• Journal of Industrial Technology
• /
• v.24 no.B
• /
• pp.133-138
• /
• 2004

The photodegradation of phenol and toluene with the $TiO_2$-coated polyethylene (PE) particles were investigated in the slurry type photocatalytic reactor, changing the $TiO_2$ particle sizes, initial phenol and toluene concentrations, and the oxygen flow rate. The nano-sized $TiO_2$ photocatalyst particles were prepared by the diffusion flame reactor and they were coated onto PE particles by using the hybridization system for the efficient recollection of $TiO_2$-coated particles after photodegradation experiments. The degradation efficiencies of phenol and toluene with the $TiO_2$-coated PE particles were more than 90% after photodegradation of 80 minutes for most cases. The efficiencies of photodegradation with the $TiO_2$-coated PE particles were found to be lower than those by the pure $TiO_2$ particles by 50%, because of the decrease in specific surface area of $TiO_2$ particles in PE particles.

• Journal of the Korean Ceramic Society
• /
• v.40 no.1
• /
• pp.62-68
• /
• 2003

Ba-ferrite particles added with Co and Ti, which were known well the additives for the control in coercivity, were synthesized by sol-gel method. In the range 90 to 120 minute reaction time, a stable sol solution which showed no change with temperature, pH, viscosity and aging time. After dried and heat treatment of sol solution, Ba-ferrite phase formed at $700^{\circ}C$ with Differential Thermal Analysis(DTA) and X-Ray Diffractometer(XRD) measurement. The crystallinity became to be better with increasing the temperature. It were showed by Scanning Electron Microscopy(SEM) that Ba-ferrite increased to particle sizes as increasing heating temperature and obtained of narrow particles size distribution. Also, magnetic characteristics of Ba-ferrite powders Co and Ti added were observed by a Vibrating Sample Magnetometer(VSM). Saturation magnetization$(M_s)$ was not much changed, however. the coercivity$(H_c)$dramatically dropped with addition of Co and Ti.

• Journal of the Korean Society for Heat Treatment
• /
• v.7 no.1
• /
• pp.11-16
• /
• 1994

Anatase $TiO_2$ particles prepared by experiment were used to study the change of crystal structure by calcination temperature. The results were as follows. Crystallite size of anatase $TiO_2$ particles increased with calcination temperature. The rate of increasing the crystallite size of anatase $TiO_2$ particles was decreased below $700^{\circ}C$ and was markedly increased above $700^{\circ}C$. Unit cell volume of $TiO_2$ was expanded at low temperature and was contracted at high temperature. This result means that the growth of crystallite size was occured in the direction.

• Applied Chemistry for Engineering
• /
• v.9 no.5
• /
• pp.634-638
• /
• 1998

Monodisperse, spherical $PMSQ/TiO_2$ composite fine powders were prepared by modified sol-gel process where 300 nm $TiO_2$ fine powders were used as seed particles for hetero-condensation with hydrolyzed MTMS (Methyltrimethoxysilane). The reaction was carried out under $N_2$ atmosphere at ambient temperature using $NH_3$ as a catalyst. Methanol was used as a solvent. Powder was obtained by the filtration of the solution with a glass filter and washing with acetone. The stirring rate, reaction temperature, $[H_2O]/[MTMS]$ and $[MTMS]/[TiO_2]$ ratio were varied to investigate shapes and sizes of particles. Monodisperse particles of $1-2{\mu}m$ diameter were obtained with [MTMS]=0.2 M, $[NH_3]=0.6M$, $[H_2O]/[MTMS]=100$, $[MTMS]/[TiO_2]=10-50$ at ambient temperature with mild stirring condition. These composite particles had a contact angle of almost 180 degree contact angle with water, which proves their excellent hydrophobicity. The study of UV absorption spectra showed that they have UV protecting effect.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.30 no.2
• /
• pp.181-187
• /
• 2004

Preparations of mesoporous materials using various templates and their applicability have been intensively investigated for many years. We studied on synthesizing mesoporous Ti02 with pores in which sensitive compounds having weak physico-chemical properties such as thermal or UV irradiation and low solubility in solvent are trapped. Prior to trapping OMC in the pores of mesoporous titania, OMC was nano-emulsified in O/W system using Lecithin. Thereafter the OMC was trapped in the pores of mesoporous titania using sol-gel method. Main focus of this work is to prepare OMC-trapped mesoporous titania and to trace the stability and solubility of nano-emulsified OMC in the pores of mesoporous titania, and compared with that of mesoporous silica. OMC-trapped mesoporous Inorganic-Organic hybrid titania showed higher factors in sun protecting and a skin penetration phenomenon was reduced.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2002.04a
• /
• pp.311-312
• /
• 2002

환경분야에서 광촉매는 주로 오염물질의 광분해처리에 이용되고 있는데, 기존에 사용되고 있는 광분해 방법은 광촉매 미립자를 수용액에 슬러리 형태로 분산시키거나 fixed bed, fluidized bed에 부착시킨 형태의 반응기들이다. 실험적 수준의 연구로부터 얻어진 여러 연구 결과에 의하면 슬러리 형태의 반응기가 고정화 촉매 반응기보다 효율이 더 높은 것으로 보고되고 있다. 그러나 엔지니어링 관점에서 슬러리형 반응기는 촉매의 재활용과 정화 처리 후 촉매입자를 유체로부터 분리해야하는 결점이 있다. (중략)

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.1
• /
• pp.25-32
• /
• 2009

The glass-ceramics composed of coal bottom ash produced from a thermal power plant, $Na_{2}O$ and $Li_{2}O$ as a flux agent and $TiO_2$ as a nucleation agent were fabricated and its microstructures were analyzed. The nepheline was a major crystal phase in the glass-ceramics fabricated and its amount increased with $TiO_2$ addition. The glass-ceramics without $TiO_2$ addition had the thick surface crystals induced by a surface-crystallization mechanism and no crystal in the interior matrix. The surface crystallization, however, was restrained and the interior matrix was completely crystallized showing dendrite shape spread with fine particles < $1{\mu}m$ when added with $TiO_2$ above 4 wt%. For the glass-ceramics containing 6 wt% $TiO_2$, the $5{\mu}m$-long dendrite crystal; were interlocked each other which could suppress the crack propagation effectively at the external loading applied.

• Journal of the Korean Society for Heat Treatment
• /
• v.6 no.4
• /
• pp.204-212
• /
• 1993

The preparation of $TiO_2$ fine particles from $TiCl_4$ and oxygen by the vapor-phasereaction was investigated at $850^{\circ}C$ with an emphasis on the effect of its experimental conditions on the crystal type of the products. Anatase $TiO_2$ particles prepared by experiment were used to study anatase-rutile transition by calcination temperature, the additives and gas atmosphere. The results were as follows. The kinetics of anatase-rutile transition was well agreed with A vrami equation, and the activation energy of transition was 35kcal/mol. The addition of CuO in anatase $TiO_2$ particles accelerated the anatase-rutile transition, and its transition was retarded in vaccum.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.5
• /
• pp.251-255
• /
• 2009

Nanocomposites based on coupling $TiO_2$ matrix with nanosized noble metals (Pt,Au) particles exhibited promising photoelectrode properties. The $M/TiO_2$ (M=Pt,Au) nanocomposite thin films were deposited on quartz and ITO glass substrates using a co-sputtering method. $TiO_2$ in rutile form is the dominant crystalline phase for as-deposited nanocomposite films. Along with heat treatment up to $600^{\circ}C$, XRD peaks of the rutile phase as well as those of noble metal increased in intensity and decreased in width, indicating the growth of crystallites. The anodic photocurrents of $M/TiO_2$ (M=Au,Pt) thin films were observed not only in the UV range but also in the visible light range. The photocurrent of the nanocomnosite films extended to the visible light region by dispersion of nano-sized noble metal in the $TiO_2$ matrix.

• Journal of the Korean Ceramic Society
• /
• v.43 no.2 s.285
• /
• pp.114-120
• /
• 2006

Nano-size Au particle doped $TiO_2$ films were prepared with $Ti(OC_3H_7^i)_4$, polyvinylpyrrolidone(PVP), $HAuCl_4$ and $C_3H_7OH$ etc. by sol-gel method. $TiO_2$ gel films were obtained by the dip-coating method on the $SiO_2$ glass substrates, and then heat-treated at $700^{\circ}C$ for 10 min. The thickness of $TiO_2$ films were $0.7\~1.8\;{\mu}m$. It was found that the thickness of films prepared from PVP containing solution was about $2\~8$ times higher values than that of thin films without PVP. The size of Au particles doped in the films were about $350\~750\;nm$. Nano-size Au particle dispersed $TiO_2$ films showed high absorption peak at visible region 450nm, which made them good candidates for non-linear optical materials and photo-catalytic materials. The contact angle of $TiO_2$ film for water was $12.5^{\circ}$, and therefore it is clear that $TiO_2$ films have very high hydrophilic properties and the self-cleaning effects.