• Journal of the Korean earth science society
• /
• v.33 no.7
• /
• pp.596-607
• /
• 2012

The R-Z relationship is one of important error factors to determine the accuracy of radar rainfall estimation. In this study, we have explored the effect of the R-Z relationships derived from disdrometer data in estimating the radar rainfall. The heavy rain event that produced flooding in St-Remi, Quebec, Canada has been occurred. We have tried to investigate the severity of rain for this event using high temporal (2.5 min) and spatial resolution ($1^{\circ}$ by 250 m) radar data obtained from the McGill S-band radar. Radar data revealed that the heavy rain cells pass directly over St-Remi while the coarse raingauge network was not sufficient to detect this rain event. The maximum 30 min (1 h) accumulation reaches about 39 (42) mm in St-Remi. During the rain event, the two disdrometers (POSS; Precipitation Occurrence Sensor System) were available: One used for the reflectivity calibration by comparing disdrometer Z and radar Z and the other for deriving disdrometric R-Z relationships. The result shows the significant improvement with the disdrometric reflectivity-dependent R-Z relationships against the climatological R-Z relationship. The bias in radar rain estimation is reduced from +12% to -2% and the root-mean squared error from 16 to 10% for daily accumulation. Using the estimated radar rainfall rate with disdrometric R-Z relationships, the flood event was well captured with proper timing and amount.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.52 no.2
• /
• pp.43-50
• /
• 2010

This study was carried out to evaluate the vertical stress properties in sandy soil according to changes of foundation condition in soil bin compacted three layers. The following conclusions and comparisons have been made based on careful analysis from theoretical and experimental methods. : When sandy soil subjected to circular uniform load, the vertical stress increments ($\Delta\sigma_z$) was increased as load increasing, the maximum values of $\Delta\sigma_z$ was achieved at the point loading axis, and $\Delta\sigma_z$ was not shown over at a distance of three times of loading plate width (B). The vertical stress increments were achieved largely at 80 % relative compaction (Rc) compared to 95 % relative compaction due to stress concentration in sandy soil. When sandy soil subjected to circular uniform load, the $\Delta\sigma_z$ differences between theoretical and experimental values as load increased were more increased and its maximum differences were achieved at stress axis. When gravel surface macadamized over sandy soil subjected to load, the $\Delta\sigma_z$ was concentrated to load axis as load increasing, so that macadamization will be decreased load transmission.

• Journal of the Mineralogical Society of Korea
• /
• v.6 no.2
• /
• pp.105-115
• /
• 1993

$M{\ddot{o}}ssbauer$ and Infrared absorption spectra of the iron-bearing tourmaline minerals show that the ferrous and ferric ions occupy the Y and Z octahedral sites. The Fe ions are almost ferrous, predominantly partitioning into Y site and partly take in Z site. The $Fe^{2+}$ content of the Z sites in brownish black tourmaline minerals are higher than that in blue/green tourmaline minerals. Therefore, 720 nm peak of brownish black samples is broader than that of blue/green samples in optical spectra. All of the blue/green tourmaline minerals used in experiment have only $Fe^{2+}$ ion. The IR spectra of tourmaline depend on the cation environments around OH groups, as also evidenced by their chemical analyses. There appear no difference in IR spectrum between O(1)H and O(3)H binding characters in the heat-treated samples. But the characteristic $3565cm^{-1}$ peak appears in the ferrous hydroxyl bearing silicates, where dehydroxylation temperature for OH coordinated to $Fe^{2+}$ is $700{\sim}800^{\circ}C$.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.24 no.5
• /
• pp.803-810
• /
• 1995

Co-immobilized mixed culture system(A-Z system) composed of two different oxygen-demanding strains, aerobic(Aspergillus awamori) and anaerobic(Zymomonas mobilis) strains, in a Ca-alginate gel beads was developed to increase ethanol production from raw starch as a carbon source. Optimal mixture ratio of A. awamori and Z. mobilis was $1.25{\times}10^{9}\;spores/L-gel$ and 0.5g cells/L-gel, respectively. After 120 hours of cultivation, gel beads distinguished oxygen-rich surface for A. awamori from oxygen-deficient central part for Z. mobilis. At A-Z culture system, yield of ethanol on glucose, $Y_{p/s}=0.18$, was very low and there was high leakage of cells from surface of gel beads. At A-Z 36 cultrue system with changing silicon check valve for cotton plug at 36 hours in A-Z culture system, there was no cell leakage from gel beads, pH was maintained at around 4.3 during cultivation, and yield of ethanol on glucose, $Y_{p/s}=0.36$, showed 2 times higher than that of control culture system(cotton plug culture).

• Membrane Journal
• /
• v.20 no.3
• /
• pp.210-216
• /
• 2010

The hydrogen permselective membrane were prepared by chemical vapor deposition (CVD) aiming at the applications to hydrogen iodide decomposition in the thermochemical IS process, and it was evaluated for the possibility as a separation membrane. An electron probe X-ray microanalyzer (EPMA) and SEM picture were used to analyze the morphology and structure of the prepared membranes. It was confirmed that Zr-Si-O layer exist in the surface of the prepared membrane using zirconia coated support. Single-component permeance to $H_2$ and $N_2$ were measured at $300{\sim}600^{\circ}C$. Hydrogen permeance through the Z-1 membrane at a permeation temperature of $600^{\circ}C$ was about $1{\times}10^{-7}\;mol{\cdot}Pa^{-1}{\cdot}m^{-2}{\cdot}s^{-1}$. The selectivities of $H_2/N_2$ at $600^{\circ}C$ were 5.0 and 5.75 for Z-1 and Z-2 membrane, respectively.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.4 no.2
• /
• pp.107-116
• /
• 1999

To study the characters of surface sediment and to describe the seasonal depositional environment as a result of sedimentation process off Byun-San Peninsula, a total 61 samples of surface sediment (32 samples in summer; 29 samples in winter) were collected and analysed. A digitized depth data from sea chart and echosounding profiles along five trans-sections were helpful for understanding the morphological factors. The types classified by the characters of surface sediment are type I (sand, S), type II (silty sand, zS), and type ill (sandy silt, sZ). Mean grain size varies from 2.11 to 7.81 ${\Phi}$. The positive-skewness shows the typical tide-dominated environment. The sediment type of the northwestern stations is medium sand and the sorting value is 0.5~1.4 ${\Phi}$ of well/moderately sorted. Meanwhile, other stations are composed of muddy sands and sandy muds transported from rivers and offshore. These sediment types toward inshore change gradually from silty sand to sandy silt. According to the C/M diagram, there are three major transport modes of sediment: bed load (Mode A), graded suspension (Mode B), and suspension (Mode C), correlating with north-eastern sandy area, middle part of silty-sand area, and southern sandy-silt area, respectively. The result of Principal Component Analysis shows also similar pattern of sediment types. In result, sediment texture of type III tends to be finer and more poorly-sorted than that of type II and sediment facies are correlateed with sedimentation process.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.7
• /
• pp.675-682
• /
• 2013

To verify the effect of inner- and outer-stage gas jets, a shear coaxial injector was designed to analyze the axial velocity profile and breakup phenomenon with an increase in the measurement distance. When the measurement position was increased to Z/d=100, the axial flow showed a fully developed shape due to the momentum transfer, aerodynamic drag effect, and viscous mixing. An inner gas injection, which induces a higher momentum flux ratio near the nozzle, produces the greater shear force on atomization than an outer gas injection. Inner- and Outer-stage gas injection do not affect the mixing between the inner and outer gas flow below Z/d=5. The experiment results showed that the main effect of liquid jet breakup was governed by the gas jet of an inner stage. As the nozzle exit of the outer-stage was located far from the liquid column, shear force and turbulence breaking up of the liquid jets do not fully affect the liquid column. In the case of an inner-stage gas injection momentum flux ratio within 0.84, with the increase in the outer gas momentum flux ratio, the SMD decreases. However, at an inner-stage gas jet momentum flux ratio over 1.38, the SMD shows the similar distribution.

• Applied Biological Chemistry
• /
• v.39 no.4
• /
• pp.255-259
• /
• 1996

In order to improve the quality of commercially manufactured Doenjang, yeast florae, gas and alcohol formation during fermentation of Doenjang were periodically examined. Candida rugosa, Candida zeylanoides, Pichia farinosa Saccharomyces cerevisiae and Zygosaccharomyces rouxii were isolated and identified from Doenjang at various fermentation stage. S. cerevisiae and Z. rouxii showed distintive gas and alcohol formation activities and the distribution ratio of Z. rouxii was 26% at 14 days and 76% as prevailed yeast strain after 30 days fermentation, respectively. Ethanol content of Doenjang was gradually increased into 2.19% at final stage of fermentation. The amount of gas generated during fermentation was 9.75 ml/g after 14 days, 4.5 ml/g after 30 days and decreased into negligible amount after 45 days fermentation. These inhibitory effects on gas generation by fermentation period would be ascribed to the ethanol Produced for fermentation. This results suggest that gas generation in commercially manufactured Doenjang could be eliminated through the effective control of fermentation by yeast without application of any preservatives.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.17-17
• /
• 2016

이중편파 레이더는 수평 수직반사도($Z_H{\cdot}Z_V$), 차등반사도($Z_{DR}$), 교차상관계수(${\rho}_{HV}$), 차등위상차(${\Phi}_{DP}$) 등 다양한 변수 산출을 통하여 대기 수상체 구분, 우적분포에 영향이 적은 강우량 추정, 밝은 띠(BB, Bright Band)의 탐지 등이 가능하게 됨으로써 수문기상 및 재해관리 분야에 활용성이 점점 더 커지고 있다. 본 연구는 RHI, PPI에서 생산된 레이더 변수를 이용하여 BB를 탐지하고 그 특성을 평가하였다. BB는 레이더를 이용하여 상층대기를 관측할 때 수직단면에서 강수입자가 눈에서 비로 변하는 구간에서 과대하게 높은 반사도가 나타나는 층을 말한다. BB에서는 QPE가 과대 추정되기 때문에, BB의 특성 파악은 레이더의 관측전략 수립과 QPE 보정에 필수적이다. 본 연구에서는 RHI에 의한 $Z_H$의 연직단면분석, RHI와 PPI의 고도각 경사거리(slant range) 빔의 ${\rho}_{HV}$, $Z_{DR}$, $Z_H$에 의한 분석을 통하여 BB의 상단부($BB_{TOP}$), 최정점($BB_{PEAK}$) 및 하단부($BB_{BOTTOM}$)의 고도를 상호 비교 평가하였다. 분석 자료는 KICT X-밴드 레이더에 의한 관측한 2015년 10월 21일의 층상운에 의한 강우를 이용하였다. RHI에 의한 $Z_H$의 연직단면 분석결과 $BB_{top}$, $BB_{bottom}$ 및 $BB_{peak}$는 KICT 레이더 고도(MSL : 40m)를 기준으로 각각 3.26Km, 2.3Km($BB_{width}$: 0.96km) 및 2.7Km로 나타났다. 이 같은 결과는 다른 2가지 분석방법에서도 유사하게 나타나고 있으며, 이는 BB분석을 위해 다양한 변수를 통한 신뢰성 있는 BB의 특성을 파악할 수 있는 기반을 제공한다.

• Korean Journal of Environmental Biology
• /
• v.33 no.1
• /
• pp.63-74
• /
• 2015

The purpose of this study is to provide the basis information for ecological conservation and restoration of Jangdo wetland conservation area through the survey of vegetation diversity and spatial distribution characteristics. Syntaxonomic account of plant communities were carried out field survey by Z.-M. school method at 14 sites and relationship analysis between plant community and environment variables with Principal Coordinate Analysis (PCoA). Based on the floristic composition, all the plots were classified into xeric and hydric type and arranged in seven plant communities. Spatial distribution of plant communities is determined primarily by the soil moisture condition and amount of organic matter. Hydric vegetation is around 8% ($7,337m^2$) of the protected area and distributed swamp forest of dominating willows under 18 years. Proliferation of willows are recognised extended from edge to centre after in 1990's caused by fallow and control of livestock grazing on wetland. Jangdo wetland will have to readjust the protection boundary because wet meadow zone and swamp forest have been distributed outside the protection area.