• Clean Technology
• /
• v.12 no.4
• /
• pp.244-249
• /
• 2006

The photocatalytic degradation of trichloroethlylene (TCE), has been investigated over $TiO_2$ photocatalysts irradiated with solar light. The effect of operational parameters, i.e., initial TCE concentration, $TiO_2$ concentration, pH and additives ($H_2O_2$, persulphate($S_2O{_8}^-$)) on the degradation rate of aqueous solution of TCE has been examined. The results presented in this work demonstrated that degradation of the TCE with $TiO_2/solar$ light was enhanced by augumentation in $TiO_2$ loading, pH, and adding additives but was inhibited by increase in initial TCE concentration. Also individual use of $H_2O_2$ was far more effective than using persulphate in TCE removal efficiency. Furthermore, the relative toxicity with a $solar/TiO_2/H_2O_2$ system was about 15% lower than with a $solar/TiO_2/persulphate$ system and about 35% lower than with a $solar/TiO_2$ system within a reaction time of 150 min, respectively.

• Korean Journal of Materials Research
• /
• v.23 no.6
• /
• pp.339-343
• /
• 2013

Porous Ti-systems with unidirectionally aligned channels were synthesized by freeze-drying and a heat treatment process. $TiH_2$ powder and camphene were used as the source materials of Ti and sublimable vehicles, respectively. Camphene slurries with $TiH_2$ content of 10 and 15 vol% were prepared by milling at $50^{\circ}C$ with a small amount of oligomeric polyester dispersant. Freezing of the slurry was done in a Teflon cylinder attached to a copper bottom plate cooled at $-25^{\circ}C$ while unidirectionally controlling the growth direction of the camphene. Pores were generated subsequently by sublimation of the camphene during drying in air for 48 h. The green body was heat-treated at $1100^{\circ}C$ for 1 h in a nitrogen and air atmosphere. XRD analysis revealed that the samples composed of TiN and $TiO_2$ phase were dependent on the heat-treatment atmosphere. The sintered samples showed large pores of about 120 mm which were aligned parallel to the camphene growth direction. The internal wall of the large pores had relatively small pores with a dendritic structure due to the growth of camphene dendrite depending on the degree of nucleation and powder rearrangement in the slurry. These results suggest that a porous body with an appropriate microstructure can be successfully fabricated by freeze-drying and a controlled sintering process of a camphene/$TiH_2$ slurry.

• Korean journal of applied entomology
• /
• v.47 no.2
• /
• pp.141-147
• /
• 2008

Male adults of bean bug, Riptortus clavatus Thunberg (Heteroptera: Alydidae), release aggregation pheromone (AP) attracting both sexes of adult and nymphs, which its egg parasite, Ooencyrtus nezarae (Hymenoptera: Encyrtidae) exploits the pheromone to find host. The AP consists of three components; (E)-2-hexenyl (Z)-3-hexenoate (E2HZ3H), (E)-2-hexenyl (E)-2-hexenoate (E2HE2H), and tetradecyl isobutyrate (TI). We analyzed composition of the pheromone components of bean bugs from different geo graphical locations of Korea and Japan. The attractiveness of different blends of AP components to R. clavatus was also tested in the fields in Jinju, Korea and in Kumamoto, Japan. Composition ratios (E2HZ3H: E2HE2H:TI) of the AP of Jinju and Iksan populations were 1:1.4:0.2 and 1:0.8:0.2, and those of Tsukuba and Kumamoto populations were 1:2.8:0.2 and 1:1.5:0.1, respectively. In field tests, traps baited with ratio of 1:1:1 (E2HZ3H:E2HE2H:TI=16.7:16.7:16.7mg/rubber septum) and 1:1:0.5(E2HZ3H:E2HE2H:TI= 20:20:10mg/rubber septum) attracted significantly greater number of adult bugs than that of 1:5:1 (E2HZ3H:E2HE2H:TI=7.1:35.7:7.1mg/rubber septum).

• Analytical Science and Technology
• /
• v.26 no.1
• /
• pp.42-50
• /
• 2013

This paper describes the electrocatalytic activity for the oxidation of small biomolecules on the surface of Pt-Ru nanoparticles supported by $TiO_2$-hollow sphere prepared for use in sensor applications or fuel cells. The $TiO_2$-hollow sphere supports were first prepared by sol-gel reaction of titanium tetraisopropoxide with poly(styrene-co-vinylphenylboronic acid), PSB used as a template. Pt-Ru nanoparticles were then deposited by chemical reduction of the $Pt^{4+}$ and $Ru^{3+}$ ions onto $TiO_2$-hollow sphere ($Pt-Ru@TiO_2-H$). The prepared $Pt-Ru@TiO_2-H$ nanocomposites were characterized by transmission electron microscopy (TEM), X-ray diffraction (XRD), and elemental analysis. The electrocatalytic efficiency of Pt-Ru nanoparticles was evaluated via ethanol, methanol, dopamine, ascorbic acid, formalin, and glucose oxidation. The cyclic voltammograms (CV) obtained during the oxidation studies revealed that the $Pt-Ru@TiO_2-H$ nanocomposites showed high electrocatalytic activity for the oxidation of biomolecules. As a result, the prepared Pt-Ru catalysts doped onto $TiO_2$-H sphere nanocomposites supports can be used for non-enzymatic biosensor or fuel cell anode electrode.

• Korean Chemical Engineering Research
• /
• v.45 no.5
• /
• pp.448-454
• /
• 2007

Hydrothermal synthesis was conducted with starting material as Barium hydroxide and hydrous titania ($TiO_2{\cdot}xH_2O$) to obtain barium titanate fine Powder. The conversion, crystal structure and properties of as-prepared powder were investigated according to reaction temperature, time and concentration. The effect of variables on conversion was in order of time < temperature < concentration and the maximum conversion reached to 99.5% in the case of hydrothermal synthesis at $180^{\circ}C$ for 2 h with 2.0 M reactant concentration. At low concentration such as 0.25 M, formation of unreacted $BaCO_3$ and $TiO_2$ was not inevitable at even high reaction temperature and these components converted into $BaTi_2O_5$ at high temperature and remained as impurity. As concentration of reactant increased, the size of as-synthesized $BaTiO_3$ powder deceased and Ba/Ti molar ratio approached into 1, showing Ba/Ti ratio of $1{\pm}0.005$ for reaction at $180^{\circ}C$ for 2 h with 2.0 M concentration.

• Korean Chemical Engineering Research
• /
• v.45 no.5
• /
• pp.455-459
• /
• 2007

Plasma catalytic methane conversion was carried out in the presence of sol-gel derived $Pt/TiO_2$ catalysts within a dielectric-barrier discharge (DBD) reactor. Plasma-assisted reduction (PAR) was applied to reduce the prepared $Pt/TiO_2$ catalysts in DBD reactor, and prepared catalysts were successively reduced by PAR within 20 min irrespective of the Pt loading and the calcination temperature. The highest methane conversion was 40% when 3 wt% $Pt/TiO_2$ and 5 wt% $Pt/TiO_2$ catalysts were used after calcination at $600^{\circ}C$. The selectivities of light alkanes ($C_2H_6$, $C_3H_8$, $C_4H_{10}$) were highly increased when $Pt/TiO_2$ catalysts were used in DBD reactor.

• Journal of Powder Materials
• /
• v.23 no.4
• /
• pp.303-306
• /
• 2016

An optimum route to synthesize Ti-Mo system powders is investigated by analyzing the effect of the heat treatment atmosphere on the formation of the reaction phase by dehydrogenation and hydrogen reduction of ball-milled $TiH_2-MoO_3$ powder mixtures. Homogeneous powder mixtures with refined particles are prepared by ball milling for 24 h. XRD analysis of the heat-treated powder in a hydrogen atmosphere shows $TiH_2$ and $MoO_3$ peaks in the initial powders as well as the peaks corresponding to the reaction phase species, such as $TiH_{0.7}$, TiO, $MoO_2$, Mo. In contrast, powder mixtures heated in an argon atmosphere are composed of Ti, TiO, Mo and $MoO_3$ phases. The formation of reaction phases dependent on the atmosphere is explained by the partial pressure of $H_2$ and the reaction temperature, based on thermodynamic considerations for the dehydrogenation reaction of $TiH_2$ and the reduction behavior of $MoO_3$.

• Journal of Photoscience
• /
• v.2 no.1
• /
• pp.7-11
• /
• 1995

Powders of artificial crystallites of titanium(IV) oxide, TiO$_2$(B), were synthesized by the calcination of tetratitanic acid (hydrate, $H_2Ti_4O_9H_2O$; TTA). The relating titanates, potassium octatitanate ($K_2Ti_8O_{17}$) and octatitanic acid($H_2Ti_8O_{17}$), were also prepared. These powders, loaded with small amount of Pt, were suspended in an aqueous solution of 2-propanol and irradiated under argon atmosphere at 298 K + 0.5 deg. All the photocatalysts tested in this study produced almost equimolar amount of acetone and molecular hydrogen (H$_2$). Among them TiO$_2$(B) and TYA showed the higher photocatalytic activity but rather lower than commercial titanium(IV) oxide (TiO$_2$) powders. The photocatalytic activity of TiO$_2$(B) for 2-propanol dehydrogenation in deaerated aqueous suspension increased with the elevating calcination temperature. Comparison of rate of H$_2$ formation from methanol and 2-propanol solutions by the TiO$_2$(B) photocatalyst suggested a possibility of selection of substrate with its molecular size by TiO$_2$(B)

• Journal of Environmental Science International
• /
• v.12 no.7
• /
• pp.775-782
• /
• 2003

The photodegradations of pyrene, chrysene and benzo[a]pyrene that were similar in structure among polycyclic aromatic hydrocarbons (PAHs) were investigated with a low-pressure mercury lamp(the wavelength of 253.7 nm and UV output of 1.35${\times}$10$\^$-3/J/s). The optimum concentrations of TiO$_2$ and H$_2$O$_2$ on the photodegradation of pyrene, chrysene and benzo[a]pyrene were 1 g/L and 1.5${\times}$10$\^$-3/ M, respectively. By these optimum concentrations, their rates increased with increasing the concentration of TiO$_2$ and H$_2$O$_2$ because the amounts of OH radical formed increased, but for the higher concentrations than the optimum, their rates decreased with increasing those concentrations because the white turbidity phenomena occurs in case of TiO$_2$ and H$_2$O$_2$ acts as an OH radical inhibitor. The photodegradation rates among the photodegradation processes such as UV, UV/TiO$_2$, UV/H$_2$O$_2$, and UV/H$_2$O$_2$/TiO$_2$ decreased in the following sequences.: UV/H$_2$O$_2$/TiO$_2$> UV/H$_2$O$_2$> UV/TiO$_2$> UV.

• Journal of Sensor Science and Technology
• /
• v.23 no.3
• /
• pp.207-210
• /
• 2014

$TiO_2$ oxide semiconductor is being widely studied in various applications such as photocatalyst and photosensor. Pd/$TiO_2$ gas sensor is mainly used to detect $H_2$, CO and ethanol. This study focus on increasing hydrogen detection ability of Pd/$TiO_2$ in room temperature through Al-doping. Pd/$TiO_2$ was fabricated by the hydrothermal method. Contacting to Aluminum (Al) foil led to Al doping effect in Pd/$TiO_2$ by thermal diffusion and enhanced hydrogen sensing response. $TiO_2$ nanoparticles were sized at ~30 nm of diameter from scanning electron microscope (SEM) and maintained anatase crystal structure after Al doping from X-ray diffraction analysis. Presence of Al in $TiO_2$ was confirmed by X-ray photoelectron spectroscopy at 73 eV. SEM-energy dispersive spectroscopy measurement also confirmed 2 wt% Al in Pd/$TiO_2$ bulk. The gas sensing test was performed with $O_2$, $N_2$ and $H_2$ gas ambient. Pd/Al-doped $TiO_2$ did not response $O_2$ and $N_2$ gas in vacuum except $H_2$. Finally, the normalized resistance ratio ($R_{H2on}/R_{H2off}$) of Pd/Al-doped $TiO_2$ increases about 80% compared to Pd/$TiO_2$.