• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2003.05a
• /
• pp.685-688
• /
• 2003

BaTiO$_3$ 분말을 Ba(OH)$_2$ㆍ8$H_2O$와 아나타제형의 TiO$_2$ㆍx$H_2O$를 이용하여 수열합성법에 의해 제조하였다. Autoclave 반응기를 이용한 본 실험의 경우, BaTiO$_3$ 분말을 생성하기 위해 반응온도, 용질의 농도 등과 같이 BaTiO$_3$ 합성에 관여하는 반응변수를 변화시켜, 각각의 실험조건이 어떠한 영향을 미치는지를 조사하였다 수열합성법에 의해 합성된 BaTiO$_3$의 전화율은 온도와 농도 증가에 따라 높아지는 현상을 보였으며, 열역학적으로 계산된 최대 전화율에 접근하였다. 또한 반응온도와 농도의 증가에 의해 생성된 BaTiO$_3$는 균일한 입도 분포와 구형에 가까운 형상을 나타내었다. 따라서 농도를 높이는 조건이 전화율과 생산성을 모두 높일 수 있는 방법이라는 것을 확인할 수 있었다.

• Journal of Powder Materials
• /
• v.13 no.6 s.59
• /
• pp.401-407
• /
• 2006

Effects of oxygen deficiency on the room temperature ferromagnetism in Fe-doped reduced $TiO_2$ have been investigated by comparing the air-annealed $Ti_{0.97}Fe_{0.03}O_2$ compound with secondly post-annealed one in vacuum ambience. The air-annealed sample showed a paramagnetic behavior at room temperature. However, when the sample was further annealed in vacuum, a strongly enhanced ferromagnetic behavior was observed at same temperature. $M{\"{o}}ssbauer$ spectra of air-annealed sample at 295K showed a single doublet of $Fe^{3+}$, suggesting that the Fe ions are paramagnetic. On the other hand, the absorption spectra after vacuum-annealing exhibited two doublets, in which one is the same component with air-annealed sample and the other is new doublet corresponding to $Fe^{2+}$ state. This result suggests that the occurrence of ferromagnetism in reduced sample may be interpreted as the contribution of unquenched orbital moment of $Fe^{2+}$ ions.

• Journal of the Korean Ceramic Society
• /
• v.35 no.7
• /
• pp.665-670
• /
• 1998

Ferroelectric anomaly in PbO-{{{{ { {B }_{2 }O }_{3 } }}-{{{{ {TiO }_{3 } }}-BaO glasses which is observed in DAT measurements was in-vestigated together with the effect of BaO content on the shift of Cuire temperature. The temperature where the ferroelectric anomaly apperars on cooling in DTA decreased in proportion with increasing BaO content,. For as-crystallized samples the ferroelectric anomaly was not observed on heating but on cooling whilist for powder samples leached chemically from the crystallized samples both endothermic and ex-otehrmic peaks were observed. This fact suggests that the appearance of the ferroelectric anomaly in DAT largely depends on glassy phases surrounding individual {{{{ {PbTiO }_{3 } }} crystals rather than effects of grain size and crystallinity.

• Journal of Powder Materials
• /
• v.16 no.1
• /
• pp.33-36
• /
• 2009

In order to increase the magnetic loss for electromagnetic(EM) wave absorption, the soft magnetic $Fe_{73}Si_{16}B_7Nb_3Cu_1$(at%) alloy strip was used as the basic material in this study. The melt-spun strip was pulverized using an attrition mill, and the pulverized flake-shaped powder was crystallized at $540^{\circ}C$ for 1h to obtain the optimum grain size. The Fe-based powder was mixed with 2 wt% $BaTiO_3$, $0.3{\sim}0.6$ wt% carbon black, and polymer-based binders for the improvement of electromagnetic wave absorption properties. The mixture powders were tape-cast and dried to form the absorption sheets. After drying at $100^{\circ}C$ for 1h, the sheets of 0.5 mm in thickness were made by rolling at $60^{\circ}C$, and cut into toroidal shape to measure the absorption properties of samples. The characteristics including permittivity, permeability and power loss were measured using a Network Analyzer(N5230A). Consequently, the properties of electromagnetic wave absorber were improved with the addition of both $BaTiO_3$ and carbon black powder, which was caused by the increased dielectric loss of the additive powders.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.425-425
• /
• 2011

The photocatalytic decomposition of toluene gas was investigated with $TiO_2$ on nano-diamond powder (NDP) under UV irradiation. Atomic layer deposition (ALD) was used for the growth of $TiO_2$ on the NDP. The structure and surface properties of catalysts were characterized by X-ray Diffraction (XRD), X-ray Photoelectron Spectroscopy (XPS) and Transmission Electron Microscopy (TEM). The photocatalytic activity for the toluene decomposition was evaluated by measuring the concentration change of toluene and $CO_2$ gas with gas chromatography (GC)-flame ionization detector (FID) system. The photocatalytic activities of $TiO_2$/NDP catalysts were compared with that of P-25. The rate of initial photocatalytic decomposition of toluene for the $TiO_2$/NDP catalysts was relatively lower when compared to P-25. The photocatalytic activity of P-25 was rapidly decreased with time, whereas, the deactivation of $TiO_2$/NDP catalysts was less pronounced. Therefore, as the reaction time increased, the photocatalytic activity of $TiO_2$/NDP catalysts became higher than that of P-25. The intermediates such as benzaldehyde or benzoic acid, etc were more easily adhered to the active site on the P-25 surface during reaction, resulting in easier deactivation of P-25. These results could be confirmed using FT-IR spectroscopy. We suggest that the NDP used as substrate can reduce the deactivation of $TiO_2$ on the surface.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.209-210
• /
• 2006

Organic binders are usually pre-mixed with ceramic powders to enhance the formability during the shape forming process. These binders, however, must be eliminated before sintering in order to avoid pore formation and unusual grain growth during sintering. The present work was performed to investigate the effects of residual binder on grain growth behavior during sintering of $Pb(Mg_{1/3}Nb_{2/3})O_3-PbTiO_3$ piezoelectric ceramics. The microstructures of sintered samples were examined for various thermal processes and atmosphere at debinding. Addition of binder seems to promote abnormal grain growth especially in incompletely debinded regions and to make the grain shape change from corner-rounded to faceted.

• Journal of Powder Materials
• /
• v.18 no.1
• /
• pp.14-17
• /
• 2011

$TiO_2$ nanopowders with anatase structure were firstly prepared by controlling the pH value of a precursor solution without any heat-treatment at room temperature. The prepared $TiO_2$ nanopowders were hydrothermally treated in 10M NaOH solution at $170^{\circ}C$. Then, the samples were washed in DI water or 0.1M HCl. The $TiO_2$ nanotubes were characterized by X-ray diffraction (XRD), scanning electron microscope (SEM) and transmission electron microscope (TEM). The gas sensitivity of $TiO_2$ nanotubes for toluene gas was also investigated. The results show that $TiO_2$ nanotubes can be prepared by hydrothermal treatment. The morphology of $TiO_2$ nanotubes prepared by 0.1M HCl washing is destroyed to some extent. $TiO_2$ nanotubes with DI water washing show better sensitivity than that with 0.1M HCl washing.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2001.11a
• /
• pp.415-416
• /
• 2001

최근 환경오염에 대한 관심이 고조되면서 VOCs를 비롯한 각종 악취물질 제거에 광촉매가 각광받고 있다. 광촉매는 기존 오염물질 제거기술과는 달리 광촉매 하나로서 복합적인 오염물질을 한꺼번에 분해할 수 있는 장점이 있다. 그러나 미세한 광촉매 분말(powder)은 오히려 분진으로 작용할 수 있고, 회수가 어려워 응용에 있어 상당한 제약을 받는다. 이에 상용화된 TiO$_2$ 분말이나 졸을 지지체에 코팅한 TiO$_2$ 박막으로 광촉매의 응용 범위를 점차 확대해 나가는 추세이다. (중략)

• Journal of the Korean Ceramic Society
• /
• v.37 no.4
• /
• pp.308-313
• /
• 2000

Hydrous titanium oxide particles with anatase phase were prepared from 0.05 mol TiCl4 solution using NH4HCO3 as precipitant by the droopping precipitant method. The sequential change of pH is completed by a sudden and steep increase in a pH value of the range of 6~7 to which the concentration of adsorbed OH- and H+ ions on TiO2 surface is equal. Rutile phase started precipitating with anatase phase as an increase of reaction temperature above 6$0^{\circ}C$ in aqueous 0.05mol TiCl4 solution and its specific surface area was found to decrease from 452 $m^2$/g($25^{\circ}C$) to 164$m^2$/g(8$0^{\circ}C$). Specific surface area decreased rapidly when anatase powders precipitated at 4$0^{\circ}C$ were heat-treated at temperature higher 40$0^{\circ}C$. FT-IR result confirmed that it was due to the decrease of OH species within hydrous titanium oxides. The loss of ethanol after illumination of the powder heated at $600^{\circ}C$ and $700^{\circ}C$ for 4 h was 66 and 68.8%, respectively.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1999.05a
• /
• pp.263-263
• /
• 1999