• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2005.10a
• /
• pp.463-466
• /
• 2005

Restoring ductility or removing residual stresses is a necessary operation when a large amount of cold working is to be performed, such as in a cold-forging or warm forging process. The advantage of annealing temperatures was investigated. After Hydrostatic Extrusion process, extruded materials were annealed at $200^{\circ}C,\;350^{\circ}C,\;450^{\circ}C$ for 1 hour. Microstructure of the annealed material was observed to make an understand about the difference in mechanical properties.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.10
• /
• pp.797-805
• /
• 2014

The purpose of this study was to investigate the drag and lift characteristics of the cavitator of a supercavitating underwater vehicle and the pressure loss due to water intake. These investigations were performed by changing the diameter, velocity, radius of curvature of the intake, and angle of attack of the cavitator. With increasing ratio of the intake diameter to the cavitator diameter ratio($d/D_1$), the drag coefficient and the pressure loss coefficient of the water intake decreased. The greater the increase in the ratio of the intake velocity-to-free stream velocity ratio(S), the smaller was the decrease in the drag coefficient and the lift coefficient. When the intake had a radius of curvature(c), the pressure loss coefficient decreased. On the contrary, the effect of the radius of curvature on the drag coefficient was imperceptible. For angles of attack (${\alpha}$) of the caviatator in the range of $0^{\circ}$ to $10^{\circ}$, the drag coefficient and the pressure loss coefficient changed slightly, whereas the lift coefficient increased linearly with increasing angle of attack.

• Magazine of the Korea Concrete Institute
• /
• v.11 no.1
• /
• pp.89-97
• /
• 1999

In this study, fifteen reinforced high-strength lightweight concrete(HLC)beams were tested to investigate shear behavior of specimens according to shear reinforcement ratio. Test variables are shear span to effective depth ratio(a/d=2.5, 3.5, 4.5) and shear reinforcement ratio(0~1.0${\rho}_{v,ACI}$). Concrete compressive strength and tensile steel reinforcement ratio are constantly 439kg/$cm^2$ and 0.0203, respectively. Test results for the HLC beams showed that ACI code equation underestimates the shear strength of concrete($V_c$), and overestimates the shear strength of shear reinforcements($V_s$). It is revealed that the effectivenesses of shear reinforcements of reinforced HLC beams are lower than those of normal weight concrete beams. Then, the shear strengths of shear reinforcements are increased in proportion not to first degree of shear reinforcement ration but to square root of them.

• Progress in Superconductivity and Cryogenics
• /
• v.9 no.1
• /
• pp.5-8
• /
• 2007

We have investigated the superconducting properties and surface morphology of $Sm_xBa_yCu_3O_{6+z}$ thin films deposited on LMO/IBAD-MgO/Hastelloy which prepared with different composition ratio by co-evaporation method(EDDC, Evaporation using Drum in Dual Chambers). We observed the composition ratio of SmBCO thin films by EDS analysis. We fabricated SmBCO thin film with critical current density of $1.5{\times}10^6A/cm^2$ at composition ratio of SM:Ba:Cu=1.10:2.01:3(at 77 K self-field). And, we confirmed that substitution of Sm-Ba did not occur at Cu rich phase by EDS analysis.

• Elastomers and Composites
• /
• v.41 no.3
• /
• pp.147-156
• /
• 2006

To investigate the influence of the foaming temperature and carbon black content on the cure behaviors and foaming characteristics of the foams. natural rubber (NR) was foamed at five temperature zones (145, 150, 155, 160 and $165^{\circ}C$) and different feeding ratios of the carbon black. A decreasing trend of the scorch time, $t_{s2}$ and cure time, $t_{90}$ was observed upon increasing foaming temperature and carbon black content. The optimal temperature for vulcanization and foaming of NRs in this study was considered to be $165^{\circ}C$ where density of the loomed NRs is lower than those at other four temperature regions. The rule rate index of the NRs foamed at $145^{\circ}C$ is smaller than those at 150, 155, 160 and $165^{\circ}C$. The results of the expansion ratio and micrographs of the foamed NRs were founded to support the density characteristics. The thickness of each of the struts formed inside the rubber matrix decreases with increasing the foaming temperature, while it increases with increasing the carbon black content.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.31 no.1 s.49
• /
• pp.85-89
• /
• 2005

An aim of this study is to study the correlation between rheological properties and sedimentation of capsules in aqueous polymer solution with low viscosity. Rheological properties of aqueous polymer solutions were controlled by carbomer (C), acylate/C10-30 alkyl acylate crosspolymer (AC), and ammonium acryloyldimethyltaurate/VP copolymer (AV). Small amount of polymer C solution had the highest viscosity and yield stress of polymer AV solution was higher than that of polymer C solution in the same viscosity when the concentration of polymer AV exceeded $0.35 wt\%$. Each aqueous polymer solution was tested and the results showed that as viscosity and yield stress increased, the sedimentation ratio of capsules decreased. The viscoelasticity data also showed the same tendency in a shear stress range of 0.1 to 2.0 Pa. These results demonstrated that the rheological properties of polymer solutions had a strong correlation with the sedimentation of capsules. When polymer I and AV were used, there was a synergistic effect and the correlation between rheological properties and sedimentation of capsules was very complicated. It was assumed that the characteristics of polymer structure and interaction between polymers caused this phenomena.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.14 no.3
• /
• pp.151-156
• /
• 1994

Exertion has been made to develop high-temperature (about $250{\sim}650^{\circ}C$) immersion ultrasonic sensor for the visualization of objects, temperature measurement, dimensional check, or nondestructive testing of welds under liquid sodium. In this study, the feasibility of the ultrasonic sensor taking advantage of a strip waveguide was confirmed by water-experiment. The lowest order of antisymmetric Lamb wave was used in the frequency range with negligible dispersion. This plate wave was excited in the stainless steel strip waveguide of 1.0mm thickness and 13mm width by the comb-structure transducer of 2.3MHz frequency. Its attenuation coefficient was 1.2dB/m in air and 380dB/m in water. The signal to noise ratio of 25dB was obtained from a planar reflector 270mm away from the beam aperture of $13mm{\times}39mm$ size.

• Journal of Environmental Health Sciences
• /
• v.11 no.2
• /
• pp.17-27
• /
• 1985

The objectives of this study is to examine efficiency of swinery wastewater treatment by trickling filters' pilot plant. The results of this study are as follows: 1. The characteristics of sample. The BOD$_5$ was from 2,450 to 2,880mg/l, COD(KMnO$_4$ acid method) was from 910 to 1,064mg/l, and SS was from 920 to 990mg/l. The pH of influent was from 7.3 to 7.6, and the temperature of water was from 17.0$\circ$C to 22.5$\circ$C. 2. For experiment by recirculation, the BODs removal efficiency is 65.2% at recirculation ratio (r)=0, and 70.7% at r=1. The ramoval efficiency of this study is higher than NRC formula of U.S.A.. The recirculation is not significant effect on removal efficiency. 3. For experiment by hydraulic load, the BOD$_5$ removal rate decreased from 73.1% at $3.1m^3/m^2\cdot d$ to 65.3% at $9.2m^3/m^2\cdot d$. The design formula of this study which shows the removal rate of soluble BOD is $Le/Li =10^{-0.24} D/Q^{0.24}$ (Q: hydraulic load, D: depth of filter). 4. For experiment by organic load, the BOD$_5$ removal rate is increased from 70.2% at $0.77kg/m^3\cdot d$ to 75.4% at $4.28kg/m^3\cdot d$. We can obtain the straight line y=0.749 x (y: removed BOD, x :applied BOD) by the least squares method. 5. We can know that trickling filters is strong with the hydraulic load and the organic matter shock load. Here, we can judge that trickling filters is a good method for the treatment of swinery wastewater which containing high concentrated organic matter.

• Childhood Kidney Diseases
• /
• v.13 no.2
• /
• pp.138-145
• /
• 2009

Purpose : This study was aimed to evaluate the changes of immunologic parameters during hospitalization, and the relationship between IgG and other laboratory or clinical indices in patients with acute poststreptococcal glomerulonephritis (APSGN). Methods : We reviewed the medical charts of 36 children with APSGN who showed ASO titer>250 Todd U/L and C3<70 mg/dL. We evaluated the levels of IgG and other laboratory parameters including C3 and ASO at admission and at discharge (14 cases). Results : The mean age of APSGN patients was $7.5{\pm}2.6$ year of age, and male-to-female ratio was 2.3:1. At presentation, hypertension (systolic blood pressure>125 mmHg), gross hematuria, and weight gain were observed in 27.8% (10/36), 80.1% (29/36), and 80% (24/30) of the patients, respectively. The mean IgG level was $1,432{\pm}322$ mg/dL ($1,025{\pm}234$ mg/dL in control group, P<0.001), and C3 and ASO levels were $26.1{\pm}16.1$ mg/dL and $1,068{\pm}730$ Todd U, respectively. There were no correlation between IgG level and the levels of any of the parameters analyzed (ASO, C3, BUN, creatinine and white blood cell count), and the severity of the disease assessed by the weight-change during admission. The patients aged<6 years of age (10 cases) had less degree of the weight-change, compared to those of the patients aged>8 years of age (15 cases) (-0.6% vs. -5.7%, P=0.01). The IgG and ASO levels did not change, but C3 (P=0.001) and IgM (P=0.02) levels increased during admission. Conclusion : Increased IgG and ASO levels in APSGN did not change, but C3 level increased during admission. IgG level was not correlated with other laboratory parameters (ASO and C3) and the severity of the disease. Younger children seem to have less severe clinical course compare to older children. With our hypothetic pathogenesis of APSGN, further studies are needed to resolve the pathogenesis of the disease including the increase of IgG.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4B
• /
• pp.298-307
• /
• 2002

This paper concentrates on developing and analyzing an advanced space-time multiuser receiver for WCDMA forward link. Through exploring the interference caused by co-channel users and delayed multipaths in CDMA, a constrained linear adaptive filter is adopted to cancel the interference. Furthermore, by utilizing the space-time diversity, an optimum diversity receiver, called a constrained adaptive space-time interference canceller (C-ASTIC), is proposed. For comparison, the statistical analysis of multiuser performance for WCDMA system with space-time diversity is described. The result of the simulation showed that C-ASTIC performs better than both the space-time diversity combining maximal ratio combiner (MRC) and the single-antenna adaptive interference canceller in a multipath fading channel. Also, the efficiency of the C-ASTIC in the multimedia communication environment is investigated under the multiuser, multi-transmit antenna, and multirate WCDMA system in a multipath fading channel. From the results, the C-ASTIC was validated to be useful for multi-rate WCDMA system through improving the performance gain by more than 3 dB at BER of 10$\^$-3/ in a half or more loaded system.