of activation energy of the active adsorbates, and it was suggested that the decrease of activation energy can be one of the reasons for the' sensitivity increase with the' fine powder.

• Clean Technology
• /
• v.23 no.1
• /
• pp.64-72
• /
• 2017

In this study, the selective catalytic reduction (SCR) for NOx removal was investigated in the temperature range of $150{\sim}400^{\circ}C$. XRD, BET and XPS analyses to determine the structural properties and valence state characteristics of the catalyst were performed. Various ball mill method were shown to a difference in activity at a low temperature below $250^{\circ}C$. Based on the catalyst with the highest denitrification efficiency, the ball mill time was the best result at 3 h. As a result of XPS analysis, the presence of the non-stoichiometric vanadium species and the increase of the number of atoms were attributed to a positive effect in the SCR reaction. it was confirmed that the correlation between the amount of lattice oxygen and the denitrification efficiency through the $O_2$ on-off experiment, and it was in a proportional relationship to each other.