• Journal of Korea Multimedia Society
• /
• v.3 no.2
• /
• pp.192-200
• /
• 2000

8 bit and 16 bit microprocessors are widely used in the small sited control machine. The embedded microprocessors which is integrated on a single chip with the memory and I/O circuit must have simple hardware circuit and high code density. This paper proposes a 16 bit high code density EISC(Extendable Instruction Set Computer) microprocessor. SE1608 has 8 general purpose registers and 16 bit fixed length instruction set which has the short length offset and small immediate operand. By using an extend register and extend flag, the offset and immediate operand in instruction could be extended. SE1608 is implemented with 12,000 gate FPGA and all of its functions have been tested and verified at 8MHz. And the cross assembler, the cross C/C++compiler and the instruction simulator of the SE1608 have been designed and verified. This paper also proves that the code density$.$ of SE1608 shows 140% and 115% higher code density than 16 bit microprocessor H-8300 and MN10200 respectively, which is much higher than traditional microprocessors. As a consequence, the SE1608 is suitable for the embedded microprocessor since it requires less program memory to any other ones, and simple hardware circuit.

• Proceedings of the KWS Conference
• /
• 2005.11a
• /
• pp.228-230
• /
• 2005

Sn-8wt%Zn-3wt%Bi (이하, Sn-8Zn-3Bi) 솔더의 장기 신뢰성을 평가하기 위하여 고용고습시험을 행하였다. 고온 고습 시험은 $85^{\circ}C$/85RH 조건에서 1000 시간 동안 하였다. 접합 기판으로는 각각 OSP (Organic Solderability Preservative), Sn 그리고 Ni/Au 처리를 한 PCB(Printed Circuit Board) 패드를 사용하였다. 접합에 사용한 부품은 1608Chip 으로 MLCC(Multi Layer Ceramic Capacitor 이하, 1608C) 와 Chip Resister(이하, 1608R)을 사용하였으며, 이 두 부품의 전극부위에 Sn-10wt%Pb(이하 Sn-l0PB), Sn을 각각 도금하였다. 솔더링 후 1608C 와 1608R의 전단 접합 강도와 솔더링부에서 Zn상의 변화를 관찰하였다. 측정결과, Sn-8Zn-3Bi 솔더의 초기 전단 접합 강도는 기판의 표면처리에 상관없이 약 40N 이었다. 그러나 고온 고습 시험 1000 시간 후에는 기판의 표면처리에 상관없이 약 30N 까지 감소하였다. 하지만 이는 reference인 Sn-37Pb 솔더의 강도값과 거의 유사하며, 이는 Sn-8Bi-3Zn 솔더의 고온 고습 시험 후 전단강도 특성은 기존 유연솔더와 비교하여 동등이상이라고 평가할 수 있다.

• Proceedings of the KWS Conference
• /
• 2005.11a
• /
• pp.225-227
• /
• 2005

Sn-8wt%Zn-3wt%Bi (이하, Sn-8Zn-3Bi) 솔더의 장기 신뢰성을 평가하기 위하여 열 충격 시험을 행하였다. 열 충격 시험은 $-40^{\circ}C$에서 $80^{\circ}C$범위에서 1000 사이클 동안 하였다. 접합 기판으로는 각각 OSP(Organic Solderability Preservative), Sn 그리고 Ni/Au 처리를 한 PCB(Printed Circuit Board) 패드를 사용하였다. 접합에 사용한 부품은 1608 Chip(Multi Layer Chip Capacitor, Chip Resistor) 으로 전극 부위에 Sn-37wt%Pb, Sn 도금하여 사용하였다. 솔더링 후 1608 Chip의 전단 강도와 솔더링부에서 미세조직 및 IMC(Inter Metallic Compound) 변화를 관찰하였다. 측정결과, Sn-8Zn-3Bi 솔더의 초기 전단 강도는 기판의 표면처리에 상관없이 약 40N 이상이었다. 그리고 열충격 시험 1000 사이클 후에는 모든 기판에서 2N 정도 약간의 강도 저하를 보였다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.11a
• /
• pp.392-395
• /
• 2004

A coupler is a microwave passive component used for power coupling or dividing. Regarding the trend of current telecommunication systems it is highly desirable for monolithic integration of passive components as such LTCC(Low temperature cofired ceramics) technology offers potential advantage in size, cost and performance. Utilizing LTCC technology a 1608 size type dual band coupler for DCS and EGSM band was fabricated. Its characteristics such as coupling, insertion loss, isolation and directivity was measured and compared with simulation results.

• Proceedings of the KWS Conference
• /
• 2006.05a
• /
• pp.221-223
• /
• 2006

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.26 no.8
• /
• pp.1608-1614
• /
• 2002

This Paper presents a novel piston friction force measurement system that has characteristics of relieving the Pressure force acting on the upper surface of the liner; the system uses general rubber O-rings for combustion chamber sealing, and does not need special changes to the piston top land. The lower supporter of the floating liner increases stiffness in liner axial direction, and results in the increase of natural frequency. The upper supporter has multi-layer structure designed fer low axial stiffness and high radial stiffness. With the use of the present system, the effects of variation in clearance and piston ring tension were studied.

• Journal of Power Electronics
• /
• v.18 no.5
• /
• pp.1608-1617
• /
• 2018

The rapid and correct isolation of faulty submodules (SMs) is of great importance for improving the reliability of modular multilevel converters (MMCs). Therefore, a fast diagnosis method containing fault detection and fault location determination was presented in this paper. An improved incremental predictive model of arm current was proposed to detect failures, and the multi-step prediction method was used to eliminate the negative impact of disturbances. Moreover, a control method was proposed to strengthen the fault characteristics to rapidly locate faulty arms and faulty SMs by detecting the variation rate of the SM capacitor voltage. The proposed method can rapidly and easily locate faulty SMs under different load conditions without the need for additional sensors. The experimental results have validated the effectiveness of the proposed method by using a single-phase MMC with four SMs per arm.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.12
• /
• pp.1608-1615
• /
• 2004

CFD data compression methods based on Full-3D and Quasi-1D supercompact multiwavelets are presented. Supercompact wavelets method provide advantageous benefit that it allows higher order accurate representation with compact support. Therefore it avoids unnecessary interaction with remotely located data across singularities such as shock. Full-3D wavelets entails appropriate cross-derivative scaling function & wavelets, hence it can allow highly accurate multi-spatial data representation. Quasi-1D method adopt 1D multiresolution by alternating the directions rather than solving huge transformation matrix in Full-3D method. Hence efficient and relatively handy data processing can be conducted. Several numerical tests show swift data processing as well as high data compression ratio for CFD simulation data.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.11
• /
• pp.1608-1614
• /
• 2014

Power demand forecasting is an important factor of the peak management. This paper deals with the 15 minutes ahead load forecasting problem in a DC urban railway system. Since supplied power lines to trains are connected with parallel, the load characteristics are too complex and highly non-linear. The main idea of the proposed method for the 15 minutes ahead prediction is to use the daily load similarity accounting for the load nonlinearity. An Euclidean norm with weighted factors including loads of the neighbor substation is used for the similar load selection. The prediction value is determinated by the sum of the similar load and the correction value. The correction has applied the neural network model. The feasibility of the proposed method is exemplified through some simulations applied to the actual load data of Incheon subway system.

• Journal of International Academy of Physical Therapy Research
• /
• v.9 no.4
• /
• pp.1608-1613
• /
• 2018

The purpose of this study was to investigate the effects of sling exercise on muscle activity and balance on football players with chronic ankle instability. Eight subjects performed Biodex and sling exercises for four weeks and compared the muscle activity and balance ability of the uninjured and injured feet. Stable and unstable foot % MVIC did not change significantly after treatment in all muscles. The total balance ability was not significantly different between the two groups, however, increased only in the unstable side. The anterior/posterior balance ability also represented no significant difference between the groups and was significantly improved only in the unstable side. The medial/lateral balance ability was not significantly different between the groups and was significantly improved only in the unstable side. This study suggests that sling exercise contributes to improving % MVIC, total balance ability, anterior/posterior balance ability, and medial/lateral balance ability of the unstable side.