• Journal of the Korean Chemical Society
• /
• v.54 no.3
• /
• pp.269-274
• /
• 2010

The solubility and the physicochemical property (refractive index) in the NaCl-$CaCl_2$-$H_2O$ and KCl-$CaCl_2$-$H_2O$ systems were determined at $50^{\circ}C$ and the phase diagrams and the diagrams of physicochemical property vs composition were plotted. One invariant point, two univariant curves, and two crystallization zones, corresponding to sodium Chloride (or potassium chloride), dihydrate ($CaCl_2{\cdot}2H_2O$) showed up in the phase diagrams of the ternary systems. The mixing parameters ${\theta}_{M,Ca}$ and ${\Psi}_{M,Ca,Cl}$ (M = Na or K) and equilibrium constant $K_{sp}$ were evaluated in NaCl-$CaCl_2-H_2O$ and KCl-$CaCl_2-H_2O$ systems by least-squares optimization procedure, in which the single-salt Pitzer parameters of NaCl, KCl and $CaCl_2$ ${\beta}^{(0)}$, ${\beta}^{(1)}$, ${\beta}^{(2)}$ and $C^{\Phi}$ were directly calculated from the literature. The results obtained were in good agreement with the experimental data.

• Korean Journal of Materials Research
• /
• v.10 no.1
• /
• pp.55-61
• /
• 2000

The sintering characteristics of PVA-Al(III) complex added $UO_2$ pellet and AlOOH added $UO_2$pellet were compared. The major phase of PVA-Al(III) complex and AlOOH decomposed at $1000^{\circ}C$ in $H_2$atmosphere was $\theta-Al_2O_3$. Compared with the apparent density of pure $UO_2$, that of AlOOH added $UO_2$ powder was higher but that of PVA-Al(III) complex was lower. the densification of AlOOH added $UO_2$ pellet was initiated at about $800^{\circ}C$, the densification of PVA-Al(III) complex added $UO_2$ pellet was initiated at about $900^{\circ}C$ respectively. In a view of pore size distribution, the PVA-Al(III) complex added $UO_2$ pellet appeared as monomodal type, whereas the AlOOH added $UO_2$ pellet appeared as bimodal type. The grain size of AlOOH added $UO_2$ pellet was about $13\mu\textrm{m}$ but the grain size of PVA-Al(III) complex added $UO_2$ pellet was increased up to about $36\mu\textrm{m}$.

• Journal of Korean Society of Steel Construction
• /
• v.23 no.3
• /
• pp.261-273
• /
• 2011

Recently, the demands for steel frame are increasing because of the trend and due to the demand for bigger and higher buildings. In the analysis of typical steel frame, connections are based on the idealized fixed or pinned connection. A fixed connection assumes that the relative angle of each member before deformation is the same after the transformation. Therefore, the stiffener reinforces the connection to sufficient rigidity and stability of the panel zone. In the economical aspect, however, the necessity of connection that the stiffener reinforcement has omitted is increasing due to the excessive production as well as labor costs of connection. In contrast, pinned connection is assumed that bending moments between the beams and columns do not transfer to each member. This is easy to make in the plant and the construction is simple. However, the structural efficiency is reduced in pinned connection because connection cannot transfer moments. The introduction of this semirigid process can decide efficient cross-sectional dimensions that promote ease in the course of structural erection, as performed by members in the field-a call for safety in the entire frame. Therefore, foreign countries exert efforts to study the practical behavior and the results are applied to criterion. This paper analyzes the semirigid connection of domestic steel by design specifications of AISC/LRFD and make data bank that pertain to each steel. After wards, the results are compared to those of idealized connection; at the same time, this paper presents a design method that matches economic efficiency, end-fixity, and rotational stiffness.

• Journal of IKEEE
• /
• v.17 no.4
• /
• pp.505-510
• /
• 2013

In this paper, a method of estimating hand and elbow movements using electrocorticogram (ECoG) signals is proposed. Using multiple channels, surface electromyogram (EMG) signals and ECoG signals were obtained from patients simultaneously. The estimated movements were those to close and then open the hand and those to bend the elbow inward. The patients were encouraged to perform the movements in accordance with their free will instead of after being induced by external stimuli. Surface EMG signals were used to find movement time points, and ECoG signals were used to estimate the movements. To extract the characteristics of the individual movements, the ECoG signals were divided into a total of six bands (the entire band and the ${\delta}$, ${\Theta}$, ${\alpha}$, ${\beta}$, and ${\gamma}$ bands) to obtain the information entropy, and the maximum likelihood estimation method was used to estimate the movements. The results of the experiment showed the performance averaged 74% when the ECoG of the gamma band was used, which was higher than that when other bands were used, and higher estimation success rates were shown in the gamma band than in other bands. The time of the movements was divided into three time sections based on movement time points, and the "before" section, which included the readiness potential, was compared with the "onset" section. In the "before" section and the "onset" section, estimation success rates were 66% and 65%, respectively, and thus it was determined that the readiness potential could be used.

• Journal of the Korean Electrochemical Society
• /
• v.4 no.1
• /
• pp.14-20
• /
• 2001

The Langmuir adsorption isotherms of the under-potentially deposited hydrogen (UPD H) and the over-potentially deposited hydrogen (OPD H) at the single crystal Pt(100)/0.5 M $H_2SO_4$ and 0.5 M LiOH aqueous electrolyte interfaces have been studied using the phase-shift method. The phase-shift profile $({-\varphi}\;vs.\;E)$ for the optimum intermediate frequency can be used as a useful method to estimate the Langmuir adsorption isotherm $(\theta\;vs.\;E)$ at the interfaces. The equilibrium constant (K) for the OPD H and the standard free energy $({\Delta}G_{ads})$ of the OPD H at the Pt(100)/0.5M $H_2SO_4$ aqueous electrolyte interface are $1.5\times10^{-4}$ and 21.8 kJ/mol, respectively. At the Pt(100)/0.5 LiOH aqueous electrolyte interface, K transits from 1.9(UPD H) to $6.8\times10^{-6}$(OPD H) depending on the cathode potential (E) and vice versa. Similarly, ${\Delta}G_{ads}$ transits -1.6 kJ/mol (UPD H) to 29.5 kJ/mol (OPD H) depending on E and vice versa. The transition of K and ${\Delta}G_{ads}$ is attributed to the two distinct adsorption sites of the UPD H and OPD H on the Pt(100) surface. The UPD H and the OPD H at the Pt(100) interfaces are the independent processes depending on the H adsorption sites rather than the sequential processes for the cathodic $H_2$ evolution reactions.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.12
• /
• pp.277-284
• /
• 2013

The analysis of phase synchronization characteristics from EEG signals is important for the understanding of information processing functionality in the brain network. In this paper, wavelet transformation(WT), Hilbert tansformation (HT), complex demodulation (CD) methods having time localization characteristics were applied to real evoked potential data and noise added simulation data with center frequencies corresponding to EEG bands for the estimation performance analysis of phase offset, phase changing point, and interband crosstalk. The WT is the best both in ${\delta}$, ${\theta}$, and ${\alpha}$ band signal decomposition, and in analyzing phase synchronization performance. The CD can be efficiently used in changing point detection under tolerant noise condition because of its abrupt performance degradation over noise endurance level. From experimental observations, the WT is the most suitable in phase synchronization application of EEG signal, and the CD can be affordable in restricted application such as changing point detection for higher bands than ${\delta}$. Particularly, WT and CD can be used to detect the changing instant of brain function by indirectly estimating the phase changing point.

• Korean Journal of Weed Science
• /
• v.32 no.3
• /
• pp.204-210
• /
• 2012

The physicochemical properties of tuber starch in water chestnut have been studied. Peak viscosity, hot paste viscosity and cooling peak viscosity were 5679, 3146 and 4262 RVU, respectively. In three transition parameters, onset temperature ($T_o$), peak temperature ($T_p$), and conclusion temperature ($T_c$) were 64.1, 68.5 and $72.3^{\circ}C$, respectively. Gelatinization enthalpy (${\Delta}H$ gel) was 4.48 J/g. A-type starch has a smaller proportion (11.4%) of short chains ($DP{\geq}12$) and a larger proportion (57.2%) of short chains ($13{\leq}DP{\geq}24$). The tuber starch of water chestnut displayed an A-type X-ray diffraction pattern showing a strong diffraction peak at $2{\Theta}$ values of $15.18^{\circ}$, $17.13^{\circ}$, and $23.1^{\circ}$, and a weak peak at $2{\Theta}$ values of $18.1^{\circ}$, $20.06^{\circ}$, and $26.69^{\circ}$. Their crystallinity was 28.6% and the mean starch granule size was 21.5 ${\mu}m$.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.3
• /
• pp.103-108
• /
• 2016

In daily life, humans get stress very often. Stress is one of the important factors of healthy life and closely related to the quality of life. Too much stress is known to cause hormone imbalance of our body, and it is observed by the brain and bio signals. Based on this, the relationship between brain signal and stress is explored, and brain signal based stress index is proposed in our work. In this study, an EEG measurement device with 32 channels is adopted. However, only two channels (FP1, FP2) are used to this study considering the applicability of the proposed method in real enveironment, and to compare it with the commercial 2 channel EEG device. Frequency domain features are power of each frequency bands, subtraction, addition, or division by each frequency bands. Features in time domain are hurst exponent, correlation dimension, lyapunov exponent, etc. Total 6 subjects are participated in this experiment with English sentence reading task given. Among several candidate features, ${\frac{{\theta}\;power}{mid\;{\beta}\;power}}$ shows the best test performance (70.8%). For future work, we will confirm the results is consistent in low price EEG device.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.22 no.3
• /
• pp.127-133
• /
• 2012

To achieve low-cost and high-efficiency of thin-film solar cells applications, the sol-gel method that can be coated on a large area substrate, obtain homogeneous thin films of high purity was used. We studied structural and optical characteristics versus annealing temperature of $Cu_2ZnSnS_4$ which has kesterite structure by substitution low-cost sulfur (S) instead of high-cost selenium (Se). By analyzing XRD patterns, main peak was observed at $2{\theta}=28.5^{\circ}$ when Zn/Sn ratio is 0.8/1.2. And when we observed kesterite structure which has orientation of (112) direction, the more annealing temperature increase the bigger strength of (112) direction is. $Cu_2ZnSnS_4$ thin film showed characteristics of kesterite structure at $550^{\circ}C$. And when we calculated lattice constant, a = 5.5047 and $c=11.014{\AA}$ as same JCPDS (Joint Committee on Powder Standards) data measured. We measured optical transmittance to analyze optical characteristics. Optical transmittance was lower than 65 % at visible ray (${\lambda}=380{\sim}770nm$).

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.1
• /
• pp.47-56
• /
• 2017

In this study, the higher temperature thermal property of the fly ash-blast furnace slag system Geopolymer including alumina aggregate was investigated whether that Geopolymer will be or not useful as thermal-resistant construction materials. Under every mixing conditions, the crack on the surface of hardened body was not observed up to $800^{\circ}C$ and it corresponded with fact that level of changes was not significant before and after heating process. Residual compressive strength is most high when mixing Blast-Furnace Slag ratio is 60 wt% until temperature reaches $800^{\circ}C$. The major hydrates of hardened body of Geopolymer; amorphous halo pattern between $20{\sim}35^{\circ}$ (2theta) and mullite ($3Al_2O_3{\cdot}2SiO_2$) and quartz ($SiO_2$) was found during the experiment. Amorphous halo pattern was a aluminosilicate gel generated by geopolymeric polycondensation and it was found that the halo pattern of aluminosilicate gel was preserved up to $800^{\circ}C$. The patterns of aluminosilicate gel disappeared from $1,000^{\circ}C$ and crystal phases like gehlenite, calcium silicate, calcium aluminum oxide, microcline was observed with the increase of exposure temperature.