• Environmental Engineering Research
• /
• v.21 no.2
• /
• pp.180-187
• /
• 2016

In the present work, bael shell (aegle marmelos) is used as the feedstock for pyrolysis, using a fixed bed reactor to investigate the characteristics of the pyrolysis oil. The product yields, e.g., liquid, char and gases are produced from the biomass at different temperatures with the particle size of 0.5-1.0 mm, at the heating rate of $150^{\circ}C/min$. The maximum liquid yield, i.e., 36.23 wt.%, was found at $5500^{\circ}C$. Some physical properties of the pyrolysis oil such as calorific value, viscosity, density, pH, flash point and fire point are evaluated. The calorific value of the bael shell pyrolysis oil was 20.4 MJ/kg, which is slightly higher than the biomass, i.e., 18.24 MJ/kg. The H/C and O/C ratios of the bio-oil were found as 2.3 and 0.56 respectively, which are quite higher than some other bio-oils. Gas Chromatography and Mass Spectroscopy (GC-MS) and Fourier Transform Infra-red (FTIR) analyses showed that the pyrolysis oil of bael shell is mostly composed by phenolic and acidic compounds. The results of the properties of the bael shell pyrolysis oil reveal the potential of the oil as an alternate fuel with the essential upgradation of some properties.

• Korean Journal of Materials Research
• /
• v.7 no.6
• /
• pp.505-509
• /
• 1997

FRAM(Ferroelectric Random Access memory)에의 응용을 위해 rf magnetron sputtering법을 이용하여 SrB $i_{2}$T $a_{2}$ $O_{9}$(SBT)박막을 증착하였다. 사용된 기판은 Pt/Ti/Si $o_{2}$Si이었으며 50$0^{\circ}C$에서 증착한 후 80$0^{\circ}C$의 산소 분위기 하에서 1시간 동안 열처리하였다. 증착시 증착 압력을 변화시켜 가면서 이에 따른 특성의 변화를 고찰하였다. 박막내의 Bi와 Sr의 부족을 보상하기 위해 20mole%의 Bi $O_{2}$와 30mole%의 SrC $O_{3}$를 과잉으로 넣어 타겟을 제조후 사용하였고 박막들의 두께는 300nm의 두께를 가지며 증착압력에 따라 다른 미세 구조르 보였다. 10mtorr에서 증착한 박막의 조성은 S $r_{0.6}$B $i_{3.8}$Ta/ sub 2.0/ $O_{9.0}$이었다. 이 SBT 박막의 잔류 분극(2 $P_{r}$)과 보전계(2 $E_{c}$)값은 각각 인가 전압 5V에서 18.5 $\mu%C/$\textrm{cm}^2$과 150kV/cm이었고, signal/noise비는 3V에서 4.6을 나타내었다. 5V의 bipolar pulse하에서 $10^{10}$cycle까지 피로 현상이 나타나지 않았으며, 누설 전류 밀도는 133kV/cm에서 약 1x$10^{-7A}$$\textrm{cm}^2$의 값을 보였다.을 보였다.

• Transactions on Electrical and Electronic Materials
• /
• v.5 no.5
• /
• pp.199-203
• /
• 2004

Superconducting B $i_2$S $r_2$C $a_{n-l}$C $u_{n}$ $O_{x}$(n=2～4) thin films were prepared by single target DC-magnetron sputtering. And, that was compared with the B $i_2$S $r_2$C $a_{n-l}$C $u_{n}$ $O_{x}$(n=1～3) thin film fabricated by using the ion beam sputtering. Phase intergrowth among n=2-3, 3-4 and 4-5 phases was observed. The molar fraction of each phase in the mixed crystal of the deposited films was determined by x-ray diffraction analyses and investigated as a function of $O_2$ gas pressure during sputtering. We investigated the changes of the superconducting properties by molar fraction of each phase. Also, the thin film surface observation was carried out by atomic force microscope. The images show the average particle size decreases, and the distribution density of particles on the film surface was to increase with lower gas pressures. The fabrication conditions for selective growth of the single n=2, 3 and 4 phases in BiSrC $a_{n-l}$C $u_{n}$ $O_{x}$(n=2～4) thin film are discussed.e discussed.ussed.

• Applied Biological Chemistry
• /
• v.7
• /
• pp.45-52
• /
• 1966

This study was carried out to determine how the water soluble, the available $P_2O_5$ and urea-N would change in the course of time, when the mixtures of calcium superphosphate and urea with lime for fertilizer which occurred in Korea and largely contained calcium carbonate were made. Three kinds of materials, i. e., calcium superphosphate, urea and lime for fertilizer were used in this study. Three kinds of mixed fertilizer, i. e., A, B and C were made up by mixing these materials to satisfy the following formula. $$1)\;Ca(H_2PO_4)_2+CaCO_3+CO(NH_2)_2{\rightarrow}$$$$Ca_2H_2(PO_4)+H_2CO_3+NH_3$$ $$2)\;Ca(H_2PO_4)_2+CaCO_3+CO(NH_2)_2{\rightarrow}$$$$Ca_3(PO_4)_2+H_2CO_3+NH_3$$ $$3)\;Ca(H_2PO_4)_2+CaCO_3+CO(NH_2)_2{\rightarrow}$$$$Ca_3(PO_4)_2+H_2CO_3+CaCO_3+NH_3$$ A,B and C were placed in desiccators respectively a six month period. During the time of storage, the water soluble, the available phosphoric acid and urea-N were measured once a month, seven times with the control measurement. The results may be summarized as follows. 1. None of A, B and C showed any change in the urea-N with the lapse of time. This fact indicated that the combination of calcium superphosphate and urea with lime for fertilizer was not unfavourable. 2. A, B and C decreased in the amount of water soluble $P_2O_5$ with the passage of time. This fact indicated that the mixing of calcium superphosphate and urea with lime for fertilizer was unfeasible. 3. The available $P_2O_5$ in any of A,B and C did not undergo a change as time went by. This fact suggested that the combination of calcium superphate and urea with lime for fertilizer was favourable.

• Journal of the Korean Home Economics Association
• /
• v.11 no.1
• /
• pp.44-56
• /
• 1973

The effect of the temperature and the time of scalding, and the addition of various seasoning on the remaining % of total Vitamin C contained in Spinach (Spinacia oleracea) was studied and discussed by means of chemical kinetics. The quantitative measurements of total Vitamin C were made by 2,4-dinitrophenyl hydrazine (DNPH) method with Clinical Electrophotometer (Fisher). The sample spinach contains 39.88mg. % of total vitamin C on the average, and the ratio of oxidized and reduced forms of Vitamin C is 1 : 4.7. When the sample spinach was scalded, the kinetics of the decrease of the remaining total vitamin C. % was observed to follow the first order reactions regardless of the temperatures applied (i,e. 70$^{o}$ , 80$^{o}$ , 90$^{o}$ and 100$^{o}$ ) with half-life range of 2.10 - 1.47 minutes. In the case of the addition of various seasonings, the addition of various seasonings, the kinetics remaining Vitamin C % showed to be the zero order reactions regardless of the kinds of seasonings and storage temperatures. With the addition of seasonings, the stability of Vitamin C was found to be increased in the order table salt+sesame oil+vinegar+soybean sauce, without seasoning, table salt+sesame oil, table salt+sesame oil+soybean sauce.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.11a
• /
• pp.123-127
• /
• 1992

When MOS devices is exposed to radiation, radiation effects of P-type MOS capacitor can cause modulation and/or degradation in devices characteristics and its operating life. The oxide layer is grown in $O_2$+T.C.E. and its thickness ranges from 40 to 80 nm. Irradiations on MOS capacitor were performed by Cobalt-60 gamma ray source and total dose ranges from $10^4$ to $10^8$ rads. The radiation effect on electrical conduction characteristics(I-V) in MOS capacitor was measured as a function of gate oxide thickness and total dose. From the experimental result, I-V characteristics is found to be influenced strongly by total dose in irradiated p-type MOS capacitors. The ohmic current is dependant on of total dose in irradiated P-type MOS capacitors. This results are explained using surface states at interface radiation-induced traps.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.191-191
• /
• 2007

유효 산화막 두께가 약 2.0nm 정도의 $ZrO_2$ 절연막 위에 Ta-Mo 금속 합금과 Ru-Zr 금속 합금을 Co-sputtering 방법을 이용하여 여러 가지 일함수를 갖는 MOS capacitor를 제작하여 전기적 재료적 특성에 관하여 연구를 하였다. 그 결과 각각의 금속 합금 게이트는 4.1eV 에서 5.1eV 사이의 다양한 일함수를 나타냈으며, $400^{\circ}C$, $500^{\circ}C$, $600^{\circ}C$, $700^{\circ}C$, $800^{\circ}C$ RTA 후의 C-V특성 곡선 및 I-V 측정을 통하여 누설전류를 확인하였다. 그 결과 Ta-Mo 금속 합금의 경우 스퍼터링 파워가 100W/70W에서 NMOS에 적합한 일함수를 가졌으며, Ru-Zr 금속 합금의 경우 스퍼터링 파워가 50W/100W에서 NMOS에 적합한 일함수를 가졌다. 열처리 후의 C-V특성 곡선에서도 정전용랑 값이 거의 변하지 않았으며 평탄 전압의 변화도 거의 없었다. 누설전류 특성에서는 물리적 두께가 비슷한 기존의 $SiO_2$ 절연막에서 실험결과와 비교하여 약 100배 정도 감소되었음을 알 수 있었다. 또한 기존의 실험들에서 나타난 열처리 후의 $ZrO_2$ 절연막과 Si 기판 사이의 Interfacial layer 의 동반 두께 증가로 인한 전기적 특성 저하가 나타나지 않는 줄은 특성을 보여준다.

• Korean Journal of Materials Research
• /
• v.14 no.10
• /
• pp.701-706
• /
• 2004

Bismuth layered structure ferroelectric thin films, La-substituted $Bi_{4}Ti_{3}O_{12}$ ($Bi_{1-x}La_{x}Ti_{3}O_{12}$, x=0.75, BLT) were prepared on the $Pt(111)/Ti/SiO_2/Si(100)$ substrates by a sol-gel spin coating process. The thin films were annealed in various conditions, i.e., oxygen, nitrogen and vacuum atmospheres for various annealing time. We investigated the annealing condition effects on the grain orientation and ferroelectric properties. The measured XRD patterns revealed that the BLT thin films showed only $Bi_{4}Ti_{3}O_{12}$-type phase with random orientation. $La^{3+}$ ion substitution for $Bi^{3+}$ ion in perovskite layers of $Bi_{4}Ti_{3}O_{12}$ decreased the degree of c-axis orientation and increased the remanent polarization ($2P_{r}$). The remanent polarization ($2P_{r}$) and the coercive field ($2E_{c}$) of the BLT thin film annealed at $650^{\circ}C$ for 5 min in oxygen atmosphere were $87{\mu}C/cm^2$ and 182 kV/cm, respectively, at an applied electric field of 240 kV/cm. For all of the BLT thin films annealed in various conditions, the fatigue resistance was shown. The improvement of ferroelectric properties with La substitution in $Bi_{4}Ti_{3}O_{12}$ could be attributed to the changes in space charge densities and grain orientation in the thin film.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2007.11a
• /
• pp.251-252
• /
• 2007

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2008.06a
• /
• pp.313-314
• /
• 2008