• Journal of the Korean Institute of Landscape Architecture
• /
• v.23 no.3
• /
• pp.80-93
• /
• 1995

The purpose of this study was to assess functioni fo urban greenspace to reduce atmospheric CO\sub 2\ concentration. The study quantified carbon storage in urban greenspace and carbon emission by fossil fuel consumptio in Chuncheon. The amount of carbon storage in vegetation by land use type was 0.02kg/$m^2$ for commercial land, 4.36kg/$m^2$ for natural land, and 0.54kg/$m^2$ for the other urban lands. In 1994, total amount of carbon emission by fossil fuel consumption was about 257,358 metric tons, and the per capita carbon emission was 1.4 metric ton. Total amount of carbon storage in vegetation was 42,942 metric tons, approximately 17% of the carbon emission. This study excluded quantification of carbon storage in soils. The role of urban greenspace to sequester atomspheric carbon might be much greater, if a soil greenspace to sequester atmospheric carbon might be much greater, if a soil greenspace to sequester atmospheric carbon might be much greater, if a soil carbon storage is included quantification of carbon storage is included. However, increasing coverage of trees and managing them for healthy growth would not be sufficient for avoiding adverse impacts by future climate change. Additional measures should be followed such as an increase of energy use efficiency and development of substitute energy.

• Journal of the Korean Ceramic Society
• /
• v.46 no.4
• /
• pp.429-435
• /
• 2009

In this study, we investigated microstructure and the CO gas sensing properties of Ag-CuO-$SnO_2$ thin films prepared by co-evaporation and subsequently thermal oxidation at air atmosphere. The sensitivity of a Cu-Sn films, thermally oxidized at $600^{\circ}C$, is strongly affected by the amount of Cu. At Cu:7 wt%-Sn:93 wt%, the film exhibited a maximum sensitivity of ${\sim}2.3$ to CO gas of 1000 ppm at $300^{\circ}C$. In contrast, the sensitivity of a Sn-Ag film did not change significantly with the amount of Ag. An enhanced sensitivity of ${\sim}3.7$ was observed in the film with a composition of Ag:3 wt%-Cu:4 wt%-Sn:93 wt%, when thermally oxidized at $600^{\circ}C$. In addition, this thin film shows a response time of ${\sim}80$ sec and a recovery time of ${\sim}450$ sec to 1000 ppm CO gas. The results demonstrate that the CO sensitivity of the Ag-CuO-$SnO_2$ thin films may be closely associated with coexistence of $SnO_2$ and SnO phase, decrease in average particle size, and a porous microstructure. We also suggest that co-evaporation and followed by thermal oxidation is a very simple and effective method to prepare oxide gas sensor thin films.

• Analytical Science and Technology
• /
• v.10 no.2
• /
• pp.131-138
• /
• 1997

Supercritical Fluid Chromatography(SFC) has become a technique for solving problems that are difficult to be monitored by other chromatographic methods. However, the most widely used fluid, is no more polar than hexane. Polar samples which are difficult to be analyzed with pure supercritical $CO_2$ because of their high polarity can be separated by adding polar modifiers to supercritical $CO_2$. In this paper, a new method for monitoring the mobile phase composition in modified supercritical fluid chromatography was developed. The amount of water dissolved in supercritical $CO_2$ was measured by amperometric microsensor which is made of thin film of perfluorosulfonate ionomer(PFSI). The amount of water dissolved in supercritical $CO_2$ stayed constant for a much longer time than with a saturator column. With this new mixing device, we could get good resolutions for vitamins which are difficult to separate with pure $CO_2$.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.1
• /
• pp.47-51
• /
• 2010

A powder, containing 80 percent of blue cobalt aluminate $(CoAl_2O_4)$ crystallites, was synthesized at $210 ^{\circ}C$ using a (metal nitrate-malonic acid-ammonium hydroxide-ammonium nitrate) system. The optimal amount of concentrated ammonia water and initial decomposition temperature were determined for the blue $CoAl_2O_4$ crystallites preparation. Three $CoAl_2O_4$ precursor pastes, corresponding to the various amounts of concentrated ammonia water, were prepared by evaporating the initial solutions in an electric furnace fixed at $80 ^{\circ}C$ under a vacuum of 25 torr. The initial solution was used to dissolve the starting materials. The powder with the maximum content (80%) of blue $CoAl_2O_4$ crystallites was prepared when the prepared precursor was decomposed at $210 ^{\circ}C$. The blue $CoAl_2O_4$ crystallite content in the prepared sample decreased with increasing initial decomposition temperature. For 0.2 mole of the $Al^{3+}$ ion, the chemical compositions of the precursor corresponded to molar ratios of 0.4, 1.40, 2.56 and 2.00 for the $Co^{2+}$ ion, malonic acid, ammonia and ammonium nitrate per mole of the $Al^{3+}$ ion, respectively. The blue $CoAl_2O_4$ crystallite content in the sample decreased with the amount of ammonia deviated from the optimal value. The characteristics of the powders were examined using X-ray diffraction, optical microscopy, Fourier transformation infrared spectroscopy and the Brunauer-Emmett-Teller technique.

• Applied Chemistry for Engineering
• /
• v.23 no.6
• /
• pp.624-629
• /
• 2012

To capture and recover carbon dioxide ($CO_2$), we impregnated honeycomb made of ceramic paper with $K_2CO_3$ and its absorption characteristics of $CO_2$ were investigated. The absorption amount of $CO_2$ on the honeycomb absorbent impregnated with $K_2CO_3$ was 13.8 wt% at a constant temperature ($70^{\circ}C$) and relative humidity (66%) condition. Because the absorption amount of $CO_2$ achieved almost the same loading ratio of $K_2CO_3$ (17.6 wt%), the absorption reaction of $CO_2$ by $K_2CO_3$ on the honeycomb absorbent seems to be going smoothly. In addition, $CO_2$ absorption breakthrough characteristics of the honeycomb absorbent were analyzed at the temperature range of $50{\sim}80^{\circ}C$, and the water vapor was fed to an absorption column before the feeding of $CO_2$ or simultaneously with $CO_2$. As a result, the absorption capacity of $CO_2$ was more enhanced using the water vapor supplying before $CO_2$ than that of simultaneous supplying. It was confirmed by temperature programmed desorption analysis that the $KHCO_3$ produced by the absorption reaction of $K_2CO_3$ and $CO_2$ is regenerated by the desorption of $CO_2$ at a temperature of about $128^{\circ}C$.

• KSBB Journal
• /
• v.11 no.3
• /
• pp.295-302
• /
• 1996

The measurements of rubisco parameters are important in photosynthetic studies. In this experiment, we used photometric assay method to detect these major parameters, such as activity, carbamylation and amount of rubisco. The main advantages of this method are very simple and as sensitive as conventional methods which usually produce radioactive waste. In this study, with kidney bean (Phaseolus vulgatis L.) leaves grown at normal $CO_2$ (350ppm) and high $CO_2$ (650 ppm), we investigated the effect of $CO_2$ concentration on activation and carbamylation of rubisco by measuring the rubisco activity, carbamylation rate and amount of rubisco using a dual beam (334nm and 405nm) spectrophotometer, and analyzed the polypeptide profiles of rubisco by SDS-PAGE. When $CO_2$ concentration was raised from 350ppm to 650ppm, all parameters of rubisco were decreased : $41.2{\mu}M/m^2/s and 52.2{\mu}M/m^2/s$ to $27.4{\mu}M/m^2/s and 46.1{\mu}M/m^2/s$ for initial and total rubisco activity, respectively ; from 79% to 58.9% for carbamylation rate ; from $1.94 {\mu}M/m^2$ to 1.58{\mu}M/m^2$ for amount of rubisco. These results suggests that the decrease in rubisco activity at high $CO_2$ was caused by carbamylation. The analysis of the preparation by SDS-PAGE showed two major polypeptides at 50 and 14.5 kD which were identified as the large and the small subunits of rubisco. There were no differences in the intensity compared high $CO_2$ to normal $CO_2$ in both 50 kD and 14.5 kD bands. We also found that these inhibitory effects of $CO_2$ were reversible. When high $CO_2$ was switched to normal $CO_2$, the parameters of rubisco changed were almost the same as normal rubisco parameters. These data provide an evidence that activity of rubisco was recovered by $CO_2$ concentration of 350 ppm.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.2
• /
• pp.172-179
• /
• 2006

This study developed a program for detecting charged refrigerant amount in system air-conditioner. System air-conditioner is an air-conditioning system with multiple indoor units. Due to the complexity of the system, it is more difficult to detect the refrigerant amount charged in the system air-conditioner than in a general single air-conditioner. Experiments were performed for a 6 HP outdoor unit with 3 indoor units in a psychrometric calorimeter. The experimental amount of the charged refrigerant was ranged from $60\%\;to\;140\%\;with\;10\%$ increasement. Fuzzy algorithm was employed for detecting the charged refrigerant amount in the system air-conditioner. The experimental data were used for curve-fitting for the general ranges of indoor and outdoor temperature conditions. Membership function was determined for the whole ranges of experimentally measured data and rule-bases were defined for each charged refrigerant amount. Developed program successfully predicted the measured data within $10\%$ resolution range.

• Proceeding of Spring/Autumn Annual Conference of KHA
• /
• 2006.11a
• /
• pp.275-280
• /
• 2006

The protection of the environment is one of today's key demanding international activities and interests. All of aspects including industry, economy and society should be changed into environmental friendly industries. The building is not exception in this trend. What is not generally realized is that building, in the lifecycle of construction, use and demolition, account for large construction, not considered with environment impact and conservation in the lifecycle. Expecially, the construction materials and components used in the construction stage has much embodied energy. And much $CO_2$ emit on the production of the construction material and component. The energy use and $CO_2$ emission would continuously diminish the limited natural resources and impact the environment such as ozon layer destruction. In this paper, it studied the estimation of the amount of energy use and $CO_2$ emission in the building construction stage, it would provide the estimation process and applied with the multifamily housing.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2007.05a
• /
• pp.417-420
• /
• 2007

This paper proposes a method to calculate the amount of the CO2 emission w.r.t. generator MW output using the input-output coefficients of the thermal power plants. A calculation of CO2 emission for an LNG fired combined cycle power plant is demonstrated.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.11a
• /
• pp.421-424
• /
• 2004

In this study, in order to develop low temperature sintering ceramics for ultrasonic vibrator, PNW-PMN-PZT system ceramics were manufactured with the amount of $CaCO_3$ addition and their piezoelectric, dielectric and microstructural characteristics were investigated. $CaCO_3$ addition to PNW-PMN-PZT basic composition was proved to be capable of sintering the ceramics at temperature below $1000^{\circ}C$ due to the effect of $Li_2CO_3-CaCO_3$ liquid phase. However, with increasing the amount of $CaCO_3$ addition, the second phase was appeared. As the results, electromechanical coupling coefficient (kp) and dielectric constant $(\epsilon_r)$ decreased. Taking into consideration electromechanical coupling coefficient (kp) of 0.49, mechanical quality factor (Qm) of 1396, dielectric constant $(\epsilon_r)$ of 1300 and density of $7.78[g/cm^2]$, it was concluded that the 0.25wt% $CaCO_3$ addition composition ceramics sintered at $920^{\circ}C$ was suitable for ultrasonic vibrator application.