• Journal of the Korean Institute of Telematics and Electronics
• /
• v.16 no.2
• /
• pp.15-18
• /
• 1979

Deposited film of a transition metal, Ti was diffused into LiNbO3 crystals to form integrated optical waveguides. By suppressing L O out -diffusion, single-mode waveguides could be constructed. Measurements on characteristics were performed by using the prise coupling technique and a He-Ne laser. ( λ = 0.6328 $\mu$m)

• Journal of Advanced Marine Engineering and Technology
• /
• v.29 no.3
• /
• pp.313-318
• /
• 2005

Li-doped ZnS layers were grown by molecular beam epitaxy. It was found that relatively low growth temperature is suitable for effective incorporation of Li acceptors. The layers grown under optimized conditions exhibited photoluminescence spectra dominated by neutral-acceptor-bound excitons. Such layers also showed electrically p-type behavior in capacitance-voltage characteristics. The net acceptor concentration is estimated to be approximately $3{\times}10^{15}\;cm^{-3}$.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.6
• /
• pp.1313-1318
• /
• 2006

The mechanism fur the surface film formation was studied by in situ Atomic Force Microscopy (AFM) observation of a highly oriented pyrolytic graphite (HOPG) basal plane surface during cyclic voltammetry at a slow scan-rate of 0.5 mV $s^{-1}$ in 1 moi $dm^{-3}$ (M) $LiPF_6$ dissolved in a mixture of ethylene carbonate (EC) and diethyl carbonate (DEC). Decomposition of the electrolyte solution began at a potential around 2.15 V vs. $Li^+$/Li on step edges. In the potential range 0.95-0.8 V vs. $Li^+$/Li, flat areas (hill-like structures) and large swelling appeared on the surface. It is considered that these two features were formed by the intercalation of solvated lithium ions and their decomposition beneath the surface, respectively. At potentials more negative than 0.80 V vs. $Li^+$/Li, particle-like precipitates appeared on the basal plane surface. After the first cycle, the thickness of the precipitate layer was 30 nm. The precipitates were considered to be decomposition of the lithium salt ($LiPF_6$) and solvent molecules (EC and DEC), and to have an important role in suppressing further solvent decomposition on the basal plane.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.1
• /
• pp.11-14
• /
• 2009

Yb and Zn co-doped $LiNbO_3$ single crystal rods which had a diameter of 2 mm and a length of $15{\sim}25 mm$ were grown by micro-pulling down (${\mu}-PD$) method. The single crystals were successfully grown and had a uniform diameter and a smooth surface without crack. We realized of $LiNbO_3$ single crystals were hexagonal structure to compare with peaks of $LiNbO_3$ powder by Raman spectra. The threshold level of Zn concentration which is effective for optical damage were observed as about 1 mol% with IR transmission spectra.

• Journal of the Korean Chemical Society
• /
• v.50 no.3
• /
• pp.243-246
• /
• 2006

The LiCoO2 thin films were prepared on the Pt/Ti/SiO2/Si substrate by spin coating using citrate sol. The citrate sol was spin-coated on substrate and dried at 380oC for 15 min. to evaporate the solvents and remove the organic materials. The as-deposited films were annealed at 750oC for 10 min. in air for crystallization. The X-ray diffraction patterns for the film have been indexed hexagonal system with space group R3m. The active area of LiCoO2 films for electrochemical test was about 11cm2. A Li foil and 1M LiClO4 in propylene carbonate(PC) and ethylene carbonate(EC) (1:1)were used as an anode and an electrolyte, respectively. The galvanostatic charge-discharge test was carried out at constant current density ranging from 5 A/cm2 in the voltage window between 4.2 and 3.0 V. The first discharge capacity of the film is 0.35Ah/cm2-m. The cycling behavior of the LiCoO2 film is also reported.

• Korean Journal of Optics and Photonics
• /
• v.15 no.5
• /
• pp.475-482
• /
• 2004

We have fabricated a LiNbO$_3$ travelling-wave optical modulator. The travelling-wave modulator consisted of M-Z(Mach-Zehnder) interferometer and CPW(Coplanar Waveguide) travelling-wave electrodes. Design of CPW electrodes were performed by SOR(Successive Over Relaxation) to obtain the conditions of Microwave effective index and impedance matching. The fabricated modulator had -3.2 dB insertion loss, and S$_{11}$ below -15 dB up to 12 GHz, S$_{21}$ better than -3 dB upto 7 GHz. It turned out that the optical response showed the 3 dB bandwidth of above 12 GHz.

• Nuclear Engineering and Technology
• /
• v.26 no.4
• /
• pp.548-554
• /
• 1994

The full-energy peak efficiency for a collimated geometry of a Si (Li) detector has been experimentally determined using the electro-deposition sources. The radioactive sources of $^{51}$ Cr, $^{54}$ Mn, $^{57}$ Co and $^{65}$ Zn nuclides are prepared by the electro-deposition method. The measured efficiency values are corrected for the escape losses due to the K X-rays of silicon and the absorptions in materials related to source-to-detector geometry. The corrected efficiency values have turned out to be nearly constant regardless of photon energy.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.3
• /
• pp.836-840
• /
• 2011

This study examines the effects of a carbon coating on the electrochemical performances of $LiFePO_4$. The results show that the capacity of bare $LiFePO_4$ decreased sharply, whereas the $LiFePO_4$/C shows a well maintained initial capacity. The Li ion diffusivity of the bare and carbon coated $LiFePO_4$ is calculated using cyclic voltammetry (CV) to determine the correlation between the electrochemical performance of $LiFePO_4$ and Li diffusion. The diffusion constants for $LiFePO_4$ and $LiFePO_4$/C measured from CV are $6.56{\times}10^{-16}$ and $2.48{\times}10^{-15}\;cm^2\;s^{-1}$, respectively, indicating considerable increases in diffusivity after modifications. The Li ion diffusivity (DLi) values as a function of the lithium content in the cathode are estimated by electrochemical impedance spectroscopy (EIS). The effects of the carbon coating as well as the mechanisms for the improved electrochemical performances after modification are discussed based on the diffusivity data.

• Korean Journal of Materials Research
• /
• v.17 no.8
• /
• pp.442-446
• /
• 2007

Microwave dielectric properties of $0.85CaWO_4-0.15LnNbO_4$ (Ln = La, Sm) ceramics were investigated as a function of the sintering temperature and $Li_2WO_4$ content from 0.8 wt.% to 1.5 wt.%. A single phase with tetragonal scheelite structure was obtained at a given composition ranges. For the specimens with $Li_2WO_4$, the sintering temperature could be effectively reduced from $1150^{\circ}C$ to $900^{\circ}C$ due to the enhancement of sinterability. Dielectric constant (K) of the specimens with $LaNbO_4$ and $SmNbO_4$ was increased with the increase of sintering temperature and/or $Li_2WO_4$ content. However, K of the specimens with $LaNbO_4$ was higher than that of $SmNbO_4$ due to the larger dielectric polarizability $(\alpha)$ of $LaNbO_4$ ($18.08{\AA}$) than that of $SmNbO_4$ ($16.75{\AA}$). With an increase of $Li_2WO_4$ content, Qf value of the specimens with $SmNbO_4$ was decreased, while that of the specimens with $LaNbO_4$ was increased. Temperature coefficient of resonant frequency (TCF) was increased with the increase of $Li_2WO_4$ content.

• Journal of the Korean Electrochemical Society
• /
• v.18 no.2
• /
• pp.58-67
• /
• 2015

The effects of electrolyte additives, lithium bis(oxalate)borate (LiBOB), fluoroethylene carbonate (FEC), vinylene carbonate (VC), 2-(triphenylphosphoranylidene) succinic anhydride (TPSA), on high-temperature storage properties of $Li(Ni_{1/3}Co_{1/3}Mn_{1/3})O_2$/graphite are investigated with coin-type full cells. The 1 wt.% LiBOB-containing electrolyte showed the highest capacity retention after high temperature ($60^{\circ}C$) storage for 20 days, 86.7%, which is about 5% higher than the reference electrolyte, 1.15M lithium hexafluorophosphate ($LiPF_6$) in ethylene carbonate/ethyl methyl carbonate (EC/EMC, 3/7 by volume). This enhancement is closely related to the formation of semi-carbonate compounds originated from $BOB^-$ anions, thereby resulting in lower SEI thickness and interfacial resistance after storage. In addition, the 1 wt.% LiBOB-containing electrolyte also exhibited better cycle performance at 25 and $60^{\circ}C$ than the reference electrolyte, which indicates that LiBOB is an effective additive for high-temperature performance of $Li(Ni_{1/3}Co_{1/3}Mn_{1/3})O_2$/graphite chemistry.