• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.682-683
• /
• 2006

Thermoelectric conversion efficiency of thermoelectric elements can be increased by using a structure combining n-type and p-type semiconductors. From the above point of view, attention was directed at ZnO as a candidate n-type semiconductor material and investigations were made. As the result, a dimensionless figure of merit ZT close to 0.28 (1073K) was obtained for specimens produced by the PCS (Pulse Current Sintering) method with addition of specified quantities of $TiO_2$, CoO, and $Al_2O_3$ to ZnO. It was found that the interstitial $TiO_2$ in the ZnO restrains the grain growth and CoO acts onto the bond between grains. The influence of the inclusion of $TiO_2$ and CoO onto the sintering behavior also was investigated.

• Korean Journal of Materials Research
• /
• v.21 no.9
• /
• pp.509-514
• /
• 2011

In this study, optical emission spectroscopy was used to monitor the plasma produced during the RF magnetron sputtering of a $BaTiO_3$ target. The intensities of chemical species were measured by real time monitoring with various discharge parameters such as RF power, pressure, and discharge gas. The emission lines of elemental and ionized species from $BaTiO_3$ and Ti targets were analyzed to evaluate the film composition and the optimized growth conditions for $BaTiO_3$ films. The emissions from Ar(I, II), Ba(I, II) and Ti(I) were found during sputtering of the $BaTiO_3$ target in Ar atmosphere. With increasing RF power, all the line intensities increased because the electron density increased with increasing RF power. When the Ar pressure increased, the Ba(II) and Ti(I) line intensity increased, but the $Ar^+$ line intensity decreased with increasing pressure. This result shows that high pressure is of greater benefit for the ionization of Ba than for that of Ar. Oxygen depressed the intensity of the plasma more than Ar did. When the Ar/$O_2$ ratio decreased, the intensity of Ba decreased more sharply than that of Ti. This result indicates that the plasma composition strongly depends on the discharge gas atmosphere. When the oxygen increased, the Ba/Ti ratio and the thickness of the films decreased. The emission spectra showed consistent variation with applied power to the Ti target during co-sputtering of the $BaTiO_3$ and Ti targets. The co-sputtered films showed a Ba/Ti ratio of 1.05 to 0.73 with applied power to the Ti target. The films with different Ba/Ti ratios showed changes in grain size. Ti excess films annealed at $600^{\circ}C$ did not show the second phase such as $BaTi_2O_5$ and $TiO_2$.

• Journal of the Microelectronics and Packaging Society
• /
• v.21 no.3
• /
• pp.31-35
• /
• 2014

$TiO_2$-nanoparticle-dispersed silicone was applied to a LED package and the light efficiency of the LED package was evaluated in this study. The addition of $TiO_2$ nanoparticles in silicone increased refractive index, which improved the light efficiency of the LED package. The $TiO_2$ nanoparticles were fabricated by hydrothermal synthesis and were dispsersed by a vinyl silane coating treatment. After the silane treatment, the $TiO_2$ nanoparticles dispersed with diameters of 10~40 nm but rod-shape $TiO_2$ nanoparticles with lengths of 100 nm were also observed. The refractive index increased with the $TiO_2$ concentration in silicone, while the transmittance decreased with the $TiO_2$ concentration. The light efficient of the LED package with $TiO_2$+silicone encapsulant was higher than that of the LED package with no $TiO_2$ in silicone encapsulant.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.245-245
• /
• 2016

본 연구에서는 선형 대향 타겟 스퍼터 (Linear Facing Target Sputtering: LFTS) 시스템을 이용하여 ITO와 Ti doped $In_2O_3$ (TIO) 타겟을 Co-sputtering한 InSnTiO 투명 전극의 전기적, 광학적 특성을 연구하였다. InSnTiO 투명전극의 전기/광학적 및 구조적 특성은 Hall measurement, UV/Vis spectrometry, X-ray Diffraciton 분석법을 통해 최적화 하였고, DC power, substrate to target distance (TSD), target to target distance (TTD), ambient treatment 변수 조절을 통해 최적화된 LFTS InSnTiO 투명전극을 제작하였다. LFTS 공정을 이용한 InSnTiO 투명전극의 성막 공정 중 DC파워와 공정압력 변화에 따른 구조적, 표면적 특성 변화는 Field-Emission Scanning Electron Microscopy (FE-SEM) 과 X-ray Diffractometer (XRD) 분석을 통해 관찰하였다. 이렇게 증착된 InSnTiO 투명전극은 급속열처리 시스템으로 (Rapid Thermal Annealing system) 후열처리를 진행하여 투과도의 향상과 면저항의 감소를 확인하였다. 본 연구에서는 다양한 분석을 통해 Co-sputtering한 InSnTiO 박막의 특성과 다양한 장점을 소개한다.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2010.05a
• /
• pp.48.2-48.2
• /
• 2010

The effect of additives as rare-earth in dielectric materials has been studied to meet the development trend in electronics on the miniaturization with increasing the capacitance of MLCCs (multi-layered ceramic capacitors). It was reported that the addition of rare-earth oxides in dielectrics would contribute to enhance dielectric properties and high temperature stability. Especially, dysprosium and thulium are well known to the representative elements functioned as selective substitution in barium titanate with perovskite structure. The effects of these additives on microstructure and electric properties were studied. The 0.8 mol% Dy doped $BaTiO_3$ and the 1.0 mol% Tm doped $BaTiO_3$ had the highest electric properties as optimized composition, respectively. According to the increase of rare-earth contents, the growth of abnormal grains was suppressed and pyrochlore phase was formed in more than solubility limits. Furthermore, the effect of two rare-earth elements co-doped $BaTiO_3$ on the dielectric properties and insulation resistance was investigated with different concentration. The dielectric specimens with $BaTiO_3-Dy_2O_3-Tm2O_3$ system were prepared by design of experiment for improving the electric properties and sintered at $1320^{\circ}C$ for 2h in a reducing atmosphere. The dielectric properties were evaluated from -55 to $125^{\circ}C$ (at $1KHz{\pm}10%$ and $1.0{\pm}0.2V$) and the insulation resistance was examined at 16V for 2 min. The morphology and crystallinity of the specimens were determined by microstructural and phase analysis.

• Journal of the Korean Ceramic Society
• /
• v.25 no.6
• /
• pp.694-698
• /
• 1988

Pb(Zr, Ti)O3-Pb(Co, Nb)O3 systems were investigated by x-ray diffraction method. System contains rhombohedral, tetragonal, and pseudocubic structures at room temperature. Crystal symmetry was changed from 4-fold symmetry to 3-fold symmetry by substituting Pb(Co1/3, Nb2/3)O3 ; PCN, to Pb(Zr0.52, Ti0.48)O3 ; PZT. As the substituted PCN concentration was increased, an increase in a-axis direction and a decrease in c-axis in the perovskite structure were occurred simultaneously, so that the crystal symmetry was changed into such way. In the higher sinteringtemperatures, the unit cell distortions occurred rather in the lower substitution range of PCN. The ferroelectric properties were maximized at the region that tetragonal and rhombohedral or pseudocubic structures were coexist.

• Korean Journal of Materials Research
• /
• v.23 no.1
• /
• pp.59-66
• /
• 2013

Opal glass samples having different chemical compositions were synthesized and transparent glass was obtained after melting. The effects of $TiO_2$, $BaF_2$, and $CeO_2$ content on the color of the opal glass were studied by observing images of the opal samples and analyzing the results via ultraviolet visible spectroscopy and color spectrometry. The aesthetic properties of the opal glass were determined by studying the transmittance of visible light in the 400 nm to 700 nm range. The basic chemical composition of opal glass was $SiO_2$ 52.9 wt%, $Al_2O_3$ 12.35 wt%, $Na_2CO_3$ 15.08 wt%, $K_2CO_3$ 10.35 wt%, $Ca_3(PO)_4$ 4.41 wt%, $MgCO_3$ 1.844 wt%, $LiCO_3$ 2.184 wt%, and $TiO_2$ 0.882 wt%. The glass samples were prepared by varying the weight percentage of $TiO_2$, $BaF_2$, and $CeO_2$. The transmittance of visible light was decreased from 95 % to 75 % in the glass samples in which $TiO_2$ content was increased from 0 to 3.882 wt%. In the blue spectrum region, as the content of $TiO_2$ increased, the reflectance value was observed to become higher. This implies that $TiO_2$ content induces more crystal formation and has an important effect on the optical properties of the glass. The opalescence of opal samples that contained $CeO_2$ or $BaF_2$ is stronger than that in the samples containing $TiO_2$. Opal glass samples comprising $TiO_2$ had tetragonal lattice structures; samples including $CeO_2$ as an additive had cubic lattice structures (FCC, $CeO_2$).

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.166-166
• /
• 2003

Si (100) 기판위에서 에피텍셜하게 자란 CoSi$_2$층은 우수한 열적안정성, 낮은 junction leakage, ultra-Shallow junction형성 등의 장점으로 인하여 많은 주목을 받아왔다. 그래서 에피텍셜 CoSi$_2$층을 형성하기 위한 많은 방법들이 보고되어 왔다. 그 방법으로는 Ti나 TiN층을 이용한 interlayer mediated epitaxy, Co의 제한적 공급을 통한 molecular beam epitaxy와 molecular beam allotaxy, 그리고 금속유기소스를 이용한 반응성화학기상증착법등이 있다. 하지만 이 방법들은 복잡한 증착공정과 열처리 후 잔류층 제거의 어려움등을 가지고 있다. 본 연구는 일반적으로 사용되는 Ti나 oxide의 중간층없이 에피층을 형성시키는 새로운 방법으로 CO-O-N 박막으로부터 열처리에 의해 확산된 Co로부터 CoSi$_2$에피층을 형성시켰다.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.97-97
• /
• 2003

Composition in the (Znl-xNix)2TiO4+ yTiO2 system (x=0-0.5, y=0-0.35) were synthesized via the solid-state reaction route. The incorporation of titanium, in the form of TiO2, in (Znl-xNix)2TiO4 spinel ceramics were investigated by analyzing the crystal structure and measuring the dielectric properties. The result of the crystal structure analysis suggested that TiO2 level of 0.01 y 0.33 could be incorporated into the (Znl-xNix)2TiO4 spinel. The change of incorporated TiO2 level is related with Co-content as a inverse proportion and the variation of lattice parameter and dielectric properties were supported the result.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.04a
• /
• pp.94-95
• /
• 2002