• Journal of Korea Foundry Society
• /
• v.17 no.5
• /
• pp.472-479
• /
• 1997

The effect of size and mass fraction of SiC particulate on the fatigue and wear have been investigated for semi-liquid formed SiCp/AZ91HP Mg composites. In the study, different particulate sizes of 7, 20, $50 {\mu}m$ were prepared with various mass fraction for sample preparation. By tension-tension fatigue tests, whose procedures are standardized in ASTM standard 647E-93, the da/dN vs. ${\Delta}K$ curves were obtained. Also, the crack propagation paths were observed by optical microscope. As a result of wear test, specific wear loss is decreased with increasing mass fraction and particulate size. Specific wear loss of 30 mass% $50 {\mu}m$ SiC reinforced Mg composite is compared to SKD11.

• Preventive Nutrition and Food Science
• /
• v.4 no.3
• /
• pp.184-187
• /
• 1999

Increase in fat mobilization by capsaicin(CAP) was investigated in high-fat-fed mice using an adjustable current water pool. Male ICR 7-wk-old mice were fed a high fat diet [50% total energy content in the diet(E%) fat, 20 E% protein, 30E% carbohydrate] for 2 wk and one group (HCAP) was orally administered CAP at 2 h before swimming. After being accustomed to swimming , the mice were subjected to forced swimming every 2d in the current water pol and the total swimming period until exhaustion was measured . The total swimming period was used as index of swimming capacity. Swimming time to exhaustion of treated mice was significantly longer than that of the high-fat-fed control group (100.2$\pm$10.6 vs. 58.0$\pm$8.5min, P<0.01) after 2wk of training. The concentration of serum-free fatty scids gradually increased up to 2 h in CAP -administered mice. The perirenal adipose tissue weight of CAP -administered mice (HCAP) before swimming was lower than that of the high-fat-fed mice adminstered placebo solution (HP) which had not ingested CAP during the 2 wk. These results suggest that the increase of swimming capacity of CAP-administered high-fat-fed mice was due to an increase of fat mobilization that was induced by CAP.

• Korean Journal of Materials Research
• /
• v.13 no.10
• /
• pp.677-682
• /
• 2003

SiC nanowires were synthesized by carbothermal reduction using metal catalysts. Synthesized nanowires had mean diameters of 30∼50 nm and several $\mu\textrm{m}$ length. The kind of catalysts affects form of SiC nanowire because of difference of growth mechanisms. These differences were made by catalyst's physical property and relative activities to the source gas. Ni acted a conventional catalyst of VLS growth mechanism. But, Case of Fe, SiC nanowire was grown by stable VLS growth mechanism without relation of growth conditions. SiC nanowire was grown by two step growth model using Cr catalyst. Conversion ratios to the SiC nanowire were increased with growth conditions. Case of Cr, conversion ratio was about 45% that was higher than other catalyst used. This high conversion ratio was obtained by the addition VS growth to radial direction on the as-grown nanowires.

• Journal of the Korean Chemical Society
• /
• v.65 no.2
• /
• pp.125-132
• /
• 2021

An electrochromic nickel oxide thin film was fabricated on a flexible PET/ITO substrate using a nanocrystallite- dispersed coating sol and bar coater. Nanocrystalline NiOx of 3-4 nm crystallite size was first synthesized by base precipitation and thermal conversion. This NiOx nanocrystallite powder was mechanically dispersed in an alcoholic solvent mixed with a silane binder to prepare a coating sol for thin film. This sol method is different from the normal sol-gel method in that it does not require the conversion of precursor by heat treatment. Therefore, this method provides a very facile method to prepare NiOx thin films on any kind of substrate and it can be easily applied to mass production. The electrochromic performance of this NiOx thin film on PET/ITO electrode with a thickness of about 400 nm was investigated in a nonaqueous LiClO4 electrolyte solution by cyclic voltammetric and repeated chronoamperometric measurements in conjunction with spectrophotometry. The visible light modulation of 44% and the colorization efficiency of 41 ㎠/C at 550 nm were obtained at the step potentials of -0.8/+1.2 V vs Ag and a duration of 30 s.

• Food Science of Animal Resources
• /
• v.38 no.6
• /
• pp.1168-1178
• /
• 2018

The present study aimed to characterise anti-oxidant peptides from water-soluble protein extracts of Hanwoo beef and evaluate their anti-proliferative effect on human colorectal carcinoma cells (HCT116). Antioxidant peptides were purified from the low-molecular-weight fraction (<3 kDa) of Hanwoo beef extract. Antioxidant activity of peptide fractions was determined using the oxygen radical absorbance capacity (ORAC) assay. Purified peptide (P3) displayed higher ORAC activity than the low-molecular-weight fraction ($202.66{\mu}M\;TE/g$ vs $167.38{\mu}M\;TE/g$ of dry matter, respectively) (p<0.05). The peptide sequence of P3 was Cys-Cys-Cys-Cys-Ser-Val-Gln-Lys (888.30 Da). The novel peptide P3, at $250{\mu}g/mL$, also significantly inhibited HCT116 cell proliferation up to 25.24% through phosphorylation of ERK, JNK, and p38 kinase (p<0.05). Hence, antioxidant peptide P3 from Hanwoo beef extract can be used as an antioxidative and anticancer agent in the functional food industry.

• Journal of Yeungnam Medical Science
• /
• v.36 no.2
• /
• pp.109-114
• /
• 2019

Background: Transforaminal epidural block (TFEB) is an effective treatment option for radicular pain. To reduce complications from intravascular injection during TFEB, use of imaging modalities such as real-time fluoroscopy (RTF) or digital subtraction angiography (DSA) has been recommended. In this study, we investigated whether DSA improved the detection of intravascular injection during TFEB at the whole spine level compared to RTF. Methods: We prospectively examined 316 patients who underwent TFEB. After confirmation of final needle position using biplanar fluoroscopy, 2 mL of nonionic contrast medium was injected at a rate of 0.5 mL/s under RTF; 30 s later, 2 mL of nonionic contrast medium was injected at a rate of 0.5 mL/s under DSA. Results: Thirty-six intravascular injections were detected for an overall rate of 11.4% using RTF, with 45 detected for a rate of 14.2% using DSA. The detection rate using DSA was statistically different from that using RTF (p=0.004). DSA detected a significantly higher proportion of intravascular injections at the cervical level than at the thoracic (p=0.009) and lumbar (p=0.011) levels. Conclusion: During TFEB at the whole spine level, DSA was better than RTF for the detection of intravascular injection. Special attention is advised for cervical TFEB, because of a significantly higher intravascular injection rate at this level than at other levels.

• Composites Research
• /
• v.34 no.1
• /
• pp.30-34
• /
• 2021

This paper present a three-dimensional unit cell finite element analysis to predict the pull-out behavior of a single stitch in a composite laminate. The stitching process used for this study correspond to the I-fiber stitching method that has been studied by the Composite Structures Lab (CSL) as a new through-thickness reinforced method. A total of six cases were analyzed, which were divided in two groups by the stitching yarn used, 6k and 12k. Each group of cases have three different thickness according to the amount of plies; 16 plies, 32 plies and 64 plies. The finite element analysis used the cohesive zone method to characterize the single stitch reinforcement in the interface. Due to the complexity of the load vs displacement curves taken from the experimental results, a bilinear and trilinear bridging laws were implemented in the models. The cohesive parameters used for each case showed a good agreement with the experimental data and can be used for future studies.

• The Korean Journal of Emergency Medical Services
• /
• v.26 no.1
• /
• pp.7-19
• /
• 2022

Purpose: The purpose of this study is to evaluate the interrupted chest compression time during the use of an automated external defibrillator (AED) depending on different AED practice training methods, and to report differences in self-efficacy before and after training. Methods: We enrolled university freshmen who have had cardiopulmonary resuscitation (CPR) training but have not or have had AED training but over 6 months. We examined differences between the group that practiced only shockable rhythms during training and the group that practiced both shockable and non-shockable rhythms. Results: A total of 72 individuals participated in this study, with 36 individuals each in the control and experimental groups. There was no statistically significant difference in the proficiency of AED usage between the two groups. In non-shockable cases, the experimental group showed shorter chest compression interruption time than the control group (2.30±1.21sec vs. 3.16±1.73 sec; p<0.01). In terms of self-efficacy before and after training, both groups showed higher self-efficacy after than before training. Conclusion: Individuals who underwent training that provided practice on both shockable and non-shockable rhythms had a shorter interrupted chest compression time when using the AED.

• Korean Journal of Exercise Nutrition
• /
• v.14 no.2
• /
• pp.95-101
• /
• 2010

The purpose of this study was to evaluate changes of body composition, cardio-respiratory function in ventilation threshold (VT) and maximal state exercise, systolic (SBP) and diastolic blood pressure (DBP) and serum nitric oxide (NO) production during acute reducing salt (RS) supplementation in college elite athletes. Variables of cardio-respiratory function during rest, ventilation threshold and maximal exercise was not shown a significantly difference between RS supplementation and non-supplementation, there was shown a significant increase in ventilation threshold time (p<0.05) and exhaustion time (p<0.05) during RS supplement compared to non-supplement. SBP and DBP were not shown a significant difference between RS supplement and non-supplement. This result suggests that acute intake of RS is not increased a blood pressure. Serum NO production was not significant difference in the RS supplement group, but it was shown a significantly increased levels (p<0.01, vs. recovery 30 min.) immediately after maximal exercise in the non-supplement group. This result suggests that acute intake of RS have important role in inhibition of serum NO production during maximal exercise. Conclusively, This study suggest that acute intake of RS was not influence in body composition variables, but it was positive effect in ventilation threshold time, exhaustion time, maintenance of blood pressure and inhibition of serum NO production in maximal treadmill exercise.

• Journal of the Korean Ceramic Society
• /
• v.27 no.3
• /
• pp.355-360
• /
• 1990

One of the possible ways to make a flexible wire of high-Tc superconductiong ceramics is the extrusion of a mixture slurry of superconducting powder with an appropriate polymer binder. The fabrication procedure for $YBa_2Cu_3O_{7-{\delta}}$ superconducting coils with this plastic mass is described. The major factors limiting the formation of extruded wire are the binder content, powder size, and entrapped gas in the mixture slurries. The optimum content of binder for both good flexbility and strength of wire was estimated to be 30wt%. The finer the powder size is, the more homogeneous structure the extruded wire has. The vacuum degassing before extrusion was necessary to remove the entrapped gas in as-extruded wire. The formability of wire depends greatly on the wire radius and binder content. After burning out the binder and the successive sintering, the contacts between the superconducting grains could be made. The resistivity vs. temperature behavior measured in the final wire showed the transition temperature of 90K with narrow transition width. However, the critical current densities of these wires are much lower in comparison to those of conventional bulk specimens.