• Information and Communications Magazine
• /
• v.33 no.4
• /
• pp.99-106
• /
• 2016

본고에서는 5세대 이동통신 핵심기술 중 하나인 전이중 (full-duplex) 전송기술의 이득을 성취할 수 있는 새로운 접근 방법인 가상 전이중 (virtual full-duplex) 중계전송 기법에 대해서 알아본다. 이는 아직 실제적인 제약들을 해결해야 하는 전이중 중계전송 기술의 대안으로 반이중 (half-duplex) 중계기 2개를 하나의 가상 중계기로 고려함으로써 네트워크 차원에서는 송신과 수신이 동시에 이루어지도록 하여 전이중 중계전송의 효과를 얻는 기술이다. 본고에서는 먼저, 중계기에서 메모리를 고려하지 않고, 2개의 중계기를 번갈아 가면서 사용하는 2경로 (two-path) 교차 (alternating) 중계전송 기법을 살펴보고, 다음으로 중계기에 버퍼를 장착한 다수 중계기 네트워크에서 가상 전이중 중계전송 기법에 대해서 알아본다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.12
• /
• pp.1639-1645
• /
• 2020

In this paper, we propose a virtual full-duplex relaying scheme based on data ferrying using two unmanned aerial vehicles (UAVs). By utilizing high mobility of two UAVs, the proposed relaying scheme can make each UAV communicate with a source node or a destination node when the UAV is near the source node or the destination node. The proposed relaying scheme can overcome the performance limitations of the half-duplex relaying and the implementation constraints of the full-duplex relaying. In addition, we propose an algorithm to shift the center point of two UAVs' trajectory with consideration of inter-relay interference (IRI). We show the simulation results of our proposed trajectory's center point shift algorithm. From the simulation results, it is shown that our proposed relaying scheme can achieve higher end-to-end spectral efficiency (SE) than the conventional static relaying scheme.

• Journal of the Korea Convergence Society
• /
• v.12 no.10
• /
• pp.333-342
• /
• 2021

The purpose of this study is to compare the differences in transfer motivation and learning self-efficacy before and after applying virtual simulation for nursing in psychiatric nursing practice, and to provide them as basic data for effective psychiatric practical education. This study was conducted from October to December 2020. The subjects were 41 people who were enrolled in the third year of a located in U city, and who had received psychiatric nursing practice education using virtual simulation for nursing. Data were analyzed by paired t-test and pearson's correlation coefficient. After practice compared to before psychiatric nursing practice with virtual simulation nursing applied, transfer motivation was significantly increased and learner self-efficacy increased, but it was not statistically significant. Therefore, It was confirmed that psychiatric nursing practice education using virtual simulation for nursing is partly an effective practice strategy.

• The Journal of Korean Association of Computer Education
• /
• v.18 no.2
• /
• pp.83-90
• /
• 2015

In an virtualization environment, several virtual machines use physical resources together. If a specific virtual machine uses to much of the computing resources, other machines may not be working properly. There are various method to solve this problem. Most representative study is to migrate a specified virtual machines to a different server, a target server. In this study, server load can be transferred to a target server by the remigrate of the load imposed on virtual machine. It is still problematic that virtual machine has to remigrate to a different server. This thesis has proposed the algorithm determining the remigration targets by applying dynamic thresholds to solve those problems. The migration algorithm applies dynamic thresholds according to the following criteria. Firstly, the usage of CPU, network and memory; secondly, decide the set of artificial machine and the target server based on the resources surpassed thresholds; thirdly, determine artificial machines based on the resource usage in the target server.

• The Journal of Korean Association of Computer Education
• /
• v.5 no.2
• /
• pp.61-68
• /
• 2002

The development of internet technology has brought many changes in education as well as in overall society and especially, web-based instructions have been rapidly increasing. Unlike the conventional education environment, many web-based instructions offer multimedia effects with text, graphics, sound, animation, video, and so on via internet. In addition, by using the hypermedia functionality, they help students to navigate anywhere they want to go. However, the web-based instructions have been evaluated by the same criteria as the conventional courses. This paper develops the course evaluation items for web-based instruction and compares the results of course evaluation for the web-based instructions and the conventional courses.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05b
• /
• pp.409-414
• /
• 1998

5 년간의 기술실증 및 안전성 검토를 거쳐 한국원자력연구소내 실증소각시설을 자체발생 가연성 $\beta$/${\gamma}$폐기물을 소각하는 시설로 인허가를 얻었다. 동위원소포함 모의폐기물 및 원전발생 가연성폐기물 실증소각 결과에 기준을 두고 연간 배출오염원 및 가상 사고시의 방사학적 위해성을 평가하여 저준위 폐기물을 부지내에서 소각처리할 때 그 위해성은 무시할 수 있을 것으로 미미함 을 확인하였다. 실증시험으로 주된 배출 방사선원은 고온의 소각로에서 휘발성이 크고 저준위 폐기물내 농도가 큰 반휘발성 Cs-137 및 Cs-134로, 발전소 가연성폐기물과 같은 핵종조성을 가진 0.109 mCi/kg 의 소각시 Cs-137 및 Cs-134의 배출농도가 공기중허용농도의 10%를 약간 상회하는 것으로 평가되었다. 비방사성 CsCI을 이용한 시험소각을 통하여 사용되는 저온배기체처리계통 에서의 휘발된 Cs의 배기체 냉각시 입자화 및 제거특성을 고찰한 결과 휘발된 기체상 Cs성분은 건식배기체 냉각공정을 거치면서 대부분 마이크론 크기이하의 입자로 생성되지만 5% 미만이 전이영역 크기에 분포하여 주여과장치인 여과포집진기에서 제거효율이 99.9% 이상이었다.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.31 no.5
• /
• pp.1001-1010
• /
• 2021

Smart factories are complex systems which combine latest information technology (IT) with operation technology (OT). A smart factory aims to provide manufacturing capacity improvement, customized production, and resource reduction with these complex technologies. Although the smart factory is able to increase the efficiency through the technologies, the security level of the whole factory is low due to the vulnerability transfer from IT. In addition, the response and restoration of the business continuity plan are insufficient in case of damage due to the absence of factory security experts. The cope with the such problems, we propose an information security practice content for analyzing the damage by generating ransomware attacks in a digital twin-based smart factory similar to the real world. In our information security content, we introduce our conversion technique of physical devices into virtual machines or simulation models to build a practical environment for the digital twin. This content generates two types of the ransomware attacks according to a defined scenario in the digital twin. When the two generated attacks are successfully completed, at least 8 and 5 of the 23 virtual elements are take damage, respectively. Thus, our proposed content directly identifies the damage caused by the generation of two types of ransomware in the virtual world' smart factory.

• Radiation Oncology Journal
• /
• v.20 no.2
• /
• pp.165-171
• /
• 2002

Purpose : In order to perform craniospinal irradiation (CSI) in the supine position on patients who are unable to lie in the prone position, a new simulation technique using a CT simulator was developed and its availability was evaluated. Materials and Method : A CT simulator and a 3-D conformal treatment planning system were used to develop CSI in the supine position. The head and neck were immobilized with a thermoplastic mask in the supine position and the entire body was immobilized with a Vac-Loc. A volumetrie image was then obtained using the CT simulator. In order to improve the reproducibility of the patients' setup, datum lines and points were marked on the head and the body. Virtual fluoroscopy was peformed with the removal of visual obstacles such as the treatment table or the immobilization devices. After the virtual simulation, the treatment isocenters of each field were marked on the body and the immobilization devices at the conventional simulation room. Each treatment field was confirmed by comparing the fluoroscopy images with the digitally reconstructed radiography (DRR)/digitally composite radiography (DCR) images from the virtual simulation. The port verification films from the first treatment were also compared with the DRR/DCR images for a geometrical verification. Results : CSI in the supine position was successfully peformed in 9 patients. It required less than 20 minutes to construct the immobilization device and to obtain the whole body volumetric images. This made it possible to not only reduce the patients' inconvenience, but also to eliminate the position change variables during the long conventional simulation process. In addition, by obtaining the CT volumetric image, critical organs, such as the eyeballs and spinal cord, were better defined, and the accuracy of the port designs and shielding was improved. The differences between the DRRs and the portal films were less than 3 mm in the vertebral contour. Conclusion : CSI in the supine position is feasible in patients who cannot lie on prone position, such as pediatric patienta under the age of 4 years, patients with a poor general condition, or patients with a tracheostomy.

• Progress in Medical Physics
• /
• v.14 no.2
• /
• pp.90-98
• /
• 2003

Purpose : A new virtual simulation technique for craniospinal irradiation (CSI) that uses a CT-simulator was developed to improve the accuracy of field and shielding placement as well as patient positioning. Materials and Methods : A CT simulator (CT-SIM) and a 3-D conformal radiation treatment planning system (3D-CRT) were used to develop CSI. The head and neck were immobilized with a thermoplastic mask while the rest of the body was immobilized with a Vac-Loc. A volumetric image was then obtained with the CT simulator. In order to improve the reproducibility of the setup, datum lines and points were marked on the head and body. Virtual fluoroscopy was performed with the removal of visual obstacles, such as the treatment table or immobilization devices. After virtual simulation, the treatment isocenters of each field were marked on the body and on the immobilization devices at the conventional simulation room. Each treatment fields was confirmed by comparing the fluoroscopy images with the digitally reconstructed radiography (DRR) and digitally composited radiography (DCR) images from virtual simulation. Port verification films from the first treatment were also compared with the DRR/DCR images for geometric verification. Results : We successfully performed virtual simulations on 11 CSI patients by CT-SIM. It took less than 20 minutes to affix the immobilization devices and to obtain the volumetric images of the entire body. In the absence of the patient, virtual simulation of all fields took 20 min. The DRRs were in agreement with simulation films to within 5 mm. This not only reducee inconveniences to the patients, but also eliminated position-shift variables attendant during the long conventional simulation process. In addition, by obtaining CT volumetric image, critical organs, such as the eyes and the spinal cord, were better defined, and the accuracy of the port designs and shielding was improved. Differences between the DRRs and the portal films were less than 3 m in the vertebral contour. Conclusion : Our analysis showed that CT simulation of craniospinal fields was accurate. In addition, CT simulation reduced the duration of the patient's immobility. During the planning process. This technique can improve accuracy in field placement and shielding by using three-dimensional CT-aided localization of critical and target structures. Overall, it has improved staff efficiency and resource utilization by standard protocol for craniospinal irradiation.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.20 no.3
• /
• pp.593-608
• /
• 2018

If a problem occurs in the strut during the construction of the braced wall, they may cause excessive deformation of the braced wall. Therefore, in this study, the behavior of the braced wall and existing tunnel adjacent to excavation were investigated assuming that the support function of strut is lost during construction process. For this purpose, a series of model test was performed. As a result of the study, the earth pressure in the ground behind wall was rearranged due to the deformation of the braced wall, and the ground displacements caused the deformation of adjacent tunnels. When the struts located on the nearest side wall from the tunnel were removed, the deformation of the braced wall and the tunnel deformation were the largest. The magnitude of transferred earth pressure depended on the location of tunnel. The increase of the cover depth of tunnel from 0.65D to 2.65D caused the increase of the earth pressure by 25.6%. As the distance between braced wall and tunnel was increased from 0.5D to 1.0D, the transferred earth pressure increased by 16% on average. Horizontal displacements of braced wall by the removal of the strut tended to concentrate around the removed struts, and the horizontal displacement increased as the strut removal position is lowered. The tunnel displacement was maximum, when the cover depth of tunnel was 1.15D and the horizontal distance between braced wall and the side of tunnel was 0.5D. The minimal displacement occurred, when the cover depth of tunnel was 2.65D and the horizontal distance between braced wall and the side of tunnel was 1.0D. The difference between the maximum displacement and the minimum displacement was about 2 times, and the displacement was considered to be the largest when it was in the range of 1.15D to 1.65D and the horizontal distance of 0.5D.