• Journal of the Korean Ceramic Society
• /
• v.42 no.9 s.280
• /
• pp.599-601
• /
• 2005

The coarsening process of two different $BaTiO_3$ single crystal seeds, one with a (111) double twin and the other without it, was investigated. Due to the presence of Twin Plane Reentrant Edge (TPRE), the coarsening rate of the twinned seed crystal was significantly higher than that without a twin. For the coarsening by the 2-dimensional nucleation and lateral growth, the energy barrier for nucleation at the TPRE was analyzed to be about a half compared with that at the terrace planes.

• Journal of the Korean Vacuum Society
• /
• v.5 no.1
• /
• pp.62-66
• /
• 1996

$(Ba_{1-x}Sr_xTiO_3$ (BST) thin films have been grown on Pt-coated MgO by metal -organic chemical vapor deposition. X-ray diffraction results showed that BST films were grown on a Pt/MgO substrate with (100) preferred orientation perpendicular to the surface. The lineawr relationship of P-E curve obtained form hysteresis loop measurement indicated that the BST films had a Curie transitions below room temperature . Films deposited at $900^{\circ}C$ exhibited a smooth and dense microstructure, a dielectric constant of 202, and a dissipation facotr of 0.02 at 100kHz. The leakage current density of the BST films is about $2\times10^{-10} \;A/\textrm{cm}^2$$ at an applied electric field of 0.2 MV/cm. The electrical behavior on the current-voltage characteristics is well explained by the bulk-limited Pool-Frenkel emission.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.284-285
• /
• 2007

본 논문에서는 저소음 및 저 신호 왜곡 특성을 가지는 내환원성 유전체 원료를 개발하기 위하여 $(Ca_{0.7}Sr_{0.3})(Zr_{0.97}Ti_{0.03})O_3$에 $CaTiO_3$, $SrTO_3$, $BaTiO_3$를 첨가하여 이에 따른 유전 특성을 조사하였다. 첨가량의 조절 및 glass frit 첨가를 통하여 환원성 분위기에서도 유전율 80 ~ 100, 절연저항 (R*C) 500[ohm-F] 이상의 유전특성을 얻었다. 본 연구결과로 얻어진 유전재료를 적용하면 무소음 및 저 신호 왜곡 특성을 가지면서도 고 신뢰성의 MLCC를 제작할 수 있을 것으로 예상된다.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.03a
• /
• pp.71-71
• /
• 2003

최근 통신용 전자부품의 소형화, 저가격화, 고기능화의 요구가 점점 더 증대되고 있으며 이를 위해서 기판의 배선밀도를 높이는 것과 개별 부품 또는 모듈의 크기와 무게를 줄이는 것이 절실히 필요하다. 본 연구에서는 저융점의 phosphate계 유리 프릿의 첨가를 통해 LTCC (Low Temperature Co-fired Ceramic) 에 적용 가능한 조성을 개발하고자 하였다. 마이크로파 용 유전재료로서 널리 사용되고있는 BNT (BaO-Nd$_2$O$_3$-TiO$_3$) 계 세라믹스에 저융점 유리 프릿의 양을 10-30wt% 범위로 변화시키면서 900-110$0^{\circ}C$ 범위에서 소결하여 이에 따른 수축률 변화와 상대밀도의 변화를 조사하였다 유리 프릿으로 P$_2$O$_{5}$-ZnO-BaO-Nd$_2$O$_3$ 계, P$_2$O$_{5}$-SnO-ZnO 계 2가지 조성의 유리를 사용하였다 그 결과로 소결체의 상대밀도는 소성온도가 900-110$0^{\circ}C$ 로 증가함에 따라 85-96% 로 증가하였고, 그 수축률은 소결온도 100$0^{\circ}C$ 에서 급격히 증가하였다. 이러한 결과는 저온 동시소성 세라믹 조성의 사용을 위해 좋은 결과가 예상된다.

• Proceedings of the Korean Ceranic Society Conference
• /
• 2000.10a
• /
• pp.87.2-87
• /
• 2000

• Proceedings of the Korean Ceranic Society Conference
• /
• 2000.10a
• /
• pp.183.2-183
• /
• 2000

• Proceedings of the Korean Ceranic Society Conference
• /
• 2003.10a
• /
• pp.196.2-196
• /
• 2003

• Journal of the Korean Ceramic Society
• /
• v.29 no.6
• /
• pp.459-462
• /
• 1992

It has been reported that the size and characteristics of ferroelectric domains which have an essential role on the ferroelectric properties depend on the grain size of ferrolectric ceramics. Therefore understanding the change of domain characteristics with grain size is so important to know the dependence of dielectric constant, dielectric loss and aging on the grain size. In this research, the equilibrim domain with is calculated as d={{{{ SQRT { { 64 pi sigma a} over {3C11Ss2 } } }}. This calculated value is nearly same to the measured value of BaTiO3 and Pb(Zr0.4Ti0.6)O3 ceramics 90$^{\circ}$domain wall width. The calculated 90$^{\circ}$domain wall enerygy in Pb(Zr0.4Ti0.6)O3 which is obtained through the model is approximately 2$\times$10-2J/$m^2$.

• Korean Journal of Materials Research
• /
• v.18 no.4
• /
• pp.169-174
• /
• 2008

The structural and electrical properties of amorphous $BaSm_2Ti_4O_{12}$ (BSmT) films on a $TiN/SiO_2/Si$ substrate deposited using a RF magnetron sputtering method were investigated. The deposition of BSmT films was carried out at $300^{\circ}C$ in a mixed oxygen and argon ($O_2$ : Ar = 1 : 4) atmosphere with a total pressure of 8.0 mTorr. In particular, a 45 nm-thick amorphous BSmT film exhibited a high capacitance density and low dissipation factor of $7.60\;fF/{\mu}m2$ and 1.3%, respectively, with a dielectric constant of 38 at 100 kHz. Its capacitance showed very little change, even in GHz ranges from 1.0 GHz to 6.0 GHz. The quality factor of the BSmT film was as high as 67 at 6 GHz. The leakage current density of the BSmT film was also very low, at approximately $5.11\;nA/cm^2$ at 2 V; its conduction mechanism was explained by the the Poole-Frenkel emission. The quadratic voltage coefficient of capacitance of the BSmT film was approximately $698\;ppm/V^2$, which is higher than the required value (<$100\;ppm/V^2$) for RF application. This could be reduced by improving the process condition. The temperature coefficient of capacitance of the film was low at nearly $296\;ppm/^{\circ}C$ at 100 kHz. Therefore, amorphous BSmT grown on a TiN substrate is a viable candidate material for a metal-insulator-metal capacitor.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.13 no.1
• /
• pp.53-59
• /
• 1999

The ceramic capacitor was fabricated by $(Ba_{0.85}Ca_(0.15)TiO_3+ZnO$ + ZnO(from 0.1 to 0.4 mol ratio). The electrical and structural properties of ceramic capacitor for high voltage application was studied in this study. The relative rensity of ceramics capacitor has shown high in all specimen. The grain was a small size from $1.0[\mum]$ to $1.22[\mum]$ and it was increased with ZnO at 0.3 mol ratio. It was stabilized that the temperature coefficient of ceramic capacitor to change temperature had below 100[ppm] at 0.12~10[kHz]. The dielectric reIaxation time was decreased by interface polarization over $110[^{\circ}C]$ and it was increased by space polarization of paraelectric layer below $110[^{\circ}C]$. The insulating layer was increased with ZnO and dielectric constant to voltage was stabilized by 0.1[%].0.1[%].